中试厌氧氨氧化反应器的运行性能及其过程动力学特性

研究了上流式中试厌氧氨氧化(anaerobic ammonium oxidation,ANAMMOX)反应器在环境温度下的运行性能及其过程动力学特性.基质浓度试验表明,中试厌氧氨氧化反应器可在进水亚硝酸盐浓度为(380.4±18.3)mg.L-1稳定运行,继续提升至(480.5±21.9)mg.L-1时,反应器性能恶化.在水力停留时间(hydraulic retention time,HRT)试验中,HRT可缩短至3.43 h,反应器容积基质氮去除速率可达3.45 kg.(m3.d)-1.长期运行中,温度对中试厌氧氨氧化反应器的性能影响较大.采用改进型的Stover-Kincannon模型可较好地模拟非抑制状态下中试厌氧氨氧化反应器在不同温度范围下的行为.获得的Stover-Kincannon模型动力学参数及其出水总基质浓度预测公式和总基质去除率预测公式,可用于指导中试厌氧氨氧化反应器的实际操作.     

春季南黄海溶解有机碳的分布特征及其受控因素

依据2007年4月对南黄海调查所得的溶解有机碳(DOC)数据,初步分析了南黄海DOC的分布特征及其影响因素。结果表明,2007年春季南黄海DOC的质量浓度为0.91～2.69 mg/L,平均值为1.62 mg/L,北部近岸DOC浓度高,长江口北部海域及南黄海中部外海DOC含量较低;在垂直方向上,10 m层DOC含量略高,各水层量值相差不大。DOC的分布趋势主要受控于水文结构,某些河口海域,生物生产对DOC含量也有一定的贡献。     

微电解-Fenton法处理拉米夫定废水试验研究

分别采用微电解-Fenton氧化串联工艺和H2O2强化微电解工艺预处理难降解拉米夫定工业废水,通过对有机物、色度去除率的优选和反应过程中Fe2＋浓度变化的分析,确定了最佳工艺及工艺运行方式。结果表明,微电解-Fenton氧化串联工艺宜采用微电解阶段后调节pH值的运行方式,与不调节pH值的运行方式相比,CODCr去除率提高了6.85%;H2O2强化微电解工艺,反应100min时,CODCr去除率为71.71%,色度去除率为98.15%,与微电解-Fenton氧化串联工艺相比反应时间短,投加药剂费用少,不需另设专门Fenton反应设备。通过废水处理前后的UV/Vis吸收光谱图比较,表明2种工艺对拉米夫定废水具有较理想的处理效果但最终降解产物不同。     

环境因子对植物-生物膜氧化沟去除氮磷的影响

将生物膜处理工艺和漂浮栽培植物技术应用于氧化沟处理系统中,组成植物-生物膜氧化沟生态处理系统,通过其对生活污水的处理,考察了pH值、溶解氧(DO)、温度等环境因子对植物-生物膜氧化沟系统去除氮磷的影响。结果表明:系统中TP的去除率与pH值之间呈抛物线关系,当系统出水TP去除率达到最高时,其pH值为7.71,TP去除率随着pH值的升高而升高,TN的去除率与pH值的相关关系达到显著水平;DO在系统中一直保持较高的浓度,其最高浓度可达到5.6mg/L,与TP去除率的关系显著;另外,系统中污水氮磷的去除率与温度关系密切,其中NH4+-N的去除率与温度呈现显著的正相关关系,温度对污水TN和TP的去除影响达到极显著水平。     

强化厌氧污泥体系同步脱硫反硝化特性研究

以硫化物为电子给体的自养反硝化厌氧体系是代替传统异养反硝化工艺处理低C/N比含氮废水的有效工艺,可以同时去除硫化物和硝酸盐.将脱氮硫杆菌菌悬液接种到厌氧污泥体系中,脱氮硫杆菌快速富集,采用5组进水比N/S比不同的反应瓶进行试验,运行15d后,测定不同时段的出水硫化物、硝酸盐、亚硝酸盐、硫酸盐浓度等指标,考察强化厌氧污泥体系去除硫化物和硝酸盐的特性,并对生化反应机制进行初步研究.结果表明,强化厌氧污泥体系运行3h后,进水中90%的硫化物被去除,硫化物的去除与进水N/S比无关,硫化物(以S计)去除速率高达20～24g·(m3·h)-1,是相关文献报道的10倍左右;运行6h后,进水中65%的硝氮被去除,硝氮的去除负荷随着进水N/S比的提高而增大,最高达到940g·(m3·h)-1,约为硫自养反硝化体系硝氮去除负荷的2倍,此时体系中亚硝氮积累,最高浓度达到93mg·L-1,进水N/S比低的条件下,6h后亚硝氮消失,进水N/S比较高时,21h后出水中未检测到亚硝氮.表明强化厌氧污泥体系停留6h后可以实现同时去除硫化物和硝酸盐,但硝酸盐首先转化为亚硝氮.与以往不同的是研究发现硫化物与生物硫粒产生多硫化合物的链式反应,是硫化物迅速转化的主要途径,此外,还原硝氮的电子给体并不来源于硫化物,可能主要来源于体系中产生的单质硫.     

改良型Carrousel氧化沟工艺在重庆某污水处理厂的应用

介绍了重庆某污水处理厂改良型Carrousel氧化沟工艺的构造、原理与主要设计参数,总结了该工艺的低温启动经验。11个月的稳定运行表明,系统在进水BOD5、CODcr、NH3-N、TN和TP浓度分别为67 mg/L～264 mg/L、281 mg/L～902 mg/L、10.1 mg/L～37.8 mg/L、20.4 mg/L～72.7 mg/L和3.1 mg/L～12.3 mg/L条件下,去除率分别达到96.3%～99.1%、90.8%～99.6%、78.2%～99.4%、63.6%～89.9%和80.6%～98.4%,各项出水指标达到《城镇污水处理厂污染物排放标准》（GB 18918-2002）一级B标准。     

An autotrophic nitrogen removal process：Short-cut nitrification combined with ANAMMOX for treating diluted effluent from an UASB reactor fed by landfill leachate

A combined process consisting of a short-cut nitrification (SN) reactor and an anaerobic ammonium oxidation upflow anaerobic sludge bed (ANAMMOX) reactor was developed to treat the diluted effluent from an upflow anaerobic sludge bed (UASB) reactor treating high ammonium municipal landfill leachate.The SN process was performed in an aerated upflow sludge bed (AUSB) reactor (working volume 3.05 L),treating about 50% of the diluted raw wastewater.The ammonium removal efficiency and the ratio of NO 2 N to NOx-N in the effluent were both higher than 80%,at a maximum nitrogen loading rate of 1.47 kg/(m 3 ·day).The ANAMMOX process was performed in an UASB reactor (working volume 8.5 L),using the mix of SN reactor effluent and diluted raw wastewater at a ratio of 1:1.The ammonium and nitrite removal efficiency reached over 93% and 95%,respectively,after 70-day continuous operation,at a maximum total nitrogen loading rate of 0.91 kg/(m 3 ·day),suggesting a successful operation of the combined process.The average nitrogen loading rate of the combined system was 0.56 kg/(m 3 ·day),with an average total inorganic nitrogen removal efficiency 87%.The nitrogen in the effluent was mostly nitrate.The results provided important evidence for the possibility of applying SN-ANAMMOX after UASB reactor to treat municipal landfill leachate.     

半短程亚硝化与厌氧氨氧化联合脱氮工艺微生物特征研究进展

半短程亚硝化-厌氧氨氧化脱氮技术具有良好的发展前景,该工艺的发展以及应用分子生物学技术对好氧氨氧化菌种群和厌氧氨氧化种群生态学的研究备受人们关注.本文综述了工艺原理和影响因子诸如温度、pH值、氧的可利用性、游离氨浓度等对氨氧化菌及厌氧氨氧化菌的影响,并介绍了应用分子生物学方法对氨氧化菌与厌氧氨氧化菌的类别及分布的研究结果,并对该工艺提出了展望.     

Effects of metal and acidic sites on the reaction by-products of butyl acetate oxidation over palladium-based catalysts

Catalytic oxidation is widely used in pollution control technology to remove volatile organic compounds. In this study, Pd/ZSM-5 catalysts with different Pd contents and acidic sites were prepared via the impregnation method. All the catalysts were characterized by means of N2 adsorption- desorption, X-ray fluorescence （XRF）, HE temperature programmed reduction （H2-TPR）, and NH3 temperature programmed desorption （NH3-TPD）. Their catalytic performance was investigated in the oxidation of butyl acetate experiments. The by-products of the reaction were collected in thermal desorption tubes and identified by gas chromatography/mass spectrometry. It was found that the increase of Pd content slightly changed the catalytic activity of butyl acetate oxidation according to the yield of CO2 achieved at 90%, but decreased the cracking by-products, whereas the enhancement of strong acidity over Pd-based catalysts enriched the by-product species. The butyl acetate oxidation process involves a series of reaction steps including protolysis, dehydrogenation, dehydration, cracking, and isomerization. Generally, butyl acetate was cracked to acetic acid and 2- methylpropene and the latter was an intermediate of the other by-products, and the oxidation routes of typical by-products were proposed. Trace amounts of 3-methylpentane, hexane, 2-methylpentane, pentane, and 2-methylbutane originated from iso4merization and protolysis reactions.     

还原脱氯-生物联合降解2,4-二氯苯氧乙酸

采用Pd/Fe双金属对2,4-二氯苯氧乙酸(2,4-D)进行催化还原脱氯,以活性污泥对2,4-D脱氯产物进行生物氧化,考察初始pH、活性污泥量、污染物初始浓度、温度等因素对生物氧化的影响情况.通过PCR-变性梯度凝胶电泳分析污泥体系菌群变化情况,高效液相色谱测定来推测目标污染物的降解过程.结果表明:1 Pd/Fe双金属可有效还原2,4-D,其主要先还原为2-氯苯氧乙酸(2-CPA),最终顺序脱氯为苯氧乙酸(PA).2 2,4-D具有较大生物毒性,其脱氯产物毒性下降,更易被生物降解.3 pH=7、污泥量50 mL/200 mL、适量的初始PA浓度(14.6 mg·L-1)和30℃均有利于PA的去除.在该条件下反应96 h,PA去除率可达84.3%.