纳米铁强化的混凝-沉淀-过滤工艺对典型印染废水中有机物去除

以东江流域某典型印染企业尾水为研究对象,将混凝剂与少量的纳米铁进行复合投加,再结合多介质过滤器对印染尾水进行深度处理实验研究.结果表明,新型混凝剂HPAC-9对极性有机物具有较强的去除能力,但对非极性或弱极性有机物去除效果不很理想.通过将纳米铁与HPAC-9复合投加并结合多介质过滤工艺,对印染企业尾水中的有机污染物进行...     

己内酰胺生产废水的铁碳微电解深度处理与机理研究

采用铁碳微电解方法对己内酰胺生产废水进行深度处理,探讨了pH值、停留时间、铁碳质量比对处理效果的影响。在pH为4、停留时间为120 min、铁碳质量比为4的最佳处理条件下,COD去除率可达57.8%,色度去除率可达68.4%。微电解对己内酰胺废水的作用主要通过铁的絮凝作用,处理过程中的酸性条件、微电解的氧化还原和电场作用,从而提高其去除效率。     

Preparation and coagulation efficiency of polyaluminium ferric silicate chloride composite coagulant from wastewater of high-purity graphite production

The aim of the present work was to produce a polyaluminium ferric silicate chloride (PAFSiC) coagulant from acidic and alkaline wastewater of purifying graphite by roasting, and subsequently to evaluate coagulation efficiency of the reagent by treating surface water from the Yellow River as well as municipal wastewater in comparison with the conventional coagulant polyaluminium chloride (PAC). The PAFSiC coagulant was prepared by co-polymerization. The effects of (Al+Fe)/Si molar ratio, OH/(Al+Fe) molar ratio (i.e., value), coagulant dosage and pH value of test suspension on the coagulation behavior of FAFSiC and the stability of the PAFSiC were also examined. Results showed that PAFSiC performed more efficiently than PAC in removing turbidity, chemical oxygen demand (COD), and total phosphate (TP). The PAFSiC with a value of 2.0 and (Al+Fe)/Si ratio of 5 (PAFSiC 2.0/5) showed excellent coagulation effect for both turbidity and COD, while PAFSiC 1.0/5 was the best for TP. The optimum coagulation pH range of PAFSiC 2.0/5 was 5.0–9.0, slightly wider than that of PAC (6.0–8.0). The process can be easily incorporated into high-purity graphite production plants, thereby reducing wastewater pollution and producing a valuable coagulant.     

Roles of manganese oxides in degradation of phenol under UV-Vis irradiation: Adsorption, oxidation, and photocatalysis

The effect of crystal structure on photocatalytic activities of manganese oxides and underlying reaction mechanism were investigated.     

La-Co-Fe-Cu/HZSM-5在尾气碳颗粒燃烧中的催化性能

采用柠檬酸络合低温浸渍法制备分子筛负载钙钛矿型复合氧化物催化剂。采用XRD、SEM和H2-TPR等手段对催化剂性能进行表征,并在微型固定床反应器中对催化剂进行活性评价。结果表明,在钙钛矿型复合氧化物中进行B位离子掺杂,可以改善催化活性,碳颗粒燃烧温度降低。在20%LaCoO3/HZSM-5催化剂中用铁离子部分取代钴离子可以改善碳颗粒的燃烧性能,取代量增加碳颗粒燃烧温度降低,但是生成CO2的选择性也降低,以20%LaCo0.2Fe0.8O3/HZSM-5为催化剂,Tig、Tm和Tf分别为256℃、399℃和403℃,但生成CO2的选择性只有72.5%。在20%LaCo1-xFexO3/HZSM-5中的钙钛矿型复合氧化物B位离子中加入铜离子后,在碳颗粒燃烧反应中生成CO2的选择性得到明显改善,Sco2提高10个单位以上。以20%LaCo0.2Fe0.6Cu0.2O3/HZSM-5为催化剂,在碳颗粒燃烧反应中生成CO2的选择性可以达到94.7%,Tig、Tm和Tf分别为242℃、427℃和445℃。     

吸附树脂负载铁酞菁催化降解硝基苯的研究

在可见光照射下,采用吸附树脂负载铁酞菁催化过氧化氢降解硝基苯.考察了光照、催化剂投加量、双氧水投加量、温度及pH值等因素对催化效果的影响.结果表明,在功率为50W卤钨灯照射下,硝基苯溶液初始质量浓度为200 mg/L,初始pH值为3,催化剂投加量为1.5 g/L,双氧水投加量为1.0 mL/L,温度为35℃下反应10h,硝基苯去除率可达到79.9％.     

再生铝项目环境影响评价重点

再生铝生产在国内铝工业中占有重要位置,也是国内鼓励发展循环经济的重点项目之一。在环境保护越来越受到重视的形势下,正确把握环境污染问题对促进再生铝经济稳定有序发展,保护生态环境十分重要。文章结合再生铝生产特征,对其环境影响评价重点予以概要性的阐述。     

聚硅酸对不同形态铝沉积行为的影响

针对给水管网中残余铝沉积和再溶解现象可能引起的水质问题,研究了聚硅酸对不同水解聚合形态铝沉积、再溶解的影响,并以石英微晶天平为表征手段,初步探讨了聚硅酸对不同形态铝沉积、再溶解过程影响的机理.结果表明,聚硅酸能显著改变不同水解聚合形态铝的沉积、再溶解行为.聚硅酸可与3种水解聚合形态的铝迅速结合而生成可沉积产物,但产物性质不同.以单体形态为主的Al_0与聚硅酸的反应产物性质较稳定,部分以溶解态存在,部分以非溶解态(可沉积态)存在;尽管铝的两种聚合形态Al_(13)和Al_(30)与聚硅酸反应也生成了部分可沉积产物,但随着时间的推移,这些产物又逐渐向溶解态转化.铝硅比对Al_0体系中铝的沉积溶解行为影响较小,而对Al_(13)和Al_(30)影响较大,且在0.2∶20(以Al和SiO_2计的质量比)时,沉积态铝的溶解速率最快.     

Debromination of decabromodiphenyl ether by organo-montmorillonite-supported nanoscale zero-valent iron：Preparation, characterization and influence factors

An organo-montmorillonite-supported nanoscale zero-valent iron material(M-NZVI) was synthesized to degrade decabromodiphenyl ether(BDE-209). The results showed that nanoscale zero-valent iron had good dispersion on organo-montmorillonite and was present as a core-shell structure with a particle size range of nanoscale iron between 30–90 nm, characterized by XRD, SEM, TEM, XRF, ICP-AES, and XPS. The results of the degradation of BDE-209 by M-NZVI showed that the efficiency of M-NZVI in removing BDE-209 was much higher than that of NZVI. The efficiency of M-NZVI in removing BDE-209 decreased as the pH and the initial dissolved oxygen content of the reaction solution increased, but increased as the proportion of water in the reaction solution increased.     

铁锰复合氧化物吸附活性黑染料的性能研究

采用高锰酸钾和硫酸亚铁反应制备铁锰复合氧化物,考察其吸附活性黑染料过程中的影响因素,并比较原位生成的和提前制备的铁锰复合氧化物的吸附性能。结果表明:铁锰复合氧化物对活性黑有较强的吸附能力,吸附过滤之后的去除率较高;染料废水中的硫酸根离子会降低去除率,而氯离子则无明显影响;染料废水的pH值对去除效果的影响较小;原位生成的铁锰复合氧化物的吸附容量大于预制的铁锰复合氧化物固体。通过傅里叶—红外光谱(FTIR)表征分析,推测出铁锰复合氧化物中丰富的表面羟基(Mn-OH、FeOOH官能团等)在吸附过程中起到了重要作用。