氟虫腈对斑马鱼和小菜蛾毒性的手性选择性研究

手性农药分子的不同对映体在环境中的降解速率和对于生物的毒性可能存在很大的差异,因此拆分并使用对靶标生物毒性较高或对非靶标生物毒性较低的单一或浓缩的对映体配方可以有效地降低杀虫剂的环境风险.本文用手性柱拆分了一种广泛使用的手性农药,氟虫腈的两种对映体,研究了这两种对映体和消旋体对靶标生物小菜蛾和非靶标生物斑马鱼的急性毒性.结果表明氟虫腈对受试靶标和非靶标生物的毒性均无手性选择性,说明无法通过对氟虫腈进行手性拆分并使用单一对映体配方来降低氟虫腈的环境风险.这一结论间接支持了农业部新近出台的禁止氟虫腈用于防治农田害虫的政策.     

我国火电行业NO_x排放现状及烟气脱氮技术发展

介绍了我国火电行业NOx的排放现状以及部分烟气脱氮技术的研究和应用现状,分析了脱氮技术存在的问题和发展方向。     

Synthesis, characterization, and adsorption performance of Pb（Ⅱ）-imprinted polymer in nano-TiO2 matrix

Surface ion-imprinted in combination with sol-gel process was applied to synthesis a new Pb(II)-imprinted polymer for selective separation and enrichment of trace Pb(II) from aqueous solution. The prepared material was characterized by using the infrared spectra, X-ray di ractometer, and scanning electron microscopy. The batch experiments were conducted to study the optimal adsorption condition of adsorption trace Pb(II) from aqueous solutions on Pb(II)-imprinted polymer. The equilibrium was achieved in approximately 4.0 h, and the experimental kinetic data were fitted the pseudo second-order model better. The maximum adsorption capacity was 22.7 mg/g, and the Langmuir equation fitted the adsorption isotherm data. The results of selectivity experiment showed that selectively adsorbed rate of Pb(II) on Pb(II)-imprinted polymer was higher than all other studied ions. Desorption conditions of the adsorbed Pb(II) from the Pb(II)-imprinted polymer were also studied in batch experiments. The prepared Pb(II)-imprinted polymer was shown to be promising for the separation and enrichment of trace Pb(II) from water samples. The adsorption and desorption mechanisms were proposed.     

Evaluation of mercury speciation and removal through air pollution control devices of a 190 MW boiler

Air pollution control devices (APCDs) are installed at coal-fired power plants for air pollutant regulation. Selective catalytic reduction (SCR) and wet flue gas desulfurization (FGD) systems have the co-benefits of air pollutant and mercury removal. Configuration and operational conditions of APCDs and mercury speciation a ect mercury removal e ciently at coal-fired utilities. The Ontario Hydro Method (OHM) recommended by the U.S. Environmental Protection Agency (EPA) was used to determine mercury speciation simultaneously at five sampling locations through SCR-ESP-FGD at a 190 MW unit. Chlorine in coal had been suggested as a factor a ecting the mercury speciation in flue gas; and low-chlorine coal was purported to produce less oxidized mercury (Hg2+) and more elemental mercury (Hg0) at the SCR inlet compared to higher chlorine coal. SCR could oxidize elemental mercury into oxidized mercury when SCR was in service, and oxidation e ciency reached 71.0%. Therefore, oxidized mercury removal e ciency was enhanced through a wet FGD system. In the non-ozone season, about 89.5%–96.8% of oxidized mercury was controlled, but only 54.9%–68.8% of the total mercury was captured through wet FGD. Oxidized mercury removal e ciency was 95.9%–98.0%, and there was a big di erence in the total mercury removal e ciencies from 78.0% to 90.2% in the ozone season. Mercury mass balance was evaluated to validate reliability of OHM testing data, and the ratio of mercury input in the coal to mercury output at the stack was from 0.84 to 1.08.     

耦合式SCR还原剂供给调节装置及控制技术的研究与应用

阐述了SCR喷氨调节控制常用的方法及存在的问题,提出了一种新型耦合式SCR还原剂供给调节装置及控制技术,并通过电厂实际案例对该调节装置与控制技术进行了说明。研究结果表明:该调节装置及控制技术可使脱硝效率相对稳定、出口NO_x的浓度不超标、喷氨不过量。     

水合氧化铁的制备及其吸附性能研究

采用恒pH沉淀法,以NaOH溶液为沉淀剂,在溶液pH为3~9的范围内制得4种水合氧化铁(即水铁矿,Fh)。通过XRD、表面零电荷时pH(pHPZC)的测定、N2吸附-脱附对其进行了表征。研究了溶液pH对Fh的甲基橙去除率的影响。表征结果显示:4种Fh均为2-线Fh;它们的pHPZC为6.7~7.9;溶液pH为5,7,9时制备的Fh(Fh5,Fh7,Fh9)的N2吸附-脱附曲线均为IUPAC定义的第Ⅲ种类型。实验结果表明:4种Fh均在溶液pH为4时对甲基橙去除率最高;当甲基橙初始质量浓度为30 mg/L时,Fh5对甲基橙的去除率最高,为92.8%。Langmuir方程更适合描述Fh5对甲基橙的吸附行为,甲基橙在Fh5上产生单分子层吸附,该吸附是自发、放热的物理吸附过程。     

响应曲面法优化镍转炉渣氧压选择性浸出工艺

为了优化镍转炉渣加压条件下H₂SO₄选择性浸出Co、Ni、Cu,抑制Fe浸出的工艺,采用响应曲面法的中心组合设计原理,建立影响选择性浸出率的二次多项式数学模型,研究浸出温度、c(H₂SO₄)及液固比及上述因素两两交互作用对提高Co、Ni、Cu浸出率及减少Fe浸出率的影响规律. 结果表明:浸出温度和c(H₂SO₄)对浸出率影响最显著,液固比次之. c(H₂SO₄)越高,Co、Ni、Cu和Fe的浸出率越高,而提高浸出温度有利于降低Fe浸出率. 响应曲面法优化获得的最佳工艺条件:浸出温度为210 ℃、c(H₂SO₄)为0.38 mol/L、液固比为4.25 mL/g,在该条件下,Co和Ni的浸出率均大于98%,Cu浸出率大于96%,Fe浸出率小于0.4%. 浸出控制参数优化后提高了有价金属的浸出率,同时也降低了Fe浸出率,实现了镍转炉渣中有价金属的回收及其与Fe的高效分离.      

磷酸铵镁沉淀法去除垃圾渗滤液中氨氮的实验研究

本试验采用磷酸铵镁沉淀法（MAP）处理垃圾渗滤液中的高浓度氨氮,采用MgCl2.6H2O和Na2HPO4.12H2O为沉淀剂,研究了该方法脱氮的主要影响因素并得出了最佳处理条件,即在室温条件时,pH值为10～10.5、反应摩尔比n（Mg2＋）：n（NH4＋）：n（PO43-）为1.2：1.0：0.9时,对于本试验中的垃圾渗滤液来说,为最佳反应条件,对氨氮的去除率可达到97%以上,达到国家杂用水水质标准中对氨氮的要求。     

氨氮测试预处理中滤纸洗涤方法的比较

纳氏试剂比色法或水杨酸-次氯酸盐比色法测定较清洁和稍混浊水样中的氨氮时,需用絮凝沉淀法进行预处理,在处理中要用经无氨水充分洗涤的中速滤纸过滤。滤纸中常含较多的氨和某些干扰物,需经多次洗涤将其除去,以减少对测试结果的影响。这在大批量水样测试中非常费时费事。今试验出一种“浸泡洗涤法”,取得了较好的效果。     

以堇青石蜂窝陶瓷为载体的新型钒氧化物脱氮催化剂研究

以TiO₂/Al₂O₃/堇青石蜂窝陶瓷为载体,以V₂O₅-MoO₃-WO₃为活性组分,用于氨法选择性催化还原烟气中NO的新型催化剂,并对该催化剂的活性性能和微观结构进行了评价和表征.同时,将该催化剂的活性性能与其它几种活性组分相同但载体、制备方法、结构不同的催化剂进行了对比.对比结果表明,该新型催化剂能取得最好的选择性催化还原氮氧化物催化性能BET、FT IR、XPS表征实验结果表明,其高催化活性得益于大比表面积及大孔体积,而TiO₂/Al₂O₃/堇青石蜂窝陶瓷载体及其制备方法对获得好的催化剂构型起了至关重要的作用.