Mobilities and leachabilities of heavy metals in sludge with humus soil

Chemical forms of Zn, Ni, Cu, and Pb in municipal sewage sludge were investigated by adding humus soil to sludge and by performing sequential extraction procedures. In the final sludge mixtures, Zn and Ni were mainly found in Fe/Mn oxide-bound (F3) and organic matter/sulfide-bound (F4) forms. For Zn, exchangeable (F1), carbonate-bound (F2), and F3 forms were transformed to F4 and residual forms (F5). For Ni, F1 and F2 forms were transformed to F1, F2, and F3 forms. Both Cu and Pb were strongly associated with the stable forms F4 and F5. For Cu, F2 and F3 forms were major contributors, while for Pb, F3 and F4 forms were major contributors to F5. Humus soil dosage and pH conditions in the sludge were strongly correlated with the forms of heavy metals. Five forms were used to evaluate metal mobilities in the initial and final sludge mixtures. The mobilities of the four heavy metals studied decreased after 28 days. The metal mobilities in the final sludge mixtures were ranked in the following order: Ni > Zn > Cu = Pb. Leaching tests showed that the mobilities of Zn and Ni in lower pH conditions (pH 4) were higher than those in higher pH conditions (pH 8).     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

湘中锑矿区土壤重金属锑的污染特征

文章研究调查了冷水江锡矿山锑矿区、桃江板溪锑矿区、桃江马迹塘锑矿区、桃江武潭锑矿区、安化符竹溪金锑矿区及安化渣滓溪锑矿区及周围土壤中锑的含量及形态分布.结果表明:各矿区土壤中总锑含量范嗣为185.6-2 081.3 mg/kg,大大超过了土壤中锑的背景值,表明各矿区土壤已被严重污染.采用Tessier逐级提取法对土壤中...     

微波酸活化粉煤灰吸附酸性大红染料废水实验研究

以微波酸活化改性后的粉煤灰为吸附剂,对酸性大红染料废水进行吸附脱色处理,考察了吸附时间、pH值、吸附剂投加量等对吸附脱色效果的影响。在酸性大红染料溶液初始浓度为100 mg/L、pH=5、活化粉煤灰投加量为10 g/L吸附1 h时,活化粉煤灰对酸性大红的脱色效果较好,去除率可达96%。对实验数据进行相关数学模型拟合,结果表明微波酸活化改性后的粉煤灰吸附去除酸性大红的等温吸附平衡符合Langmuir吸附等温式,改性前后的吸附过程动力学符合准二级吸附动力学模型,线性相关系数良好。     

废弃线路板热解油中酚类物质的提取与分离

将FR-4型废弃线路板热解,并对热解油中含量最多的组分-酚类物质进行分离提取.比较研究线路板热解油的分离提取方法,探索出"碱液处理-酸化-萃取-减压蒸馏"的新方法,对分离出的组分进行GCMS(气质联用)测试.结果显示运用该方法对FR-4型线路板的热解油进行提取分离,得到的总酚占热解油的62.0%,其中苯酚的最高纯度可达...     

ICP-AES法测定农田土壤中重金属含量

土壤样品经预处理后,采用微波溶样消解法提取农田土壤中的有效态铜、锌元素,通电感耦合等离子体原子发射光谱法(ICP-AES),在最佳测定条件下利用标准曲线法,完成对土壤中有效态铜、锌元素的测定.测定方法操作简便、线性范围大,结果精密度高、准确度好,可以满足农田土壤样品中有效铜、锌元素的测定需要.     

海岸带表层沉积物中磷的地球化学特征

通过连续提取法对莱州湾主要入海河流及近岸海域表层沉积物中5种形态磷进行了定量分析.结果表明,近海沉积物自生钙结合磷含量(45.6%)高于河流(37.3%),而铁结合磷(Fe-P)含量(18.2%)却低于河流(31.3%).在近海,可交换或弱结合磷含量和粉砂比例呈正相关,表明该形态磷主要吸附于细粒粉砂.河流沉积物Fe-P与Fe浓度呈显著正相关(P0.01),表明河流沉积物Fe-P分布受沉积物活性铁含量的控制.河口处Fe-P普遍低于相应河流,这可能与海相泥沙输入及河口厌氧区硫酸盐还原或硫化物累积有关.近海沉积物总可提取态磷平均浓度总体呈现出由海洋向河口方向递减的趋势.     

脱水污泥中聚合物的碱提取及其镉吸附效能研究

市政污水处理厂产生的脱水剩余污泥中含有大量的细菌胞外聚合物、胞内聚合物等大分子有机物,是一种良好的生物吸附剂制备原料。以脱水污泥为原料,采用碱提取的方法,对污泥中胞外聚合物与胞内聚合物进行提取,提取得到聚合物吸附剂,分析了聚合物吸附剂中聚合物浓度、核酸浓度随提取剂中NaOH浓度的变化,考察了聚合物吸附剂对水中镉的等温吸附性能。研究结果表明,当NaOH浓度小于0.5 mol/L时,随着提取剂NaOH浓度的升高,得到的提取液中聚合物浓度、核酸浓度逐渐升高。最佳的提取剂中NaOH浓度为0.3 mol/L,该条件下能够充分实现污泥中聚合物的提取。当NaOH浓度高于0.5 mol/L,聚合物中核酸存在一定程度的分解。聚合物吸附剂对水中Cd2+的吸附符合Langmuir模型,NaOH浓度为0.3 mol/L条件下提取得到的聚合物吸附剂的镉饱和吸附容量最大,达1.022 mmol/g。     

黄石市典型农业土壤中重金属污染水平及评价

以黄石市阳新县某大型农场作为研究区,于2012年2月采集8个代表性表层(0~20 cm)土壤样品,采用火焰-原子吸收分光光度法分析了各重金属元素(Cu、Pb、Zn、Cd、Mn、Co)的总量及BCR连续提取法提取土壤中重金属的弱酸态、可还原态、可氧化态和残渣态含量。结果显示,Cu、Pb、Zn、Cd、Mn和Co总量的平均值分别为122.10、141.29、335.53、2.18、2 606.58和128.27 mg/kg,其中Cd超过了土壤环境三级标准限值,Mn具有最强的变异系数,受到外来污染因素的影响最大。通过地积累指数法和潜在生态危害法表明,6种重金属累积程度由高到低依次为CdCoCuPbZnMn,且Cd、Mn为主要生态风险因子。同时由形态分析可知,Cu、Pb、Cd、Zn、Mn和Co的化学形态分布均以残渣态为主,说明该农场土壤中重金属元素比较稳定,不易迁移转化,对生物的毒性较小。