Methanotrophic community structure of aged refuse and its capability for methane bio-oxidation

Aged refuse from waste landfills closed for eight years was examined and found to contain rich methanotrophs capable of biooxidation for methane. Specially, community structure and methane oxidation capability of methanotrophs in the aged refuse were studied. The amount of methanotrophs ranged 61.97 103–632.91 103 cells/g (in dry basis) in aged refuse from Shanghai Laogang Landfill. Type I and II methanotrophs were found in the aged refuse in the presence of sterilized sewage sludge and only Type I methanotrophs were detected in the presence of nitrate minimal salt medium (NMS). The clone sequences of the pmoA gene obtained from the aged refuse were similar to the pmoA gene of Methylobacter, Methylocaldum, and Methylocystis, and two clones were distinct with known genera of Type I methanotrophs according to phylogenetic analysis. Aged refuse enriched with NMS was used for methane biological oxidation and over 93% conversions were obtained.     

Reversibly enhanced aqueous solubilization of volatile organic compounds using a redox-reversible surfactant

Surfactant-enhanced remediation (SER) is an effective method for the removal of volatile organic compounds (VOCs) from contaminated soils and groundwater. To reuse the surfactant the VOCs must be separated from the surfactant solutions. The water solubility of VOCs can be enhanced using reversible surfactants with a redox-acive group, (ferrocenylmethyl)dodecyldimethylammonium bromide (Fcl2) and (ferrocenylmethyl)tetradecanedimethylammonium bromide (Fcl4), above and below their critical micelle concentrations (CMC) under reducing (I⁺) and oxidative (I²⁺) conditions. The CMC values of Fcl2 and Fcl4 in I⁺ are 0.94 and 0.56 mmol/L and the solubilization of toluene by Fcl2 and Fcl4 in I⁺ for toluene is higher than the solubilization achieved with sodium dodecyl sulfate, cetyltrimethylammonium bromide and Trition X-114. The solubilization capacity of the ferrocenyl surfactants for each tested VOCs ranked as follows: ethylbenzene > toluene > benzene. The solubilities of VOCs by reversible surfactant in I⁺ were 30% higher than those in I²⁺ at comparable surfactant concentrations. The effects of Fcl4 concentrations on VOCs removal efficiency were as follows: benzene > toluene > ethylbenzene. However, an improved removal efficiency was achieved at low ferrocenyl surfactant concentrations. Furthermore, the reversible surfactant could be recycled through chemical approaches to remove organic pollutants, which could significantly reduce the operating costs of SER technology.     

无砾石微孔管地下渗滤系统试验研究

针对传统无砾石管式地下渗滤系统存在的处理性能差,渗滤通量低两个问题,通过去掉包裹织物,提高渗滤管开孔率、改变开孔方式,设计了无砾石微孔管地下渗滤系统。通过实验研究表明,无砾石微孔管地下渗滤系统对COD、氨氮的去除率比传统管式系统分别提高了10.8%、12.7%,总磷去除率并无显著差异,ORP值提高约85 mV,渗滤通量提高26.8%。在3.3 cm/d的水力负荷下,无砾石微孔管地下渗滤系统出水COD、氨氮、总磷平均浓度分别为19 mg/L,0.62 mg/L,0.048 mg/L。渗滤管下10 cm的土壤层去除了约70%的COD,80%的氨氮和91%的总磷,向下随着土壤深度的增加,单位厚度的土壤层去除的污染物量呈显著下降趋势。     

Ti/SnO2-Sb2O5/PbO2阳极电化学氧化降解苯甲酸研究

文章研究了TI/SnO2-Sb2O5/Pbo2在两室电解池中氧化降解苯甲酸的性能,主要考察了电流密度、初始pH值、初始苯甲酸浓度和支持电解质这四个参数对TOC去除效率的影响。实验表明在电流密度为30 mA/cm2,初始苯甲酸浓度为0.5 mmol/L,支持电解质(Na2SO4)为0.1mol/L的条件下,经过6 h反应...     

Fenton氧化在废水处理中的应用

综述了近年来Fenton氧化在废水处理领域的应用状况,对Fenton试剂氧化的机理和主要影响因素:温度、pH、反应时间、H2O2和Fe2+的投加量、H2O2/Fe2+量比以及反应动力学模型进行了简要介绍.最后探讨了Fenton氧化技术在废水处理领域现存不足之处及今后的发展趋势.     

Cu-K型低温碳烟氧化催化剂的合成及表征

柴油机排放中碳烟的低温氧化是近年来研究的热点.通过原位合成法制备Cu2K/Al2O3和CuK／Al2O3两种碳烟氧化催化剂,并采用低温氮吸附/脱附实验、X射线衍射、X射线光电子能谱、程序升温氧化对其结构进行系统表征,并用U碳模拟柴油机碳烟,研究其催化活性,评测其对柴油机排气中碳烟颗粒的净化效果.研究表明,Cu2K/Al...     

控制游离氨实现单级自养生物脱氮的研究

通过实时调控SBR反应器内的游离氮浓度的控制策略,实现以亚硝化作用和厌氧氨氧化作用协同的单级自养生物脱氮工艺.实验分成亚硝酸菌富集和厌氧氨氧化菌混合接种2个阶段,SBR内的温度始终保持在(31±2)℃.亚硝酸菌富集阶段,pH值稳定在7.8左右,通过调节进水氩氮浓度(56～446 mg·L-1)实现FA浓度的变化,从而实...     

高压脉冲电凝-Fenton-生化法处理制药废水

通过高压脉冲电凝-Fenton对制药废水进行预处理,出水进入UASB-AO生化处理系统.研究表明:高压脉冲电凝-Fenton氧化法的最佳工况条件为进水pH值为4.0左右,高压脉冲电凝反应时间为45 min,H2O2投加量为4mL/L,Fenton氧化时间为60min.高压脉冲电凝-Fenton对CODCr去除率为36.5%～39.2%,ρ(BOD5)/ρ(CODCr)从0.13提高到0.32-0.34,废水的可生化性大大提高,UASB厌氧反应器去除率为81.4%～82.1%,AO系统去除率为88.0%～88.5%,而整个生化处理系统对CODCr去除率为95.4%～97.9%,最终出水各项指标可达到GB 8978-1996<污水综合排放标准>中一级标准.     

絮凝-SBR-Fenton氧化处理酶制剂废水的研究

以某酶制品厂的废水为研究对象,确定了絮凝-SBR-Fenton高级氧化的试验方法.结果表明,在絮凝阶段,当聚合氯化铝(PAC)投加量为0.6g/L,搅拌6 min,絮凝70min的条件下,预处理的出水CODCr效果最好,去除率为44.6%;再经过SBR工艺处理,停留时间为14 h时,CODCr去除率达到了89.2%;之后再进行Fenton高级氧化,氧化的最佳条件是:ρ(FeSO4·7H2O)为3 g/L,ρ(H2O2)为0.8g/L,反应时间2 h.最终出水达到了GB 8978-1996<污水综合排放标准>中二级排放标准.     

协同氧化工艺处理焦化废水的试验研究

采用微电解-芬顿氧化的组合工艺处理末端焦化废水,考察静态实验中微电解填料的铁碳比、过氧化氢添加方式及加入量、曝气量、反应时间、pH值等不同条件因素对COD去除率的影响情况,确定最佳条件是铁碳质量比是2.5∶1,分批加入过氧化氢,且加入量为0.25 mL/L,曝气量为1.25 L/min,pH值为3,反应时间140 min.最终实现将焦化废水COD的去除率达88％以上的目的.按静态实验的各因素条件进行动态实验,试验结果COD去除率可达87％以上,处理后℃OD质量浓度为为91 mg/L,达到排放标准.同时处理后焦化废水的颜色变淡.