高中速过滤器的选择

介绍了高中速过滤器的应用环境、工作原理和结构组成,并从结构组成及工艺环境和实际应用性价比方面,提出实际工作时选择高中速过滤器的注意事项。     

V_2O_5-TiO_2离子存储电极薄膜的溶胶-凝胶法制备与性能研究

利用无机溶胶-凝胶技术制备了V2O5-（TiO2）x离子存储电极薄膜。采用X射线衍射（XRD）、原子力显微镜（AFM）、Raman光谱、循环伏安法（CV）和紫外-可见光透射光谱分别研究了复合薄膜的微观结构、化学计量、锂离子注入性能以及光学性能。结果表明复合薄膜具有V2O5的层状结构,其c轴方向的结构取向性有所降低;颗粒尺寸和表面粗糙度显著减小;同时TiO2的复合导致薄膜中V2O5的化学计量发生偏移,氧空位数量增多。当x=0.2时,薄膜具有相对较高的离子存储容量及循环稳定性,并且在离子注入/脱出状态均获得相当高的可见光透过性。     

Efficacy of two chemical coagulants and three different filtration media on removal of Aspergillus flavus from surface water

Aquatic fungi are common in various aqueous environments and play potentially crucial roles in nutrient and carbon cycling as well as interacting with other organisms. Species of Aspergillus are the most common fungi that occur in water. The present study was undertaken to elucidate the efficacy of two coagulants, aluminum sulfate and ferric chloride, used at different concentrations to treat drinking water, in removing Aspergillusflavus, as well as testing three different filtration media： sand, activated carbon, and ceramic granules, for their removal of fungi from water. The results revealed that both coagulants were effective in removing fungi and decreasing the turbidity of drinking water, and turbidity decreased with increasing coagulant concentration. Also, at the highest concentration of the coagulants, A. flavus was decreased by 99.6% in the treated water. Among ceramic granules, activated carbon, and sand used as media for water filtration, the sand and activated carbon filters were more effective in removing A.flavus than ceramic granules while simultaneously decreasing the turbidity levels in the test water samples. Post-treatment total organic carbon （TOC） and total nitrogen （TN） concentrations in the experimental water did not decrease; on the contrary, TN concentrations increased with the increasing dosage of coagulants. The filtration process had no effect in reducing TOC and TN in tested water.     

Experimental study on filtration and continuous regeneration of a particulate filter system for heavy-duty diesel engines

This study investigated the filtration and continuous regeneration of a particulate filter system on an engine test bench, consisting of a diesel oxidation catalyst（DOC） and a catalyzed diesel particulate filter（CDPF）. Both the DOC and the CDPF led to a high conversion of NO to NO2 for continuous regeneration. The filtration efficiency on solid particle number（SPN） was close to100%. The post-CDPF particles were mainly in accumulation mode. The downstream SPN was sensitively influenced by the variation of the soot loading. This phenomenon provides a method for determining the balance point temperature by measuring the trend of SPN concentration.     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

应用陶粒过滤-陶瓷膜组合对止咳糖浆制药废水深度处理的试验研究

止咳精浆制药废水经生物接触氧化一体化废水处理装置处理后,其出水中COD、BOD和氨氮等主要污染物质均不能达标排放.在实验室中采用陶粒过滤-陶瓷膜组合对经一体化处理装置处理后的制药废水进行深度处理,在陶粒柱反应器选用粒径为1～2 mm的陶粒滤料,陶瓷膜反应器选用孔径为2～3/μm陶瓷膜的条件下对水样进行测试.废水经陶粒过滤-陶瓷膜组合处理后,其BOD、COD、SS和氨氮指标均可稳定达标排放.     

薄膜扩散梯度技术在重金属生物有效态监测中的应用

重金属生物有效性是评估重金属元素迁移性、生物可利用性和生态影响的关键参数。薄膜扩散梯度技术(DGT)是一种原位被动采样技术,因其具有原位富集性、形态选择性,可提供被监测物质在监测时间段内的平均浓度等优点,可作为生物对重金属摄取的模拟替代物对环境介质中重金属的生物可利用度进行预测,已被广泛应用于环境介质中重金属生物有效性的测定。研究主要介绍了DGT技术的原理、组成和特点,评述了其近年来在水体、土壤、沉积物中重金属生物有效态应用方面的新进展,提出了DGT技术未来要提高抗生物污染能力及寻找可与DGT技术联用的相关技术的观点。     

含碳纳米TiO2光催化降解甲醇

采用管式光催化反应器,在石英玻璃管壁上涂镀含碳纳米TiO2薄膜,研究含碳纳米TiO2对甲醇气体的光催化降解性能。实验结果表明：随气体流量增加,甲醇降解率呈线性降低;在气体流量为200mL／min、相对湿度为40％、甲醇初始质量浓度为90～170mg／m^3的较佳条件下,甲醇降解率维持在80％以上,最高达85％;在甲醇初始质量浓度为150mg／m^3、气体流餐为200mL／min、相对湿度为40％的条件下,德国Degusa—P25光催化剂对甲醇的平均降解率为89％,含碳纳米TiO2对甲醇的平均降解率为82％,最人降解率为85％。     

Fe3+掺杂TiO2薄膜的制备及光催化降解甲醛的研究

采用溶胶-凝胶法制备Fe3+掺杂的TiO2薄膜光催化剂,进行甲醛的光催化实验,考察Fe3+掺杂量、薄膜焙烧温度及溶胶体系pH值对光催化性能的影响。结果表明,Fe3+掺杂量为1.0%,焙烧温度500℃1h,加硝酸溶胶体系pH=4时,Fe3+掺杂TiO2薄膜光催化活性最高。     

Mass transport model of ions within biofilms under the effect of external field

A mass transport model was developed to predict the transport rate of ions within biofilms, which was experimentally verified using the fluxes of NH4^＋ and Ca^2＋ through the heterotrophic biofilms with the thickness varying from 230 to 1430μm under the effect of external field in the range of-20 V/m to 60 V/m. It is found that the result predicted by the model is in agreement with the experimentally obtained one, with the error less than 5 percent for the thin biofilms. The error increases with the increase of the biofilm thickness. The transport rate of ions caused by electric migration is affected by the charges, field strength, and biofilm thickness and so on.