用TRIZ解决水循环冷却系统管路爆裂

工业生产过程中,由于工件热处理后,为改变其性能或提高效率,需要对热处理后的工件进行冷却。冷却方式常采用自然风冷、油浸冷却和水循环冷却。冷却系统在生产过程中,常因各车间液体循环系统压力不均衡,引起爆管现象,影响正常生产。     

主成分分析法在水环境质量评价中的应用进展

对研究水质的一种多元统计方法——主成分分析法做了详细介绍,并对主成分分析法在河流、地下水、矿区、湖泊水质评价中的应用进行了综述,简要分析了主成分分析法在水环境质量评价中尚有不足之处。     

响应面法优化厌氧上清液除磷的研究

在用铁盐对厌氧段富磷上清液进行化学磷沉淀以实现磷的回收和达标排放的SBR系统中,为了减少铁盐化学除磷残余物可能对生物处理系统的影响,采用Box-Benhnken中心组合试验原理和响应面分析法,选择Fe:P、混凝搅拌强度、絮凝搅拌强度、搅拌时间等为自变量,残余铁离子为响应值,研究自变量之间的交互作用,以期优化化学除磷条件.通过Design-Expert 8.0软件得到1个二次响应曲面模型.得出最佳除磷条件:Fe:P比为1.40:1,搅拌强度为275r/min,快速搅拌时间为30s,絮凝搅拌强度为60r/min,絮凝时间为18min,沉淀时间为20min.在此条件下,化学混凝后残余铁离子浓度为0.37mg/L,化学除磷率大于97.66%.     

Reduction and characterization of bioaerosols in a wastewater treatment station via ventilation

Bioaerosols from wastewater treatment processes are a significant subgroup of atmospheric aerosols. In the present study,airborne microorganisms generated from a wastewater treatment station(WWTS) that uses an oxidation ditch process were diminished by ventilation.Conventional sampling and detection methods combined with cloning/sequencing techniques were applied to determine the groups,concentrations,size distributions,and species diversity of airborne microorganisms before and after ventilation. There were 3021 ± 537 CFU/m3 of airborne bacteria and 926 ± 132 CFU/m3 of airborne fungi present in the WWTS bioaerosol.Results showed that the ventilation reduced airborne microorganisms significantly compared to the air in the WWTS. Over 60% of airborne bacteria and airborne fungi could be reduced after4 hr of air exchange. The highest removal(92.1% for airborne bacteria and 89.1% for fungi) was achieved for 0.65–1.1 μm sized particles. The bioaerosol particles over 4.7 μm were also reduced effectively. Large particles tended to be lost by gravitational settling and small particles were generally carried away,which led to the relatively easy reduction of bioaerosol particles0.65–1.1 μm and over 4.7 μm in size. An obvious variation occurred in the structure of the bacterial communities when ventilation was applied to control the airborne microorganisms in enclosed spaces.     

Genotoxicity removal of reclaimed water during ozonation

Genotoxicity in wastewater and reclaimed water now is gaining increased attention because of genotoxins' potential damage to the ecosystem and human health. The effect of ozonation on genotoxicity in reclaimed water was investigated. It was found that ozonation decreased the genotoxicy dramatically in three tertiary treatment plants. In the further batch ozonation experiment in laboratory,secondary effluent sample used exhibited the genotoxicity of(41.1 ± 4.1) μg 4NQO/L. Ozonation with a dose of 10 mg O3/L completely removed the genotoxicity in secondary effluent. However,after ozonation, the dissolved organic carbonvalue of the sample didn't change much but the specific ultraviolet absorbance(SUVA) value dropped sharply. With the help of Fourier transform infrared spectroscopy, ozonation was found to change chemical aliphatic carbon and C–O of the dissolved arganic matter, which might be the reason of the significant decreases of SUVA and genotoxicity.     

Antimony smelting process generating solid wastes and dust：Characterization and leaching behaviors

A large amount of solid waste has been produced by the antimony smelting process in the＂World Capital of Antimony＂, Xikuangshan area in China. This study comprehensively investigated the physical and chemical characteristics of the various solid wastes, as well as the leaching behavior of the solid wastes, which included water-quenched slag,arsenic-alkali residue, desulfurized slag and blast furnace dust. These four types of waste were enriched in a variety of heavy metals and metalloids and more specifically with As and Sb levels up to 8.6 × 104 and 3.16 × 105mg/kg, respectively, in arsenic-alkali residue. For desulfurized slag and water-quenched slag, the leaching concentration of Sb significantly exceeded the acceptable limits during the leaching tests using the toxicity characteristic leaching procedure and the synthetic precipitation leaching procedure. In addition, As leaching in arsenic-alkali residue was extraordinarily hazardous, being three orders of magnitude higher than the regulatory level of As. According to the results of the extraction tests, all the tested wastes were classified as hazardous waste.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Fouling distribution in forward osmosis membrane process

Fouling behavior along the length of membrane module was systematically investigated by performing simple modeling and lab-scale experiments of forward osmosis （FO） membrane process. The flux distribution model developed in this study showed a good agreement with experimental results, validating the robustness of the model. This model demonstrated, as expected, that the permeate flux decreased along the membrane channel due to decreasing osmotic pressure differential across the FO membrane. A series of fouling experiments were conducted under the draw and feed solutions at various recoveries simulated by the model. The simulated fouling experiments revealed that higher organic （alginate） fouling and thus more flux decline were observed at the last section of a membrane channel, as foulants in feed solution became more concentrated. Furthermore, the water flux in FO process declined more severely as the recovery increased due to more foulants transported to membrane surface with elevated solute concentrations at higher recovery, which created favorable solution environments for organic adsorption. The fouling reversibility also decreased at the last section of the membrane channel, suggesting that fouling distribution on FO membrane along the module should be carefully examined to improve overall cleaning efficiency. Lastly, it was found that such fouling distribution observed with co-current flow operation became less pronounced in counter- current flow operation of FO membrane process.     

Arsenic removal from groundwater by acclimated sludge under autohydrogenotrophic conditions

Arsenic in the environment is attracting increasing attention due to its chronic health effects. Although arsenite(As(III)) is generally more mobile and more toxic than arsenate(As(V)), reducing As(V) to As(III) may still be a means for decontamination, because As(III) can be removed from solution by precipitation with sulfide or by adsorption or complexation with other metal sulfides. The performance of As(V) bio-reduction under autohydrogenotrophic conditions was investigated with batch experiments. The results showed that As(V) reduction was a biochemical process while both acclimated sludge and hydrogen were essential. Most of the reduced arsenic remained in a soluble form, although 20% was removed with no addition of sulfate, while 82% was removed when sulfate was reduced to sulfide. The results demonstrated that the reduced arsenic was re-sequestered in the precipitates, probably as arsenic sulfides. Kinetic analysis showed that pseudo first-order kinetics described the bio-reduction process better than pseudo second-order. In particular, the influences of pH and temperature on As(V) reduction by acclimated sludge under autohydrogenotrophic conditions and total soluble As removal were examined. The reduction process was highly sensitive to both pH and temperature, with the optimum ranges of pH 6.5–7.0 and 30–40°C respectively. Furthermore, Arrhenius modeling results for the temperature effect indicated that the As(V) reduction trend was systematic. Total soluble As removal was consistent with the trend of As(V) reduction.     

印染前处理节能减排评价模型的建立及应用

针对目前印染前处理工艺,依据评价指标的原则,采用层次分析法从资源指标、环境指标、生产指标及经济指标4个方面建立了印染前处理工艺节能减排综合评价指标体系;提出了基于AHP-Fuzzy方法上的前处理工艺节能减排效果综合评价模型。最后,将该模型应用到印染前处理新工艺中,根据对新工艺相关节能减排指标的监测、核算以及调查,依照隶属函数值计算方法,得到其模糊评价矩阵及其向量,其结果表明,新工艺的节能减排综合评价等级为"优",节能减排效果很好。