煤液化催化剂生产废水处理工艺设计和运行

采用斜板沉降-流砂过滤-蒸发器-结晶器工艺来处理煤液化催化剂生产废水。本文对该项目的催化剂生产废水处理工艺路线进行了详细介绍,并对实际生产期间的运行数据做了总结分析。通过运行数据表明:该工艺线路技术可靠,产品水的各项指标均能稳定达到再生水用作工业用水水源的水质标准,满足了生产回用的目的,且能够实现长期连续稳定运行。     

LNAPL在砂质含水层中动态迁移的电阻率法监测试验研究

在海滨潮间带采集细砂,通过室内柴油泄漏模拟试验,利用自制电阻率监测系统对轻非水相液体在砂土-地下水系统垂向渗透过程进行电阻率变化动态监测;通过配制不同含油率砂土测定其静态电阻率变化规律,探讨电阻率变化的影响因素;最后取样分析测定污染含水介质稳定后含水率及含油率,对监测结果有效性进行了验证;并利用显微成像法对污染砂土进行了微观形态分析.结果表明,柴油污染砂土微观形态上胶结现象明显;柴油渗透海滨砂土过程电阻率大小同含水饱和度,比电阻率和含油饱和度之间存在良好的相关性,均可用Archie公式拟合,n值分别为2.36和0.15;通过电阻率测定可以有效估算柴油透镜体厚度;电阻率随深度的变化可以反映含油率和含水率的垂向分布.本研究为轻质油品储罐或者海上油品输运过程泄露造成的海滨砂土地下污染扩散过程监测及机制研究提供了一种有效的方法,也可为其他典型石油泄漏污染场地的电阻率法探测或监测提供参考.     

Development of analytical methods for polycyclic aromatic hydrocarbons （PAHs） in airborne particulates： A review

In the present work, the different sample collection, pretreatment and analytical methods for polycyclic aromatic hydrocarbons （PAHs） in airborne particulates is systematacially reviewed, and the applications of these pretreatment and analytical methods for PAHs are compared in detail. Some comments on the future expectation are also presented.     

催化剂Ru/ZrO2-CeO2催化湿式氧化苯酚

催化剂Ru/ZrO₂-CeO₂催化湿式氧化苯酚的过程表明,Ru/ZrO₂-CeO₂可以显著提高COD和苯酚去除效果,当反应温度为170℃,压力为3 MPa,反应120 min后,COD和苯酚的去除率分别达到了99％和100％.试验还考察了不同反应条件对苯酚溶液COD去除的影响,并获得了最优的反应条件：温度为170℃,压力为3 MPa,催化剂的投加量为5　g/Ｌ,搅拌速度为500 r/min.通过对中间产物的分析,本研究提出了催化湿式氧化苯酚的简单路径图,认为苯酚首先被氧化成小分子有机酸,接着小分子有机酸被氧化成二氧化碳和水.前一个过程是快速反应,后一个过程中的乙酸氧化是慢速过程,需要在高温下才能完成.乙酸的氧化主要是自由基攻击α碳上的C—H键,先生成甲酸,并最终生成二氧化碳和水.     

Pd/C气体扩散电极用于电生成H2O2降解苯酚的研究

采用自制的Pd/C气体扩散阴极和Ti/IrO2/RuO2阳极,在无隔膜电解槽中对苯酚模拟废水降解效果及机制进行了研究,采用电子自旋共振法(ESR)对电解体系中产生的羟自由基(·OH)进行了检测.结果表明,在Pd/C气体扩散体系中掺杂Pd催化剂可以促进H2 O2的生成(H2 O2的稳定浓度是7.5 mg/L),有利于·OH的产生.经电化学氧化处理120 min后,苯酚和COD的去除率分别达到97.2%和50%,表明在电催化氧化过程中苯酚被氧化生成了大量低分子量中间产物.废水的BOD5/COD值达到0.73是处理前的9.1倍,苯酚废水的可生化降解性通过电化学氧化处理后显著提高.在该电化学体系中苯酚的降解是在阳极直接、间接氧化及阴极产生的H2 O2、·OH的氧化共同作用下完成的.通过对紫外扫描光谱图的分析推断出苯酚在电解过程中有醌类物质生成;由GC-MS检测到了邻苯二酚、对苯二酚、苯醌等芳香族化合物和己二酸、顺丁烯二酸、反丁烯二酸、丁二酸、丙二酸、乙二酸等短链羧酸,据此提出了苯酚降解的可能历程.     

实车三效催化剂表面成分分析

对主要在北京行驶的总里程在34×104～59×104km的6辆轻型出租车用三效催化剂,利用X射线荧光光谱仪(XRF)分析了其表面元素的种类、含量,以及污染物元素含量与行驶里程的关系.结果表明,在催化剂表面检测到的元素种类近30种,含量较高的元素种类基本相同.前后级催化剂上检测到的共同污染物元素有P、Ca、Zn和Mn等,主要来自于机油和汽油,34×104km行驶里程后,P在催化剂的累积速度已非常缓慢,Ca、Zn和Mn在催化剂表面的沉积经过56×104km后仍有增加的趋势.在后级催化剂上还检测到了明显的S含量,说明S更容易在后级催化剂上沉积.经过40×104km行驶里程后,S在催化剂表面的沉积量基本达到平衡状态.累积规律说明经过40×104km行驶里程后,容易使催化剂中毒的P和S对催化剂活性影响已较小,而Ca、Zn和Mn的持续累积,将会继续降低催化剂的活性.     

Effect of platinum on the photocatalytic degradation of chlorinated organic compound

TiO2 nanoparticles, doped with di erent Pt contents, were prepared by a modified photodeposition method using Degussa P-25 TiO2, H2PtCl6 6H2O and methanol as the solvents. The physicochemical properties of Pt/TiO2 were investigated by the nitrogen adsorption and desorption isotherm measurement technique, X-ray di raction analysis and photoluminescence spectra, respectively. Reaction rates from photocatalytic removal of dichloromethane over Degussa P-25 TiO2 and Pt/TiO2 were evaluated. The average diameter and BET surface area of the TiO2 catalyst particles were 300 nm and 50 m2/g, respectively. The degradation e ciency was 99.0%, 82.7%, 55.2%, and 57.9% with TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. And the degradation e ciency was 99.3%, 79.7%, 76.5%, and 73.4% with a 0.005 wt.% Pt/TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. In addition, we found that the photoluminescence emission peak intensities decreased with increases in the doping amount of Pt, which indicates that the irradiative recombination was weakened. Furthermore, the results showed that the UV/0.005 wt.% Pt/TiO2 process was capable of e ciently decomposing gaseous DCM in air.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

陕西县域经济发展与SO2排放及环境容量测评

本文依据2008年的有关统计资料,对陕西省97个县市地均GDP及地均SO2排放量进行了存量核算,借用二维组合矩阵方法分析了二者之间的相关关系,并计算陕西省各县域的环境容量及环境承载能力。本研究对认识陕西省的地均SO2排放量的地域分布格局,并从宏观上指导生产的合理布局具有一定的参考意义。