Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.     

3-甲基吡啶-N-氧化物热稳定性分析

为了评估反应体系发生热失控时引发3-甲基吡啶-N-氧化物分解的可能性,采用差示扫描量热仪(DSC Q20)对3-甲基吡啶-N-氧化物在不同升温速率下的催化分解过程进行了试验研究。采用Kissinger法和Starink法计算热分解反应的活化能和指前因子。根据得到的活化能,计算3-甲基吡啶-N-氧化物在不同温度下到达最大反应速率所需要的时间(TMRad),结合可能性评估判据进行评估。结果表明:3-甲基吡啶-N-氧化物的分解由两部分组成;两种方法计算得到的活化能较为接近;当冷却失效,反应体系热失控温度达到448 K时,3-甲基吡啶-N-氧化物发生分解的可能性为高级,当温度为433~443 K时,可能性为中级,而当温度低于428 K时,可能性为低级。     

Comparison of quartz sand, anthracite, shale and biological ceramsite for adsorptive removal of phosphorus from aqueous solution

The choice of substrates with high phosphorus adsorption capacity is vital for sustainable phosphorus removal from waste water in constructed wetlands. In this study, four substrates were used： quartz sand, anthracite, shale and biological ceramsite. These substrate samples were characterized by X- ray diffractometry and scanning electron microscopy studies for their mineral components （chemical components） and surface characteristics. The dynamic experimental results revealed the following ranking order for total phosphorus （TP） removal efficiency： anthracite 〉 biological ceramsite 〉 shale 〉 quartz sand. The adsorptive removal capacities for TP using anthracite, biological ceramsite, shale and quartz sand were 85.87, 81.44, 59.65, and 55.98 mg/kg, respectively. Phosphorus desorption was also studied to analyze the substrates＇ adsorption efficiency in wastewater treatment as well as the substrates＇ ability to be reused for treatment. It was noted that the removal performance for the different forms of phosphorus was dependent on the nature of the substrate and the adsorption mechanism. A comparative analysis showed that the removal of particulate phosphorus was much easier using shale. Whereas anthracite had the highest soluble reactive phosphorus （SRP） adsorptive capacity, biological ceramsite had the highest dissolved organic phosphorus （DOP） removal capacity. Phosphorus removal by shale and biological ceramsite was mainly through chemical adsorption, precipitation or biological adsorption. On the other hand, phosphorus removal through physical adsorption （electrostatic attraction or ion exchange） was dominant in anthracite and quartz sand.     

Fabrication and photoelectrocatalytic properties of nanocrystalline monoclinic BiVO4 thin-film electrode

Monoclinic bismuth vanadate(BiVO4) thin film was fabricated on indium-tin oxide glass from an amorphous heteronuclear complex via dip-coating.After annealation at 400,500,and 600°C,the thin films were characterized by X-ray diffraction,field emission scanning electron microscopy,X-ray photoelectron spectroscopy,and UV-Vis spectrophotometry.The BiVO4 particles on the ITO glass surface had a monoclinic structure.The UV-Visible diffuse reflection spectra showed the BiVO4 thin film had photoabsorption propertie...     

土壤胡敏素对铜离子的吸附作用及其机理研究

以暗棕壤为供试土壤,研究了不同溶液pH值、离子强度、接触时间、反应温度和初始铜离子(Cu~(2+))浓度条件下,胡敏素对Cu~(2+)的吸附作用;利用扫描电子显微镜(SEM)、X-射线能量色散谱(EDS)、傅立叶变换红外光谱(FTIR)和X-射线光电子能谱(XPS),对胡敏素/胡敏素-Cu~(2+)复合物的表面形貌、元素分布和官能团组成进行了分析;应用延展X-射线吸收精细结构谱(EXAFS),对吸附态Cu~(2+)的局域配位结构进行了表征.结果表明:胡敏素对Cu~(2+)的吸附量随pH值、接触时间、反应温度和Cu~(2+)浓度的增加而增加,但随离子强度的增加而下降;吸附动力学符合准二级动力学方程,而吸附等温线用Langmuir方程的拟合效果较好;吸附过程需要能量,是自发、吸热和自由度增加的缔合反应;吸附Cu~(2+)之后,胡敏素表面产生了团聚现象,表面羧基、羟基、吡啶氮和N—O基团参与了Cu~(2+)的吸附作用,同时吸附态Cu~(2+)是以内层配位形式与胡敏素表面的O/N和C原子结合.     

环球扫描

壳牌计划每年投资10亿美元开发中国页岩气资源 中国被认为是世界上拥有最多非常规天然气的国家,贮藏在古代页岩中的天然气可用水力压裂法进行开采,这一技术近年在北美已发展得相当成熟。     

Effect of manufacturing methods of AgCl/Al2O3 catalyst on selective catalytic reduction of NOx

The AgCl/Al2O3 catalyst has potential for use in the selective catalytic reduction (SCR) of NOx. A compound hydrocarbon, following oxygenation is used as a type of reducing agent. In this experiment, the AgCl/Al2O3 catalyst was produced by four different methods, and the differences among their reduction catalysis of NOx were compared. Ethanol was used as a type of reducing agent. X-ray diffraction analysis was performed to study the crystalline structure and scanning electron microscope and transmission electron microscope (TEM) were applied to determine the microindentation. The results indicated that, in the range of 350–400°C, there was no significant difference on the NOx reduction rate; however, there was dispersion at high and low temperature ranges. The size of the AgCl particles was about 20–100 nm.     

药物混粉爆炸事故及防范对策的研究

从近几年制药行业频繁爆炸事故出发,分析制药行业爆炸事故的种类,从粉尘爆炸入手,以某制药企业为研究对象,对其爆炸粉体克拉维酸钾进行了爆炸参数测试,运用20L球形粉尘爆炸测试装置测定其爆炸下限为40g/m3。同时运用差热扫描热分析法对其进行放热反应进行研究,再利用毛细管气相色谱法对该混合物中是否存在可燃气体进行了评定,发现其存在丙酮可燃气体,但含量较低为9.3×10-5。针对上述特点,从技术和管理角度出发,分析应对措施以及常见的问题,设计了混粉机械人机界面,编制了安全检查表,对该类共性问题进行了归纳,以供防范药物混粉事故发生参考。     

Ultrasonic preparation of nano-nickel/activated carbon composite using spent electroless nickel plating bath and application in degradation of 2,6-dichlorophenol

Ni was effectively recovered from spent electroless nickel （EN） plating baths by forming a nano-nickel coated activated carbon composite. With the aid of ultrasonication, melamine- formaldehyde-tetraoxalyl-ethylenediamine chelating resins were grafted on activated carbon （MFT/AG）. PdC12 sol was adsorbed on MFT/AC, which was then immersed in spent electroless nickel plating bath; then nano-nickel could be reduced by ascorbic acid to form a nano-nickel coating on the activated carbon composite （Ni/AC） in situ. The materials present were carefully examined by Fourier transform infrared spectroscopy, X-ray diffraction, field emission scanning electron microscopy, X-ray photoelectron spectroscopy and electro- chemistry techniques. The resins were well distributed on the inside and outside surfaces of activated carbon with a size of 120 ± 30 nm in MFT/AC, and a great deal of nano-nickel particles were evenly deposited with a size of 3.8 ± 1.1 nm in Ni/MFT. Moreover, Ni/AC was successfully used as a catalyst for ultrasonic degradation of 2.6-dichloronhenol.     

Biofilm structure and its influence on clogging in drip irrigation emitters distributing reclaimed wastewater

Using reclaimed wastewater for crop irrigation is a practical alternative to discharge wastewater treatment plant effluents into surface waters.However,biofouling has been identified as a major contributor to emitter clogging in drip irrigation systems distributing reclaimed wastewater.Little is known about the biofilm structure and its influence on clogging in the drip emitter flow path.This study was first to investigate the microbial characteristics of mature biofilms present in the emitters and the effect of flow path structures on the biofilm microbial communities.The analysis of biofilm matrix structure using a scanning electron microscopy (SEM) revealed that particles in the matrix of the biofilm coupled extracellular polysaccharides (EPS) and formed sediment in the emitter flow path.Analysis of biofilm mass including protein,polysaccharide and phospholipid fatty acids (PLFAs) showed that emitter flow path style influenced biofilm community structure and diversity.The correlations of biofilm biomass and discharge reduction after 360 h irrigation were computed and suggest that PFLAs provide the best correlation coefficient.Comparatively,the emitter with the unsymmetrical dentate structure and shorter flow path (Emitter C) had the best anti-clogging capability.By optimizing the dentate structure,the internal flow pattern within the flow path could be enhanced as an important method to control the biofilm within emitter flow path.This study established electron microscope techniques and biochemical microbial analysis methods that may provide a framework for future emitter biofilm studies.