氧化/膜过滤工艺处理屠宰废水研究

研究了二氧化氯(Cl O2)氧化/陶瓷超滤膜过滤工艺对屠宰废水的处理效果,对比不同Cl O2投加量、反冲条件(反冲周期、反冲时间等)对产水指标的影响,确定适宜参数。结果表明:其他条件相同,Cl O2投加量140 mg/L时,氧化单元COD去除率较高;反冲周期50 min、反冲时间50 s时渗透通量恢复较好,陶瓷膜装置运行效果最优,COD和浊度的总去除率分别达93.6%、95.8%,产水水质可达标排放,且运行总成本较低,有较好的工业推广前景。     

电增强零价铁强化厌氧氨氧化处理高氮养猪废水

为解决ZVI(零价铁)电极表面的钝化问题,实现anammox(厌氧氨氧化)工艺稳定、高效地运行,采用EEZVI-UASB(电增强零价铁-升流式厌氧污泥床)技术处理养猪废水,研究了EEZVI电极电压、ρ(COD_Cr)及脱氮贡献率的相关性. 结果表明,在温度为(35±1)℃、pH为6.80～7.10、电极电压为0.60 V的条件下,EEZVI-UASB对NH₄+-N和NO₂--N的去除率均维持在较高的水平;NH₄+-N去除率＞90.00%,NO₂--N去除率＞96.00%,TN平均去除率>90.00%. 当EEZVI电极电压为0.60 V时,AAOB(厌氧氨氧化菌)的活性为91.10 mg/(g·d)(以NH₄+-N计);EEZVI-UASB中的优势功能菌主要为Pseudomonas属,其菌属16S rDNA的PCR扩增相似性达97%;系统中同时存在着反硝化、anammox、甲烷化等反应;其中anammox占主导作用,其对TN去除率的贡献率为54.10%~93.30%,反硝化及其他反应对TN去除率的贡献率为6.70%~45.90%.      

Effect of metal ion-doping on characteristics and photocatalytic activity of TiO2 nanotubes for removal of humic acid from water

The effect of ion-doping on TiO₂ nanotubes were investigated to obtain the optimal TiO₂ nanotubes for the effective decomposition of humic acids (HA) through O₃/UV/ion-doped TiO₂ process. The experimental results show that changing the calcination temperature, which changed the weight fractions of the anatase phase, the average crystallite sizes, the Brunauer-Emmett-Teller surface area, and the energy band gap of the catalyst, affected the photocatalytic activity of the catalyst. The ionic radius, valence state, and configuration of the dopant also affected the photocatalytic activity. The photocatalytic activities of the catalysts on HA removal increased when Ag⁺, Al³⁺, Cu²⁺, Fe³⁺, V⁵⁺, and Zn²⁺ were doped into the TiO₂ nanotubes, whereas such activities decreased as a result of Mn²⁺- and Ni²⁺-doping. In the presence of 1.0 at.% Fe³⁺-doped TiO₂ nanotubes calcined at 550°C, the removal efficiency of HA was 80% with a pseudo-first-order rate constant of 0.158 min⁻¹. Fe³⁺ in TiO₂ could increase the generation of ·OH, which could remove HA. However, Fe³⁺ in water cannot function as a shallow trapping site for electrons or holes.     

Efficient dechlorination of 2,4-dichlorophenol in an aqueous media with a mild pH using a Pd/TiO2NTs/Ti cathode

In this study, palladium-loaded titania nanotubes was fabricated on a titanium plate (Pd/TiO₂NTs/Ti) for efficient electrodechlorination of 2,4-chlorophenol with a mild pH condition. The nature of Pd/TiO₂NTs/Ti electrodes was characterized by field-emission scanning electron microscope (FESEM), X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), and cyclic voltammetry (CV) techniques. The characterization results indicated the generation of Pd⁰ nanoparticles which were evenly dispersed on titania nanotubes arrays on the Pd/TiO₂NTs/Ti surface. An effective degradation efficiency of up to 91% was achieved within 60 min at cathode potential of −0.7 V (vs. SCE) and initial pH of 5.5. The effects of the applied cathode potential and initial pH on the degradation efficiency were studied. A near neutral condition was more favorable since very low and very high pHs were not conducive to the dechlorination process. Furthermore, the intermediates analysis showed that the Pd/TiO₂NTs/Ti electrode could completely remove chlorine from 2, 4-dichlorophenol since only phenol was detected as the byproduct and the concentration of released chlorine ions indicated near-complete dechlorination. This work presents a good alternative technique for eliminating persistent chlorophenols in polluted wastewater without maintaining strong acidic environment.     

覆膜滤料特性实验研究

覆膜滤料是降低微细颗粒物排放,降低大气环境中PM2．5浓度源头的净化技术之一。对氟美斯（FMS ）针刺毡为基布覆膜滤料,进行了表面微观结构电镜扫描,同时,进行了这种滤料的阻力实验测试和分级效率测试。表面电镜扫描结果显示,覆膜呈微孔且直径为0．5μm左右的多层铰链结构。实验结果表明,覆膜滤料周期性清灰后阻力为1200 Pa ,万次老化实验后覆膜滤料阻力是1163．3 Pa;在过滤风速为1．4 m／min时,滤料对PM2．5的过滤效率高于99％。实验结果对使用覆膜滤料的布袋除尘器设计具有一定指导意义。     

Zn2+对SBR单级好氧模式生物除磷性能的影响

以合成废水为研究对象,以丙酸盐为单一外加碳源,通过比较进水中不同Zn2+浓度(0,1,5,10,20mg/L)下单级好氧模式下序批式反应器(SBR)的除磷效果,考察进水Zn2+浓度对单级好氧SBR生物除磷性能的影响,并通过分析各反应器中典型周期内磷及微生物体内储能物质的变化,探究Zn2+对单级好氧SBR生物除磷性能的影响机理.当进水Zn2+浓度为0和1mg/L时,除磷率分别高达96.84%和97.90%.当进水Zn2+浓度为5,10,20mg/L时,系统除磷率分别为89.32%,76.43%和57.29%,说明较高浓度Zn2+对单级好氧SBR生物除磷有抑制作用.结果表明,较高浓度Zn2+可抑制COD的降解,微生物体内聚羟基脂肪酸酯好氧合成及磷酸盐激酶活性,并促进GAOs的代谢,使聚磷合成和水解量减少,从而降低系统的除磷性能.     

基于卫星遥感的广东地区对流层二氧化碳时空变化特征

利用瓦里关全球本底站和番禺气象局地面观测的CO2浓度资料对SCIAMACHY反演得到的对流层CO2产品进行验证.结果显示:SCIAMACHY产品能较好地反映对流层CO2的分布状况,在珠三角地区反演和观测的残差为1.29×10-6,相关系数为0.69,可用于分析区域对流层CO2的时空分布特征.利用2003~2009年SCIAMACHY观测资料分析研究显示:广东地区对流层CO2柱浓度最高值出现在春季,最低值出现在夏季,浓度年均值和年增长率分别为384.84′10-6和1.53′10-6/a,大于全球和我国同期的观测结果;粤东、粤西、粤北和珠三角地区的浓度均在春、冬季显著高于夏季、秋季 ,相同季节内各区域之间的差异不显著;粤西地区CO2柱浓度的年增长率最高,为1.82′10-6/a,珠三角和粤东地区的年增长率相当,分别为1.65,1.64′10-6/a,粤北地区的年增长率最低,为1.61′10-6/a.     

碳磷比对SND过程污染物去除及N2O释放的影响

以两个平行运行的SBR反应器为研究对象,研究了碳磷比对同步硝化反硝化过程中污染物去除及温室气体N2O释放的影响.结果表明:系统对COD和氨氮的去除率均能达到90%以上,总磷和总氮去除率随碳磷比的降低而提高,这是由于低碳磷比下聚磷菌得到富集,同时部分聚磷菌利用NO3-和NO2-为电子受体吸收磷,从而实现脱氮除磷的同步提高.系统的N2O释放量随碳磷比的降低而降低,低碳磷比下N2O释放量仅为高碳磷比的76%.低碳磷比下N2O释放量的减少主要是由于异养反硝化过程对N2O释放的贡献降低导致的.     

基于国内水泥生产现状的碳排放因子测算

水泥生产过程中碳排放因子的测算是计算水泥碳排放量的基础,为了准确测算我国水泥行业熟料煅烧阶段碳酸盐矿物分解释放CO2的碳排放因子,就需要对水泥生产线上相关样品做成分测定和综合分析.通过对国内近百条代表性较强的水泥生产线上的生料、熟料、水泥、石灰石、燃煤等样品进行钙、镁、烧失量、碳酸盐等化学成分的定量分析,并考虑新型干法窑和立窑两种生产工艺类型的差别,分析测算了基于国内水泥生产的工艺碳排放因子.结果表明:生料碳酸盐法测算碳排放因子的结果较熟料法的结果低约10kgCO2/tcl;不同窑型的碳排放因子存在明显差异,新型干法窑的碳排放因子多集中在500~520kgCO2/tcl,立窑碳排放因子多集中在480~500kgCO2/tcl;多数熟料含有少量碳酸盐.生料碳酸盐法不涉及燃煤灰分的化学成分,可以规避燃煤灰分成分的影响,测算碳排放因子采用生料碳酸盐法较准确,并且应基于不同窑型,同时考虑碳酸盐分解率问题.     

基于ASM 2d的数学模型在六箱一体化工艺分析中的应用

以六箱一体化工艺为例,建立了基于ASM 2d(activated sludge process 2d,活性污泥工艺2d)的数学模型,并研究其在脱氮除磷中的应用. 在HRT(水力停留时间)为16 h的工况下,利用灵敏度分析挑选了含有7个参数的待优化参数集,通过使用遗传算法优化校正函数的方式进行校正计算,获得了校正后的六箱一体化工艺模型,并在HRT为20和24 h下对该模型做了进一步验证. 结果表明,校正后的模型对出水水质的预测性较好,在HRT为16 h下,出水ρ(COD_Cr)、ρ(TN)、ρ(TP)和ρ(NH₄+-N)的模型计算值与实测值间的绝对差值较小,分别为1.96、0.83、0.06和0.24 mg/L. 在校正后模型的基础上,详细分析了HRT为20 h时各池中ρ(NH₄+-N)、ρ(NO₃--N)和ρ(PO₄3--P)在1个周期内的动态变化,指出了影响该工艺处理效果的主要原因(如碳源不足的问题),并与通过试验分析得到的结果基本一致.