电动技术去除城市污泥重金属的试验研究

采用直流电解污泥反应器,在20V稳定电压作用下进行试验,通过采用蒸馏水和添加电解质的蒸馏水为电极液的两套反应器进行对比试验,测定电动过程中污泥工作区pH值、电压降分布和重金属浓度变化情况,研究电动去除城市污泥中重金属过程中不同污泥工作区的污泥性质的变化及重金属去除效果,并确定了能有效去除污泥中高浓度重金属的有效电动工作区。     

采用体积信息熵表征颗粒污泥系统稳定性及其稳定机制

SBR反应器中培养自养硝化颗粒污泥,在絮体转化为颗粒过程中,颗粒的体积信息熵从2.05(27 d,初见颗粒)降低为1.85(95 d),熵值降低的主要动力来自于松散的絮体在较快沉速选择压条件下被淘洗出系统.当絮体被淘洗出系统即完成颗粒化过程,在129 d时测得系统中颗粒沉速分布的中位数为6.27 m.h-1,因此颗粒体积熵值的变化不再受沉速选择压(6m.h-1)的控制.颗粒的粒径、沉速及体积熵值分布均呈现周期性变化,其中信息熵的均值为2.16,最小值为1.79,最大值为2.63.在这种周期性变化过程中,系统总是表现为粒径均值先增大后减小.熵值的波动的驱动力来自于颗粒的破碎与破碎体的成长,体积分布信息熵的大小可以很好地表征系统的稳定性及其稳定机制.     

SRT影响MBR有机污染物去除速率研究

通过考察污泥停留时间(SRT)对膜生物反应器(MBR)和粉末活性炭膜生物反应器(PAc-MBR)降解有机物速率的影响,探讨了污泥活性与胞外聚合物(EPS)的关系.结果表明:MBR和.PAC-MBR中COD降解速率随SRT延长均呈先上升后下降的趋势,分别在39～48d和48d时达到最快,对应速率常数为2.586和3.856,PAC-MBR中COD降解速率普遍高于MBR,说明投加PAC使污泥活性提高,SRT对污泥活性影响较大;MBR和PAC-MBR中胞外聚合物质量浓度与COD降解速率常数K1变化趋势一致,且胞外聚合物质量浓度与K1呈良好正相关关系,说明系统的胞外聚合物质量浓度可以作为衡量污泥活性的指标.     

脱水污泥等温干燥特性实验研究及回归分析

利用热重差热分析仪（DTG）对脱水污泥进行干燥实验,测定干燥参数和干燥条件对脱水污泥等温干燥特性的影响,研究了3个温度水平（85℃,100℃,120℃）,5个空气流速（10mL/min,20mL/min,40mL/min,50mL/min,70mL/min）和3个升温速率（15℃/min,20℃/min,40℃/min）。结果表明,样品的干燥速率随着终温的升高、升温速率和空气流速的增大而加快。脱水污泥的干燥过程主要分为加速、恒速和降速3个阶段,且降速干燥段在整个干燥过程中所占的比例较大。其干燥数学模型符合Page方程,经拟合得到 。验证表明,拟合方程算得的MR值与实验结果比较接近。该模型方程可用于描述城市污水污泥的干燥。     

氧化沟处理煤矿低浓度生活污水运行控制技术探讨

本文给出了济三煤矿生活污水水量和水质情况,以及采用卡鲁塞尔氧化沟处理该低浓度生活污水的工艺流程和特点。详细描述了实际运行过程中培养和驯化适应低浓度生活污水优势菌种的几个步骤,以及防止和控制污泥膨胀和老化的方法。运行试验结果表明：采用污泥回流比150%、控制氧化沟未端溶解氧（DO）1.5 mg/L,能取得最佳的CODcr去除率和总氮（TN）去除率,分别为76.7%和79.8%。     

好氧颗粒污泥处理青霉素废水研究

青霉素在其生产过中产生大量的废水,其COD值较高,生化性较差,成分复杂,微生物难以降解,其处理技术是世界性难题。文章采用以葡萄糖模拟废水培养的好氧颗粒污泥为接种体,经青霉素废水逐步驯化后,使其完全处理青霉素废水。实验结果表明,应用好氧颗粒污泥技术,处理青霉素废水,COD,NH3_N,TP去除率较高,具有很好的处理效果。     

Arsenic removal from groundwater by acclimated sludge under autohydrogenotrophic conditions

Arsenic in the environment is attracting increasing attention due to its chronic health effects. Although arsenite(As(III)) is generally more mobile and more toxic than arsenate(As(V)), reducing As(V) to As(III) may still be a means for decontamination, because As(III) can be removed from solution by precipitation with sulfide or by adsorption or complexation with other metal sulfides. The performance of As(V) bio-reduction under autohydrogenotrophic conditions was investigated with batch experiments. The results showed that As(V) reduction was a biochemical process while both acclimated sludge and hydrogen were essential. Most of the reduced arsenic remained in a soluble form, although 20% was removed with no addition of sulfate, while 82% was removed when sulfate was reduced to sulfide. The results demonstrated that the reduced arsenic was re-sequestered in the precipitates, probably as arsenic sulfides. Kinetic analysis showed that pseudo first-order kinetics described the bio-reduction process better than pseudo second-order. In particular, the influences of pH and temperature on As(V) reduction by acclimated sludge under autohydrogenotrophic conditions and total soluble As removal were examined. The reduction process was highly sensitive to both pH and temperature, with the optimum ranges of pH 6.5–7.0 and 30–40°C respectively. Furthermore, Arrhenius modeling results for the temperature effect indicated that the As(V) reduction trend was systematic. Total soluble As removal was consistent with the trend of As(V) reduction.     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

UASB处理酒精废水耐冲击特性与颗粒污泥分析

针对UASB耐冲击能力低的问题,采用短暂冲击负荷的方法进行52 d中试研究,并考察接种絮状污泥的UASB对以污冷凝水为主要成分的酒精废水的处理效果,结果表明,UASB呈现较强耐冲击负荷能力;第49天产气速率最高,可达3.03 L/(L·d),反应器内形成了粒径0.5~1.5 mm的颗粒,电镜扫描的颗粒污泥结构致密,由多个杆状细菌形成网状结构。在夏季无保温措施、负荷冲击条件下培养颗粒污泥是可行的。     

剩余污泥微生物燃料电池产电性能的优化试验研究

通过优化阴极材料,构建新型单室无膜壁式空气阴极微生物燃料电池,开展了污泥浓度、阳极面积、导线材料和NaCl离子浓度等影响因素及其优化试验研究。结果显示:在恒温30℃和外接电阻1 000Ω的条件下,以铜线为导线,污泥浓度为21 000 mg/L,阳极面积为31.4 cm2,Na+浓度为200 mmol/L时,其产电性能最佳,最大电压为597 mV,最大输出功率密度为301 mW/m2,内阻为92.5Ω。此外,还分析了污泥运行过程中的变化。与目前其他以未经过预处理的剩余污泥作为底物的微生物燃料电池相比,该新型单室无膜壁式空气阴极微生物燃料电池功率密度较高,内阻较低。