利用改性粉煤灰处理造纸废水的研究

我国是世界上最大的产煤国和耗煤国,燃煤占了我国能源结构的70％,处置粉煤灰用的储灰场占据了大量的土地同时消耗了大量的水,目前我国粉煤灰的利用率只有30％.随着造纸厂的增多,造纸黑液对水体的污染也日益加重.     

pH和共存阳离子对草莓茎吸附水体氨氮的影响

为了开发新型氨氮吸附剂和探讨环境因素对氨氮吸附的影响,以草莓茎为吸附材料,通过批平衡法研究了不同初始pH、共存阳离子、初始浓度和温度下氨氮去除的特点.结果表明,等温吸附符合Langmuir和Freundlich这2种模型,理论最大吸附量qm在15、25和35℃下分别为3.05、4.24和4.79 mg.g-1.温度升高有利于草莓茎对氨氮的吸附.草莓茎吸附氨氮最适初始pH为4～8.低pH减少草莓茎表面负电荷,高pH减少溶液中NH 4+的含量,都减少氨氮的吸附.草莓茎对溶液pH的缓冲则缓和了两者对氨氮吸附的影响.共存阳离子K+、Na+、Ca2+、Mg2+对草莓吸附铵离子没有竞争作用,而Zn2+、Al3+则由于其水解降低溶液的pH而显著降低草莓茎对氨氮的吸附.草莓茎吸附氨氮的应用pH范围较广且不易受废水中常见金属阳离子的干扰,说明草莓茎不仅可以作为废水中氨氮的吸附剂原料,而且较大多数矿物原料还有其自身的优势.     

Fe/Al改性膨润土对铬酸根的吸附性能研究

利用膨润土原矿提取了粒径小于2μm的膨润土胶体,经过钠质化处理后分别用聚羟基铁和聚羟基铝进行改性,然后用一次平衡法研究了改性膨润土对水体中铬酸根的吸附性能.结果表明,与原矿相比,改性膨润土对铬酸根的吸附量有了不同程度的提高,铁改性膨润土对铬酸根的吸附量大于铝改性者.CrO42-的吸附平衡浓度为0.5 mmol·L-1时,Mt-1(Fe)、Mt-2(Fe)和Mt-3(Al)对铬酸根的吸附量分别为271.0 mmol·kg-1、114.0 mmol·kg-1和16.1 mmol·kg-1.改性膨润土对铬酸根的吸附量随离子强度的增加而增大,随体系pH值的增加而减小.铬酸根在改性膨润土表面的吸附以专性吸附机制为主,静电吸附所占比例很小,一般不超过30%.这些研究结果可为开发新型水处理剂提供理论指导.     

球衣菌对Pb2+的吸附及其影响因素研究

采用球衣菌(Sphaerotilus natans)FQ32为生物吸附剂,研究了Pb2 初始浓度、吸附剂用量、菌龄、pH值、温度和吸附时间等理化因素对球衣菌吸附硝酸铅溶液模拟废水中Pb2 的影响.结果表明,球衣菌在Pb2 初始质量浓度为50mg,/L、吸附剂0.6g/L用量、菌龄32h、pH=7、温度30℃、吸附时间60min的条件下,对Pb2 的吸附率为89.98%,吸附量为74.98mg/g;该吸附过程是一个快速的过程,在吸附5mln时,吸附量已达总吸附量的94%,90min达到吸附平衡.球衣菌对Pb2 的吸附基本为细胞表面的被动吸附,吸附条件对吸附效率有较大影响.     

有机化改性海泡石对六六六吸附性能的探讨

分别采用阴阳离子表面活性剂对海泡石进行有机化改性处理,并对改性海泡石进行了吸附六六六实验.结果表明,未经有机化改性的海泡石对六六六各异构体去除能力由小到大依次为:γ-六六六(12.66%)、δ-六六六(12.79%)、α六六六(17.35%)、β-六六六(33.57%).经DOSO3Na有机化改性的海泡石对六六六各异构体的去除能力由小到大依次为:β-六六六、γ δ-六六六、α-六六六.经CTMAB有机化改性的海泡石对六六六各异构体的去除能力由小到大依次为:β-六六六、α-六六六、γ δ-六六六.有机化改性海泡石使体系中β-六六六大幅度增加,可能为有机化海泡石催化α、γ、δ各异构体向β异构体转化.     

铁氧化物改性黏土对Cr(Ⅵ)的吸附性能研究

利用铁氧化物对黏土进行了包覆改性,采用静态吸附法对该改性黏土吸附Cr(Ⅵ)的特性进行了研究,并考虑了反应时间、pH、浓度、温度对吸附的影响。实验结果表明,整个吸附过程基本在3h内完成;改性黏土对Cr(Ⅵ)的吸附量随溶液初始pH的增大而明显减小;随着溶液初始浓度和温度的增大而增大。同时,在初始pH为3.0的条件下,研究了改性黏土吸附Cr(Ⅵ)的动力学和热力学特性,结果表明,改性黏土对Cr(Ⅵ)吸附能较好地符合准二级动力学方程和Langmuir等温式。由Langmuir等温式得出,在293K、初始pH为3.0条件下的单层饱和吸附量为12.91 mg•g-1。确定了改性黏土吸附Cr(Ⅵ)的热力学参数,表明该吸附过程是一个吸热的自发过程。与原土的对比实验表明,改性黏土对Cr(Ⅵ)的吸附能力大大增强。     

无机-有机复合絮凝剂PST处理印染废水效果研究

以模拟印染废水和实际印染废水为实验对象,检验了一种新合成有机-无机复合絮凝剂(PST)的絮凝效果。结果表明,PST具有良好的絮凝性能。在受试条件下,絮凝效果与絮凝剂投加量、染料浓度有较大相关性。废水的pH值应用范围较宽;搅拌时间对COD去除率和脱色率没有显著影响。采用PST处理广东省高明市某印染厂的印染废水后,COD去除率为75.16%,脱色率为76.18%,处理效果良好,处理成本明显低于目前市场上普遍使用的聚铝等絮凝剂。     

Application of magnetic particles modified with amino groups to adsorb copper ions in aqueous solution

A magnetic adsorbent can be easily recovered from treated water by magnetic force,without requiring further downstream treatment.In this research,amine-functionalized silica magnetite has been synthesized using N-[3-(trimethoxysilyl)propyl]-ethylenediamine(TPED) as a surface modification agent.The synthesized magnetic amine adsorbents were used to adsorb copper ions in an aqueous solution in a batch system,and the maximum adsorption was found to occur at pH 5.5 ± 0.1.The adsorption equilibrium data fitted t...     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Removal of heavy metal ions from aqueous solution using red loess as an adsorbent

The adsorption behaviors of heavy metals onto novel low-cost adsorbent, red loess, were investigated. Red loess was characterized by X-ray diffraction, scanning electron microscopy and Fourier transform infrared spectra. The results indicated that red loess mainly consisted of silicate, ferric and aluminum oxides. Solution pH, adsorbent dosage, initial metal concentration, contact time and temperature significantly influenced the efficiency of heavy metals removal. The adsorption reached equilibrium at 4 hr, and the experimental equilibrium data were fitted to Langmuir monolayer adsorption model. The adsorption of Cu(II) and Zn(II) onto red loess was endothermic, while the adsorption of Pb(II) was exothermic. The maximum adsorption capacities of red loess for Pb(II), Cu(II) and Zn(II) were estimated to be 113.6, 34.2 and 17.5 mg/g, respectively at 25°C and pH 6. The maximum removal efficiencies were 100% for Pb(II) at pH 7, 100% for Cu(II) at pH 8, and 80% for Zn(II) at pH 8. The used adsorbents were readily regenerated using dilute HC1 solution, indicating that red loess has a high reusability. All the above results demonstrated that red loess could be used as a possible alternative low-cost adsorbent for the removal of heavy metals from aqueous solution.