重型货运车辆碳排放特性研究

以重型货运车辆为研究对象,研究车辆碳排放与车速、装载率、货运周转量等的关系。选取20辆重型货运车,通过油耗测试装置与GPS装置等采集了货运车辆连续6个月的油耗、行驶里程、平均速度、货运周转量等数据,根据碳平衡原理计算出车辆的CO2e排放因子,得出了车速与装载率分布规律。结果表明,重型货运车辆行驶速度主要分布在50~70 km/h范围内,其行驶时间占比达67.2%;0.4~0.8之间的装载率占比达到75.25%;单车月度货运周转量主要分布范围在10×104~40×104t·km;CO2e排放因子主要分布在1 000~1200 g/km,其平均值为1 120 g/km,而平均吨千米CO2e排放因子为52g/(t·km)。本研究得出了装载率与吨千米CO2e排放因子的拟合关系式,发现车速提高时CO2e排放因子降低,装载率自0.2提高到1.0时吨千米CO2e排放因子降低70%以上,货运周转量提高时吨千米CO2e排放减少。     

3-甲基吡啶-N-氧化物热稳定性分析

为了评估反应体系发生热失控时引发3-甲基吡啶-N-氧化物分解的可能性,采用差示扫描量热仪(DSC Q20)对3-甲基吡啶-N-氧化物在不同升温速率下的催化分解过程进行了试验研究。采用Kissinger法和Starink法计算热分解反应的活化能和指前因子。根据得到的活化能,计算3-甲基吡啶-N-氧化物在不同温度下到达最大反应速率所需要的时间(TMRad),结合可能性评估判据进行评估。结果表明:3-甲基吡啶-N-氧化物的分解由两部分组成;两种方法计算得到的活化能较为接近;当冷却失效,反应体系热失控温度达到448 K时,3-甲基吡啶-N-氧化物发生分解的可能性为高级,当温度为433~443 K时,可能性为中级,而当温度低于428 K时,可能性为低级。     

垃圾填埋场有机污染物的生物降解机理

概述了垃圾填埋场中微生物的作用特性，微生物对有机污染物的降解及其影响因素，介绍了有机污染物降解的两种生化动力学模型：“速度指数模型”和“双曲线速度模型”，以及垃圾降解的动力学方程。     

Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.     

Critical velocity in phosphorus exchange processes across the sediment-water interface

Sediments are ultimate sinks of nutrients in lakes that record the pollution history evolutionary processes, and anthropogenic activities of a lake. However, sediments are considered as inner sources of environmental factor changes such as the variation in hydrodynamic conditions because of the nutrients they release. How does this process happen？ This study investigates a typical nutrient phosphorus （P） exchange among sediment, suspended particle matter （SPM）, and water. Compared with numerical and experimental studies, this study confirms that the critical velocity that occurs at a lower flow rate state exists in the range of 7 to 15 crn/sec. Critical velocity below the critical flow rate promotes the migration of particulate phosphorus （PP） to the SPM. On the other hand, critical velocity above the critical flow rate promotes the release of PP in water.     

不同出口结构旋流板分离器内流场的数值模拟

基于Fluent软件,采用雷诺应力（RSM）湍流模型对不同出口结构分离器内气相旋流流场进行了数值模拟。模拟结果表明：分离器出口角度Ф变化对流场的影响显著,出口直径H变化对流场的影响甚微;有出口装置分离器内的切向速度均有所增加,最大切向速度向轴心方向移动。     

滤料粒径对BAF小尺度下流场形态及挂膜速度的影响

为探讨颗粒粒径对曝气生物滤池(BAF)运行效果的影响,采用数值模拟和实验研究方法分析了滤料粒径对曝气生物滤池流场形态及挂膜速度的作用机理.选用5个颗粒尺寸结构空间作为计算区域,利用Fluent软件对相同颗粒间隙、不同颗粒粒径下BAF小尺度下的流场形态进行模拟分析,并通过对3种粒径下流线图、速度矢量图、压力分布及湍流强度变化的对比分析,发现颗粒粒径为3 mm时流场形态最好,最有利于气水混合及氧传质的进行.同时,为验证模拟结果的正确性,对同种材质、相同运行条件下3种不同颗粒粒径进行挂膜速度对比,通过考察挂膜启动28 d的COD去除率变化及污泥生物量的对比分析,发现颗粒粒径为3 mm时,运行最为稳定,系统运行第16 d时就达到了80%的COD去除效率.     

Fabrication and photoelectrocatalytic properties of nanocrystalline monoclinic BiVO4 thin-film electrode

Monoclinic bismuth vanadate(BiVO4) thin film was fabricated on indium-tin oxide glass from an amorphous heteronuclear complex via dip-coating.After annealation at 400,500,and 600°C,the thin films were characterized by X-ray diffraction,field emission scanning electron microscopy,X-ray photoelectron spectroscopy,and UV-Vis spectrophotometry.The BiVO4 particles on the ITO glass surface had a monoclinic structure.The UV-Visible diffuse reflection spectra showed the BiVO4 thin film had photoabsorption propertie...     

环球扫描

壳牌计划每年投资10亿美元开发中国页岩气资源 中国被认为是世界上拥有最多非常规天然气的国家,贮藏在古代页岩中的天然气可用水力压裂法进行开采,这一技术近年在北美已发展得相当成熟。     

土壤胡敏素对铜离子的吸附作用及其机理研究

以暗棕壤为供试土壤,研究了不同溶液pH值、离子强度、接触时间、反应温度和初始铜离子(Cu~(2+))浓度条件下,胡敏素对Cu~(2+)的吸附作用;利用扫描电子显微镜(SEM)、X-射线能量色散谱(EDS)、傅立叶变换红外光谱(FTIR)和X-射线光电子能谱(XPS),对胡敏素/胡敏素-Cu~(2+)复合物的表面形貌、元素分布和官能团组成进行了分析;应用延展X-射线吸收精细结构谱(EXAFS),对吸附态Cu~(2+)的局域配位结构进行了表征.结果表明:胡敏素对Cu~(2+)的吸附量随pH值、接触时间、反应温度和Cu~(2+)浓度的增加而增加,但随离子强度的增加而下降;吸附动力学符合准二级动力学方程,而吸附等温线用Langmuir方程的拟合效果较好;吸附过程需要能量,是自发、吸热和自由度增加的缔合反应;吸附Cu~(2+)之后,胡敏素表面产生了团聚现象,表面羧基、羟基、吡啶氮和N—O基团参与了Cu~(2+)的吸附作用,同时吸附态Cu~(2+)是以内层配位形式与胡敏素表面的O/N和C原子结合.