Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

电价市场化需突破体制藩篱

国家发改委批复了云南直购电试点的输配电价,这意味着从政策制定者角度看,直购电仍是现阶段探索电力体制改革的可行方式。分析人士认为,电力体制改革不能仅停留在直购电试点上,不从根本上改变对现行电网的定位,不将竞价上网与输配分开统筹考虑,简单通过直购电试点,很难达到电力体制改革的预期效果。     

失效催化剂的问题有多大？

四川大学化学学院教授、催化材料研究所所长陈耀强指出．汽车行驶10万公里以后,催化剂逐渐失去作用。而中国车主没有更换尾气净化催化剂的习惯。政府也没有强制措施,导致大量催化剂失效的车辆仍在行驶．加剧了机动车排放污染。     

SCR催化剂对汞的催化氧化研究进展

文章综述了目前国内外选择性催化还原(SCR)催化剂催化氧化燃煤烟气中汞的研究现状。介绍了钒基、铜基、铁基、锰基、铈基以及贵金属SCR催化剂对汞的催化氧化性能;分别分析了烟气温度、烟气组分(Cl2、HCl、SO2、NH3等)、空速等因素对各催化剂汞氧化性能的影响;最后运用文献对比方法综合概括了燃煤烟气条件对汞氧化的影响,并结合我国燃煤电厂现状,对SCR催化脱汞技术的发展方向提出建议:利用SCR催化剂实现燃煤烟气中汞的氧化,结合现有污染物控制设备实现汞的脱除,是一种经济、高效的燃煤烟气脱汞技术;当前应深入研究SCR催化剂对汞的催化氧化机理,开发能够实现NOx与汞协同控制的,稳定、高效、普适性强的低温SCR催化剂。     

MIL-101(Cr~(3+))可见光催化氧化降解甲基橙的研究

以金属有机多孔材料MIL-101(Cr3+)为非均相催化剂,过硫酸钠(Na2S2O8)为类Fenton体系的氧化剂,在可见光(300 W)下对甲基橙进行催化氧化降解研究。结果表明,MIL-101(Cr3+)在反应时间为120 min时对甲基橙降解率高达91.0%,且回收利用3次后仍表现出优异的降解性能(降解率达到81.0%)。同样条件下,把MIL-101(Cr3+)替换为TiO2或者不添加任何催化剂,甲基橙的降解率分别为25.6%和8.8%。采用紫外-可见漫反射光谱考察了常温下MIL-101(Cr3+)的禁带宽度大小,进一步证明其优异的光催化降解性能;同时还探讨了MIL-101(Cr3+)催化降解甲基橙的可能机理。     

喹啉为单一燃料在填料型MFC的产电特性研究

多环芳烃是我国近岸海域水体和沉积物中需要优先控制的首位有机污染物,喹啉是典型的含氮杂环芳烃,具有较大的毒性、致畸性和潜在的致癌作用。该研究利用填料型MFC对单一喹啉为燃料的产电性能进行了研究。经过6个月利用喹啉和葡萄糖作混合燃料的驯化,MFC中的阳极群落发生了改变,可以利用单一喹啉进行产电,以200 mg/L喹啉为燃料时的最大体积功率密度为2.7 W/m3。在没有外加葡萄糖可能带来的协同共代谢作用下,利用单一喹啉做燃料时,对喹啉在MFC中的降解途径进行了研究。实验结果表明,以喹啉为燃料时,MFC可以在不利用有机物本身作为电子受体的作用下,通过外电路的电子传递完成电子从阳极到阴极的传递而达到相同的目的。     

V2O5/TiO2催化剂脱除NO的研究

采用了等体积浸渍法制备二氧化钛负载钒氧化物催化剂（V2O5/TiO2）,研究了V2O5负载量、反应温度、烟气流量、氨氮比以及运行时间各因素对NH3选择性催化还原NO反应（SCR）效率的影响.研究结果表明：经过500℃温度下煅烧,烟气流量为200ml/min,负载量为7wt％的V2O5/TiO2催化剂,在400℃温度下反应,NO脱除率可达70.5％.     

三维双阴极-电Fenton法处理腌制酸菜废水的试验研究

采用三维双阴极-电Fenton法处理腌制酸菜废水,通过正交试验考察了酸菜废水中有机物去除的影响因素及其处理效果,并优化了试验条件。试验结果表明:各因素对酸菜废水COD去除率的影响程度大小依次为:pH值电流密度Fe2+用量活性炭用量极板间距电解质Na2SO4用量电解温度;通过对比分析两种电解方式对酸菜废水的处理效果,结果显示三维双阴极-电Fenton法处理酸菜废水时产生的H2O2量、电流效率、溶液中Fe2+浓度以及废水的COD去除率均高于传统单电极-电Fenton法,并分析了反应机理。三维双阴极-电Fenton法用于腌制酸菜废水处理切实可行、效果明显,为实际废水处理提供了参考。