剩余污泥中木质纤维素稳定并转化能源可行性分析

剩余污泥中往往含有大量木质纤维素物质,在厌氧消化过程中难以降解,最终被浓缩于熟污泥中,这就是导致污泥有机物稳定并转化能源效率低下的主要原因之一.本文分析了剩余污泥中木质纤维素的含量与来源;阐述了木质纤维素的结构特点以及对其生物降解的关键技术所在;揭示了污泥常规预处理与木质纤维素预处理存在工艺条件不同的相似技术.文章结合两种预处理技术的特点和工艺条件,从原理、技术等角度分析了通过强化剩余污泥预处理而同时达到破解木质纤维素的技术思路.为此,提出了将污泥细胞破碎与木质纤维素破解耦合的观点,以期将污泥中木质纤维素的稳定与能源转化合二为一,从而构建木质纤维素稳定化、能源化与碳减排三位一体的技术策略     

热预处理对酸碱强化污泥发酵产酸过程的影响

污水处理厂产生的污泥是一种含有许多有机物的生物质,这些有机物主要是总糖和蛋白质。实验采用4种预处理(酸、碱、热-酸和热-碱)来提高污泥的发酵产酸,并探索热预处理对酸碱调控后的剩余污泥产酸的影响。结果表明,热-碱处理方式可大幅提高SCOD的生成,最大可以达到15 364.8 mg/L,碱处理次之,热-酸处理和酸处理的贡献较小。溶解性蛋白质和总糖的溶出也表现了类似的规律,热-碱处理后溶解性蛋白质和总糖最大可以达到3 474.9 mg/L和731.4 mg/L。对挥发酸(VFAs)的研究结果表明,酸性处理反而阻碍了其生成积累,即使辅以热预处理后,产酸量仍没有得到明显提高,最佳的产酸条件仍然是热-碱预处理,最大产酸量可以达到4 783.5 mg/L。     

减小浊度对水中六价铬测定产生影响的方法

简要介绍了二苯碳酰二肼分光光度法测定六价铬时,几种减小浊度对测定产生影响的较为适用、快捷的预处理方式.     

ε-聚赖氨酸生产废菌体对六价铬吸附影响的研究

以ε-聚赖氨酸(ε-PL)发酵生产废菌体小白链霉菌(Streptomyces albulus)PD-1为研究对象,探讨了其对吸附Cr(Ⅵ)的影响.实验过程中,对预处理方式、pH、初始Cr(Ⅵ)浓度、吸附时间和温度等因素进行了考察.结果表明,HCl预处理的菌体具有较好的吸附能力,Cr(Ⅵ)的吸附增加率达到22.7%,最佳pH为2.0左右,温度对Cr(Ⅵ)的吸附影响不大.实验过程中分别采取Langmuir和Freundlich 2种吸附等温模型对实验数据进行了拟合,得到2个模型的线性相关系数R2分别为0.979 4和0.979 8,这表明吸附过程中既存在单层吸附同时也存在复杂的多层吸附,小白链霉菌对Cr(Ⅵ)的最大理论吸附量为23.92mg.g-1.通过傅里叶变换红外光谱分析,酰胺基和羟基等基团在吸附过程中起主要作用.     

连续流动分光光度法测水体中的氨氮

采用连续流动分析仪,用连续流动分光光度法,对水体中的氨氮进行实验研究。优化了试验方法,使氨氮的标准曲线线性相关性高,操作简便,大大提高了检测的效率,缩短了样品测量时间。样品中的测量值均在国家标准之内,测量的精度高。     

利用紫外预处理加强氯苯的生物滴滤净化

试验采用主波长为185nm的低压汞灯为紫外光源、醚型聚氨酯海绵(PU-foam)为填料的紫外-生物滴滤塔联合装置净化氯苯废气.进气氯苯浓度为600mg·m-3、停留时间分别为92、69和46s时,联合装置的平均去除率分别达到99%、95%和80%;最大去除负荷达到59.6g·(m3·h)-1;联合装置和单独生物滴滤塔生物膜形成时间分别为20d和27d;联合装置的抗冲击能力较好,停留时间缩短至30s,联合装置去除效率可达75%以上,高于单独生物滴滤塔的去除效率(25%).对紫外-生物滴滤塔联合装置机制初步探讨表明,紫外氧化氯苯形成了水溶性较好的可生物降解的物质,降低生物滴滤塔氯苯的处理负荷,同时紫外辐照过程中产生的O3能有效地控制生物滴滤塔内微生物的过量生长,从而维持整个装置的最佳运行状态.     

Enhancement of thermophilic anaerobic digestion of thickened waste activated sludge by combined microwave and alkaline pretreatment

Pretreatment of thickened waste activated sludge (TWAS) by combined microwave and alkaline pretreatment (MAP) was studied to improve thermophilic anaerobic digestion efficiency. Uniform design was applied to determine the combination of target temperature (110–210°C), microwave holding time (1–51 min), and NaOH dose (0–2.5 g NaOH/g suspended solids (SS)) in terms of their effect on volatile suspended solids (VSS) solubilization. Maximum solubilization ratio (85.1%) of VSS was observed at 210°C with 0.2 g-NaOH/g-SS and 35 min holding time. The effects of 12 different pretreatment methods were investigated in 28 thermophilic batch reactors by monitoring cumulative methane production (CMP). Improvements in methane production in the TWAS were directly related to the microwave and alkaline pretreatment of the sludge. The highest CMP was a 27% improvement over the control. In spite of the increase in soluble chemical oxygen demand concentration and the decrease in dewaterability of digested sludge, a semi-continuous thermophilic reactor fed with pretreated TWAS without neutralization (at 170°C with 1 min holding time and 0.05 g NaOH/g SS) was stable and functioned well, with volatile solid (VS) and total chemical oxygen demand (TCOD) reductions of 28% and 18%, respectively, which were higher than those of the control system. Additionally, methane yields (L@STP/g-CODadded, at standard temperature and pressure (STP) conditions of 0°C and 101.325 kPa) and (L@STP/g VSadded) increased by 17% and 13%, respectively, compared to the control reactor.     

Archaeal community structure along a gradient of petroleum contamination in saline-alkali soil

The impact of petroleum on archaeal community in salinealkali soils was investigated, which will expand the knowledge of the archaeal population involved in the natural attenuation of hydrocarbons in extreme environments.     

稀释接种法测BOD5考核样品的一些注意点

用稀释接种法测定BOD5时,由于操作繁琐,全部实验时间需要5d,任一环节出现问题都会影响实验结果。在进行考核实验时,由于时间紧,样品量有限,因此每个实验操作步骤都要谨慎仔细。通过实践经验,就BOD,考核实验总结了一些注意点。     

Characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China

To understand the pollution characteristics of atmospheric particles and heavy metals in winter in Chang-Zhu-Tan city clusters, China, total suspended particulate(TSP) and PM10samples were collected in cities of Changsha, Zhuzhou and Xiangtan from December 2011 to January 2012, and heavy metals of Cd, Pb, Cr, and As were analyzed. It shows that the average TSP concentration in Changsha, Zhuzhou and Xiangtan were(183 ± 73),(201 ± 84) and(190 ± 66) μg/m3respectively, and the average PM10 were(171 ± 82),(178 ± 65) and(179 ± 55) μg/m3respectively. The lowest TSP and PM10concentrations occurred at the background Shaping site of Changsha. The average ratio of ρ(PM10)/ρ(TSP) was 91.9%, ranging from 81.3% to 98.9%. Concerning heavy metals, in TSP samples, the concentration of Cr, As, Cd and Pb were 28.8–56.5, 18.1–76.3, 3.9–26.1 and 148.0–460.9 ng/m3, respectively, while in PM10samples, were 16.4–42.1, 15.5–67.9, 3.3–22.2 and 127.9–389.3 ng/m3, respectively. The enrichment factor of Cd was the highest, followed by Pb and As, while that of Cr was the lowest.