放电作用下四氯化碳的吸附、脱附及降解特性

考察了填充式反应器中放电对四氯化碳（CCl₄）的吸附、脱附作用影响．结果表明,放电作用下CCl₄在反应器中的移动速度加快,穿透时间的从17min缩短到6min,脱附时间约从60min缩短至14min,反应器对CCl₄的吸附能力显著下降;脉冲电压峰值越高,CCl₄吸附一脱附速率越快,降解效率越高．载气成分对CCl₄影响,在电压为50kV的条件下,分别以氮气和氧气作载气,CCl₄的降解效率可达69.1％和97.6％;放电可对吸附剂起脱附再生作用,具有放电脱附速率快、工艺简单等特点,有较好的应用前景．     

Technical and theoretical considerations in the HLA typing of amniotic fluid cells for prenatal diagnosis and paternity testing

HLA typing of amniotic fluid cells has been used for the prenatal diagnosis of the HLA linked diseases congenital adrenal hyperplasia (21-OH-deficiency (21-OH-def) type) and complement C4 deficiency and it has also been used for the prenatal de termination of paternity. There are, however, technical difficulties in this test associated with the weak expression of some B locus antigens on amniotic fluid cells, and theoretical difficulties related to associations between particular HLA antigens and the 21-OH-def allele. Since certain HLA-B locus antigens are found in significantly increased frequencies among patients with 21-OH-def, there is a relatively high incidence of HLA-B homozygosity among the patients and over 40 percent of the parents of these patients share one or more HLA-B locus antigens. Results of some prenatal HLA typing tests may thus be difficult to interpret, and supplementary tests should be used whenever possible. HLA typing of amniotic cells is, however, the only available procedure for prenatal diagnosis of C4 deficiency and it is the best available procedure for prenatal determination of paternity. A modification of our original procedure allows HLA typing to be performed with increased numbers of HLA typing sera, and sera with optimum reactivity for amniotic fluid cells have now been selected for the definition of most of the more commonly expressed HLA antigens. Although amniotic fluid cells do not express DR antigens, amniotic fluid cells can be typed for the HLA-linked marker glyoxalase I (GLO) and this may be the informative for prenatal diagnosis in some cases.     

废渣──Al(OH)_3凝胶再利用研究

研究了对处理铝材加工含Al3＋的酸性废液过程中产生的二次污染物Al（OH）3凝胶废渣的应用。含水分约90％、80％左右的Al（OH）3凝胶200g分别与14～16mL、22～24mL95％的工业浓硫酸酸反应，可制得浓度为20％～23％的Al（SO4）3溶液，经稀释可用作造纸原料。     

Relationships between anaerobic consortia and removal efficiencies in an UASB reactor degrading 2,4 dichlorophenol (DCP)

To gain more insight into the interactions between anaerobic bacteria and reactor performances (chemical oxygen demand-COD, 2,4 dichlorophenol-2,4 DCP removals, volatile fatty acid-VFA, and methane gas productions) and how they depended on operational conditions the microbial variations in the anaerobic granular sludge from an upflow anaerobic sludge blanket (UASB) reactor treating 2,4 DCP was studied. The study was composed of two parts. In the first part, the numbers of methanogens and acedogens in the anaerobic granular sludge were counted at different COD removal efficiencies. The relationships between the numbers of methanogens, the methane gas production and VFA production were investigated. The COD removal efficiencies increased to 74% from 30% while the number of total acedogens decreased to 10 from 30 cfu ml(-1). The number of total methanogens and acedogens varied between 11 x 10(3) and 10 x 10(9)MPN g(-1) and 10 and 30 cfu ml(-1) as the 2,4 DCP removal efficiencies were obtained between 60% and 99%, respectively. It was seen that, as the number of total acedogens decreased, the COD removal efficiencies increased. However, the number of total methanogens increased as the COD removal efficiencies increased. Correlations between the bacterial number and with the removal efficiencies obtained in different operational conditions were investigated. From the results presented in this paper a high correlation between the number of bacteria, COD removals, methane gas percentage, 2,4 DCP removals and VFA was observed. In the second part, methanogen bacteria in the anaerobic granular sludge were identified. Microbial observations and biochemical tests were applied to identify the anaerobic microorganisms from the anaerobic granular sludge. In the reactor treating 2,4 DCP, Methanobacterium bryantii, Methanobacterium formicicum, Methanobrevibacter smithii, Methanococcus voltae, Methanosarcina mazei, Methanosarcina acetivorans, Methanogenium bourgense and Methanospirillum hungatei were identified.     

A numerical study on the effects of EGR and spark timing to combustion characteristics and NOx emission of a GDI engine

EGR is one of the most significant strategies for reducing especially nitrogen oxides (NO_x) emissions from internal combustion engines. The thermal efficiency of spark ignition engines is lower than compression ignition engines because of its lower compression ratio. If the compression ratio is increased to obtain higher thermal efficiency, there may be a knocking tendency in spark ignition engines. EGR can be used in order to reduce NO_x emissions and avoid knocking phenomena at higher compression ratios. In-cylinder temperature at the end of combustion is decreased and heat capacity of fresh charge is increased when EGR applied. Besides EGR, spark timing is another significant parameter for reducing exhaust emissions such as nitrogen oxides, and unburned hydrocarbon (UHC). In this study the effects of EGR and spark timing on spark ignition engine were investigated numerically. KIVA codes were used in order to model combustion process. The combustion process has been modeled for a single cylinder, four stroke and gasoline direct injection (GDI) spark ignition engine. The results showed that in-cylinder pressure and heat release rate decrease as EGR ratio increase. In-cylinder pressure increases with the advancing of spark timing. Advancing spark timing increases the heat release rate and in-cylinder temperature. The simulation results also showed that EGR reduced exhaust gas temperature and NO_x emissions.     

A study on oxidative degradation of polyacrylamide in wastewater with UV/FENTON/C4H4O62−

The degradation of polyacrylamide (PAM) in simulate wastewater was studied in UV/Fenton/C₄H₄O₆^2? system. The factors such as molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2?, pH, and the dosage of Fenton reagent that could affect the PAM degradation in the UV/Fenton/C₄H₄O₆^2? system were investigated. The experimental results showed that adding C₄H₄O₆^2? to UV/Fenton system could form photosensitive ferrous complexes, which led to higher degradation efficiency of PAM. The degradation rate of PAM could be up to 95.2% under the following conditions: the concentration of H₂O₂, Fe²⁺, and C₄H₄O₆^2? were 22.5, 2.25, and 2.25 mmol/L, respectively (i.e., molecular ratio of H₂O₂/Fe²⁺/C₄H₄O₆^2? was 10:1:1), the pH value was 3.0.     

云桌面终端电源端传导骚扰和辐射骚扰整改案例

某云桌面终端在进行中国强制性认证(CCC)时,电磁兼容试验项目电源端传导骚扰、辐射骚扰测试均出现超标现象。将重点从PCB板级电路EMC设计方面剖析其测试不合格原因,并给出相应的整改措施,最后对此案例进行总结,给出类似电子产品在PCB设计时的注意事项,以期能给PCB设计工程师提供一些参考意见。     

碱激发胶凝材料及其固化Pb^2＋的试验研究

对碱激胶凝材料（碱-偏高岭土、碱-矿渣和碱-粉煤灰）与水-水泥体系固化Ph^2＋进行了试验研究,其中水-水泥体系为对比样。结果表明：对于相同稠度的碱激发胶凝材料,即使Pb^2＋含量达到2．4％,除了碱-粉煤灰的抗压强度略低外,其他都达到30MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子（Ph^2＋）浸出浓度,其规律性与其NH4交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性。     

碱激发胶凝材料及其固化Pb~(2+)的试验研究

对碱激胶凝材料(碱-偏高岭土、碱-矿渣和碱-粉煤灰)与水-水泥体系固化Pb2+进行了试验研究,其中水-水泥体系为对比样.结果表明:对于相同稠度的碱激发胶凝材料,即使Pb2+含量达到2.4%,除了碱-粉煤灰的抗压强度略低外,其他都达到30 MPa以上,满足填埋或做建筑基材的使用要求;与水泥相比,碱激发胶凝材料能显著降低重金属离子(Pb2+)浸出浓度,其规律性与其NH4+交换容量大小的规律性一致,与其固化体的抗压强度的大小没有相关性.     

Polychlorinated dibenzo-p-dioxins, dibenzofurans and polychlorinated biphenyls levels in human breast milk from different regions of Turkey

Human breast milk offers the optimal nutrition for all infants and have been widely used in biomonitoring programs to assess human exposure to lipophylic environmental contaminants such as polychlorinated dibenzo-p-dioxins (PCDD), polychlorinated dibenzofurans (PCDF) and polychlorinated biphenyls (PCB). There are no previous reports from Turkey on chemically determined levels of PCDDs, PCDFs, and PCBs in human breast milk expressed as World Health Organization (WHO) toxic equivalents (TEQ). To get an overview of the levels of these contaminants in Turkish human milk, samples from 51 Turkish women living in the Ankara, İstanbul, Antalya, Kahramanmaraş, and Afyon provinces were analyzed by high resolution gas chromatography/high resolution mass spectrometry (HRGC/HRMS) throughout 2007. The mean concentrations of WHO_PCDD/F-TEQ and WHO_PCB-TEQ of all samples from the five regions were 7.5 and 3.1 pg g⁻¹ on a lipid basis, respectively. PCDD/F concentrations ranged between 0.78 and 29.3 pg WHO-TEQ g⁻¹ fat (1.7 and 36.2 pg WHO-TEQ g⁻¹ fat, respectively, including PCB). Of the five studied locations, the lowest levels of ∑TEQs (PCDD/F + PCB) were found in the Afyon (6.8 pg WHO-TEQ g⁻¹ fat) and the highest in the Antalya (15.6 pg WHO-TEQ g⁻¹ fat) province. The results have been discussed in terms of regions and PCDD/F and PCBs for which analyses had been made. The mean levels of PCDD/Fs and PCBs in Turkish human milk are comparable to that found in other countries.