Chemical cleaning of fouled PVC membrane during ultrafiltration of algal-rich water

Cleaning of hollow-fibre polyvinyl chloride (PVC) membrane with di erent chemical reagents after ultrafiltration of algal-rich water was investigated. Among the tested cleaning reagents (NaOH, HCl, EDTA, and NaClO), 100 mg/L NaClO exhibited the best performance (88.4% 1.1%) in removing the irreversible fouling resistance. This might be attributed to the fact that NaClO could eliminate almost all the major foulants such as carbohydrate-like and protein-like materials on the membrane surface, as confirmed by Fourier transform infrared spectroscopy analysis. However, negligible irreversible resistance (1.5% 1.0%) was obtained when the membrane was cleaning by 500 mg/L NaOH for 1.0 hr, although the NaOH solution could also desorb a portion of the major foulants from the fouled PVC membrane. Scanning electronic microscopy and atomic force microscopy analyses demonstrated that 500 mg/L NaOH could change the structure of the residual foulants on the membrane, making them more tightly attached to the membrane surface. This phenomenon might be responsible for the negligible membrane permeability restoration after NaOH cleaning. On the other hand, the microscopic analyses reflected that NaClO could e ectively remove the foulants accumulated on the membrane surface.     

2-丁烯醛生产废水中溶解性有机物的分级解析

采用超滤膜法将2-丁烯醛生产废水中的有机物分为相对分子质量不同的7个级分,并应用溶解性有机碳(dissolved organic carbon,DOC)、紫外吸收光谱(ultraviolet spectrum,UV)、傅里叶变换红外光谱(fourier transform infrared spectrometer,FT-IR)和气相色谱/质谱联用仪(gas chromatography with mass spectrometry,GC-MS)技术对不同相对分子质量区间的有机物所占比例及物质结构进行了研究.结果表明,废水中相对分子质量1×103的有机物所占比例最高,达到88.57%;采用GCMS对废水中相对分子质量1×103的级分进行分析,定性出27种化合物,包含醛、酮、酯、醇、酚、酸、烷烃类及其他苯系物等,其峰面积占有机物峰面积总和的比例分别为6.9%、5.3%、35.4%、13.2%、4.6%、0.4%、1.7%、16.8%,总和为84%.UV和FT-IR分析结果均显示不同相对分子质量区间的光谱吸收特征没有明显差别,级分中存在含有不饱和双键、羟基、羰基化合物及芳香族化合物,与GC-MS检测结果相吻合.研究结果为废水处理工艺的开发与优化提供了重要的指导作用.     

Removal of polycyclic aromatic hydrocarbons from aqueous solution by raw and modified plant residue materials as biosorbents

Removal of polycyclic aromatic hydrocarbons （PAHs）, e.g., naphthalene, acenaphthene, phenanthrene and pyrene, from aqueous solution by raw and modified plant residues was investigated to develop low cost biosorbents for organic pollutant abatement. Bamboo wood, pine wood, pine needles and pine bark were selected as plant residues, and acid hydrolysis was used as an easily modification method. The raw and modified biosorbents were characterized by elemental analysis, Fourier transform infrared spectroscopy and scanning electron microscopy. The sorption isotherms of PAHs to raw biosorbents were apparently linear, and were dominated by a partitioning process. In comparison, the isotherms of the hydrolyzed biosorbents displayed nonlinearity, which was controlled by partitioning and the specific interaction mechanism. The sorpfion kinetic curves of PAHs to the raw and modified plant residues fit well with the pseudo second-order kinetics model. The sorption rates were faster for the raw biosorbents than the corresponding hydrolyzed biosorbents, which was attributed to the latter having more condensed domains （i.e., exposed aromatic core）. By the consumption of the amorphous cellulose component under acid hydrolysis, the sorption capability of the hydrolyzed biosorbents was notably enhanced, i.e., 6-18 fold for phenanthrene, 6-8 fold for naphthalene and pyrene and 5-8 fold for acenaphthene. The sorpfion coefficients （Kd） were negatively correlated with the polarity index [（O＋N）/C], and positively correlated with the aromaticity of the biosorbents. For a given biosorbent, a positive linear correlation between logKoc and logKow for different PAHs was observed. Interestingly, the linear plots of logKoc-logKow were parallel for different biosorbents. These observations suggest that the raw and modified plant residues have great potential as biosorbents to remove PAHs from wastewater.     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.     

Characterization of extracellular polymeric substances in the biofilms of typical bacteria by the sulfur K-edge XANES spectroscopy

A combined approach of physicochemical extraction and sulfur K-edge X-ray absorption near-edge structure（XANES） spectroscopy was applied to characterize the extracellular polymeric substances（EPS） of typical bacterial biofilms in this study. Physicochemical analysis showed variation of the contents of DNA,polysaccharide and protein in different fractions of EPS in different mediums. The sulfur K-edge XANES analysis yielded a variety of spectra.Spectral fitting of the XANES spectra utilizing a large set of model compounds showed that there was more reduced sulfur in both LB-EPS（loosely bound EPS） and TB-EPS（tightly bound EPS） of all the biofilms in LB medium than in R2 A medium. More oxidized sulfur was identified in LB-EPS than that in TB-EPS,suggesting different niches and physiological heterogeneity in the biofilms. Our results suggested that the sulfur K-edge XANES can be a useful tool to analyze the sulfur speciation in EPS of biofilms.     

电力行业碳捕集现状和发展趋势

全面介绍了燃煤电厂3种CO2捕集技术,包括燃烧前捕集,燃烧后捕集以及富氧燃烧捕集技术。通过对各种CO2捕集技术的对比,提出各种捕集方法的适用范围和优、缺点。在此基础上调查了我国碳捕集技术的研究以及碳捕集示范工程项目的进展,分析了我国电力行业碳捕集技术现状和面临的问题并对电力行业碳捕集发展趋势进行了探讨。     

光学气体成像技术在泄漏检测与维修中的应用研究

通过介绍光学气体成像技术的原理、泄漏检测与维修关键技术、甲烷气体泄漏检测与识别实验情况,讨论了该技术在石化生产过程中的应用发展趋势。     

HPLC-ICP-MS在植物有机硒形态分析中的应用现状

植物是人们摄取硒的主要来源,富硒植物中富含可开发利用的有机硒,我国湖北恩施高硒地区富硒植物资源丰富亟待开发利用。植物中硒的形态分析是研究开发富硒植物资源的基础,而高效液相色谱与电感耦合等离子体质谱联用技术(HPLC-ICP-MS)是目前硒形态分析使用最为广泛的技术,它在样品的前处理、分析灵敏度、准确性等方面均具有优势,可以实现富硒植物中含硒生物大分子、硒形态以及与氨基酸结合位点及机理的分析。因此作者综述了植物样品的预处理过程,介绍了HPLC-ICP-MS联用技术在测定植物硒形态及其应用方面的研究成果,为我国富硒植物、富硒产品中硒形态的分析测定、开发富硒植物资源提供指导。     

水中氨氮测定用纳氏试剂配制的研究简

纳氏试剂分光光度法是测定水中氨氮含量的一种常用方法,操作步骤简单和灵敏度高.但是,纳氏试剂的配制却非常复杂,而试剂配制的好坏又直接关系到水中氨氮测定结果的准确性.笔者从纳氏试剂配制的原理出发,分析影响试剂配制的因素,并在此基础上提出解决方法,最后总结了纳氏试剂配制中应注意的细节问题.