菌株Desulfovibrio sp. CMX的DNRA性能和影响因素

微生物的硝酸盐异化还原为铵(DNRA)过程对自然界中铵根离子的存在和转化具有重要影响,然而关于SRB菌株DNRA过程影响和机制尚未探明.本文考察了实验室筛选的SRB菌株Desulfovibrio sp.CMX的DNRA能力、影响因素及其影响机制.结果表明,无外加氮源的情况下,分别以10 mmol·L-1NO_3~-和NO_2~-作为唯一电子受体,菌株Desulfovibrio sp.CMX最终NH_4~+生成率分别达到85.8%和97.3%,且无N2和N2O等副产物产生.实验探究了不同外加氮源、不同初始浓度的SO_4~(2-)、S~(2-)对菌株DNRA过程的影响.酵母浸粉作为外加氮源可促进菌株的生长和代谢从而促进菌株DNRA过程;SO_4~(2-)对于NO_3~-还原为NO_2~-阶段起促进作用,而对NO_2~-还原为NH_4~+阶段起抑制作用,综合两方面影响,最终表现出对菌株DNRA过程的抑制作用;S~(2-)对菌株生长及DNRA过程都表现出抑制作用,且S~(2-)浓度越高抑制作用越强,当S~(2-)浓度达到6 mmol·L-1后,S~(2-)对于NO_3~-还原为NO_2~-阶段的抑制作用强于NO_2~-还原为NH_4~+阶段的抑制作用,NO_3~-还原为NO_2~-速率低于NO_2~-还原为NH_4~+速率,此时体系中不再有NO_2~-的积累.     

2-丁烯醛生产废水中溶解性有机物的分级解析

采用超滤膜法将2-丁烯醛生产废水中的有机物分为相对分子质量不同的7个级分,并应用溶解性有机碳(dissolved organic carbon,DOC)、紫外吸收光谱(ultraviolet spectrum,UV)、傅里叶变换红外光谱(fourier transform infrared spectrometer,FT-IR)和气相色谱/质谱联用仪(gas chromatography with mass spectrometry,GC-MS)技术对不同相对分子质量区间的有机物所占比例及物质结构进行了研究.结果表明,废水中相对分子质量1×103的有机物所占比例最高,达到88.57%;采用GCMS对废水中相对分子质量1×103的级分进行分析,定性出27种化合物,包含醛、酮、酯、醇、酚、酸、烷烃类及其他苯系物等,其峰面积占有机物峰面积总和的比例分别为6.9%、5.3%、35.4%、13.2%、4.6%、0.4%、1.7%、16.8%,总和为84%.UV和FT-IR分析结果均显示不同相对分子质量区间的光谱吸收特征没有明显差别,级分中存在含有不饱和双键、羟基、羰基化合物及芳香族化合物,与GC-MS检测结果相吻合.研究结果为废水处理工艺的开发与优化提供了重要的指导作用.     

固态胺吸附剂分离密闭空间低浓度CO_2的研究进展

近年来,密闭空间低浓度CO2的吸附分离技术是研究热点,固态胺吸附剂因其再生能耗低、选择性高、易操作等优点受到广泛关注。综述了固态胺吸附剂常见的制备方法、表面改性剂和多孔材料载体,同时综合评价CO2的吸附效率,最终展望了固态胺的发展趋势。     

某机场大气环境现状监测分析

为了研究机场大气环境质量状况,在某机场选取三个监测点,在正常飞行条件下,对不同时间段污染物浓度进行监测与分析。测试结果表明:七天监测期间,机场及机场周围SO2、NO2浓度均未超标,PM10在机场内部有一天超标;各时间段SO2的贡献率在2.9%~12%,各时间段NO2的贡献率在6.9%~77%,机场飞机的尾气对周围空气质量的影响不容忽视。     

壳聚糖对Cu~(2+)的吸附与解吸

研究了溶液pH值、Cu2+初始浓度、吸附剂投加量、吸附时间及温度对壳聚糖吸附Cu2+的影响,并对达到吸附平衡的壳聚糖进行了解吸研究。结果表明,壳聚糖对Cu2+的吸附量随pH值的升高而增大,在pH值为4.7时,基本达到吸附平衡;吸附过程同时符合Langmuir模型和Freundlich模型,最大吸附量为142.9 mg/g;与拟一级动力学模型相比,拟二级动力学模型可以更好地描述吸附过程;吸附剂最佳投加量为1 g/L。用0.03 mol/L H2SO4溶液做脱附液,搅拌10 min,脱附率为73.4%;经过4次脱附-吸附循环,壳聚糖平衡吸附量变化不大,具有良好的重复使用性。     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

Seasonal and diurnal variations of atmospheric peroxyacetyl nitrate, peroxypropionyl nitrate, and carbon tetrachloride in Beijing

Atmospheric peroxyacetyl nitrate(PAN), peroxypropionyl nitrate(PPN), and carbon tetrachloride(CCl4) were measured from September 2010 to August 2011 in Beijing. PAN exhibited low values from mid-autumn to early spring(October to March) with monthly average concentrations ranging from 0.28 to 0.73 ppbV, and increased from early spring to summer(March to August), ranging from 1.37–3.79 ppbV. The monthly variation of PPN was similar to PAN, with low values(below detection limit to 0.18 ppbV) from mid-autumn to early spring, and a monthly maximum in September(1.14 ppbV). The monthly variation of CCl4was tightly related to the variation of temperature, exhibiting a minimum in winter(69.3 pptV) and a maximum of 180.6 pptV in summer. Due to weak solar intensity and short duration, PAN and O3showed no distinct diurnal patterns from morning to night during winter, whereas for other seasons, they both exhibited maximal values in the late afternoon(ca. 15:00 to 16:00 local time) and minimal values during early morning and midnight. Good linear correlations between PAN and PPN were found in autumn(R = 0.91), spring(R = 0.94), and summer(R = 0.81), with slopes of 0.130, 0.222, and 0.133, respectively, suggesting that anthropogenic hydrocarbons dominated the photochemical formation of PANs in Beijing. Positive correlation between PAN and O3 in summer with the low slopes( O3 / PAN) ranging from 9.92 to 18.0 indicated serious air pollution in Beijing, and strong negative correlation in winter reflected strong O3consumption by NO titration and less thermal decompositin of PAN.     

Compositions and sources of organic acids in fine particles (PM2.5) over the Pearl River Delta region, south China

Organic acids as important constituents of organic aerosols not only influence the aerosols' hygroscopic property, but also enhance the formation of new particles and secondary organic aerosols. This study reported organic acids including C14–C32fatty acids, C4–C9dicarboxylic acids and aromatic acids in PM2.5collected during winter 2009 at six typical urban, suburban and rural sites in the Pearl River Delta region. Averaged concentrations of C14–C32fatty acids, aromatic acids and C4– C9 dicarboxylic acids were 157, 72.5 and 50.7 ng/m3, respectively. They totally accounted for 1.7% of measured organic carbon. C20–C32fatty acids mainly deriving from higher plant wax showed the highest concentration at the upwind rural site with more vegetation around, while C14–C18fatty acids were more abundant at urban and suburban sites, and dicarboxylic acids and aromatic acids except 1,4-phthalic acid peaked at the downwind rural site. Succinic and azelaic acid were the most abundant among C4–C9dicarboxylic acids, and 1,2-phthalic and 1,4-phthalic acid were dominant aromatic acids. Dicarboxylic acids and aromatic acids exhibited significant mutual correlations except for 1,4-phthalic acid, which was probably primarily emitted from combustion of solid wastes containing polyethylene terephthalate plastics. Spatial patterns and correlations with typical source tracers suggested that C14–C32fatty acids were mainly primary while dicarboxylic and aromatic acids were largely secondary. Principal component analysis resolved six sources including biomass burning, natural higher plant wax, two mixed anthropogenic and two secondary sources; further multiple linear regression revealed their contributions to individual organic acids. It turned out that more than 70% of C14–C18fatty acids were attributed to anthropogenic sources, about 50%–85% of the C20–C32fatty acids were attributed to natural sources, 80%–95% of dicarboxylic acids and 1,2-phthalic acid were secondary in contrast with that 81% of 1,4-phthalic acid was primary.     

Efficient dechlorination of chlorinated solvent pollutants under UV irradiation by using the synthesized TiO2 nano-sheets in aqueous phase

Titanium dioxide(TiO2), which is the widely used photo-catalyst, has been synthesized by simple hydrothermal solution containing tetrabutyl titanate and hydrofluoric acid. The synthesized product has been applied to photo-degradation in aqueous phase of chlorinated solvents, namely tetrachloroethene(PCE), trichloroethene(TCE) and 1,1,1-trichloroethane(TCA). The photo-degradation results revealed that the degradation of these harmful chemicals was better in UV/synthesized TiO2 system compared to UV/commercial P25 system and UV only system. The photo-catalytic efficiency of the synthesized TiO2 was 1.4, 1.8 and 3.0 folds higher compared to the commercial P25 for TCA, TCE and PCE degradation, respectively. Moreover, using nitrobenzene(NB) as a probe of hydroxyl radical(.OH), the degradation rate was better over UV/synthesized TiO2, suggesting the high concentration of.OH generated in UV/synthesized TiO2system. In addition,.OH concentration was confirmed by the strong peak displayed in EPR analysis over UV/synthesized TiO2system. The characterization result using XRD and TEM showed that the synthesized TiO2 was in anatase form and consisted of well-defined sheet-shaped structures having a rectangular outline with a thickness of 4 nm, side length of 50 nm and width of 33 nm and a surface 90.3 m2/g. XPS analysis revealed that ≡Ti-F bond was formed on the surface of the synthesized TiO2. The above results on both photocatalytic activity and the surface analysis demonstrated the good applicability of the synthesized TiO2 nano-sheets for the remediation of chlorinated solvent contaminated groundwater.     

Dyes adsorption using a synthetic carboxymethyl cellulose-acrylic acid adsorbent

Removal of noxious dyes is gaining public and technological attention. Herein grafting polymerization was employed to produce a novel adsorbent using acrylic acid and carboxymethyl cellulose for dye removal. Scanning electron microscopy and Fourier-transform infrared spectroscopy verified the adsorbent formed under optimized reaction conditions. The removal ratio of adsorbent to Methyl Orange, Disperse Blue 2BLN and malachite green chloride reached to 84.2%, 79.6% and 99.9%, respectively. The greater agreement between the calculated and experimental results suggested that pseudo second-order kinetic model better represents the kinetic adsorption data. Equilibrium adsorptions of dyes were better explained by the Temkin isotherm. The results implied that this new cellulose-based absorbent had the universaiity for removal of dyes through the chemical adsorption mechanism.