我国VOCs的排放特征及控制对策研究

挥发性有机物(volatile organic compounds,VOCs)是一类具有刺激性、致畸、致癌、致突变作用、易燃易爆的有机物,对人体和生态系统健康有很大危害.本文从工业固定源、机动车尾气排放源和日常生活源等角度分析不同排放源的VOCs排放特征,绘制并分析了我国重点区域重点行业VOCs排放的空间分布格局,甄别出东部沿海地区VOCs 2010年总量和单位面积均高于中西部地区,且工业产生源有明显差异.进一步归类分析了欧美等发达国家针对VOCs排放控制的政策法规,对比分析我国目前治理VOCs的有关法规和标准,提出了现阶段我国VOCs管理存在的问题,并提出了相应的控制对策建议.     

生物陶粒反应器的氢自养反硝化研究

利用氢自养反硝化生物陶粒反应器处理硝酸盐废水,探讨了生物陶粒反应器中氢自养反硝化生物脱氮的实现过程.考察了水力停留时间、进水硝氮负荷、进水pH值、温度、供氢量等因素对反应器脱氮效果的影响.结果表明,当水力停留时间为24 h和48 h时,反应器对硝酸氮的平均去除率分别达到94.54%和97.47%.在水力停留时间为5~16 h时,NO-3-N去除率随水力停留时间的缩短而降低;进水NO-3-N浓度较低时,NO-3-N的降解速率随其浓度的升高而增大,当NO-3-N浓度大于110mg·L-1时,氢自养反硝化反应受到抑制;中偏碱性环境较酸性或碱性环境更利于反应器对硝酸盐的去除;反应器有较宽的温度适应范围,最适温度为25~30℃;当反应器供氢不足时,脱氮效果明显降低,表明了氢自养反硝化菌对氢气利用的专一性.在整个运行阶段,出水中亚硝酸氮浓度一直保持在较低水平.     

活性污泥TB-EPS的絮凝特性研究:絮体的成长、破碎与再凝聚

为了解活性污泥中紧密结合胞外聚合物(tightly bound extracellular polymeric substances,TB-EPS)的絮凝特性,采用激光粒度仪在线监测技术考察了TB-EPS与高岭土生成絮体的过程以及絮体的破碎与再凝聚规律.结果表明,TB-EPS的主要组分为蛋白质和多糖聚合物,增加TB-EPS的投加量,絮体的粒径相应增大,悬浊液的剩余浊度降低.随着絮体破碎-再凝聚次数的增加,絮体的破碎因子升高而恢复因子降低,表明TB-EPS形成的絮体的强度逐渐降低,同时再凝聚的能力也逐渐降低.TB-EPS吸附高岭土的主要作用力为氢键作用,但在絮体形成过程中多糖聚合物之间的纠缠作用和蛋白质成分之间的疏水作用也可能发挥一定的作用.絮体的破碎是侵蚀和破裂同时作用的结果.     

温度对生物强化除磷工艺反硝化除磷效果的影响

以处理城市污水的中试规模生物强化除磷A2/O活性污泥工艺系统为研究对象,考察了温度对系统COD去除和脱氮除磷效果的影响,特别是温度对活性污泥反硝化除磷性能的影响.结果表明,当温度从(30.9±0.8)℃降低到(9.1±0.6)℃时,A2/O系统的脱氮除磷效果显著下降,系统对TN和TP的污泥去除负荷明显下降.通过污泥反硝化除磷活性实验发现,随着温度的降低,系统中活性污泥的最大厌氧释磷速率、最大好氧吸磷速率和最大缺氧吸磷速率都降低.活性污泥中反硝化除磷菌(DPB)占聚磷菌(PAOs)总量的比例随温度降低稍有下降,但平均值仍维持在47.5％左右.用阿伦尼乌斯公式对实验结果进行拟合,得到系统中活性污泥聚磷菌厌氧释磷反应活化能Ea1为148.0 kJ· mol-1,聚磷菌好氧吸磷反应活化能Ea2为228.8 kJ·mol-1,发生在缺氧条件下反硝化除磷菌的吸磷反应活化能Ea3为315.8 kJ·mol-1.对不同温度下污泥絮体粒径分析结果表明,随温度降低,粒径分布更加集中,系统中活性污泥絮体颗粒平均粒径减小,不利于污泥絮体内部反硝化除磷缺氧微环境的形成.     

高岭土负载纳米Fe/Ni同时去除水中Cu2+和NO3-

工业废水常含有不同污染物如重金属离子和无机阴离子,而如何有效去除复合污染物就成为环境科学前沿研究的挑战性课题.这些污染物因化学性质不同而导致去除机理和途径也不同.本文采用合成高岭土负载纳米双金属Fe/Ni(K-Fe/Ni)同步去除水中Cu2+和NO-3.结果表明K-Fe/Ni能有效去除水中Cu2+和NO-3,但它们的去除效果却会相互受到影响.在Cu2+浓度为200mg·L-1时,NO-3的去除率达到42.5%;而未加入Cu2+时,NO-3的去除率仅有26.9%,说明Cu2+的存在提高了NO-3降解效率.同样,水中NO-3的存在也影响Cu2+的去除(Cu2+去除率从99.7%降到96.5%).但NO-3浓度对去除Cu2+的影响小于Cu2+浓度对NO-3的影响.通过BET比表面积、X射线衍射(XRD)、扫描电镜(SEM)、X射线能量散射(EDS)和X射线光电分析(XPS)对K-Fe/Ni表征的结果显示,反应后K-Fe/Ni的表面存在铁的氧化物、Ni0和被还原的Cu0.基于以上结果,我们发现K-Fe/Ni同步去除水中Cu2+和NO-3的机理是:高岭土负载下的纳米Fe0作为还原剂,在Ni0的催化产氢作用下将Cu2+还原成Cu0并沉积在K-Fe/Ni上而形成纳米Fe/Ni/Cu三金属催化剂,从而加速催化水中NO-3降解.     

湿式静电除尘器IWS(R)技术及在工业废气治理中的运用

在湿式静电除尘器Ionizing wet scrubber(简称IWS(R))中,废气中的粉尘在-30 kV DC高压直流电场中充分荷电后,小部分粉尘吸附到电极上,为了达到较好的清灰效果,用循环水持续冲洗电极,随后大部分粉尘随气流进入填料Tellerette(R)塔中并吸附在填料表面;此时有毒、有腐蚀性和恶臭的气体也被吸收到填料塔中,然后也采用循环水流对填料进行连续冲洗,最终达到废气除尘的目的.     

短程硝化颗粒污泥的快速培养与硝化特性研究

以城市污水处理厂剩余污泥为种泥,以2 min沉淀时间为选择压,在序批式反应器(SBR)中快速培养出好氧颗粒污泥。经过60个周期(20 d),反应器内出现砂粒状颗粒,并持续稳定运行120 d。成熟的颗粒污泥平均粒径856.56μm,具有良好的硝化性能。SBR反应器以固定曝气时间方式运行,亚硝酸盐积累率达80%以上,实现了稳定短程硝化。试验结果表明:絮体污泥(即接种污泥)与颗粒污泥的硝化过程相似但略有差异。二者差别在于,氨氮氧化结束后,继续曝气120 min,絮体污泥将亚硝酸盐完全转化为硝酸盐,而颗粒污泥仅将部分亚硝酸盐转化且过程比较缓慢。     

活性炭吸附法处理冶金废水的工程设计模型

以博哈特(Bohart)和亚当斯(Adams)方程为推导依据,结合连续进水活性炭模型实验,证明了活性炭吸附法处理冶金废水的可行性,且得出了活性炭吸附高度、工作周期、污染物去除率等重要设计参数之间的关系,为活性炭的工程设计提出了一套有效的参考计算方法和设计程序。     

Biodegradation of 2-methylquinoline by Enterobacter aerogenes TJ-D isolated from activated sludge

Bacterial strain Enterobacter aerogenes TJ-D capable of utilizing 2-methylquinoline as the sole carbon and energy source was isolated from acclimated activated sludge under denitrifying conditions. The ability to degrade 2-methylquinoline by E. aerogenes TJ-D was investigated under denitrifying conditions. Under optimal conditions of temperature (35℃) and initial pH 7, 2-methylquinoline of 100 mg/L was degraded within 176 hr. The degradation of 2-methylquinoline by E. aerogenes TJ-D could be well described by the Haldane model (R² > 0.91). During the degradation period of 2-methylquinoline (initial concentration 100 mg/L), nitrate was almost completely consumed (the removal efficiency was 98.5%), while nitrite remained at low concentration (< 0.62 mg/L) during the whole denitrification period. 1,2,3,4-Tetrahydro-2-methylquinoline, 4-ethyl-benzenamine, N-butyl-benzenamine, N-ethyl-benzenamine and 2,6-diethyl-benzenamine were metabolites produced during the degradation. The degradation pathway of 2-methylquinoline by E. aerogenes TJ-D was proposed. 2-Methylquinoline is initially hydroxylated at C-4 to form 2-methyl-4-hydroxy-quinoline, and then forms 2-methyl-4-quinolinol as a result of tautomerism. Hydrogenation of the heterocyclic ring at positions 2 and 3 produces 2,3-dihydro-2-methyl-4-quinolinol. The carbon-carbon bond at position 2 and 3 in the heterocyclic ring may cleave and form 2-ethyl-N-ethyl-benzenamine. Tautomerism may result in the formation of 2,6-diethyl-benzenamine and N-butyl-benzenamine. 4-Ethyl-benzenamine and N-ethyl-benzenamine were produced as a result of losing one ethyl group from the above molecules.     

Ethyl thiosemicarbazide intercalated organophilic calcined hydrotalcite as a potential sorbent for the removal of uranium(VI) and thorium(IV) ions from aqueous solutions

This work was conducted to determine the practicability of using a new adsorbent 4-ethyl thiosemicarbazide intercalated,organophilic calcined hydrotalcite(ETSC-OHTC) for the removal of uranium(U(VI)),and thorium(Th(IV)) from water and wastewater.The FTIR analysis helped in realizing the involvement of nitrogen and sulphur atoms of ETSC in binding the metal ions through complex formation.Parameters like adsorbent dosage,solution pH,initial metal ions concentration,contact time and ionic strength,that influence adsorption phenomenon,were studied.The optimum pH for maximum adsorption of U(VI) and Th(IV) was found to be in the range 4.0-6.0.The contact time required for reaching equilibrium was 4 hr.The pseudo second-order kinetic model was the best fit to represent the kinetic data.Analysis of the equilibrium adsorption data using Langmuir,Freundlich and Sips models showed that the Freundlich model was well suited to describe the metal ions adsorption.The K F values were 25.43 and 29.11mg/g for U(VI) and Th(IV),respectively,at 30°C.The adsorbent can be regenerated effectively from U(VI) and Th(IV) loaded ones using 0.01mol/L HCl.The new adsorbent was quite stable for many cycles,without much reduction in its adsorption capacity towards the metals.