Influence of temperature on the characteristics of aerobic granulation in sequencing batch airlift reactors

Aerobic granular sludge was cultivated in sequencing batch airlift reactors(SBAR) at 25,30,and 35°C,respectively.The effect of temperature on the granules characteristics was analyzed and the microbial community structures of the granules were probed using scanning electron microscope(SEM) and polymerase chain reaction-denaturing gradient gel electrophoresis(PCR-DGGE).The results showed that 30°C is optimum for matured granule cultivation,where the granules had a more compact structure,better settling abili...     

Combined alkaline and ultrasonic pretreatment of sludge before aerobic digestion

Alkaline and ultrasonic sludge disintegration can both be used as pretreatments of waste activated sludge (WAS) for improving the subsequent anaerobic or aerobic digestion. The pretreatment has been carried out using different combination of these two methods in this study. The effect was evaluated based on the quantity of soluble chemical oxygen demand (SCOD) in the pretreated sludge as well as the degradation of organic matter in the following aerobic digestion. For WAS samples with combined pretreatment, the released COD was in high level than those with ultrasonic or alkaline treatment. When combined with the same ultrasonic treatment, NaOH treatment resulted in more solubilization of WAS than Ca(OH)2. For combined NaOH and ultrasonic treatments with different sequences, the released COD were in the order: simultaneous treatment > ultrasonic treatment following NaOH treatment > NaOH treatment following ultrasonic treatment. For simultaneous treatment, low NaOH dosage (100 g/kg dry solid), short duration (30 min) of NaOH treatment, and low ultrasonic specific energy (7 500 kJ/kg dry solid) were beneficial for sludge disintegration. Using combined NaOH and ultrasonic pretreatment with the optimium parameters, the degradation efficiency of organic matter was increased from 38.0% to 50.7%, which is much higher than with ultrasonic (42.5%) or with NaOH pretreatment (43.5%) in the subsequent aerobic digestion at the same retention time.     

钙镁磷肥生产富氧空气助燃节能可行性分析

介绍了钙镁磷肥传统生产方法,分析了钙镁磷肥高炉富氧空气助燃的可行性,认为该方法可行。     

组合人工湿地对城镇污水处理厂尾水中有机物的去除特征研究

采用物理分级和三维荧光光谱法,研究了组合人工湿地对城镇污水处理厂尾水中不同形态有机物的去除特征.结果表明,组合人工湿地对污水处理厂尾水具有较好的深度处理效果,出水水质基本可以达到国家地表水环境质量标准(GB38382-2002)Ⅲ或Ⅳ类水标准.组合人工湿地处理系统对尾水中CODCr和BOD5总体去除率分别达到35.2%和44.3%,对尾水中总有机碳(TOC)、溶解性有机碳(DOC)、颗粒有机碳(POC)的平均去除率分别为46.9%、45.9%、48.3%.组合人工湿地系统不同单元对尾水中有机物的去除贡献率存在差异,其中,潜流湿地单元对尾水中CODCr和BOD5及其不同组分有机碳的去除效率较高.试验期间,由于藻类滋生,表流湿地单元出水中有机物含量波动较大,去除效果明显降低,藻类被打捞后,出水水质明显改善.三维荧光光谱分析结果显示,各个处理单元取样点的水样三维荧光光谱均出现4个明显的荧光峰.人工湿地各单元出水溶解性有机质(DOM)中,类蛋白和类腐殖酸物质含量较高,类富里酸物质含量较低.人工湿地对类蛋白和类腐殖酸物质有较强的去除作用.     

Selective removal of 2,4-dichlorophenoxyacetic acid from water by molecularly-imprinted amino-functionalized silica gel sorbent

A molecularly-imprinted amino-functionalized sorbent for selective removal of 2,4-dichlorophenoxyacetic acid(2,4-D) was prepared by a surface imprinting technique in combination with a sol-gel process.The 2,4-D-imprinted amino-functionalized silica sorbent was characterized by FT-IR,nitrogen adsorption and static adsorption experiments.The selectivity of the sorbent was investigated by a batch competitive binding experiment using an aqueous 2,4-D and 2,4-dichlorophenol(2,4-DCP) mixture or using an aqueous 2...     

汽油车非常规污染物排放特性研究

选择3种不同排量的典型汽油车,基于国Ⅲ标准的轻型车排放测试循环,用SKC采样泵和2, 4-DNPH、Tenax TA采样管采集尾气中的非常规污染物,利用高效液相色谱仪和热脱附气相色谱质谱联用仪分析汽油车排放中醛酮类化合物和挥发性有机物的组成及含量,同时利用电子低压冲击仪研究了其颗粒物排放的粒径和质量浓度分布特征.结果表明,不同汽油车之间非常规污染物的比排放值有较大差异,3辆汽油车总醛酮比排放量分别为36.44、 16.71、 10.43 mg/km,TVOC分别为155.39、 103.75、 42.29 mg/km.排放的醛酮化合物中甲醛、乙醛、丙烯醛、丙酮和环己酮的检出含量较高,占总醛酮量的77.9%～89.7%,且绝大部分为有毒有害物质;废气中挥发性有机物绝大部分为芳香烃和烷烃,分别占总数的31.6%～39.2%和23.1%～27.9%,其中又以芳香烃类化合物甲苯、二甲苯和苯的检出含量最高,平均占TVOC的16.68%、 16.87%和5.23%;其颗粒物排放以超细颗粒物（<100nm）为主,高速工况下排放的颗粒物明显多于低速和中速工况.     

紫外光降解反应器去除氯苯气体模型的建立与应用

从光化学反应过程出发,基于线性光源球面辐射能量分布（LSSE）,以反应器内部空间的辐射能吸收密度、空塔停留时间、进口浓度等为主要参数,建立了气相环境中紫外光化学反应器去除氯苯的数学模型.结果表明,建立的模型能很好地模拟和预测紫外光化学反应器对氯苯气体的去除性能.氯苯气体的紫外光化学反应表现出一级反应动力学的特征.该模型包含了紫外光降解反应器设计的主要参数,同时被用于预测了反应器在不同进口浓度和不同空塔停留时间条件下的出口氯苯浓度,进而获得不同进口浓度达标排放所需要的最小空塔停留时间,为气相污染物的紫外光降解反应器的设计与运行提供了重要的理论指导.     

EGSB反应器中实现完全自营养脱氮与运行优化

同时接种好氧氨氧化污泥和厌氧氨氧化污泥启动EGSB反应器,培养完全自营养脱氮颗粒污泥,总氮去除速率达0.101 kg·(m³·d)^-1.基于边界层假设模拟颗粒污泥与液相主体间的传质过程,并将其与颗粒污泥内传质过程以及好氧氨氧化、厌氧氨氧化和亚硝酸盐氧化过程相耦合,建立了颗粒污泥完全自营养脱氮模型,应用实验结果对模型进行了验证.根据模拟结果对EGSB反应器运行条件进行优化,总氮平均去除效率由52%提高到61%,平均去除速率由0.103 kg·(m³·d)^-1提高到0.114 kg·(m³·d)^-1.     

A2/O工艺中好氧污泥絮体的分形结构与理化特征分析

采用图像法和沉降柱法分别研究了A²/O工艺中好氧污泥絮体的形貌、粒度分布、低维分形维数和沉降速率、有效密度、空隙率以及质量分形维数,并尝试探讨了上述相关性质与这些污泥宏观操作性质(沉降、压缩、脱水和稳定性)相关的各种理化指标以及胞外高分子物质(EPS)的含量之间的变化关系.结果表明,污泥絮体呈现不规则的形貌,表面具有空隙.其有效密度一般随着其粒径的增加而降低,而空隙率和沉降速率却呈现与有效密度相反的变化趋势,这些均表明了污泥絮体的分形结构的存在.2次所采集的污泥絮体的中位直径分别为248.81、 332.86 μm,有效密度的平均值分别为0.004 0、 0.007 2 g·cm^-3,自由沉降速率的平均值分别为2.67、 4.79　mm·s^-1,空隙率的平均值分别为0.94、 0.89,一维分形维数分别为1.03、 1.19,二维分形维数分别为1.64、 1.84,采用基于Logan经验公式的有效密度-最大直径的双对数关系确定的质量分形维数分别为1.74、 2.29.尽管第2次所采集的污泥絮体较为密实,但其表面粗糙程度却比第1次的低.此外,研究中发现絮凝能力较高或负电荷较高的A²/O好氧污泥絮体具有高的SVI和ZSV值;分形维数较低的污泥具有高的剪切敏感性和低絮体强度,相应的污泥稳定性低;EPS总量高的污泥脱水性能差,EPS中蛋白质含量高的污泥其表面电荷也较高.     

温度对好氧颗粒污泥吸附铅离子的影响

由活性污泥培养得到好氧颗粒污泥,研究了温度对好氧颗粒污泥吸附Pb²⁺的影响.结果表明,好氧颗粒污泥主要含有C、H、N、O、P等元素,其经验结构式为C_5.7H_10.9O3.9NS_0.04.好氧颗粒污泥表面主要由球状细菌组成,具有明显的孔隙结构.在20～40℃时,Pb²⁺在好氧颗粒污泥上的吸附过程可以由Langmuir和Freundlich等温方程进行拟合（R²>0.914）.Pb2+最大吸附量Qmax由80.65 mg·g-1（20℃）增至97.09　mg·g-1（40℃）.吸附过程的表观自由能变ΔG<0、 ΔH>0、 ΔS>0,表明Pb2+在好氧颗粒污泥表面的吸附为吸热、熵增的自发过程.红外扫描分析(FTIR)结果表明,吸附过程Pb2+主要与—OH、蛋白质中的—COOH以及PO发生作用,与含氮官能团无关.