猪粪秸秆高温堆肥过程中碳氮转化特征与堆肥周期探讨

将猪粪与秸秆以7：1（质量比,以鲜重计）的比例,在自制的强制通风静态堆肥反应箱中进行高温堆肥试验,研究了堆肥过程中碳氮转化特征及其腐熟时间.同时,在堆制的23d中,根据堆温变化采样6次,分析了堆肥样品中各种氮素和碳素含量及其它性质的变化情况.结果表明：堆肥结束时,硝态氮含量增加了103.0%,铵态氮、有机氮、总氮含量分...     

黄土丘陵沟壑区地形和土地利用对深层土壤有机碳的影响

研究地形和土地利用对深层土壤有机碳(soil organic carbon,SOC)的影响,对准确评估土壤固碳潜力和土壤碳循环具有重要意义.以3种地形(峁顶、峁坡、沟底)和7种土地利用类型(农田、果园、天然草地、人工与天然灌木林、人工与天然乔木林)为对象,在黄土丘陵沟壑区燕沟流域采集53个0～1m土壤剖面中6个层次,898个土壤样品,研究了地形和土地利用方式对黄土丘陵沟壑区小流域深层SOC含量和分布影响.结果表明,地形、土地利用方式、土层深度及其两两交互作用对流域深层SOC空间分布有极显著影响(p0.01).深层(10～100cm)与表层(0～10cm)SOC在3种地形的分布不同.对于表层土壤(0～10cm),峁坡SOC含量(10.7g·kg-1)最高,其次是沟底(8.9g·kg-1),峁顶最低(4.4g·kg-1);对深层土壤有机碳,沟底最高(5.6g·kg-1),峁坡次之(4.5g·kg-1),峁顶最低(3.2g·kg-1).深层SOC空间分布因土地利用方式存在显著差异.与农田相比,果园0～40cm土层SOC含量降低21%,但80～100cm土层SOC含量提高13%;天然灌木林40～100cm平均含量(5.3g·kg-1)较农田高66%(p0.05);但天然乔木林40～100cm与其它土地利用方式差异较小.沟底深层(20～100cm)SOC储量(5.04kg·m-2)最大,占1m剖面SOC储量的71.4%;峁坡占63.6%;峁顶占72.3%.深层(20～100cm)SOC储量天然灌木林最高,为6.01kg·m-2,占1m剖面SOC储量的64.7%,天然乔木林深层相对储量最小,仅占49.7%;农田和果园深层相对储量均达到70%以上.     

己内酰胺生产废水的铁碳微电解深度处理与机理研究

采用铁碳微电解方法对己内酰胺生产废水进行深度处理,探讨了pH值、停留时间、铁碳质量比对处理效果的影响。在pH为4、停留时间为120 min、铁碳质量比为4的最佳处理条件下,COD去除率可达57.8%,色度去除率可达68.4%。微电解对己内酰胺废水的作用主要通过铁的絮凝作用,处理过程中的酸性条件、微电解的氧化还原和电场作用,从而提高其去除效率。     

Application of magnetic particles modified with amino groups to adsorb copper ions in aqueous solution

A magnetic adsorbent can be easily recovered from treated water by magnetic force,without requiring further downstream treatment.In this research,amine-functionalized silica magnetite has been synthesized using N-[3-(trimethoxysilyl)propyl]-ethylenediamine(TPED) as a surface modification agent.The synthesized magnetic amine adsorbents were used to adsorb copper ions in an aqueous solution in a batch system,and the maximum adsorption was found to occur at pH 5.5 ± 0.1.The adsorption equilibrium data fitted t...     

TiO2 nanotubes as solid-phase extraction adsorbent for the determination of polycyclic aromatic hydrocarbons in environmental water samples

An analytical method based on TiO2 nanotubes solid-phase extraction (SPE) combined with gas chromatography (GC) was established for the analysis of seven polycyclic aromatic hydrocarbons (PAHs): acenaphtylene, acenaphthene, anthracene, fluorene, phenanthrene, fluoranthene and pyrene. Factors a ecting the extraction e ciency including the eluent type and its volume, adsorbent amount, sample volume, sample pH and sample flow rate were optimized. The characteristic data of analytical performance were determined to investigate the sensitivity and precision of the method. Under the optimized extraction conditions, the method showed good linearity in the range of 0.01–0.8 g/mL, repeatability of the extraction (RSD were between 6.7% and 13.5%, n = 5) and satisfactory detection limits (0.017–0.059 ng/mL). The developed method was successfully applied to the analysis of surface water (tap, river and dam) samples. The recoveries of PAHs spiked in environmental water samples ranged from 90% to 100%. All the results indicated the potential application of titanate nanotubes as solid-phase extraction adsorbents to pre-treat water samples.     

Removal of heavy metal ions from aqueous solution using red loess as an adsorbent

The adsorption behaviors of heavy metals onto novel low-cost adsorbent, red loess, were investigated. Red loess was characterized by X-ray diffraction, scanning electron microscopy and Fourier transform infrared spectra. The results indicated that red loess mainly consisted of silicate, ferric and aluminum oxides. Solution pH, adsorbent dosage, initial metal concentration, contact time and temperature significantly influenced the efficiency of heavy metals removal. The adsorption reached equilibrium at 4 hr, and the experimental equilibrium data were fitted to Langmuir monolayer adsorption model. The adsorption of Cu(II) and Zn(II) onto red loess was endothermic, while the adsorption of Pb(II) was exothermic. The maximum adsorption capacities of red loess for Pb(II), Cu(II) and Zn(II) were estimated to be 113.6, 34.2 and 17.5 mg/g, respectively at 25°C and pH 6. The maximum removal efficiencies were 100% for Pb(II) at pH 7, 100% for Cu(II) at pH 8, and 80% for Zn(II) at pH 8. The used adsorbents were readily regenerated using dilute HC1 solution, indicating that red loess has a high reusability. All the above results demonstrated that red loess could be used as a possible alternative low-cost adsorbent for the removal of heavy metals from aqueous solution.     

响应面法优化复合微生物吸附剂对低浓度Cr3+的吸附

根据已有4种微生物吸附剂的吸附基团存在的差异特征,将其复配成复合吸附剂,借助统计学方法研究其对低ρ(Cr3+)废水的吸附性能.在单因素试验基础上,利用P-B(Plackett-Burman)法筛选出吸附过程4个主要影响因素分别为pH,初始ρ(Cr3+)及微生物吸附剂XB和TQ的投加量,应用最陡爬坡试验接近主要因素最优水平,采用Box-Behnken试验设计和响应面分析得到对低浓度Cr3+吸附过程的二阶模型.结果表明,最优吸附条件为pH 4.0,初始ρ(Cr3+)为4.86mg/L,XB和TQ的投加量分别为0.20和0.13 g/L,实际吸附率达到87.54%,与理论预测值(87.68%)接近,且高出单一吸附剂吸附率7.79%～17.35%.FT-IR扫描显示,复合微生物吸附剂性能提高与表面基团增多有关.通过响应面分析法优化复合微生物吸附,吸附性能明显提高.     

吸附剂烟气脱砷的研究现状

大气砷污染问题日益引起人们的重视,吸附剂能够在去除烟气中砷的同时去除其他有害气体,是控制烟气砷含量、防止砷污染的有效途径.文章分析了砷在废气中的形态及分布,总结了近年来氧化钙、活性炭、飞灰和金属氧化物作为吸附剂用于烟气脱砷的最新研究进展,重点分析了各自的吸附机理及不同因素对脱砷过程的影响.指出吸附过程通常以化学吸附为主...     

La-Co-Fe-Cu/HZSM-5在尾气碳颗粒燃烧中的催化性能

采用柠檬酸络合低温浸渍法制备分子筛负载钙钛矿型复合氧化物催化剂。采用XRD、SEM和H2-TPR等手段对催化剂性能进行表征,并在微型固定床反应器中对催化剂进行活性评价。结果表明,在钙钛矿型复合氧化物中进行B位离子掺杂,可以改善催化活性,碳颗粒燃烧温度降低。在20%LaCoO3/HZSM-5催化剂中用铁离子部分取代钴离子可以改善碳颗粒的燃烧性能,取代量增加碳颗粒燃烧温度降低,但是生成CO2的选择性也降低,以20%LaCo0.2Fe0.8O3/HZSM-5为催化剂,Tig、Tm和Tf分别为256℃、399℃和403℃,但生成CO2的选择性只有72.5%。在20%LaCo1-xFexO3/HZSM-5中的钙钛矿型复合氧化物B位离子中加入铜离子后,在碳颗粒燃烧反应中生成CO2的选择性得到明显改善,Sco2提高10个单位以上。以20%LaCo0.2Fe0.6Cu0.2O3/HZSM-5为催化剂,在碳颗粒燃烧反应中生成CO2的选择性可以达到94.7%,Tig、Tm和Tf分别为242℃、427℃和445℃。     

Cu-K型低温碳烟氧化催化剂的合成及表征

柴油机排放中碳烟的低温氧化是近年来研究的热点.通过原位合成法制备Cu2K/Al2O3和CuK／Al2O3两种碳烟氧化催化剂,并采用低温氮吸附/脱附实验、X射线衍射、X射线光电子能谱、程序升温氧化对其结构进行系统表征,并用U碳模拟柴油机碳烟,研究其催化活性,评测其对柴油机排气中碳烟颗粒的净化效果.研究表明,Cu2K/Al...