Ti/SnO_2-Sb阳极-空气阴极电催化降解染料废水

为解决电化学法处理高盐染料废水存在的能耗大、成本高等问题,分别采用溶胶-凝胶法和辊压法制备Ti/SnO_2-Sb阳极和空气阴极,构建了Ti/SnO_2-Sb阳极-空气阴极双极体系(TSSA-ADC)。甲基橙(MO)作为高盐染料废水的典型污染物,考察了电流强度、MO浓度、电解液浓度和初始p H对TSSA-ADC体系和TSSA单阳极体系降解MO的影响。结果表明:与TSSA单阳极体系相比,TSSA-ADC体系具有更好的抗有机负荷冲击、抗盐分冲击、抗酸碱波动能力,能够维护酸碱平衡防止硬度离子结垢。最佳反应条件为电流强度为0.030 A,电解液浓度为3%,MO浓度为100 mg/L,初始pH=6。以MO去除率达到98%为基准,TSSA-ADC体系比TSSA体系可节能74.26%。     

焙烧温度对CeO_2(ZrO_2)/TiO_2选择性催化脱硝性能的影响

采用溶胶-凝胶法并以不同温度焙烧制备一系列CeO_2(ZrO_2)/TiO_2(CZT)催化剂,考察了CZT催化剂固相结构、酸量、比表面积等性能与催化活性的关系。采用XRD、BET、NH3-TPD、H2-TPR以及XPS等表征技术对催化剂进行表征。结果表明:焙烧温度为450℃时CZT催化剂具有最高的催化活性,其在240~400℃的温度窗口内活性均高于90%,且具有较好的抗水和抗硫中毒能力。随着焙烧温度的提高,催化剂表面的Ce和Zr原子进入体相晶格且Ce0.5Zr0.5O2向Ce0.75Zr0.25O2转变,导致催化剂的储释氧能力和氧化还原性能降低。另外,锐钛矿和金红石型TiO_2晶粒尺寸的增加,催化剂的有效比表面积和总酸量降低,因此CZT催化活性随着焙烧温度的提高而有所降低。换言之,大的比表面积、良好的氧化还原性能、表面Ce4+的富集以及酸性位的增多均有利于NH3-SCR活性的提高。     

化学实验室事故应急处置对策

分析了化学实验室中的化学品事故类型及典型事故案例,对事故发生的原因进行了剖析,提出了实验室化学品事故应急处置对策。     

基于实时控制技术的CANON工艺稳定性运行

为保证出水水质稳定并提高氨氮去除率,实现CANON工艺的优化,利用SBR反应器进行了基于实时控制技术的CANON工艺稳定性研究.试验过程中,温度控制在30℃±1℃,pH 7~8,通过反应过程中氨氮、硝态氮、亚硝态氮和pH、DO、ORP的变化规律,制定了可行的实时控制策略.结果表明,进水氨氮浓度为917~1 540 mg·L~(-1)时,以6 mg·L~(-1)的剩余氨氮浓度作为控制参数可以满足工艺稳定性的要求,但氨氮传感器存在费用昂贵和误差较大等问题.采用pH、DO和ORP曲线的平台和特征点作为自控参数,可以维持CANON工艺的长期稳定运行,保证氨氮去除率平均维持在99%以上且出水水质稳定.     

利用FeS去除水中硝基苯的试验研究

为研究FeS还原去除硝基苯的性能,采用批次试验的方法,考察了各因素对FeS去除硝基苯性能的影响.结果表明,在初始硝基苯浓度为0.96 mmol·L-1条件下,当FeS用量为1.2 g时,反应180 min后,硝基苯去除率达到90%.初始硝基苯浓度、FeS用量、温度、FeS重复使用次数对硝基苯去除率有较大影响.初始硝基苯浓度在0.74～1.74 mmol·L-1之间变化时,初始硝基苯浓度每增加0.1 mmol·L-1,硝基苯去除率下降4.7%.FeS用量在0.3～1.5 g内变化时,FeS用量每增加0.3 g,硝基苯去除率增加近20%;FeS用量为1.8 g时,硝基苯去除率为100%.温度在10～25℃范围内变化时,温度每升高1℃,硝基苯去除率增加1.6%;温度为30℃时,硝基苯去除率为100%.硝基苯去除率随FeS重复使用次数的增加而下降.转速在10～80 r.min-1内变化时,转速变化对硝基苯去除率的影响较小,硝基苯去除率稳定在75%左右.FeS对模拟化工废水有较好的处理效果,反应60 min后,硝基苯去除率为100%.     

畜禽养殖污染防治的美国经验

近年来,我国畜禽养殖业规模化快速发展,但养殖场环境管理水平普遍较低.在防污治污方面,大部分养殖场缺少干湿分离这一最基本的污染防治措施,由于缺少必要的污染治理投资,绝大多数的养殖场没有建造配套的粪污处理设施.根据2010年污染源普查动态更新结果,农业源化学需氧量(COD)排放总量为1204万吨,约占全国COD排放总量的47.6％.其中,畜禽养殖排放的COD约占农业源COD排放总量的96％,占全国COD总量的比例达45％.     

Effect of transition metal doping under reducing calcination atmosphere on photocatalytic property of TiO2 immobilized on SiO2 beads

TiO₂ immobilized on SiO₂ (TiO₂/SiO₂) have been prepared by sol-gel method and various ions of transition metals (Cr³⁺, Co²⁺, Ni²⁺, Cu²⁺, and Zn²⁺) were doped on the photocatalyst using wet impregnation method under reducing calcination atmosphere. The photocatalytic activity of metal doped TiO₂/SiO₂ towards phenol degradation under black light irradiation were investigated and compared with undoped TiO₂/SiO₂. The results showed that the photoresponse of Cu²⁺ and Zn²⁺ doped TiO₂/SiO₂ were larger than undoped TiO₂/SiO₂, indicating that the photogenerated carriers were separated more efficiently in Cu²⁺ and Zn²⁺ doped TiO₂/SiO₂. The reactivity was in the order of Cu²⁺ > Zn²⁺ > Ni²⁺ > Cr³⁺ > Co²⁺. The different photoreactivity was ascribed to combine effect of the different ionic radii and photocorrison tendency of the dopants. The sample was also characterized by surface analytical methods such as X-ray diffraction, scanning electron micrograph/electron dispersive X-ray analyzer and UV-Vis absorption spectrum.     

Iron and lead ion adsorption by microbial flocculants in synthetic wastewater and their related carbonate formation

Although microbial treatments of heavy metal ions in wastewater have been studied, the removal of these metals through incorporation into carbonate minerals has rarely been reported. To investigate the removal of Fe^3＋ and Pb^2＋, two representative metals in wastewater, through the precipitation of carbonate minerals by a microbial flocculant （MBF） produced by Bacillus mucilaginosus. MBF was added to synthetic wastewater containing different Fe^3＋ and Pb^2＋ concentrations, and the extent of flocculation was analyzed. CO2 was bubbled into the mixture of MBF and Fe^3＋/Pb^2＋ to initiate the reaction. The solid substrates were analyzed via X-ray diffraction, transmission electron microscopy and energy dispersive spectroscopy. The results showed that the removal efficiency decreased and the MBF adsorption capacity for metals increased with increasing heavy metal concentration. In the system containing MBF, metals （Fe^3＋ and Pb^2＋）, and CO2, the concentrated metals adsorbed onto the MBF combined with the dissolved CO2, resulting in oversaturation of metal carbonate minerals to form iron carbonate and lead carbonates. These results may be used in designing a method in which microbes can be utilized to combine CO2 with wastewater heavy metals to form carbonates, with the aim of mitigating environmental problems.     

Electrochemical and spectroscopic characteristics of dissolved organic matter in a forest soil profile

Dissolved organic matter （DOM） represents one of the most mobile and reactive organic compounds in ecosystem and plays an important role in the fate and transport of soil organic pollutants, nutrient cycling and more importantly global climate change. Electrochemical methods were first employed to evaluate DOM redox properties, and spectroscopic approaches were utilized to obtain information concerning its composition and structure. DOM was extracted from a forest soil profile with five horizons. Differential pulse voltammetry indicated that there were more redox-active moieties in the DOM from upper horizons than in that from lower horizons. Cyclic voltammetry further showed that these moieties were reversible in electron transfer. Chronoamperometry was employed to quantify the electron transfer capacity of DOM, including electron acceptor capacity and electron donor capacity, both of which decreased sharply with increasing depth. FT-IR, UV-Vis and fluorescence spectra results suggested that DOM from the upper horizons was enriched with aromatic and humic structures while that from the lower horizons was rich in aliphatic carbon, which supported the findings obtained by electrochemical approaches. Electrochemical approaches combined with spectroscopic methods were applied to evaluate the characteristics of DOM extracted along a forest soil profile. The electrochemical properties of DOM, which can be rapidly and simply obtained, provide insight into the migration and transformation of DOM along a soil profile and will aid in better understanding of the biogeochemical role of DOM in natural environments.     

铬(Ⅵ)土著还原菌筛选及初步鉴定实验研究

以重铬酸钾为供试物,用固体平板法和还原实验对铬(Ⅵ)土著还原菌进行筛选,用载片培养法、革兰氏染色法、鞭毛染色法、芽孢染色法对还原菌做初步的鉴定,共筛选出16株铬(Ⅵ)土著还原菌,并挑选出还原率相对较高的Z2(35.2%)、Z3(45.2%)、Z4(38.6%)、X8(30.4%)、X10(29.4%)作为铬(Ⅵ)的优势还原菌株。经初步鉴定,土著真菌Z2为黑曲霉(Aspergillusniger),Z3、Z4为镰刀菌属(Fusariumsp.),土著细菌X8、X10为芽孢杆菌(Bacillussp.)。实验的方法和成果将为铬(Ⅵ)污染土壤微生物治理技术的推广应用提供技术支持。