我国沿海地区城镇污水处理厂污泥重金属污染状况及其处置分析

采用ICP-MS分析法测定了我国3个典型沿海城市广州、上海和大连共13个污水处理厂污泥的7种重金属含量,并与2006年和2001年的数据进行了对比,以了解我国沿海城市污水处理厂重金属污染状况、变化趋势和处置方案.结果表明,我国沿海城市污泥中重金属污染分布存在较大差异,7种重金属平均含量大小顺序为Cr>Zn>Cu>Pb>As>Hg>Cd,Cr、Cu和As的含量超出了《城镇污水处理厂污染物排放标准》,污染严重.相对于以前,我国沿海城市污泥中Zn的含量明显减少,Pb、Hg和Cd的含量与没有明显变化,但Cr、Cu、As均明显增加.各区域各类型污水处理厂城市污泥重金属含量分析表明,来源于工业废水的城市污泥中Zn、Cu和Hg的平均含量较生活污水为主的污泥高;广州污水处理厂城市污泥中Cr、Pb、As、Hg和Cd的含量均高于上海和大连.沿海城市污水处理厂中超出《城镇污水处理厂污染物排放标准》中污泥农用标准限值的占总调查污水处理厂的23%,我国沿海城市污泥大部分仍可采用污泥农用的有益处置方式进行处置.同时,本次调查数据也为我国沿海城市开展污水污泥海洋倾倒相关技术标准的制定提供了基础数据.     

聚磷污泥去除高浓度铅的影响因素研究

利用聚磷活性污泥去除废水中的铅[ρ(Pb2+)=150.0 mg·L-1],研究了反应体系内不同溶解氧状况和初始pH值对污泥除铅的效率和稳定性的影响.结果表明,厌氧条件下,pH 6时,铅的去除率随时间增长呈上升趋势,32 d后铅去除率达99.8%,其中有机物及硫化物结合态铅、残渣态分别占41.8%和52.6%,污泥中铅的稳定性良好.好氧条件下,在相对较短时间内铅的去除率随pH上升而增加,反应2 h时,pH 6、pH 4和pH 2对应的铅的去除率分别为99.9%、96.9%和30.3%;而好氧32 d后pH 6、pH 4和pH 2的污泥中残渣态铅含量分别为3 072.3、4 726.8和2 359.1 mg·kg-1,分别占污泥中总铅的41.8%、65.8%和88.8%.综合考虑除铅率和除铅后污泥稳定性,好氧且pH 4理论上是聚磷污泥除铅的最佳条件.     

进水底物浓度对蔗糖废水产酸合成PHA影响研究

混合菌群合成生物可降解塑料(PHA)成为目前研究的热点,三段式PHA合成工艺(水解产酸、产PHA菌富集、PHA合成)被广泛应用.在三段式工艺中,产PHA菌的富集非常关键,只有稳定产生PHA菌才能保障PHA合成的产量.针对产PHA菌富集系统容易出现污泥膨胀的问题,本研究考察了进水底物浓度对产PHA菌富集效率及运行稳定性的影响.在560mg·L-1、1 120 mg·L-1、1 680 mg·L-1这3组不同进水底物浓度的对比实验中,证实了COD 1 120 mg·L-1条件下富集反应器能够在较短污泥龄下稳定富集具有较高污泥浓度的高效产PHA菌,且不会发生污泥膨胀.在94 d的富集期后其批次实验最大PHA含量、PHA转化率(COD/COD)及PHA比合成速率能分别达到50%、0.714 5及0.191 2 mg·(mg·h)-1.研究还同时证实细胞内糖原水平高低与其PHA合成能力密切相关,可采用其作为富集效果的重要检测指标之一.     

Cost-performance analysis of nutrient removal in a full-scale oxidation ditch process based on kinetic modeling

A full-scale oxidation ditch process for treating sewage was simulated with the ASM2d model and optimized for minimal cost with acceptable performance in terms of ammonium and phosphorus removal. A unified index was introduced by integrating operational costs (aeration energy and sludge production) with effluent violations for performance evaluation. Scenario analysis showed that,in comparison with the baseline (all of the 9 aerators activated), the strategy of activating 5 aerators could save aeration energy significantly with an ammonium violation below 10%. Sludge discharge scenario analysis showed that a sludge discharge flow of 250–300 m3/day (solid retention time (SRT), 13–15 days) was appropriate for the enhancement of phosphorus removal without excessive sludge production. The proposed optimal control strategy was: activating 5 rotating disks operated with a mode of "111100100" ( "1"represents activation and "0" represents inactivation) for aeration and sludge discharge flow of 200 m3/day (SRT, 19 days). Compared with the baseline, this strategy could achieve ammonium violation below 10% and TP violation below 30% with substantial reduction of aeration energy cost (46%) and minimal increment of sludge production (< 2%). This study provides a useful approach for the optimization of process operation and control.     

Biodegradation of 2-methylquinoline by Enterobacter aerogenes TJ-D isolated from activated sludge

Bacterial strain Enterobacter aerogenes TJ-D capable of utilizing 2-methylquinoline as the sole carbon and energy source was isolated from acclimated activated sludge under denitrifying conditions. The ability to degrade 2-methylquinoline by E. aerogenes TJ-D was investigated under denitrifying conditions. Under optimal conditions of temperature (35℃) and initial pH 7, 2-methylquinoline of 100 mg/L was degraded within 176 hr. The degradation of 2-methylquinoline by E. aerogenes TJ-D could be well described by the Haldane model (R² > 0.91). During the degradation period of 2-methylquinoline (initial concentration 100 mg/L), nitrate was almost completely consumed (the removal efficiency was 98.5%), while nitrite remained at low concentration (< 0.62 mg/L) during the whole denitrification period. 1,2,3,4-Tetrahydro-2-methylquinoline, 4-ethyl-benzenamine, N-butyl-benzenamine, N-ethyl-benzenamine and 2,6-diethyl-benzenamine were metabolites produced during the degradation. The degradation pathway of 2-methylquinoline by E. aerogenes TJ-D was proposed. 2-Methylquinoline is initially hydroxylated at C-4 to form 2-methyl-4-hydroxy-quinoline, and then forms 2-methyl-4-quinolinol as a result of tautomerism. Hydrogenation of the heterocyclic ring at positions 2 and 3 produces 2,3-dihydro-2-methyl-4-quinolinol. The carbon-carbon bond at position 2 and 3 in the heterocyclic ring may cleave and form 2-ethyl-N-ethyl-benzenamine. Tautomerism may result in the formation of 2,6-diethyl-benzenamine and N-butyl-benzenamine. 4-Ethyl-benzenamine and N-ethyl-benzenamine were produced as a result of losing one ethyl group from the above molecules.     

三槽氧化沟内底推位置与积泥厚度的分析研究

氧化沟工艺由于进水中含有大量的无机颗粒,无机颗粒的沉淀导致沟内积泥较厚。为了不影响正常生产,依据经验数据,依次对1号、2号氧化沟安装底推。对沟内积泥情况及影响因素进行分析比较,得出氧化沟的积泥主要由进水中密度较大的无机颗粒造成,且积泥规律与底推安装位置和运行情况相关。     

Differences in rheological and fractal properties of conditioned and raw sewage sludge

Rheological tests for raw and conditioned activated sludge(AS) or anaerobic digested sludge(ADS) show that power-law relationships can be used to describe the evolution of several rheological parameters,i.e.,limiting viscosity(η∞),yield stress(τy),cohesion energy of the sludge network(Ec),and storage modulus(G’),with total suspended solid(TSS) content in raw and conditioned sludge.A gel-like structure that behaves similar to weak-link flocs/aggregates was observed in AS and ADS.As derived from the double-logarithmic plots of G’-TSS content,the mass fractal dimensions of the raw and conditioned AS or ADS flocs/aggregates were 2.70 and 2.53 or 2.85 and 2.79,respectively.The rheological tests also indicate that both polymer conditioning and increased TSS content led to improved elastic behavior,cohesion energy,and yield stress of the sludge network,as well as expanded the corresponding linear viscoelastic range.The porosity of AS or ADS flocs/aggregates will be improved by polymer conditioning.     

活化温度对SCAC制备过程中副产物生成规律的影响

文章研究了污泥-玉米芯活性炭(SCAC)制备过程中,活化温度对副产物(热解气和热解油)生成规律的影响。热解气和热解油分别采用气相色谱仪和气质联用仪进行分析检测。试验结果表明,随着活化温度的升高,SCAC的产量逐渐降低,热解气与热解油的产量则随之增多。不同温度条件下,热解气的主要成分均为H2和CO2,热解气中H2所占的体积百分数随着活化温度的升高而增加,而CO2则相应降低。此外,热解气中CH4的含量也会随着活化温度的上升而略有提高,说明较高的活化温度更有利于热解气的资源利用。热解油组分较为复杂,每个温度条件下的液态产物都包括上百种化合物,可分为烷烃,烯烃,苯类,酚类,腈类,杂环化合物,多环芳烃,有机酸,酰胺,酯类,甾体,醇,酮以及其他类共14大类型,其中以有机酸、腈类和甾体类有机物含量居多。随着活化温度的升高,有机酸和多环芳烃的含量有所增加,而酚类化合物的含量则有所降低;当活化温度升高至650℃以上时,甾体类有机物含量明显降低。     

原子吸收火焰法次灵敏线测定污水和电镀污泥中高含量的锌

对采用原子吸收火焰法次灵敏线测定污水和电镀污泥中高含量的锌进行了研究。试验结果表明：在锌浓度50．0～600．0mg/L之间,溶液锌含量与吸光度呈线性关系。线性回归方程为y＝0．000661x-0．0007,相关系数γ＝0．9998。方法检出限为25．0mg/L,相对标准误差（RSD）＜2．96％,加标回收率为92．5％～105％,与标准法的相对误差＜2．76％。     

流化床污泥干燥器床料的颗粒度对流化情况的影响

以上海白龙港污水处理厂流化床污泥干燥系统为研究对象,针对流化床污泥干燥器流化情况的好坏分析,在确定其它变量（流化风量、给料分配器转速、料层压差、运行负荷等）不变的情况下,对床料颗粒度的工艺参数进行研究实验,总结颗粒度的工艺参数对流化情况的运行变化规律,从而提高了流化床污泥干燥系统的稳定性、连续性和高效性。