固定化微生物吸附剂对Cr3+的吸附特性研究

从皮革铬鞣、复鞣污泥等处分离、纯化出4株菌株TP、XB、MY和TQ,采用海藻酸钠悬滴法并添加膨润土制成微生物固定化吸附剂,研究该吸附剂对低质量浓度Cr3+的吸附特性。结果表明,4种固定化颗粒对低质量浓度Cr3+有较好的吸附作用。实验室条件下,当吸附温度为30℃时,6 h后固定化吸附剂进入缓慢吸附和平衡吸附阶段。吸附等温曲线拟合研究表明,不同温度下吸附剂适合不同的等温模型。4种微生物吸附剂均与Lagrange拟二级动力学模型拟合最佳,且吸附量从高到低为TQ、TP、XB、MY。颗粒内扩散模型研究表明,20℃下XB和MY对Cr3+的吸附分为快速吸附和缓慢吸附阶段;30℃和40℃下固定化颗粒均呈现表面吸附—缓慢吸附—平衡吸附过程。热力学研究表明,吸附反应均属于自发进行的吸热过程,并且均是化学吸附。     

煤和瓦斯突出过程中瓦斯作用机理的研究

阐述了瓦斯在煤和瓦斯突出过程中所起的作用 ;指出煤层中瓦斯的存在改变了煤岩体的物理力学性质及响应特性 ,使之成为非稳定介质 ;特别强调在瓦斯突出发生时 ,瓦斯膨胀能起了至关重要的作用 ;由于瓦斯的存在 ,加剧了煤体失稳破坏的过程。     

Adsorption of As(III) on chitosan-Fe-crosslinked complex (Ch-Fe)

It was reported the adsorption of As(III) on the surface of the chitosan-Fe-crosslinked complex. Theoretical correlation of the experimental equilibrium adsorption data for As(III)/Ch-Fe system is best explained by the non-linearized form Langmuir-Freundlich isotherm model. At optimum conditions, pH 9.0, the maximum adsorption capacity, calculated using the Langmuir-Freundlich isotherm model was 13.4 mg g⁻¹. The adsorption kinetics of As(III) onto Ch-Fe are described by the pseudo-first-order kinetic equation. The results of the Mössbauer spectroscopy showed that there is no redox process on the surface of the adsorbent.     

Industrial wastewater pre-treatment for heavy metal reduction by employing a sorbent-assisted ultrafiltration system

This work examined the adoption of a sorbent-assisted ultrafiltration (UF) system for the reduction of Pb(II), Cu(II), Zn(II) and Ni(II) from industrial wastewater. In such a system metals were removed via several processes which included precipitation through the formation of hydroxides, formation of precipitates/complexes among the metal ions and the wastewater compounds, adsorption of metals onto minerals (bentonite, zeolite, vermiculite) and retention of insoluble metal species by the UF membranes. At pH = 6 the metal removal sequence obtained by the UF system was Pb(II) > Cu(II) > Zn(II) > Ni(II) in mg g⁻¹ with significant amount of lead and copper being removed due to chemical precipitation and formation of precipitates/complexes with wastewater compounds. At this pH, zinc and nickel adsorption onto minerals was significant, particularly when bentonite and vermiculite were employed as adsorbents. Metal adsorption onto zeolite and bentonite followed the sequence Zn(II) > Ni(II) > Cu(II) > Pb(II), while for vermiculite the sequence was Ni(II) > Zn(II) > Cu(II) > Pb(II) in mg g⁻¹. The low amount of Pb(II) and Cu(II) adsorbed by minerals was attributed to the low available lead and copper concentration. At pH = 9 the adoption of UF could effectively reduce heavy metals to very low levels. The same was observed at pH = 8, provided that minerals were added. The prevailing metal removal process was the formation of precipitates/complexes with wastewater compounds.     

Adsorptive removal of an acid dye by lignocellulosic waste biomass activated carbon: equilibrium and kinetic studies

Chemically prepared activated carbon material derived from palm flower was used as adsorbent for removal of Amido Black dye in aqueous solution. Batch adsorption studies were performed for the removal of Amido Black 10B (AB10B), a di-azo acid dye from aqueous solutions by varying the parameters like initial solution pH, adsorbent dosage, initial dye concentration and temperature with three different particle sizes such as 100 μm, 600 μm and 1000 μm. The zero point charge was pH 2.5 and the maximum adsorption occurred at the pH 2.3. Experimental data were analyzed by model equations such as Langmuir, Freundlich and Temkin isotherms and it was found that the Freundlich isotherm model best fitted the adsorption data and the Freundlich constants varied from (K_F) 1.214, 1.077 and 0.884 for the three mesh sizes. Thermodynamic parameters such as ΔG, ΔH and ΔS were also calculated for the adsorption processes and found that the adsorption process is feasible and it was the endothermic reaction. Adsorption kinetics was determined using pseudo first-order, pseudo second-order rate equations and also Elovich model and intraparticle diffusion models. The results clearly showed that the adsorption of AB10B onto lignocellulosic waste biomass from palm flower (LCBPF) followed pseudo second-order model, and the pseudo second-order rate constants varied from 0.059 to 0.006 (g mg⁻¹ min) by varying initial adsorbate concentration from 25 mg L⁻¹ to 100 mg L⁻¹. Analysis of the adsorption data confirmed that the adsorption process not only followed intraparticle diffusion but also by the film diffusion mechanism.     

污水污泥在富氧环境下燃烧特性的实验研究

采用综合热分析仪研究了空气气氛和富氧气氛下污水污泥和煤的燃烧曲线,分析比较氧浓度对污泥燃烧特性参数的影响,并计算得到各工况下的动力学参数。结果表明：随着氧浓度增加,污泥燃烧DTG曲线向低温区移动,着火温度和燃尽温度均降低,综合燃烧指数大大提高,污泥燃烧特性得到改善。可用两段一级反应动力学模型来较好的描述污泥的主要燃烧过...     

恶臭假单胞菌降解苯酚的动力学研究

研究了恶臭假单胞菌（Pseudomonas putida LY1）利用苯酚作为唯一碳源和能源时的生长动力学特性。通过对该菌株在不同温度、pH和初始苯酚浓度下的生长和降解情况的研究,可知该菌株在温度为25℃左右、pH为中性和偏碱性的条件下具有更高的降解活性。细菌的生长动力学过程符合基质抑制型的Haldane方程,可利用该...     

Effects of compositional heterogeneity and nanoporosity of raw and treated biomass-generated soot on adsorption and absorption of organic contaminants

A biomass-generated soot was sequentially treated by HCl-HF solution, organic solvent, and oxidative acid to remove ash, extractable native organic matter (EOM), and amorphous carbon. The compositional heterogeneity and nano-structure of the untreated and treated soot samples were characterized by elemental analysis, thermal gravimetric analysis, BET-N₂ surface area, and electron microscopic analysis. Sorption properties of polar and nonpolar organic pollutants onto the soot samples were compared, and individual contributions of adsorption and absorption were quantified. The sorption isotherms for raw sample were practically linear, while were nonlinear for the pretreated-soot. The removal of EOM enhanced adsorption and reduced absorption, indicating that EOM served as a partitioning phase and simultaneously masked the adsorptive sites. By drastic-oxidation, the outer amorphous carbon and the inner disordered core of the soot particles were completely removed, and a fullerene-like nanoporous structure (aromatic shell) was created, which promoted additional π-π interaction between phenanthrene and the soot.     

湖泊沉积物中磷化氢的释放动力学初探

采用柱状芯样模拟法,研究了太湖沉积物-水界面磷化氢的释放动力学.结果表明:当沉积物-水界面磷化氢的释放达到动态平衡时,水界面中磷化氢的浓度基本不再增大,大约在0.34 pg·l-1左右,此时磷化氢的释放通量约为0.008 pg·dm-2·h-1.根据室内模拟结果,太湖沉积物每年的磷化氢释放量在13.81-49.62 g之间,从而使磷化氢在湖水中的平均浓度达到0.16 pmol·l-1.     

太阳光/电-Fenton法降解H-acid的表观动力学研究

进行了太阳光/电-Fenton法降解染料中间体H-acid模拟废水的表观动力学研究,通过对不同初始H-acid浓度和Fe2+浓度体系以及不同初始电压浓度体系反应的分析,确定该反应的表观动力学方程和动力学参数,为该技术降解H-acid废水优化反应条件提供了依据.结果表明,在固定初始pH值、支持电解质Na2SO4为0.10...