氨水土壤混合物脱除CO2温室气体的实验研究

为了脱除CO2温室气体,提出了利用氨水土壤混合物去除CO2的新方法.分别考察了土壤颗粒粒径、CO2初始流量、氨水浓度(质量比)和温度对CO2脱除量和脱除率的影响.实验结果表明,该方法去除CO2的量较土壤物理吸附量和氨水化学吸收量的总和提高了大约15%;随着氨水浓度的增大,CO2的脱除率和脱除量都增大;随着土壤颗粒粒径和CO2初始流量的增大,CO2的脱除率和脱除量都减小;当温度由22℃升高到31℃,CO2的脱除率随着温度的升高而增大,但是继续升高温度到40 ℃,CO2的脱除率反而下降.     

Gas/particle partitioning of atmospheric PCDD/Fs in a satellite town in Eastern China

Gas/particle partitioning of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in ambient air was investigated in a satellite town in Eastern China from April 2007 to January 2008 comprehending large temperature variations (from 3 to 34 °C, daily average). Molecular weight, molecular structure and ambient temperatures are the three major factors that govern the gas/particle partitioning of atmospheric PCDD/Fs throughout the year. Generally, good agreements were obtained (except for winter) between measured particulate fractions and theoretical estimates of both the Junge–Pankow adsorption model and Harner Bidleman absorption model using different sets of subcooled liquid vapor pressure and octanol–air partition coefficient (K_oa), respectively. Models utilizing estimates, derived from gas chromatographic retention indices (GC-RIs), are more accurate than that of entropy-based. Moreover, during winter, the K_oa-based model using the GC-RIs approach performs better on lower chlorinated PCDD/Fs than that of -based. Furthermore, possible sources of mismatch between measured and predicted values in winter (3–7 °C) were discussed. Gas adsorption artifact was demonstrated to be of minor importance for the phenomena observed. On the other hand, large deviations of slopes (m_r) and intercepts (b_r) in logK_p vs. plots from theoretical values are observed in the literature data and these are found to be linearly correlated with ambient temperatures (P<0.001) in this study. This indicates that the non-equilibrium partitioning of PCDD/Fs in winter may be significantly influenced by the colder temperatures that may have slowed down the exchange between gaseous and particulate fractions.     

How will Ocean Acidification Affect Baltic Sea Ecosystems? An Assessment of Plausible Impacts on Key Functional Groups

Increasing partial pressure of atmospheric CO₂ is causing ocean pH to fall—a process known as ‘ocean acidification’. Scenario modeling suggests that ocean acidification in the Baltic Sea may cause a ≤3 times increase in acidity (reduction of 0.2–0.4 pH units) by the year 2100. The responses of most Baltic Sea organisms to ocean acidification are poorly understood. Available data suggest that most species and ecologically important groups in the Baltic Sea food web (phytoplankton, zooplankton, macrozoobenthos, cod and sprat) will be robust to the expected changes in pH. These conclusions come from (mostly) single-species and single-factor studies. Determining the emergent effects of ocean acidification on the ecosystem from such studies is problematic, yet very few studies have used multiple stressors and/or multiple trophic levels. There is an urgent need for more data from Baltic Sea populations, particularly from environmentally diverse regions and from controlled mesocosm experiments. In the absence of such information it is difficult to envision the likely effects of future ocean acidification on Baltic Sea species and ecosystems.     

超声辐射浸渍法制备Fe-Ni-Mn/Al_2O_3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

Ti/BDD/PbO_2复合电极在化学需氧量测定中的应用

以钛基掺硼金刚石为基体,采用电沉积的方法制备了Ti/BDD/PbO2复合电极,并将其用于化学需氧量（COD）的测定。采用扫描电子显微镜（SEM）和X射线衍射谱图（XRD）表征了电极的微观形貌及结构,采用电化学工作站考察了电极对有机物响应特性。实验结果表明,在1.45 V的低电位条件下,线性范围为0.5～175 mg/L,检测限为0.3 mg/L（S/N=3）。采用Ti/BDD/PbO2复合电极测定法和重铬酸钾标准方法对市政污水、食品废水及印染废水的对比结果表明,2种方法的相对误差小于10%,具有良好的一致性。     

核桃壳粉对水溶液中Pb2＋的吸附

实验通过间歇吸附方式研究了核桃壳粉对水溶液中Pb^2＋的吸附特性,探讨了核桃壳粉粒径及用量、溶液pH、Pb^2＋初始浓度等参数对吸附的影响,并讨论了吸附过程的热力学和动力学特征。结果表明,核桃壳粉对Pb^2＋吸附的最佳pH为5．0,去除率随吸附剂粒径的减小、用量的增加、Pb^2＋初始浓度的减小而增加。优化实验条件下,0～0．3mm15g／L的吸附剂在298K时,对pH=5的50mL50mg／LPb^2＋溶液的去除率达96．98％。核桃壳粉对Pb^2＋的吸附等温线符合Sips模型,在283、293和303K的最大吸附量分别为18．25、18．27和20．94mg／g。吸附过程是放热的、混乱度减小的自发过程,且符合准二级动力学模型。吸附速率常数随温度升高而减小,在293和303K时分别在90和120min基本达到平衡。结合FTIR和SEM手段发现核桃壳对Pb^2＋的吸附以物理吸附为主,同时包括离子交换、螯合等化学吸附以及颗粒内扩散步骤,是一个复杂的过程。     

MnxCe1-xO2／γ-Al2O3催化剂的制备及其催化甲苯的燃烧性能

以γ-Al2O3为载体,以MnxCe1-xO2为催化活性组分,采用浸渍法制备了一系列负载型MnxCe1-xO2／γ-Al2O3催化剂（x=0、0．2、0．4、0．6、0．8、0．9、1）,在固定床反应器中评价了催化剂对甲苯的催化燃烧性能。结果表明,MnxCe1-xO2／γ-Al2O3催化剂的催化活性与催化剂的焙烧温度、活性组分MnxCe1-xO2的负载量以及Mn、Ce摩尔比有显著关系,其中焙烧温度550℃、负载量为20％、Mn、Ce摩尔比为4：1时,即MnxCe1-xO2／γ-Al2O3催化剂对甲苯的催化性能最佳,反应温度为180℃时,甲苯的转化率达到95％。并在连续100h的稳定性操作后,催化剂的活性基本无变化。采用XRD、BET以及SEM等分析测试手段对催化剂的结构以及表面进行了表征。     

碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

用H2O2/Fe^3＋处理高浓度含甲醛废水的研究

研究采用H2O2/Fe^3＋催化氧化处理高浓度含甲醛废水,探讨了双氧水和催化剂投加量、反应pH及反应温度等操作条件对处理效果的影响,并通过酸溶解回用失活催化剂。结果表明,较优的操作条件为：H2O2/COD（质量比）=2.2～2.6,Fe^3＋/H2O2（摩尔比）=0.048～0.058,反应pH1.80～2.68,反应温度50℃,反应时间40 min;在上述操作条件下,甲醛去除率达到99%以上,COD去除率达到85%以上。失活的催化剂可通过稀酸溶解后循环使用,其效果与三价铁盐作催化剂的基本相同。采用H2O2/Fe^3＋处理含甲醛废水具有比采用H2O2/Fe^2＋较优的效果。     

中心组合设计优化S-Cr-TiO2催化剂光降解工艺条件

在确定的温度和光照条件下,采用中心组合设计法研究了固相反应法合成的硫与铬共掺杂二氧化钛(S-Cr-TiO2)光催化剂与水溶苯胺蓝(ANB)可见光降解过程中的三个作用因子:催化剂的浓度、水溶苯胺蓝水溶液的pH值及其初始浓度之间的相互作用关系,得到了影响因子与降解速率之间的回归方程及因素之间相互作用的响应面图.结果表明,S...