Arsenic removal from groundwater by acclimated sludge under autohydrogenotrophic conditions

Arsenic in the environment is attracting increasing attention due to its chronic health effects. Although arsenite(As(III)) is generally more mobile and more toxic than arsenate(As(V)), reducing As(V) to As(III) may still be a means for decontamination, because As(III) can be removed from solution by precipitation with sulfide or by adsorption or complexation with other metal sulfides. The performance of As(V) bio-reduction under autohydrogenotrophic conditions was investigated with batch experiments. The results showed that As(V) reduction was a biochemical process while both acclimated sludge and hydrogen were essential. Most of the reduced arsenic remained in a soluble form, although 20% was removed with no addition of sulfate, while 82% was removed when sulfate was reduced to sulfide. The results demonstrated that the reduced arsenic was re-sequestered in the precipitates, probably as arsenic sulfides. Kinetic analysis showed that pseudo first-order kinetics described the bio-reduction process better than pseudo second-order. In particular, the influences of pH and temperature on As(V) reduction by acclimated sludge under autohydrogenotrophic conditions and total soluble As removal were examined. The reduction process was highly sensitive to both pH and temperature, with the optimum ranges of pH 6.5–7.0 and 30–40°C respectively. Furthermore, Arrhenius modeling results for the temperature effect indicated that the As(V) reduction trend was systematic. Total soluble As removal was consistent with the trend of As(V) reduction.     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

利用微型后生动物进行污泥原位减量的试验研究

在A/A/O普通活性污泥工艺中引入非寡毛类微型后生动物考察其生长条件和对剩余污泥的减量效果及对系统处理效果的影响。结果表明,当进水负荷小于0.5 mg(/mg MLSS·d)时,非寡毛类微型后生动物可大量生长;当内回流比升高、外回流比降低时,更有利于虫体的繁殖。经过适时的运行工艺调整可使生化系统虫体密度和稳定性提高,污泥减量效果可达到40%以上。非寡毛类后生动物的活动与摄食作用提高了系统污泥的沉降性能,并对系统出水COD、NH3-N、TN、TP、SS没有影响。。     

UASB处理酒精废水耐冲击特性与颗粒污泥分析

针对UASB耐冲击能力低的问题,采用短暂冲击负荷的方法进行52 d中试研究,并考察接种絮状污泥的UASB对以污冷凝水为主要成分的酒精废水的处理效果,结果表明,UASB呈现较强耐冲击负荷能力;第49天产气速率最高,可达3.03 L/(L·d),反应器内形成了粒径0.5~1.5 mm的颗粒,电镜扫描的颗粒污泥结构致密,由多个杆状细菌形成网状结构。在夏季无保温措施、负荷冲击条件下培养颗粒污泥是可行的。     

剩余污泥微生物燃料电池产电性能的优化试验研究

通过优化阴极材料,构建新型单室无膜壁式空气阴极微生物燃料电池,开展了污泥浓度、阳极面积、导线材料和NaCl离子浓度等影响因素及其优化试验研究。结果显示:在恒温30℃和外接电阻1 000Ω的条件下,以铜线为导线,污泥浓度为21 000 mg/L,阳极面积为31.4 cm2,Na+浓度为200 mmol/L时,其产电性能最佳,最大电压为597 mV,最大输出功率密度为301 mW/m2,内阻为92.5Ω。此外,还分析了污泥运行过程中的变化。与目前其他以未经过预处理的剩余污泥作为底物的微生物燃料电池相比,该新型单室无膜壁式空气阴极微生物燃料电池功率密度较高,内阻较低。     

低碳高氮污水处理应用技术研究

针对碳氮比小于7的污水,其碳源不能满足硝化与反硝化的要求这一问题,通过改变SBR工艺的运行方式、调解工艺参数等技术手段,使其能够达标处理此类工业废水,并通过某淀粉厂的工程实例进行了验证:采用改良的SBR工艺可以对低碳高氮污水进行有效的处理。     

剩余污泥对柠檬黄-85的吸附行为

以城市污水厂中的剩余污泥为主要原料制备污泥吸附剂(SA),并用于柠檬黄-85(Tt-85)脱色的实验研究。静态实验主要考察了pH值、投加量、反应时间、反应温度和Tt-85初始浓度对吸附的影响。结果表明:在投加质量浓度为6 g/L,pH值=2.0,温度为25℃的条件下,反应90 min后,SS对水中初始质量浓度为65 mg/L和221 mg/L的Tt-85去除率分别达到了97%和75%。对动力学实验数据进行拟合,发现准二级动力学模型能较好地描述SA对Tt-85的吸附行为。动态吸附柱实验表明,污泥凝胶球对水中Tt-85的去除率为64%。Langmuir等温吸附模型符合SA对Tt-85的吸附过程,其最大吸附质量比为27.78 mg/g,由SEM,FTIR和XRD的分析可得,SA对柠檬黄-85的化学吸附主要发生在表面,其中SA表面羟基官能团起到关键性作用。     

浙江省污水污泥处理处置状况的调查

通过对丽水、宁波、衢州、诸暨等浙江省境内十几个地区的污水处理厂的调查发现:目前浙江省内的污水处理工艺中,A2/O、A/O、氧化沟三种工艺占了近50%的份额。而SBR因其方法特点正在受到越来越多的重视。在污泥处理工艺中,填埋占了最大的一部分,有近70%的污水处理厂将产生的污泥进行填埋处理。目前,污泥处理技术单一,需要继续探寻污泥的减量和资源化技术,为日益增多的污泥探寻出路。     

渭河流域关中段城镇污水处理厂污泥处置技术调查与分析

根据渭河流域关中段的污染状况及《(渭河流域水污染防治三年行动方案(2012—2014年)》对科技攻关的实际需求,采用资料搜集、实地调查、问卷发放、数理统计等方式对渭河流域关中段55座城镇污水处理厂的污泥处置情况进行了调查与分析。根据调查分析结果,提出了渭河流域关中段城镇污水处理厂污泥处置技术在应用过程中存在的一些问题,并结合该流域实际情况提出了相应建议。     

污泥处理产物资源化利用方向的分析

结合沈阳市污泥及其生物干化后的产物指标情况,对污泥处理产物的资源化利用方向进行分析,主要有土地利用、焚烧发电及填埋场覆盖土等几个方面。