垃圾渗滤液的膜生物反应器与传统生物工艺述评

采用文献调研法比较评价了膜生物反应器与传统生物工艺对垃圾渗滤液的处理效果。结果表明,渗滤液的水质特征(主要指COD)主要由渗滤液年龄决定,B/C值和渗滤液年龄对COD去除有重要影响。传统生物处理常采用多级组合工艺,渗滤液特性、工艺单元数、水力停留时间和有机负荷率等是影响COD去除的重要参数。近年来,MBR工艺的应用日益广泛,对于B/C值较低的老龄渗滤液,MBR工艺可获得更好的COD去除效果,也有利于废水的膜深度处理。     

A~2/O工艺厌氧池有机物降解动力学模型对比研究

试验考察了东阿县污水处理厂一期A2/O工艺厌氧池去除有机污染物效能,当进水ρ(COD)为548.3 mg/L时,厌氧池平均去除率达78.7%。同时探讨了几种常见数学模型模拟厌氧池去除有机物规律情况,根据实际工程监测数据确定有机底物降解动力学常数,得出Grau模型、Stover-kincannon模型和改进的Monod模型较适合模拟厌氧池去除有机物的规律,并对模型进行了检验。     

酸化液对厌氧释磷好氧吸磷速率的影响研究

采用序批式试验研究了酸化液对聚磷菌厌氧释磷好氧吸磷速率的影响。同一活性污泥混合液中聚磷菌的释磷潜力相当,混合液中挥发性脂肪酸越多则越有利于激发聚磷菌的释磷潜能。酸化液投加量越大,对应的混合液中聚磷菌的平均释磷速率也越大。当酸化液投加量为30 mg/L(以TOC计)时,聚磷菌的平均释磷速率达0.137 mg/(mg.d),是未投加酸化液工况的3.26倍。聚磷菌厌氧释磷过程中,活性污泥的MLVSS值逐渐增大,而MLSS值却不断减小,这是由聚磷菌释磷反应过程中聚磷颗粒和糖原的消耗,以及PHB的生成而产生的。碳源充足与否,对聚磷菌的平均好氧吸磷速率影响不大,研究各工况中,聚磷菌的平均吸磷速率在0.129~0.160 mg/(mg.d)内。碳源越充足,则聚磷菌在好氧吸磷反应持续的时间越长,因此,具有更强的超量吸磷能力。酸化液投加量为20 mg/L时(以TOC计),聚磷菌在好氧吸磷结束时,出水的SP浓度能减少到0.5 mg/L以下。     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Effect of anaerobic digestion on the high rate of nitritation, treating piggery wastewater

Laboratory reactors were operated by using piggery wastewater and the effluent of anaerobic digester from piggery wastewater plants to study the effect of anaerobic digestion on nitritation rate.     

COD/SO42-对硫酸盐有机废水处理效率的影响

以人工配制的含硫酸盐有机废水作为原水,研究不同COD/SO42-值下厌氧折流板反应器(ABR)处理含硫酸盐有机废水去除率.试验结果表明:当COD/SO42-＜14.8时COD的去除率可达95%,SO42-的去除率在86%～96%之间;当COD/SO42-在14.8～4.0之间时,COD的去除率有所下降但仍能保持在94%...     

新型专性厌氧菌利用葡萄糖进行发酵产氢的实验研究

采用批式发酵法对厌氧产氢菌株Bacteria.P利用葡萄糖发酵,在底物浓度、初始pH值、接种比例等不同培养条件下的产氢能力进行了研究。结果表明:专性厌氧菌P是一种高效产氢的菌株,在葡萄糖质量浓度为10 g/L、初始pH为6.0、接种比例为1∶20时,发酵气体总产量和细胞干重达到最大值,分别为485 mL和0.836 g/L。     

控制游离氨实现单级自养生物脱氮的研究

通过实时调控SBR反应器内的游离氮浓度的控制策略,实现以亚硝化作用和厌氧氨氧化作用协同的单级自养生物脱氮工艺.实验分成亚硝酸菌富集和厌氧氨氧化菌混合接种2个阶段,SBR内的温度始终保持在(31±2)℃.亚硝酸菌富集阶段,pH值稳定在7.8左右,通过调节进水氩氮浓度(56～446 mg·L-1)实现FA浓度的变化,从而实...     

长江口邻近海域沉积物中厌氧氨氧化细菌分布特征研究

海洋生态系统氮素循环对维持海洋生态收支平衡具有重要意义,由厌氧氨氧化细菌(anaerobic ammonia-oxidizing bacteria,ANAMMOX Bacteria)推动的厌氧氨氧化过程是海洋氮素移除的重要途径.本研究采用荧光定量PCR(q PCR)技术,并结合环境理化因子,分析了2011年夏季长江口邻近海域沉积物中厌氧氨氧化细菌的种群丰度分布特征.结果表明,厌氧氨氧化细菌的种群丰度在长江口邻近海域的空间分布与环境因子密切相关,总有机碳含量、盐度、铵盐浓度对长江口邻近海域沉积物中厌氧氨氧化细菌的种群丰度具有重要调控作用.厌氧氨氧化细菌的丰度分布与总有机碳含量呈显著正相关关系(P0.01,r=0.69),同时又随亚硝酸盐浓度、溶解氧浓度的升高而降低,而盐度对厌氧氨氧化细菌丰度分布的影响较为复杂.     

含固率和接种比对叶菜类蔬菜垃圾厌氧消化的影响

通过叶菜类蔬菜垃圾中温批式厌氧消化实验,比较了含固率(3%、5%、7%)和接种比(1.5、2.5、3.5)对产甲烷效果的联合影响.结果表明,在研究实验参数范围内,含固率越低、接种比越高,越有利于缩短产甲烷反应迟滞期,平均日产甲烷速率越快.经过52d的培养,在含固率为3%、接种比为3.5的工况中,平均日产甲烷速率最快,达到9.5mL/(gVS·d),日最大产甲烷速率最快,达到49.8mL/(gVS·d),最早进入快速产甲烷期.当接种比为3.5时,随着含固率的升高,产甲烷速率下降,迟滞期延长,但单位底物累计产甲烷量增大,含固率7%时单位底物累计净产甲烷量为481mL/gVS.而当接种比为1.5时,含固率为5%和7%的工况均无法启动甲烷化反应,含固率为3%的工况的产气迟滞期达15d.挥发性有机酸的累积抑制甲烷化反应的启动,迟滞期随着液相中有机酸浓度的增加而延长,当有机酸浓度低于1260mg/L,甲烷化反应没有明显的迟滞期.