回火焊道焊接技术在焦炭塔修复中的应用

为了避免耗时长、费用高的焊后热处理或整体更换筒节,针对铬钼钢焦炭塔内壁环焊缝的裂纹和锥段内壁腐蚀缺陷,提出采用回火焊道焊接技术对内壁缺陷部位进行修复。结果表明,严格按照经评定合格的焊接工艺进行施焊,回火焊道焊接技术可以利用层道间的焊接热循环作用达到焊后热处理的效果,使焊接修复后铬钼钢焦炭塔的母材和复合层的冶金和力学性能满足要求。     

钢铁企业大型低位料仓汽车卸料的粉尘控制

某钢企大型低位料仓为汽车卸料,料仓厂房内空高,跨度大,料仓上部贯通,物料落差大,卸料中产生大量粉尘,环境污染问题典型突出。通过对低位料仓汽车卸料产尘特性分析,采取加强生产管理、组织汽车有序卸料、料仓厂房有效密闭、合理设计捕尘方式和布袋除尘系统等措施,能够有效地控制粉尘污染。除尘系统具有投资及运行费用少,除尘效果明显的优点。     

4A沸石去除水中Pb2＋的研究

在静态条件下,研究了4A沸石对废水中Pb2＋的吸附性能,并探讨了影响吸附的因素。实验表明：当温度为30℃,废水pH为5～6,0．01g4A沸石对100mg／LPb2＋溶液10mL吸附20min,Pb2＋的去除率可达到99％以上。在实验研究条件下,4A沸石对Pb2＋的吸附符合Langmuir和Freundlich等温吸附方程,相关系数为0．9819和0．9998。经计算,4A沸石对Pb2＋的饱和吸附量为125mg／g。4A沸石吸附水中Pb2＋达到吸附平衡的时间较短;溶液pH值的变化对吸附效果影响不显著;温度从室温略微升高,Pb2＋的去除率略有增大。吸附在4A沸石上的Pb“可回收利用,处理后的4A沸石可以再生,且重复使用性能较好。     

人工湿地基质对NH4＋-N吸附性能

为研究建筑废物红砖和工业废物煤渣用作人工湿地脱氮基质的可行性,分别通过静态吸附实验和动态NHf—N去除效果实验进行考察。结果表明,红砖和煤渣对NH4＋-N最大静态吸附量分别为0．2533mg／g和0．0533mg／g,其吸附等温曲线均符合Freundlich型吸附方程,吸附常数分别为0．0419和0．0091;红砖煤渣组合对污水中NH4＋-N平均动态脱除率达到41．18％,高于红砖的37．63％和煤渣的30．92％。     

钢框架厂房火灾后的破坏形态

端部约束不同的构件在火灾中的破坏形态不同,研究整体结构构件在火灾中的破坏形态,可以为钢结构抗火研究与设计提供依据。某钢结构框架厂房发生火灾,大火历时3个多小时,火场最高温度达1000°C以上。火灾后,框架梁均有不同程度的破坏,钢梁端部下翼缘屈曲破坏较普遍;由于钢梁顶没有设置抗剪键,钢梁与顶部的混凝土现浇楼板脱开,火灾后残留有较大的挠屈变形;钢柱在火灾后未有明显的破坏现象,但有侧向变形产生。这些现象与实验室中标准试验的结果不同。     

约束高强度Q460钢柱抗火性能分析

为了研究高强度约束钢柱在火灾下的反应,根据高强度结构钢Q460在高温下的力学性能参数,建立了约束高强度钢柱受火分析模型,得到了高强度约束钢柱在火灾下的轴向位移、跨中挠度、最大应力以及临界温度。采用有限元分析对理论结果进行了验证,两者吻合很好。利用验证过的该文计算方法计算了2种荷栽比、长细比和约束刚度比条件下的高强钢柱的抗火性能;采用CECS200:2006的力学性能参数计算了约束普通钢柱的抗火性能。通过对高强钢和普通钢的抗火性能分析发现,轴向约束明显降低钢柱的临界温度,长细比、荷载比越大,临界温度越低;高强钢的抗火性能要优于普通钢。     

Technologically enhanced 210Pb and 210Po in iron and steel industry

Iron and steel manufacture has been ranked as the largest industrial source of environmental contamination in the USA; the wastes generated in their production processes contain heavy elements that can be a source of contamination, and natural radionuclides that can produce an occupational and/or public radiological impact. In this work the potential occupational effective dose rate (μSv/y) due to inhalation in four integrated steel-making factories from Egypt has been evaluated, by assuming a well defined scenario and with basis in the ²¹⁰Pb and ²¹⁰Po activity concentrations determined in ore and wastes collected in the aforementioned factories. Activity concentrations, in Bq/kg, of ²¹⁰Pb and ²¹⁰Po, and leachable Pb and Fe were measured using gamma-ray spectrometry based on HPGe detector, alpha particle spectrometry based on PIPS detector, and inductively coupled plasma-mass spectrometry (ICP-MS). Levels of ²¹⁰Pb and ²¹⁰Po in the range of <DL-4238 and 1-5660 Bq/kg, respectively, were found. According to the assumed scenarios, the occupational exposures by inhalation are much lower than the recommended annual effective dose limit, although the environmental impact due to waste storage and/or use should be considered based on case by case evaluation.     

Nitrous oxide and methane emission from a flooded rice field as influenced by separate and combined application of herbicides bensulfuron methyl and pretilachlor

Combination of divergent active principles to achieve broad-spectrum control is gaining popularity to manage the weed menace in intensive agriculture. However, such application could have non-target impacts on the soil processes affecting soil ecology and environmental interactions. A field experiment was conducted to investigate the impact of separate and combined applications of herbicides bensulfuron methyl and pretilachlor on the emission of N₂O and CH₄, and related soil and microbial parameters in a flooded alluvial field planted to rice cv Lalat. Single application of the herbicide bensulfuron methyl or pretilachlor resulted in a significant reduction of N₂O and CH₄ emissions while the combination of these two herbicides distinctly increased N₂O and CH₄ emissions. Cumulative N₂O emissions (kg N₂O-N) followed the order of bensulfuron methyl (0.35 kg ha⁻¹) < pretilachlor (0.36 kg ha⁻¹) < control (0.45 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% single dose (0.49 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% double dose (0.54 kg ha⁻¹). Cumulative CH₄ emissions (kg CH₄), on the other hand, followed the order of bensulfuron methyl (47.89 kg ha⁻¹) < pretilachlor (73.17 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% single dose (93.50 kg ha⁻¹) < control (106.54 kg ha⁻¹) < bensulfuron methyl 0.6% + pretilachlor 6.0% double dose (124.67 kg ha⁻¹). The inhibitory effect of separate application of herbicides bensulfuron methyl 0.6% and pretilachlor 6.0% on N₂O emission was linked to lower mineral N, lower denitrifying and nitrifying activity and low denitrifier and nitrifier populations. Inhibitory effect on CH₄ emission, on the contrary, was linked to prevention in the drop of redox potential, lower readily mineralizable carbon (RMC) and microbial biomass carbon (MBC) contents as well as lower methanogenic and higher methanotrophic bacterial population. Admittedly, stimulatory effect of combined application of herbicides bensulfuron methyl 0.6% and pretilachlor 6.0% at double dose on N₂O and CH₄ emission was related to reversal of the identified indicators of inhibition. Results indicate that while individual application of herbicides bensulfuron methyl 0.6% or pretilachlor 6.0% can reduce N₂O and CH₄ emission from flooded soil planted to rice, their combined application at normal dose can keep the emission at a comparatively lower level with significantly higher grain yield as compared to the herbicides applied alone.     

CePO4-TiO2固溶体的NH3-SCR活性

采用共沉淀法合成了不同Ce与Ti摩尔比的CePO₄-TiO₂复合材料,利用XRD、TEM、NH₃-TPD和H₂-TPR技术对其物理化学性质进行了表征,并对其NH₃-SCR活性进行了评价。实验结果表明：随着CePO₄含量的增加,催化剂的活性提高;当Ce与Ti的摩尔比为8:2时催化剂的活性最高,230 ℃的NO转化率达到100%,且具有更广的温度窗口,优于纯CePO₄。表征结果显示,CePO₄与TiO₂形成固溶体后,颗粒尺寸较为均匀,强酸位的数量增多,氧化还原性能提升,从而提高了催化剂的SCR反应活性,同时改善了其抗水抗硫性能。