纳米助燃固硫添加剂的催化作用机理

溶胶.凝胶法制备的纳米TiO2作为CaO固硫添加剂,用热分析法对纳米TiO2催化煤燃烧以及催化CaO固硫的过程进行了实验研究.对燃烧后煤灰的孔径分布进行了分析.采用未反应收缩核模型对固硫反应的动力学过程进行表征.研究结果表明,纳米TiO2与CaO共同作用条件下对煤燃烧有明显的促进作用,即燃烧反应活化能E下降,同时纳米TiO2还能增大燃烧后煤灰的孔径,提高固硫率.氧气的存在抑制氧化钙的固硫转化率,纳米TiO2可以消弱氧气的抑制作用.对固硫反应的影响表现为在反应后期(即产物层扩散控制阶段),与固硫转化率和孔径分布的实验结果非常吻合;讨论了纳米TiO2催化燃烧催化固硫的机理,纳米TiO2导致碳晶格的扭曲,增加表面活性部位,加快氧气的吸附速度,使添加剂周围燃烧速度加快,煤灰孔隙增大从而强化燃烧,促进SO2转化成SO3的本征反应,促进二氧化硫向氧化钙内部的扩散从而提高CaO的固硫效果.     

基于纳污量的流域水环境管理模式——以金华江流域义乌段为例

为解决金华江流域义乌段水质与水功能区要求间失衡的环境问题,建立基于水体纳污能力的流域水环境管理模式.以QUAL2K模型为基础估算了金华江流域义乌段BOD和氨氮纳污能力;建立了同时考虑点源和面源的BOD、氨氮日最大排污量的管理模式.结果表明,流域BOD、氨氮纳污总量分别为4865.5 kg·d-1和431.20 kg·d-1;按照BOD、氨氮现状,其排放量分别削减49.63%和88.71%,才能基本满足流域水环境功能区要求.     

Impacts of climate change and CO2 increase on agricultural production and adaptation options for Southern Québec, Canada

This study involves the assessment of the potential impacts of greenhouse gas climate change and changing ambient carbon dioxide (CO₂) levels on crop yields in Quebec, Canada. The methodology involves coupling the transient diagnostics of two Atmosphere-Ocean General Circulation Models, namely the Canadian CGCM1 and the British HadCM3, to the Decision Support System for Agrotechnology Transfer (DSSAT) 3.5 crop models to simulate current (1961–1990) and future (2040–2069) crop yields and changes. This is done for four different crop species, namely spring wheat, maize, soybean, and potato, and for seven agricultural regions of Southern Quebec. The results of this study focus on the main causative factors influencing crop yields, namely the direct CO₂ fertilization effect, the influence of the increase in growing season temperature, including optimal thermal conditions and acceleration in crop maturation, soil moisture availability, as influenced by precipitation and evapotranspiration, and nitrogen uptake by crops. Our results show that crop yield changes may vary according to climate scenario, crop species, and agricultural region. Consistent with other similar research, it would seem that these multiple causative factors very often seem to cancel each other out and dilute the impacts of climate change on crop yields.     

Influence of environmental temperature and relative humidity on photocatalytic oxidation of toluene on activated carbon fibers coated TiO2

TiO₂ supported on active carbon fiber (TiO₂/ACF), an absorbable photocatalyst, is a new kind of material applied in air purification. In this paper, the influence of environmental temperature (T) and relative humidity (RH) on the gas-solid adsorption of toluene and the photocatalytic oxidation (PCO) efficiency of adsorbed toluene on TiO₂/ACF were studied, and then, the purification capability of TiO₂/ACF was estimated. PCO results showed that although the PCO efficiency increased under high RH and T levels, the amount of adsorption of toluene decreased. Moreover, quantitative analysis results of intermediates indicated that more environmental risk emerged when PCO of toluene was carried out at higher environmental T and RH levels because more toxic intermediates would be accumulated on the TiO₂/ACF. So, it is significant to control the environmental T and RH conditions in the application of the PCO technique. T = 25°C and RH530% is the optimal condition for purifying toluene in our experimental system. __________ Translated from Urban Environment & Urban Ecology, 2007, 20(5): 10–13 [译自: 城市环境与城市生态]     

Catalytic destruction of pentachlorobenzene in simulated flue gas by a V2O5-WO3/TiO2 catalyst

Pentachlorobenzene (PeCB) in simulated flue gas was destructed by a commercial V₂O₅-WO₃/TiO₂ catalyst in this study. The effects of reaction temperature, oxygen concentration, space velocity and some co-existing pollutants on PeCB conversion were investigated. Furthermore, a possible mechanism for the oxidation of PeCB over the vanadium oxide on the catalysts was proposed. Results show that the increase of gas hourly space velocity (GHSV) and the decrease of operating temperature both resulted in the decrease of PeCB removal over the catalyst, while the effect of the oxygen content in the range of 5-20% (v/v) on PeCB conversion was negligible. PeCB decomposition could be obviously affected by the denitration reactions under the conditions because of the positive effect of NO but negative effect of NH₃. The introduction of SO₂ caused the catalyst poisoning, probably due to the sulfur-containing species formed and deposited on the catalyst surface. The PeCB molecules were first adsorbed on the catalyst surface, and then oxidized into the non-aromatic acyclic intermediates, low chlorinated aromatics and maleic anhydride.     

纳米催化剂Pd/SnO2的制备及催化还原硝酸盐反应的调控

采用热分解法制备了SnO2载体,并用浸渍法制备了Pd/SnO2催化剂.同时,采用X射线衍射仪(XRD)、透射电镜(TEM)、扫描电镜(SEM)及BET比表面积仪等对所制载体和催化剂材料进行了分析表征.结果表明,热分解法和浸渍法都能够获得纳米材料,SnO2及Pd/SnO2的粒径均在9～10nm左右,比表面积分别达到144.99m·2g-1和147.36m·2g-1.在以甲酸为还原剂的Pd/SnO2催化还原硝酸盐体系中,在Pd与SnO2负载比为2%～7%,反应温度为20～50℃和甲酸投加量4.0～24.0mmol·L-1的条件下,催化活性为0.70～9.48mg·min-·1g-1,且催化活性随着负载比、温度和甲酸投加量的增大而增大,随着pH的升高先升后降,最佳pH为3.反应温度升高及pH降低都能够提高Pd/SnO2的选择性.甲酸-Pd/SnO2催化还原硝酸盐体系中还原反应的调控策略为:反应温度宜控制在40～50℃内,这样可同时获得较高的催化活性和选择性,温度过高对催化活性和选择性影响很小,温度过低则会同时降低催化活性和选择性;控制pH为3时,可以获得最大的催化活性及较好的选择性,pH升高会降低Pd/SnO2的催化活性和选择性,pH降低会导致催化活性迅速降低,但对选择性影响不大;甲酸与硝酸盐的物质的量比宜大于4:1,此时可以有效地抑制pH的上升,同时获得较高的催化活性和选择性,甲酸与硝酸盐的物质的量比小于4:1时,会同时降低Pd/SnO2的催化活性和选择性.     

pH对铜在黄土中吸持及其形态的影响

用黄土为吸持剂,以石英砂作对照,研究了pH对铜的吸持及形态的影响,并用MINTEQA2模型对铜离子的沉淀形态进行了理论计算.结果表明:无论吸持剂是石英砂还是黄土,随着pH的升高,吸持曲线都分为3区:低pH微吸持区、中pH吸持增长区和高pH强吸持区.含沙量一定,随着铜液初始浓度的增加,吸持量、可交换态含量和碳酸盐结合态含量均增加;铜液初始浓度一定,随着含沙量的增加,吸持量、可交换态含量和碳酸盐结合态含量均减少.MINTEQA2模型计算结果表明,对于不同的吸持剂,铜离子发生沉淀的比例及沉淀的物质组成是不同的;以黄土为吸持剂时,中pH范围内随着含沙量的增加铜离子沉淀的比例减少.     

复合氧化物汽车尾气净化催化剂抗SO2中毒机理研究

复合氧化物催化剂(ASC)具有较高的活性和良好的抗SO_2中毒性能.用IR、XPS、TPD等技术研究了该催化剂抗SO_2中毒机理,结果表明,与易失活催化剂相比,ASC经500h反应(反应气含SO_2约20ppm),其活性组分价态无显著变化,仅表面发生SO_2的化学吸附,经与约500ppm的SO_2作用20h后,发现仅有少量SO_4~(2-)形成.这是由于在ASC催化剂中添加了特殊助剂,而使催化剂活性组分得到保护的缘故.     

海藻酸钠包埋活性炭与细菌的条件优化及其对Pb2+的吸附特征研究

利用海藻酸钠固定化包埋活性炭与多黏类芽孢杆菌GA1,通过正交试验研究海藻酸钠溶液浓度、包炭量及包菌量吸附Pb2+的最佳配比,并研究了这种新型的固定化小球对Pb2+的吸附特征.结果表明,固定化活性炭与多黏类芽孢杆菌GA1小球最佳制备条件为海藻酸钠质量分数2.5%、包炭量1:20和包菌量1:2,在该制备条件下吸附率达到93.74%.固定化小球的最佳吸附条件为pH5、温度30℃和Pb2+初始浓度300mg·L-1,活性炭与GA1经固定后对pH、温度和Pb2+初始浓度适应范围扩大.吸附平衡曲线表明,对Pb2+的吸附在30min内是一个快速的过程,在2h时基本趋于平衡,且平衡曲线能较好地用Langmuir模型和Freundlich模型来描述,其吸附过程主要为单分子层吸附,最大单分子层吸附量为370.37mg·g-1.解吸结果表明固定化小球能有效地循环利用.     

不同生长期的Pseudomonas putida 5-x细胞对工业废水中Cu~(2+)的吸附

研究了不同生长阶段的Cu2 + 吸附细菌Pseudomonasputida 5 x对Cu2 + 的吸附容量 .结果表明在低硫培养基中 ,当P putida 5 x细胞生长刚进入对数生长期时 ,单位细胞对Cu2 + 的吸附溶量最低 .而当生长进入稳定生长期的后期或死亡期的早期时 ,单位细胞对Cu2 + 的吸附量最大 .实验结果还表明 ,高浓度的Cu2 + 对对数期细胞的吸附能力有一定的抑制 ,而对死亡期的细胞影响较小 .早期研究已证明细胞对重金属离子的吸附和细胞表面某些对重金属离子具有亲和性的功能基团 (如某些膜蛋白及羰基化合物 )有关 .利用透视电子显微镜观察了不同生长阶段的细胞表面结构及对铜离子的吸附效果 ,发现生长后期细胞表面吸附有较多的Cu2 + ,这表明生长后期的细胞表面可能含有较多的这类功能基团