柠檬酸浸出废弃电池材料中镍钴锰金属的研究

随着锂离子电池使用领域和范围越来越广泛,其产销量日益增长,由此产生的废旧锂离子电池的回收处理问题也日趋严重.如何提高废旧电池中锂镍钴锰等有价金属的回收效率,以及在回收过程中减少对环境造成的二次污染,是目前环境科研者研究的热点问题.以柠檬酸为浸出酸,研究了废弃锂离子电池正极材料镍钴锰酸锂在柠檬酸溶液中浸出效果,比较不同反应时间、反应温度、柠檬酸浓度、固液比以及添加双氧水和硫代硫酸钠对镍钴锰浸出效率的影响.结果表明延长反应时间、提高反应温度和柠檬酸浓度有利于有价金属的浸出,双氧水和硫代硫酸钠的添加对镍钴锰的浸出有显著促进作用.     

农田施用水葫芦对水稻氮素吸收利用的影响

以粳稻品种运2645为供试材料,设计农田施用水葫芦(将晒干水葫芦按4 500 kg·hm-2农田施用)、不施用水葫芦处理和施N量为120 kg·hm-2(LN)、240 kg·hm-2(NN)处理,研究其对水稻不同生育时期N素含量、N素吸收、N素分配和N素利用效率的影响.结果表明:①农田施用水葫芦使水稻不同生育时期植株...     

北京城区夏季O3化学生成过程

选取2007年7月1日—8月31日中的21个晴空日,利用观测资料和光化学箱模式计算了北京城区测点的O₃生成速率G(O₃)和O₃生成效率OPE.结果表明,21个晴空日中G(O₃)日最高小时值分布在(18~82)×10^-9h^-1之间;在O₃污染和非污染日G(O₃)最高值的平均水平无显著差异,且与O_x浓度之间不存在一致的对应关系,表明O₃化学生成过程不能全面解释地面O₃浓度的累积,物理传输过程对测点O₃实测浓度有显著作用;各个化学过程对G(O₃)的贡献率对比结果显示,HO₂ 在 NO向NO₂的转化中贡献最大;OPE值分布在2.8~5.8之间,总体水平为4.1±0.1;OPE值与NO_x浓度之间为非线性关系,OPE值随NO_x浓度的增加而减少,表明消减测点附近VOCs排放能有效降低O₃浓度.     

塔体倾斜条件下船舶尾气SO2洗涤脱除强化

针对恶劣海况下船舶洗涤塔倾斜的情况,利用船舶尾气净化小试试验台,开展了洗涤塔不同倾斜角度下对镁基吸收剂脱硫效率影响的实验,研究了液气比、入口SO₂浓度、烟气量、浆液pH值、对洗涤塔内SO₂脱除效率的影响.结果表明：脱硫效率随洗涤塔倾角度的增大而降低.脱硫效率随液气比的增大而升高,较低的液气比时倾斜角度对SO₂脱除效率的影响更明显;脱硫效率随SO₂入口浓度的增大而略微降低,入口SO₂浓度较高时,SO₂脱除效率的降低随倾斜角度的增加变化较为明显;相同液气比条件下,脱硫效率随塔内烟气量的增加而升高;脱硫效率随浆液pH值的增大而升高,低pH值时SO₂脱除效率的降低随倾斜角度的增加变化较为明显.筛板-边壁环的加入可有效提高倾斜条件下洗涤塔的脱硫效率,倾斜角度为15°时,脱硫效率提高将约3%;倾斜角度为10°时,脱硫效率提高约5%;倾斜角度在5°以下时,脱硫效率可提高将近7%.     

生物过滤塔处理工业有机废气

选用生物载体作为反应器的填料,并利用沈阳北部污水处理厂的活性污泥对填料进行挂膜,由低到高通入工业有机气体进行驯化。在系统稳定后进行了生物过滤塔净化工业有机气体的实验研究。实验结果表明:入口气体浓度<25mg/m3时,有机废气的净化效率可保持在97%以上,当超过此值时,效率有明显下降。随着进口气体流量的增加,净化率逐渐下降,由入口流量为0.2m3/h时的97.2%下降到入口流量为0.8m3/h时的73.0%。湿度对净化率的影响较大,其中当湿度达到40%以上时,反应器有良好的去除效果。生物过滤塔的压降随着气体流量和填料高度的增加而增加。     

The potential for improvements in energy efficiency and CO2 emissions in the EU27 cement industry and the relationship with the capital budgeting decision criteria

This paper performs a cost-effectiveness analysis of some of the best available technologies (BAT) that can contribute to decreasing the energy consumption and CO₂ emissions in the European Union’s (EU27) cement industry. Several capital budgeting decision criteria have been used (the payback period, the net present value and the internal rate of return) to study whether or not an investment should be considered worthwhile. The results show that, independent of the capital budgeting decision criteria used, the number of cost-effective retrofitting possibilities available is large compared to the rate of improvements that the industry undertakes annually. This shows the insensitivity of the industry to financial criteria when it comes to making their investment decisions. The possible thermal energy improvement in the clinker production, if all these BATs were implemented, has been quantified to be around 10%. This achievement would place the cement industry in the upper bound of the benchmark range for clinker manufacture. However considering the delays observed nowadays in terms of diffusion of BATs in the cement industry, it requires a conducive policy environment that combines support for both technology development and to their deployment.     

新型单室无质子膜微生物燃料电池性能研究

采用不锈钢金属丝阳极构建了管状单室无质子交换膜空气阴极微生物燃料电池(MFC),并以葡萄糖为唯一电子供体,研究MFC的性能.在室温下,初始ρ(CODCr)为496 mg/L,外接电阻为1 000 Ω时,该MFC可以连续产电,最高电压达235.11 mV,开路电压为461.00 mV,内电阻约2 820 Ω.实验条件下测得该MFC的最大功率密度为137.1 mW/m2,库仑效率为32.4%.采用该MFC进行了啤酒酿造废水处理对比实验,在进水ρ(CODCr)为15 900 mg/L,停留时间为96 h下,MFC对废水CODCr的去除率达40%～55%,比厌氧生物处理效率高5%～10%.表明MFC技术可以在获得电能的同时,强化有机废水的生物处理过程.     

污泥增活剂影响MBR处理效果试验研究

向一体式膜生物反应器(Membrane Bioreactor,MBR)中投加污泥增活剂,与普通MBR进行试验对比,考察了污泥增活剂-MBR复合工艺对污染物去除的强化作用及对混合液污泥特性的影响。结果表明,污泥增活剂不仅提高了COD和氨氮的去除效果,而且由于增活剂与污泥形成的生物团粒的有效作用使系统总氮去除率提高10%以上。污泥增活剂-MBR中污泥混合液胞外聚合物(extra-cellular polymeric substances,EPS)含量高于MBR,上清液溶解性微生物产物(soluble microbial products,SMP)和Zeta电位相对较低,及EPS与SMP和Zeta电位的变化对应规律,说明污泥增活剂使EPS含量升高,促进了污泥活性的提高。较低的SMP浓度将降低膜自身污染的程度,活性炭的作用可使泥饼层结构疏松,能够减缓泥饼层带来的膜通量下降。     

Performance of a large-scale greenhouse solar dryer integrated with phase change material thermal storage system for drying of chili

ABSTRACT

Large-scale greenhouse solar dryers have been used for drying various products and this type of dryer is usually equipped with LPG burner as auxiliary heater, which creates more operating cost. To overcome this problem, phase change material (PCM) thermal storage was proposed to substitute for the LPG burner. In this work, the performance of a large-scale greenhouse solar dryer integrated with a PCM as a latent heat storage for drying of chili was investigated. Experimental studies were conducted to compare the performance of this dryer with that of another large-scale greenhouse solar dryer without the PCM thermal storage and open sun drying. Chili with an initial moisture content of 74.7% (w.b.) was dried to a final moisture content of 10.0% (w.b.) in 2.5 days, 3.5 days, and 11 days using the solar dryer integrated with the PCM thermal storage, the solar dryer without the PCM thermal storage and the open sun drying, respectively. The performance of the solar dryer integrated with the PCM thermal storage was also evaluated using exergy analysis. The exergy efficiency of the drying room of the solar dryer integrated with the PCM thermal storage and the solar dryer without the PCM thermal storage for drying of chili was found to be 13.1% and 11.4%, respectively and the thermal storage helps to dry chili during adverse weather conditions. The results of exergy analysis implied that the exergy losses from the dryer with the PCM should be reduced.     

Experimental and DFT insights into nitrogen and sulfur co-doped carbon nanotubes for effective desulfurization of liquid phases: Equilibrium & kinetic study

• Synthesis of NS-CNTS is used in a high desulfurization performance. • Synthesizing NS-CNT is considered as a novel adsorbent from low-cost precursors. • A high sulfur removal capacity for NS-CNT is attained compared with recent works. Herein, nitrogen and sulfur co-doped carbon nanotubes (NS-CNT) adsorbents were synthesized via the chemical vapor deposition technique at 1000°C by employing the camphor, urea and sulfur trioxide pyridine. In this study, desulfurization of two types of mercaptans (dibenzothiophene (DBT) and tertiary butyl mercaptan (TBM) as nonlinear and linear forms of mercaptan) was studied. In this regard, a maximum capacity of NS-CNT was obtained as 106.9 and 79.4 mg/g and also the removal efficiencies of 98.6% and 88.3% were achieved after 4 h at 298K and 0.9 g of NS-CNT for DBT and TBM, respectively. Characterization of the NS-CNTs was carried out through exploiting scanning electron microscopy (SEM), X-ray diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and elemental analysis (CHN). The isotherm equilibrium data could be ascribed to the Freundlich nonlinear regression form and the kinetic data was fitted by nonlinear form of the pseudo second order model. The negative values of ΔS⁰, ΔH⁰ and ΔG⁰ specify that the adsorption of both types of mercaptans was a natural exothermic process with a reduced entropy. Maintenance of more than 96% of the adsorption capacity even after nine cycles suggest the NS-CNT as a superior adsorbent for mercaptans removal in the industry. Density functional theory (DFT) calculations were also performed to peruse the effects of S/N co-doping and carbon monovacancy defects in CNTs toward the adsorption of DBT and TBM.