加油站油气回收系统分析与关键技术研究

深入分析了加油站平衡式油气回收系统、真空泵辅助式油气回收系统的美国模式和德国模式的油气回收效率和关键技术问题,揭示了密封性是平衡式失败和美国模式低效的根本原因,解决了困扰业界的罐压不高、罐压保持、后处理装置是否必要等困惑和争议,提出高效率、低密封性要求的"低罐压真空泵辅助式油气回收系统"技术方案和实施方案。     

Effect of platinum on the photocatalytic degradation of chlorinated organic compound

TiO2 nanoparticles, doped with di erent Pt contents, were prepared by a modified photodeposition method using Degussa P-25 TiO2, H2PtCl6 6H2O and methanol as the solvents. The physicochemical properties of Pt/TiO2 were investigated by the nitrogen adsorption and desorption isotherm measurement technique, X-ray di raction analysis and photoluminescence spectra, respectively. Reaction rates from photocatalytic removal of dichloromethane over Degussa P-25 TiO2 and Pt/TiO2 were evaluated. The average diameter and BET surface area of the TiO2 catalyst particles were 300 nm and 50 m2/g, respectively. The degradation e ciency was 99.0%, 82.7%, 55.2%, and 57.9% with TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. And the degradation e ciency was 99.3%, 79.7%, 76.5%, and 73.4% with a 0.005 wt.% Pt/TiO2 at inlet concentrations of 50, 100, 200, and 300 ppm, respectively. In addition, we found that the photoluminescence emission peak intensities decreased with increases in the doping amount of Pt, which indicates that the irradiative recombination was weakened. Furthermore, the results showed that the UV/0.005 wt.% Pt/TiO2 process was capable of e ciently decomposing gaseous DCM in air.     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

无砾石微孔管地下渗滤系统试验研究

针对传统无砾石管式地下渗滤系统存在的处理性能差,渗滤通量低两个问题,通过去掉包裹织物,提高渗滤管开孔率、改变开孔方式,设计了无砾石微孔管地下渗滤系统。通过实验研究表明,无砾石微孔管地下渗滤系统对COD、氨氮的去除率比传统管式系统分别提高了10.8%、12.7%,总磷去除率并无显著差异,ORP值提高约85 mV,渗滤通量提高26.8%。在3.3 cm/d的水力负荷下,无砾石微孔管地下渗滤系统出水COD、氨氮、总磷平均浓度分别为19 mg/L,0.62 mg/L,0.048 mg/L。渗滤管下10 cm的土壤层去除了约70%的COD,80%的氨氮和91%的总磷,向下随着土壤深度的增加,单位厚度的土壤层去除的污染物量呈显著下降趋势。     

等离子体催化降解有机废水研究

研究了多种因素对高压脉冲介质阻挡放电低温等离子体法处理印染废水效果的影响。通过实验得出结论:随着有效处理时间和峰值外施电压的增加,废水中的有机物的去除率增加;随着水样浓度的增加,废水中有机物的去除率降低;随着催化剂(TiO)2量的增加,废水中有机物的去除率先升高后降低,最佳催化剂的加入量为0.5 g/L TiO2悬浮液0.5 mL。     

有关斜管沉淀池的上升流速讨论

文章从理论上了分析斜管沉淀池上升流速对沉淀池处理效果的影响,及原水特性与斜管沉淀池上升流速取值的关系。讨论分析斜管沉淀池设计时,应根据原水特性不同选择不同的斜管沉淀池上升流速。     

蒲河流域污染状况与生态修复技术对策的研究

概述了2010年以前蒲河的污染状况及形成原因,介绍了目前通过蒲河综合整治系列工程实施及生态修复技术的应用,蒲河污染状况和生态环境得到了明显改善,由2009的劣V类水质提高到目前V类水质,同时,提出目前尚存在的问题及蒲河水污染控制和水环境建设的对策和方案,为"十二五"沈阳市创建生态城市和消除劣五类水体的既定目标的实现奠定基础。     

含固率和接种比对叶菜类蔬菜垃圾厌氧消化的影响

通过叶菜类蔬菜垃圾中温批式厌氧消化实验,比较了含固率(3%、5%、7%)和接种比(1.5、2.5、3.5)对产甲烷效果的联合影响.结果表明,在研究实验参数范围内,含固率越低、接种比越高,越有利于缩短产甲烷反应迟滞期,平均日产甲烷速率越快.经过52d的培养,在含固率为3%、接种比为3.5的工况中,平均日产甲烷速率最快,达到9.5mL/(gVS·d),日最大产甲烷速率最快,达到49.8mL/(gVS·d),最早进入快速产甲烷期.当接种比为3.5时,随着含固率的升高,产甲烷速率下降,迟滞期延长,但单位底物累计产甲烷量增大,含固率7%时单位底物累计净产甲烷量为481mL/gVS.而当接种比为1.5时,含固率为5%和7%的工况均无法启动甲烷化反应,含固率为3%的工况的产气迟滞期达15d.挥发性有机酸的累积抑制甲烷化反应的启动,迟滞期随着液相中有机酸浓度的增加而延长,当有机酸浓度低于1260mg/L,甲烷化反应没有明显的迟滞期.     

环境空气颗粒物湿式净化技术研究

研究设计了一种用于环境空气中颗粒物净化的喷淋净化装置,并进行了效率、不同粒径颗粒物去除情况以及单级和累积效率的测试研究。并研究了喷淋量、雾滴粒径大小等对净化效果的影响以及雾滴携带情况,对湿式喷淋净化空气中颗粒物研究提供了参考。     

Enhanced struvite recovery from wastewater using a novel cone-inserted fluidized bed reactor

The feasibility of struvite recovery at low （12.5 mg/L） and high （120 mg[L） phosphorus concentrations was studied by constructing a novel fluidized bed reactor with cones （FBRwc） and without cones （FBRwoc）. The crystallization process was continuously operated for 133 days under different hydraulic retention times （HRT = 1-10 hr）, pH （7.5-10）, and molar ratios of Mg/P （0.75-1.75）, N/P （1-10） and Ca/Mg （0-2）. The optimum operating conditions of HRT, pH, Mg/P and N/P molar ratios were found to be 2 hr, 9, 1.25, and 7.5, respectively. Under these optimum conditions, the phosphorus precipitation efficiencies of FBRwc were 93% for low and 98% for high phosphorus influent; however, the efficiencies were 78% and 81% for FBRwoc, respectively. Due to crystal losses at each junction （17%-31%）, the crystal recovery efficiency of FBRwoc was relatively low （47%-65%） for both influent concentrations. However, the losses were minimal in FBRwc, which showed 75% and 92% crystal recovery for low and high phosphorus concentrations, respectively. At low calcium concentration, crystal chemical analysis showed the product to be pure struvite （〉 99%）. The scanning electron microscope and X-ray diffraction results further confirmed that the crystal recovered from FBRwc contained pure struvite, which could be considered a high quality fertilizer. Except HRT, all parameters （pH, Mg/P, N/P and Ca/Mg） were found to be influencing factors for FBRwc performance. Overall, inserting cones in each part of the reactor played a significant role in enhancing struvite recovery from a wide range of phosphorus-containing wastewater.