UASB-好氧工艺处理碳酸饮料废水

从废水特点、工艺流程、主要构筑物等方面介绍UASB-好氧工艺处理碳酸饮料废水,并与传统好氧处理工艺进行经济及技术分析比较,表明该工艺处理水质良好,成本降低。     

基于升流式厌氧污泥床反应器的微生物燃料电池的研究

构建了一种基于升流式厌氧污泥床反应器（UASB）的微生物燃料电池（MFCs）,利用UASB高效去除COD能力及连续进样方式,获得稳定电能输出。考察了水力停留时间、进液方式、电极材料、离子交换膜种类、溶液离子强度等因素对于MFCs性能的影响。实验结果表明：在水力停留时间6h、连续进液、高纯石墨板电极以及均相阳离子交换膜条件下,连续运行3个月,放电功率稳定在145mW／m^2,开路电压0．78V,放电电流最高可达321mA／m^2。     

常温条件下UASB+SBR工艺处理甲胺、甲醇废水试验研究

甲胺、甲醇及其产品均具有较强的毒性和危险性,因此含甲胺的废水须经一定处理达标后才能排放.以山东肥城某化工厂含甲胺、甲醇混合(体积比1∶1)废水.在常温条件下,采用厌氧 好氧(UASB SBR)2级串联组合工艺进行处理.该甲胺,甲醇混合废水呈酸性,COD浓度较高.其BOD与COD比值为0.64.可生化性良好.试验中调整、控制UASB和SBR反应器的各运行参数,通过检测处理效果比较得出该工艺在常温条件下处理该化工废水的最佳运行参数值.试验结果表明UASB在常温下运行81d,启动基本完成.UASB最佳水力停留时间为24h整个工艺对COD有机物有一定的去除效果,COD平均去除率为68.14%;系统的TN去除效率较为稳定.平均去除率可达72.3%.出水TN浓度在16.56mg/L以下;系统有一定的抗冲击负荷能力,但不是很强;系统有一定的耐低温性,低温环境下(9.0～14.2'C.平均为12.3℃)系统COD平均去除率为55.80%,UASB反应器未发生酸化现象.     

4种浮床栽培植物生长特性及吸收氮磷能力的比较

选取美人蕉、风车草、菖蒲和香根草4种常见的浮床植物为研究对象,对其生长特性及吸收氮磷的能力进行比较研究.结果显示,4种植物的成活率均在90%以上,移栽后60-100d为植物的快速生长期.经过4个月的生长.4种植物水面上部生物量均明显高于下部;除香根草外,其它3种植物体内的氮磷含量均呈叶>根>茎的分布;植物体内的氮、磷累积量大小依次为美人蕉>风车草>菖蒲>香根草.植物吸收占浮床系统氮去除的比例均低于40%,占浮床系统磷去除的比例均高于55%.4种植物中,美人蕉对水体中氮磷的吸收能力最强,可以将其作为三峡库区次级河流的浮床栽培植物进行推广.     

复合生态滤床用于重金属污染地表水体修复

以蛭石为滤床基质,研究了复合生态滤床对受重金属污染地表水体的修复效能.结果表明,复合生态滤床对重金属污染水体有较好的处理效果,在水力负荷为2.0m.3m-.2d-1时,系统对Cu、Zn、Pb和Cd的平均去除率分别达到81.60%、80.55%、83.20%、62.21%;按照国家《地表水环境质量标准》(GB3838-2002),出水重金属浓度达到Ⅱ类水质标准;出水COD值为9.7～38.3mg·L-1,达到Ⅰ类水质标准;出水NH4+-N达到1mg·L-1以下,达到Ⅲ类水质标准.滤床基质中铜离子含量稳定在30mg·kg-1左右,表明植物根系可以有效地吸收蛭石吸附的重金属,从而有效提高蛭石的再吸附能力,延长滤床工作周期.     

新型PP填料生物滴滤法净化高浓度H_2S的实地中试研究

针对制药行业污水处理中水解酸化池的高浓度H2S恶臭气体,采用新型PP填料生物滴滤床处理方法,进行实地中试研究。生物滴滤塔塔形为长方形,填料层高1m,空塔停留时间10.7s,在进气H2S浓度低于1420 mg/m3时,循环营养液pH值0.35,生物去除率保持80%以上。实际工程中,在进气H2S浓度高于1500 mg/m3时,可以增加碱洗预处理工艺,经过2个月的跟踪检测,绝大部分的去除率能保持80%以上,最高去除率可以达到96%以上,出口排放量可控制在250mg/m3以内,符合《恶臭污染物排放标准》(GB14554-93)的相关要求。     

An innovative membrane bioreactor and packed-bed biofilm reactor combined system for shortcut nitrification-denitrification

An innovative shortcut biological nitrogen removal system, consisting of an aerobic submerged membrane bioreactor (MBR) and an anaerobic packed-bed biofilm reactor (PBBR), was evaluated for treating high strength ammonium-bearing wastewater. The system was seeded with enriched ammonia-oxidizing bacteria (AOB) and operated without sludge purge with a decreased hydraulic retention time (HRT) through three phases. The MBR was successful in both maintaining nitrite ratio over 0.95 and nitrification efficiency higher than 98% at a HRT of 24 h. The PBBR showed satisfactory denitrification efficiency with very low effluent nitrite and nitrate concentration (both below 3 mg/L). By examining the nitrification activity of microorganism, it was found that the specific ammonium oxidization rate (SAOR) increased from 0.17 to 0.51 g N/(g VSS·d) and then decreased to 0.22 g N/(g VSS·d) at the last phase, which resulted from the accumulation of extracellular polymers substances (EPS) and inert matters enwrapped around the zoogloea. In contrast, the average specific nitrite oxidization rate (SNOR) is 0.002 g N/(g VSS·d), only 1% of SAOR. Because very little Nitrobactor has been detected by fluorescence in situ hybridization (FISH), it is confirmed that the stability of high nitrite accumulation in MBR is caused by a large amount of AOB.     

Nitrogen removal via nitrite from municipal landfill leachate

A system consisting of a two-stage up-flow anaerobic sludge blanket (UASB), an anoxic/aerobic (A/O) reactor and a sequencing batch reactor (SBR), was used to treat landfill leachate. During operation, denitrification and methanogenesis took place simultaneously in the first stage UASB, and the e uent chemical oxygen demand (COD) was further removed in the second stage UASB. Then the denitrification of nitrite and nitrate in the returned sludge by using the residual COD was accomplished in the A/O reactor, and ammonia was removed via nitrite in it. Last but not least, the residual ammonia was removed in SBR as well as nitrite and nitrate which were produced by nitrification. The results over 120 d (60 d for phase I and 60 d for phase II) were as follows: when the total nitrogen (TN) concentration of influent leachate was about 2500 mg/L and the ammonia nitrogen concentration was about 2000 mg/L, the shortcut nitrification with 85%–90% nitrite accumulation was achieved stably in the A/O reactor. The TN and ammonia nitrogen removal e ciencies of the system were 98% and 97%, respectively. The residual ammonia, nitrite and nitrate produced during nitrification in the A/O reactor could be washed out almost completely in SBR. The TN and ammonia nitrogen concentrations of final e uent were about 39 mg/L and 12 mg/L, respectively.     

纤维乙醇黑液处理

采用微电解＋厌氧折流板反应器（ABR）＋上流式厌氧污泥床（UASB）＋膜生物反应器（MBR）组合工艺对纤维乙醇黑液进行处理。结果表明：当黑液中COD质量浓度在12000mg／L左右,该组合工艺中厌氧停留时间（HRT）为48h时,厌氧COD去除率达到72％,MBR中的HRT为20h时,COD的去除率在80．8％～87．5％之间,出水COD质量浓度稳定在301～537mg／L．且MBR抗冲击负荷能力较强。