有机改性膨润土在印染废水处理中的应用

膨润土是一种非常有用的非金属矿物原料,其有机改性得到的有机改性膨润土可以较好地去除印染废水中的有机污染物和色度。本文综述了有机改性膨润土的制备方法及其在印染废水处理中的应用现状。     

制革废水二沉池反硝化浮泥产生机理及解决措施

反硝化反应受到抑制导致硝化反应消耗的碱度未能得到平衡,偏低的PH使微生物的代谢速度减慢。因而生化系统的处理能力降低,同时较高的亚硝酸盐氮、硝酸盐氮含量使二沉池极易发生污泥上浮。通过增加有机负荷来降低溶解氧确实可以抑制硝化反应。让问题得到缓解,但通过污泥龄来控制硝化程度,确保比较彻底的反硝化、氮最大程度的得以脱除,使生化系统形成良性循环,这才是根本的解决措施。     

蒙脱石对有机物料施入土壤磷形态和有效性的影响

以冷砂黄泥和矿子黄泥为研究对象,猪粪沼渣为有机物料,分别添加0%、5%、7.5%和10%质量分数的蒙脱石,采用室内培养试验研究了蒙脱石对施有机物料土壤pH、磷形态和有效性的影响.结果表明,有机物料对两种土壤pH无显著影响,而蒙脱石使土壤pH显著提高.施加有机物料使两种土壤铝结合态磷(Al-P)含量和分布比例提高,铁结合态磷(Fe-P)含量培养后期提高、比例略有下降,闭蓄态磷(O-P)含量无明显变化、比例下降.有机物料对冷砂黄泥中钙结合态磷(Ca-P)的含量无明显影响、比例下降,却使矿子黄泥Ca-P含量和比例提高.在施加有机物料基础上添加蒙脱石后,冷砂黄泥Al-P和O-P含量和比例下降,Fe-P含量无明显变化、比例下降,Ca-P含量和比例大幅度提高;矿子黄泥Fe-P和O-P含量和比例下降,Al-P含量无明显变化、比例下降,Ca-P含量和比例大幅度提高.培养过程中,有机物料使冷砂黄泥和矿子黄泥有效磷含量分别提高了17.9%~38.0%和17.1%~33.7%,土壤磷的活化系数也显著提高,添加蒙脱石后使两种土壤有效磷含量分别降低8.8%~35.5%和1.1%~11.6%.相关分析结果表明,蒙脱石通过提高pH和Ca-P含量、降低Al-P含量降低冷砂黄泥磷的有效性,通过提高pH、降低Fe-P含量降低矿子黄泥磷的有效性,对冷砂黄泥磷有效性的影响较矿子黄泥大.     

市政污泥深度脱水滤液水质特性研究

以武汉市五座污水处理厂剩余污泥经Ⅰ、Ⅱ、Ⅲ三种污泥调理方法调理及脱水的污泥深度脱水滤液为研究对象,分析测定了水样的常规水质指标。结果表明,配方Ⅰ所得脱水滤液pH为12.8左右,呈强碱性,配方Ⅱ、Ⅲ所得脱水滤液pH=3.0~6.2,呈酸性。污泥深度脱水滤液的水质随脱水污泥的来源、污泥调理方法不同而异,稳定、氧化程度高的污泥其深度脱水滤液水质较好。经调理后的深度脱水滤液ρ(COD)为180~1200 mg/L,为中低浓度有机废水;BOD5/COD=0.49~0.66,可生化性良好;氨氮浓度为20~200 mg/L,差异较大,但普遍较高,C/N在2.2~13.4,属低C/N比废水;TP在0.4~5.5 mg/L,C∶N∶P对微生物生长来说并不协调。污泥调理剂中的破胞试剂对污泥脱水滤液水质影响较大,配方Ⅱ、Ⅲ调理剂中含破胞试剂,调理后的污泥深度脱水滤液COD和氨氮值较大。最后,建议对氨氮负荷过高而不适合回流的深度脱水滤液采用高效的生物脱氮工艺进行处理。     

脱水污泥中聚合物的碱提取及其镉吸附效能研究

市政污水处理厂产生的脱水剩余污泥中含有大量的细菌胞外聚合物、胞内聚合物等大分子有机物,是一种良好的生物吸附剂制备原料。以脱水污泥为原料,采用碱提取的方法,对污泥中胞外聚合物与胞内聚合物进行提取,提取得到聚合物吸附剂,分析了聚合物吸附剂中聚合物浓度、核酸浓度随提取剂中NaOH浓度的变化,考察了聚合物吸附剂对水中镉的等温吸附性能。研究结果表明,当NaOH浓度小于0.5 mol/L时,随着提取剂NaOH浓度的升高,得到的提取液中聚合物浓度、核酸浓度逐渐升高。最佳的提取剂中NaOH浓度为0.3 mol/L,该条件下能够充分实现污泥中聚合物的提取。当NaOH浓度高于0.5 mol/L,聚合物中核酸存在一定程度的分解。聚合物吸附剂对水中Cd2+的吸附符合Langmuir模型,NaOH浓度为0.3 mol/L条件下提取得到的聚合物吸附剂的镉饱和吸附容量最大,达1.022 mmol/g。     

Debromination of decabromodiphenyl ether by organo-montmorillonite-supported nanoscale zero-valent iron：Preparation, characterization and influence factors

An organo-montmorillonite-supported nanoscale zero-valent iron material(M-NZVI) was synthesized to degrade decabromodiphenyl ether(BDE-209). The results showed that nanoscale zero-valent iron had good dispersion on organo-montmorillonite and was present as a core-shell structure with a particle size range of nanoscale iron between 30–90 nm, characterized by XRD, SEM, TEM, XRF, ICP-AES, and XPS. The results of the degradation of BDE-209 by M-NZVI showed that the efficiency of M-NZVI in removing BDE-209 was much higher than that of NZVI. The efficiency of M-NZVI in removing BDE-209 decreased as the pH and the initial dissolved oxygen content of the reaction solution increased, but increased as the proportion of water in the reaction solution increased.     

碱改性脱水污泥对水中镉的吸附效能研究

城市市政污水处理厂产生的剩余污泥是一种良好的重金属生物吸附剂制备原料。以北京某市政污水处理厂产生的脱水剩余污泥为原料,采用碱改性处理方法,制备得到碱改性脱水污泥生物吸附剂,通过其对水中镉的等温吸附实验,考察其重金属吸附效能。研究结果表明:碱改性脱水污泥对水中镉的等温吸附曲线符合Langmuir等温吸附模型。碱改性处理后,脱水污泥对水中镉的最大饱和吸附容量提高了2.8倍,达0.966 mmol/g,显著高于同类型脱水污泥生物吸附剂。碱改性脱水污泥对水中镉的最大饱和吸附容量与改性过程中所使用的Na OH浓度之间的线性相关性较差,呈现一定的波动变化趋势。     

Beyond hypoxia：Occurrence and characteristics of black blooms due to the decomposition of the submerged plant Potamogeton crispus in a shallow lake

Organic matter-induced black blooms(hypoxia and an offensive odor) are a serious ecosystem disasters that have occurred in some large eutrophic shallow lakes in China. In this study, we investigated two separate black blooms that were induced by Potamogeton crispus in Lake Taihu, China. The main physical and chemical characteristics, including color- and odor-related substances, of the black blooms were analyzed. The black blooms were characterized by low dissolved oxygen concentration(close to 0 mg/L), low oxidation-reduction potential, and relatively low pH of overlying water. Notably higher Fe2+and∑S2-were found in the black-bloom waters than in waters not affected by black blooms. The black color of the water may be attributable to the high concentration of these elements, as black FeS was considered to be the main substance causing the black color of blooms in freshwater lakes. Volatile organic sulfur compounds, including dimethyl sulfide, dimethyl disulfide, and dimethyl trisulfide, were very abundant in the black-bloom waters. The massive anoxic degradation of dead Potamogeton crispus plants released dimethyl sulfide, dimethyl disulfide, and dimethyl trisulfide, which were the main odor-causing compounds in the black blooms. The black blooms also induced an increase in ammonium nitrogen and soluble reactive phosphorus levels in the overlying waters. This extreme phenomenon not only heavily influenced the original lake ecosystem but also greatly changed the cycling of Fe, S, and nutrients in the water column.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Arsenic removal from groundwater by acclimated sludge under autohydrogenotrophic conditions

Arsenic in the environment is attracting increasing attention due to its chronic health effects. Although arsenite(As(III)) is generally more mobile and more toxic than arsenate(As(V)), reducing As(V) to As(III) may still be a means for decontamination, because As(III) can be removed from solution by precipitation with sulfide or by adsorption or complexation with other metal sulfides. The performance of As(V) bio-reduction under autohydrogenotrophic conditions was investigated with batch experiments. The results showed that As(V) reduction was a biochemical process while both acclimated sludge and hydrogen were essential. Most of the reduced arsenic remained in a soluble form, although 20% was removed with no addition of sulfate, while 82% was removed when sulfate was reduced to sulfide. The results demonstrated that the reduced arsenic was re-sequestered in the precipitates, probably as arsenic sulfides. Kinetic analysis showed that pseudo first-order kinetics described the bio-reduction process better than pseudo second-order. In particular, the influences of pH and temperature on As(V) reduction by acclimated sludge under autohydrogenotrophic conditions and total soluble As removal were examined. The reduction process was highly sensitive to both pH and temperature, with the optimum ranges of pH 6.5–7.0 and 30–40°C respectively. Furthermore, Arrhenius modeling results for the temperature effect indicated that the As(V) reduction trend was systematic. Total soluble As removal was consistent with the trend of As(V) reduction.