嗜水气单胞菌强化老化纳米零价铁去除水中Cr(VI)

基于老化对纳米零价铁（NZVI）去除水中Cr（VI）的不利影响,本研究考察了接种嗜水气单胞菌（Aeromonas hydrophila）强化老化NZVI对水中Cr（VI）的去除,并分析了溶解氧、温度、pH、Cr（VI）初始浓度对其去除Cr（VI）的影响,同时利用扫描电镜（SEM）、X射线光电子能谱（XPS）等分析了反应前后材料的形貌特征及Cr的价态变化.结果表明,接种嗜水气单胞菌能显著提高无氧条件下老化NZVI对Cr（VI）的去除效果,且在酸性条件和30~40 ℃条件下去除效果较好,可能是因为该条件下更有利于老化NZVI的腐蚀和微生物的生长,此外,Cr（VI）去除效率随Cr（VI）初始浓度升高而降低.在pH=6,温度为30 ℃,老化nZVI投加量为0.1 g·L^-1,Cr（VI）初始浓度为50 mg·L^-1的条件下反应24 h后,Cr（VI）的去除率可达到100%.XPS分析表明,反应后NZVI表面沉积的Cr主要以Cr（III）的形式存在,可能为Cr（OH）₃沉淀或Fe_xCr_1-x（OH）₃共沉淀物.动力学研究发现,Cr（VI）去除过程符合准二级动力学,去除机制为Cr（VI）的吸附、还原与共沉淀,其中以还原作用为主.     

基于MGWR模型的中国城市PM2.5影响因素空间异质性

基于全国297个地级市2018年PM_2.5浓度数据、自然与社会经济数据,采用多尺度地理加权回归（MGWR）模型分析了各影响因素对PM_2.5浓度的作用尺度与影响效果的空间异质性.结果表明,MGWR模型适用于中国地级市PM_2.5浓度影响因素研究.在作用尺度上,人均GDP、技术支持水平作用尺度最大,其次是相对湿度、居民地比重、人口密度与风速,降水量、第二产业比重、植被覆盖状况、温度与能源消费强度作用尺度最为局限.在影响效果上,相对湿度、人口密度与居民地比重全部为正向作用;第二产业比重和能源消费强度主要为正向作用,分别占总样本的70.71%与64.98%;风速、温度既存在正向作用也存在负向作用,空间上呈两极分化,其中正向作用分别占总样本的49.83%与57.91%;降水量、植被覆盖状况主要为负向作用,分别占总样本的91.58%与69.70%;人均GDP、技术支持水平全部为负向作用.研究结果表明各因素对于中国城市PM_2.5浓度的影响均存在着不同程度的空间异质性.     

Aging of PVDF and PES ultrafiltration membranes by sodium hypochlorite: Effect of solution pH

Sodium hypochlorite (NaClO) is a commonly applied cleaning agent for ultrafiltration membranes in water and wastewater treatment. Long-term exposure to NaClO might change the properties and performance of polymeric membranes, and ultimately shorten membrane lifespan. Active species in NaClO solution vary with solution pH, and the aging effects can change depending on the membrane material. In this study, the aging of polyvinylidene fluoride (PVDF) and polyethersulfone (PES) membranes by NaClO at pH 3–11 was investigated by examining variations in chemical composition, surface charge, surface morphology, mechanical strength, permeability, and retention ability. Polyvinyl pyrrolidone (PVP), which was blended in both membranes, was oxidized and dislodged due to NaClO aging at all investigated pH values, but the oxidation products and dislodgement ratio of PVP varied with solution pH. For the PVDF membrane, NaClO aging at pH 3–11 caused a moderate increase in permeability and decreased retention due to the oxidation and release of PVP. The tensile strength decreased only at pH 11 because of the defluorination of PVDF molecules. For the PES membrane, NaClO aging at all investigated pH resulted in chain scission of PES molecules, which was favored at pH 7 and 9, potentially due to the formation of free radicals. Therefore, a decrease in tensile strength and retention ability, as well as an increase in permeability, occurred in the PES membrane for NaClO aging at pH 3–11. Overall, the results can provide a basis for selecting chemical cleaning conditions for PVDF and PES membranes.     

Degradation of poly(butylene adipate-co-terephthalate) by Stenotrophomonas sp. YCJ1 isolated from farmland soil

In recent years, poly (butylene adipate-co-terephthalate) (PBAT) has been widely used. However, PBAT-degrading bacteria have rarely been reported. PBAT-degrading bacteria were isolated from farmland soil and identified. The effects of growth factors on the degradation of PBAT and the lipase activity of PBAT-degrading bacteria were assessed. The degradation mechanism was analyzed using scanning electron microscopy, attenuated total reflection Fourier transform infrared spectroscopy, proton nuclear magnetic resonance, X-ray diffraction, and liquid chromatography-mass spectrometry. The results showed that Stenotrophomonas sp. YCJ1 had a significant degrading effect on PBAT. Under certain conditions, the strain could secrete 10.53 U/mL of lipase activity and degrade 10.14 wt.% of PBAT films. The strain secreted lipase to catalyze the degradation of the ester bonds in PBAT, resulting in the production of degradation products such as terephthalic acid, 1,4-butanediol, and adipic acid. Furthermore, the degradation products could participate in the metabolism of YCJ1 as carbon sources to facilitate complete degradation of PBAT, indicating that the strain has potential value for the bioremediation of PBAT in the environment.     

Influence of particle size on the aggregation behavior of nanoparticles: Role of structural hydration layer

More and more attention has been paid to the aggregation behavior of nanoparticles, but little research has been done on the effect of particle size. Therefore, this study systematically evaluated the aggregation behavior of nano-silica particles with diameter 130–480 nm at different initial particle concentration, pH, ionic strength, and ionic valence of electrolytes. The modified Smoluchowski theory failed to describe the aggregation kinetics for nano-silica particles with diameters less than 190 nm. Besides, ionic strength, cation species and pH all affected fast aggregation rate coefficients of 130 nm nanoparticles. Through incorporating structural hydration force into the modified Smoluchowski theory, it is found that the reason for all the anomalous aggregation behavior was the different structural hydration layer thickness of nanoparticles with various sizes. The thickness decreased with increasing of particle size, and remained basically unchanged for particles larger than 190 nm. Only when the distance at primary minimum was twice the thickness of structural hydration layer, the structural hydration force dominated, leading to the higher stability of nanoparticles. This study clearly clarified the unique aggregation mechanism of nanoparticles with smaller size, which provided reference for predicting transport and fate of nanoparticles and could help facilitate the evaluation of their environment risks.     

Properties of a Poly(3-hydroxybutyrate) Depolymerase from Penicillium funiculosum

A poly(3-hydroxybutyrate) (PHB) depolymerase was purified from a fungus, Penicillium funiculosum (IFO6345), with phenyl-Toyopearl and its properties were compared with those of other PHB depolymerases. The molecular mass of the purified enzyme was estimated at about 33 kDa by sodium dodecyl sulfate (SDS) polyacrylamide gel electrophoresis. The pH optimum and pI were 6.5 and 6.5, respectively. The purified protein showed affinity to Con A-Sepharose, indicating that it is a glycoprotein. Diisopropylfluorophosphate and dithiothreitol inhibited the depolymerase activity completely. The N-terminal amino acid sequence of the purified enzyme was TALPAFNVNPNSVSVSGLSSGGYMAAQL, which contained a lipase box sequence. This purified enzyme is one of the extracellular PHB depolymerase which belong to serine esterase. The purified enzyme showed relatively strong hydrolytic activity against 3-hydroxybutyrate oligomers compared with its PHB-degrading activity. PHB-binding experiments showed that P. funiculosum depolymerase has the weakest affinity for PHB of all the depolymerases examined.     

结合外场观测分析珠三角二次有机气溶胶的数值模拟

结合2008年11月18~25日期间珠三角地区的二次有机气溶胶(SOA)外场观测数据,验证区域空气质量模式WRF/Chem(weather research and forecasting model with chemistry)中两种SOA化学机制——VBS(volatile basis set)和SORGAM(secondary organic aerosol model)对珠三角SOA的模拟效果.VBS机制考虑了更为广泛的SOA前体物和化学老化过程,SOA模拟值更接近观测值,能合理反映SOA观测值的逐天变化趋势,与观测值的平均绝对偏差和相关性分别是-4.88μg·m-3和0.91,而SORGAM机制的分别为-5.32μg·m-3和0.18.利用VBS机制模拟区域内SOA的时空分布,结果显示SOA浓度具有显著的昼夜变化特征,浓度峰值出现在中午时段.受到输送和臭氧区域分布的影响,各城市SOA浓度差异显著,下风向的城市(如中山、珠海、江门)SOA浓度较高.     

电捕法净化焙烧炉沥青烟气

针对炭素焙烧炉烟气特点,采用雾化水预处理和电捕焦油技术,对某炭素厂焙烧炉烟气进行治理,达到既高效净化有害气体,又降低资金投入。处理后的烟气指标为:沥青烟浓度13.8mg/m3,苯并(a)芘浓度0.053×10-3mg/m3,烟尘浓度19.1mg/m3,各项污染物均达标排放。     

阴离子型聚丙烯酰胺相对分子质量和水解度对污泥脱水性能影响的研究

通过对污泥絮凝颗粒粒径分布、污泥比阻、泥饼含固率、上清液体积及其中核酸、蛋白质和总糖浓度的测定,研究了不同剂型和剂量阴离子型聚丙烯酰胺（PAM）对城市污泥沉降性能和脱水性能的影响及机制.结果表明,当PAM相对分子质量相同时,提高水解度能改善污泥的沉降和脱水性能;当PAM水解度相同时,提高相对分子质量亦可改善其沉降和脱水...     

建立我国战略环境评价理论与方法体系

战略环境评价是环境影响评价在战略层次上的应用，是具体落实可持续发展战略的重要工具。在分析其现实意义的基础上，提出我国战略环境评价理论与方法体系的主要研究内容，就建立我国战略环境评价理论与方法提出建议。