脉冲电场破乳耦合活化过硫酸盐工艺处理乳化油废水

乳化油废水普遍具有有机污染物质浓度高、成分复杂,处理难度大的特征。利用脉冲电场,实现油水分离,并结合脉冲电场活化过硫酸盐产生具有强氧化性的SO^-₄·,对破乳后废水中有机物进行降解。结果表明：脉冲电场破乳试验中,当电源电压为18 V,溶液pH=2,电源频率为800 Hz,占空比为50%,极板间距为2.5 cm,反应时间为50 min时破乳效果最好,对于初始COD浓度为78340 mg/L的乳化油废水,COD的去除率高达98.03%;脉冲电场活化PMS处理破乳后废水试验中,当ρ(PMS),ρ(COD)=3,溶液pH=2,电源电压为15 V,频率为3000 Hz,占空比(一个脉冲循环内,通电时间占总时间的比例)为70%,极板间距为2.5 cm,反应时间为2 h时,乳化油废水中有机物降解率最高达60.8%;且相同条件下,脉冲电源+PMS处理体系较直流电源+PMS处理体系降解率高出6.4百分点。     

稀土/Y分子筛多相催化电解氧化深度去除渗滤液中难降解有机物

采用浸渍和焙烧法制备了以Y分子筛为载体的几种稀土催化剂,并用玻璃纤维包埋催化剂形成反应床体,构建稀土多相催化电解氧化体系,探索这一体系对垃圾渗滤液中难降解有机物的去除效果.同时,以COD值为控制指标,考察了焙烧温度、浸渍液金属离子浓度、稀土元素种类对电催化活性的影响.最后,用SEM和XRD等手段对催化剂的微观结构、表面形貌进行了表征,并与稀土/γ-Al2O3催化剂的电催化活性和结构进行了比较.结果表明,Y分子筛中引入稀土元素后没有破坏Y分子筛的晶体结构,稀土/Y分子筛催化剂的表面并没有检测到稀土氧化物的物相,稀土/γ-Al2O3催化剂的表面形成了明显的稀土氧化物衍射峰;稀土/Y分子筛催化剂的最佳制备条件为焙烧温度400℃,浸渍液中金属离子质量分数1%～3%,负载金属为铈;所制备的稀土/Y分子筛催化剂具有良好的电催化活性和稳定性,其活性高于稀土/γ-Al2O3催化剂.     

溶胶/粉末复合浸渍法制备颗粒状SCR脱硝催化剂的特性

针对以V₂O₅-WO₃/TiO₂为成分的颗粒状SCR脱硝催化剂在制备过程中存在的有效组分加载均匀性等问题,尝试了利用偏钛酸溶胶作为载体的催化剂生产方法.利用粉末/溶胶复合浸渍方式设计出4种催化剂的制备方法并分别制得样品.通过在不同温度条件下样品对烟气中NO_x成分去除效能的性能测试,以及进行相关的微观表征分析,研究比较了不同制备方式对催化剂特性的影响规律,旨在探索出一种合理、高效的催化剂制备工艺.结果表明:利用偏钛酸溶胶作为载体,同步浸渍加载WO₃和V₂O₅ 2种组分,相比传统的粉末浸渍和两步浸渍方式,该方法能够使浸渍组分在载体表面获得较高的覆盖率,并有效避免了浸渍组分溶出和重结晶现象的发生,所制得的催化剂样品具有较高的脱硝效率.      

制备工艺对活性炭电极电吸附性能的影响

用活性炭、酚醛树脂和乌洛托品制备了活性炭电极。研究了电极制备过程中黏结剂添加量、活性炭用量以及成型后活性炭的炭化温度和炭化时间对电吸附除盐性能的影响,并利用扫描电子显微镜(SEM)分析了电极的表面形貌。结果表明:当活性炭、酚醛树脂和乌洛托品混合比例为8:1.8:0.2时,电极能够成型,随着黏结剂的比例增加,电极的除盐率降低;随着活性炭用量的增加,吸附平衡的时间增加,除盐率提高,但平衡吸附量降低,当NaCl浓度降低到一定程度时,再增加活性炭用量去除率变化变小,试验选定的活性炭用量为0.45g/片电极;随着炭化温度的升高和炭化时间的增长,活性炭电极电吸附除盐效果明显提高,850℃下炭化2h的电极炭化完全,除盐率是未炭化的电极除盐率的2.08倍。     

电袋复合型除尘器在电厂除尘改造中的应用

介绍晋北铝业自备电厂4台240t/h锅炉电除尘器改造成电袋复合型除尘器的方案、原理、运行情况,为国内燃煤电厂的电除尘器改造提供借鉴和参考。     

汽车尾气三效催化剂简介

文章综合了相关资料，比较详细介绍了汽车尾气三效催化剂的载体、涂层、活性组分和主要助剂，并指出三效催化剂研究、应用的发展趋势。     

Reaction mechanism and metal ion transformation in photocatalytic ozonation of phenol and oxalic acid with Ag+/TiO2

Photocatalytic ozonation of phenol and oxalic acid （OA） was conducted with a Ag^＋/TiO2 catalyst and different pathways were found for the degradation of different compounds. Ag^＋ greatly promoted the photocatalytic degradation of contaminants due to its role as an electron scavenger. It also accelerated the removal rate of OA in ozonation and the simultaneous process for its complex reaction with oxalate. Phenol could be degraded both in direct ozonation and photolysis, but the TOC removal rates were much higher in the simultaneous processes due to the oxidation of hydroxyl radicals resulting from synergetic effects. The sequence of photo-illumination and ozone exposure in the combined process showed quite different effects in phenol degradation and TOC removal. The synergetic effects in different combined processes were found to be highly related to the properties of the target pollutants. The color change of the solution and TEM result confirmed that Ag＋ was easily reduced and deposited on the surface of Tit2 under photo-illumination, and dissolved again into solution in the presence of ozone. This simple cycle of enrichment and distribution of Ag^＋ can greatly benefit the design of advanced oxidation processes, in which the sequences of ozone and photo-illumination can be varied according to the needs for catalyst recycling and the different properties of pollutants.     

铁基催化剂的微波水热处理对其SCR脱硝性能的影响

利用微波对共沉淀制备的铁铈钛复合氧化物催化剂前驱体进行水热处理,探讨了微波水热处理对铁基催化剂低温SCR脱硝性能的优化;并对微波水热处理条件的影响进行了正交分析.结果表明:对铁基催化剂前驱体进行微波水热处理,可提高其低温SCR脱硝性能,使其脱硝温度窗口向低温偏移;且微波水热处理的低温优化效果与催化剂中Fe/Ti摩尔比密切相关,Fe/Ti摩尔比越小,微波水热处理的低温优化越强;微波加热方式和微波辐射时间会影响微波水热处理对铁基催化剂SCR脱硝性能的低温优化;在相同微波辐射时间条件下,当P30逐渐变为P80,微波水热处理对铁基催化剂低温SCR脱硝的促进作用降低;在P30条件下,微波辐射15min使铁基催化剂具有最佳低温SCR脱硝活性.     

国内首个MW级分布式能源系统烟囱合理性分析

介绍了分布式能源系统的构成、运行特点及技术发展情况,研究了国内首个MW级分布式供能系统工程的烟囱高度和形式,预测和分析了项目大气污染物对环境的影响,证明了该项目烟囱选择的合理性,为下阶段国内分布式能源系统烟囱选型奠定技术基础。     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.