顶空气相色谱法测定水中苯系物实验研究

采用顶空气相色谱法对水中苯系物的测定方法进行了研究。在研究过程中讨论了盐,顶空平衡温度和平衡时间等因素对测定结果的影响。实验结果表明无机盐的加入可以提高苯系物的响应值,顶空平衡温度和平衡时间分别为60℃和50 min时为最优的实验分析条件。在此实验条件下,苯系物各组分回归方程的线性相关性较为显著。方法的检出限在2.5~5.9μg/L,加标回收率为93.8%～96.8%,相对标准偏差小于14.7%。该方法对于水中苯系物的测定准确、快捷、重现性好。     

2008-2012年包头市空气质量变化分析

本文依据包头市环保局提供的该市每日空气质量实况日均值,对该市2008-2012年空气质量变化,特别是Ⅲ级/轻微污染以上日的天气特点进行了分析。结果表明,近5 a(2008-2012)里,按照国家《环境空气质量标准》(GB3095-1996),包头市空气质量较好,Ⅰ级优天数逐年增多,Ⅲ级/轻微污染以上日逐年减少,本市Ⅲ级/轻微污染以上日的空气质量主要介于Ⅲ级/轻微污染与Ⅲ级/轻度污染之间;包头市Ⅲ级/轻微污染以上日的首要污染物年和季节变化较显著;强沙尘或沙尘暴天气是本市出现严重污染的主要灾害性天气因素。     

新版GB/T28001的主要变化

介绍了GB／T28001—2001标准修订的背景及修订原则,解读了新版标准的主要变化。     

催化剂Ru/ZrO2-CeO2催化湿式氧化苯酚

催化剂Ru/ZrO₂-CeO₂催化湿式氧化苯酚的过程表明,Ru/ZrO₂-CeO₂可以显著提高COD和苯酚去除效果,当反应温度为170℃,压力为3 MPa,反应120 min后,COD和苯酚的去除率分别达到了99％和100％.试验还考察了不同反应条件对苯酚溶液COD去除的影响,并获得了最优的反应条件：温度为170℃,压力为3 MPa,催化剂的投加量为5　g/Ｌ,搅拌速度为500 r/min.通过对中间产物的分析,本研究提出了催化湿式氧化苯酚的简单路径图,认为苯酚首先被氧化成小分子有机酸,接着小分子有机酸被氧化成二氧化碳和水.前一个过程是快速反应,后一个过程中的乙酸氧化是慢速过程,需要在高温下才能完成.乙酸的氧化主要是自由基攻击α碳上的C—H键,先生成甲酸,并最终生成二氧化碳和水.     

低温A/O-MBR工艺启动试验研究

研究了A/O-MBR工艺低温(水温在5~12℃)启动效能,结果表明,低温下A/O-MBR工艺启动迅速,活性污泥的培养驯化时间较短。启动过程中根据出水水质情况,逐渐提高负荷,运行34 d,系统对COD的去除率能达到90%以上,系统对氨氮的去除率能达到96%以上,至稳定运行后氨氮的负荷平均可达到0.419kg/(m3.d),反硝化效果系统去除率基本能稳定在60%左右。     

用GC/MS分析火灾后苯板产生固体废物中的有机物

采用GC/MS方法对某苯板厂火灾后产生的固体废弃物进行检测分析.结果表明,在苯板火灾后产生的固体废弃物中检测出61种化合物,其中被美国EPA列入优先污染物的苯系物、萘和蒽等占总有机物12.2％.     

基于神经网络的生化池能耗预测模型研究

我国城市污水处理的能耗处于较高水平,直接能耗中电耗占60%~90%。为了合理利用电能,以A/O工艺为基础,选取BP神经网络建立能耗预测模型,由入水信息对溶解氧进行预测,为污水处理过程中曝气量的及时调度、有效利用能量提供可靠的决策依据。     

Unregulated emissions from diesel engine with particulate filter using Fe-based fuel borne catalyst

The alteration and formation of toxic compounds and potential changes in the toxicity of emissions when using after-treatment technologies have gained wide attention. Volatile organic compound（VOC）, carbonyl compound and particle-phase polycyclic aromatic hydrocarbon（PAH） emissions were tested at European Steady State Cycle（ESC） to study unregulated emissions from a diesel engine with a fuel-borne catalyst and diesel particulate filter（FBC–DPF）. An Fe-based fuel-borne catalyst was used for this study. According to the results, brake specific emissions of total VOCs without and with DPF were 4.7 and4.9 mg/kWh, respectively, showing a 4.3% increase. Benzene and n-undecane emissions increased and toluene emission decreased, while other individual VOC emissions basically had no change. When retrofitted with the FBC–DPF, total carbonyl compound emission decreased 15.7%, from 25.8 to 21.8 mg/kWh. The two highest carbonyls, formaldehyde and acetaldehyde, were reduced from 20.0 and 3.7 to 16.5 and 3.3 mg/kWh respectively. The specific reactivity（SR） with DPF was reduced from 6.68 to 6.64 mg/kWh. Total particle-phase PAH emissions decreased 66.4% with DPF compared to that without DPF. However, the Benzo[a]pyrene equivalent（BaPeq） with DPF had increased from 0.016 to 0.030 mg/kWh.Fluoranthene and Pyrene had the greatest decrease, 91.1% and 88.4% respectively. The increase of two- and three-ring PAHs with DPF indicates that the fuel-borne catalyst caused some gas-phase PAHs to adsorb on particles. The results of this study expand the knowledge of the effects of using a particulate filter and a Fe-based fuel-borne catalyst on diesel engine unregulated emissions.     

Photocatalytic activity of Fe-doped CaTiO3 under UV-visible light

The photocatalytic degradation of methylene blue（MB） over Fe-doped CaTiO3 under UV-visible light was investigated. The as-prepared samples were characterized using X-ray diffraction（XRD）, scanning electron microscope（SEM） equipped with an energy dispersive spectrometer（EDS） system, Fourier transform infrared spectra（FT-IR）, and UV-visible diffuse reflectance spectroscopy（DRS）. The results show that the doping with Fe significantly promoted the light absorption ability of CaTiO3 in the visible light region. The Fe-doped CaTiO3 exhibited higher photocatalytic activity than CaTiO3 for the degradation of MB.However, the photocatalytic activity of the Fe-doped CaTiO3 was greatly influenced by the calcination temperature during the preparation process. The Fe-doped CaTiO3 prepared at500°C exhibited the best photocatalytic activity, with degradation of almost 100% MB（10 ppm）under UV-visible light for 180 min.     

农田土壤酞酸酯的生物降解及真菌生长动态试验研究

室内模拟研究了农田土壤中酞酸酯(PAEs)含量、土壤基础呼吸量和真菌数量在PAEs降解过程中的变化。试验设对照(CK)、接种(JZ)和补种(BZ)3种处理,补接种的PAEs降解真菌(棒束梗霉属F3、芽枝状枝孢F4和爪哇正青霉F9)以每种2%的接种量加入土中,补种量与接种量相同,补种周期为20 d。结果表明,3种处理对土壤PAEs都有一定的降解作用,但接种和补种处理的土壤中4种复合PAEs总降解率分别比对照处理高出46.53%和51.54%。在试验周期内,补种处理的土壤麦角固醇含量维持在2.5~3.0μg/g,表明真菌数量稳定,而对照处理的土壤麦角固醇含量表现为先升高随后逐渐降低的趋势,60 d时下降到1.9μg/g;3种处理的土壤基础呼吸量也均呈下降趋势。因此,接种真菌可提高土壤PAEs的降解效率,而补种措施是保持土壤中真菌数量稳定的有效方法。