一种厌氧微观定量研究新方法

厌氧消化由于低成本和能源回收等优点越来越引起广泛关注.为克服现有方法研究动态厌氧过程的不足,基于微反应器和定量图像分析技术开发出一种新型的污泥层面的微观定量方法.试验首次展示了静态下颗粒污泥产气的动态过程和特点.试验结果重复性好.静态产气可分为3个阶段,分别是高速线性增加阶段、减速增加阶段和低速线性增加阶段.初始有机负荷较高时,高速线性增加阶段比较长,产气速率也比较高.结果表明,微反应器中进行厌氧产甲烷过程是可行的,该方法可靠,能够在微观层面直观地展示厌氧反应的动态过程,研究结果有利于增进对厌氧过程理解.     

pH和DO对好氧颗粒污泥去除高氨氮废水的影响研究

研究使用SBR成功培养的结构紧密、外形规则,具有良好脱氮性能的成熟好氧颗粒污泥处理高浓度氨氮废水,并探讨pH和DO对其处理效果的影响,旨在为工程实践提供理论依据。通过人工模拟废水,以蔗糖作为唯一碳源,NH4Cl为氮源,将进水NH4+-N浓度由300 mg/L逐步提高至900 mg/L,相应的NH4+-N负荷由0.6 kg/(m3.d)提高至1.8 kg/(m3.d),考察pH和DO对其处理效果的影响。研究结果表明:当控制反应器pH为8.0,曝气量为75 L/h时,好氧颗粒污泥脱氮的效果最好,氨氮去处率分别为96.70%9、2.33%。由于运行过程中每隔15 min监测每个反应器pH值,使其维持在各自pH值7.0±0.1范围内。这种酸碱度环境对异养菌等微生物并没有产生抑制作用;因此在各pH条件下,COD去除的所需时间和去除率基本没有差别。在不同的DO下,COD在初始的60 min里降解速度有明显区别。曝气量为150 L/h时,COD的降解速度最快,但是曝气量过大颗粒污泥内部厌氧区被压缩,因此选择最佳的曝气量为75 L/h。     

搅拌-序批式活性污泥反应器(WSBR)中好氧颗粒污泥的特性研究

为研究搅拌-序批式活性污泥反应器(WSBR)中好氧颗粒污泥的特性,利用WSBR反应器与传统SBR反应器对好氧活性污泥颗粒化的过程进行了比较.结果表明,在添加同量的聚炳烯酰胺(PAM)条件下,具有合理二次流场的WSBR反应器在4d就可见好氧颗粒污泥,而SBR反应器则在第10d才出现好氧颗粒污泥,且WSBR反应器中好氧颗粒...     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

应用新型好氧堆肥反应器连续投加处理人粪便的研究

针对间歇式堆肥反应器处理效率低、不便移动、单次投加所需物料量大等不足,以及为更有效地处理分散型人粪便,使人粪便资源化,开发了梨形筒式好氧堆肥反应器。在获得该反应器的最佳通风与搅拌频率分别为3.0 L/min,5 min/h以及最佳m（粪便）︰m（锯末）为1︰2.5的条件下进行连续投加人粪便好氧堆肥。在不接种微生物的30 d堆制过程中,升-降温周期为36 h,平均温度为51.44℃,第15天时COD降解率达到63.99%并趋于稳定,TN损失率第17天时达到56.68%,GI于第21天时达到106.25%,堆肥完全腐熟,稳定期处理效率为23.81 g/（L·d）。接种土著菌种时,升-降温周期缩短至24 h,平均温度为53.96℃,COD降解率8 d可达65.28%,TN 损失率仅为25.75%,GI于第8天达到108.22%,稳定期处理效率可达35.71 g/（L·d）,比不接种时提高1.5倍,同时节约能耗50%。     

中温和高温厌氧生物产氢反应器连续运行的研究

采用2个厌氧生物产氢反应器分别在中温(37℃)和高温(55℃)下连续运行.以河底沉积物接种,葡萄糖为基质,在CSTR中成功实现了连续中温厌氧产氢,最高产氢量达8.6L/(L·d),基质产氢摩尔比(H₂/葡萄糖)为1.98.以厌氧产甲烷颗粒污泥接种,蔗糖为基质,在UASB反应器中成功实现了连续高温厌氧产氢过程,最高产氢量达6.8L/(L·d),基质产氢摩尔比(H₂/蔗糖)为3.6.在高温UASB反应器中培养获得了灰白色的产氢颗粒污泥,平均粒径为0.8～1.2mm,沉速为30～40m/h,电镜观察发现其表层生长大量杆状细菌.对2种产氢污泥的总DNA进行提取和纯化,通过PCR扩增和DGGE分析,发现高温和中温厌氧产氢污泥中的大部分真细菌种类相同,但各自的优势菌种明显不同.     

低强度超声波强化剩余活性污泥好氧消化的研究

污泥是城市污水处理厂的副产物,若处理不当,将会带来一系列严重的环境问题.实验采用低强度超声波对剩余活性污泥(WAS)的好氧消化过程进行强化,选取超声强度、超声时间、超声间隔3个因素设计正交实验.结果表明,经超声辐照的WAS,其好氧消化时间最短仅约为13 d,比未经超声辐照的缩短了18.00 d.对实验结果的极差分析和方差分析表明,低强度超声波强化WAS好氧消化的最佳参数为:超声强度1.0 W/cm2、超声时间10 min、超声间隔8 h.实验还研究了WAS达标前后溶解性化学需氧量(SCOD)和总化学需氧量(TCOD)的变化情况,发现在相对较短的处理时间内,经低强度超声波强化处理的WAS的TCOD降解率仍然能与对照相近甚至高于对照,主要原因是低强度超声波强化了微生物的新陈代谢,促进了其对有机物的吸收分解.     

好氧硝化颗粒污泥膜生物反应器性能和膜污染研究

实验研究了好氧硝化颗粒污泥膜生物反应器AGMBR的处理性能,并将其与活性污泥膜生物反应器ASMBR进行对比,考察了颗粒污泥在减缓膜污染中所起的作用.好氧硝化颗粒污泥膜生物反应器AGMBR连续稳定运行102 d,系统具有良好的去除有机物和同时硝化反硝化能力,在进水COD和NH+4-N浓度分别为500和200 mg/L时,COD、NH+4-N和TN的去除率分别稳定在86%、94%和45%以上.颗粒污泥有效减缓了膜污染,延长了膜清洗的周期,AGMBR中的膜污染以膜孔堵塞为主,占总阻力的64.81%;滤饼层的阻力为2.1×1012m-1,远小于ASMBR中的16.07×10"m-1;膜清洗周期是相同条件下ASMBR的2.43倍以上;而且AGMBR内不断有新颗粒生成,维持了AGMBR系统性能和运行的稳定.     

Influence of Technological Process on Biodegradation of PVA/Waxy Starch Blends in an Aerobic and Anaerobic Environment

Improving biodegradability of PVA/starch blends is a reality already documented by a number of works. Admittedly, mechanical properties of products (for example, tensile strength) are somewhat worse, but suitable composition optimizing or chemical modifying of starch may eliminate the problem to a large degree. This work is an attempt to find another potential effect influencing biodegradability, that of technological procedure for producing films from these blends on an extruder. The procedure with a so-called pre-extrusion step (two-stage) and dry-blend (single-stage) produced blends of slightest differences in achieved biodegradability (virtually within limits of experimental error) in aerobic (76 vs. 79%) as well as anaerobic breakdown (48 vs. 52%). Conversely, morphological analysis exhibited superior homogeneity of films prepared by the two-stage process; their tensile strength was also higher.     

Aerobic treatment of swine manure to enhance anaerobic digestion and microalgal cultivation

Aerobic treatment of swine manure was coupled with anaerobic digestion and microalgal cultivation. A 14-day aerobic treatment reduced the total solid content of swine manure by >15%. Ammonia and carbon dioxide were stripped by the air supplied, and this off-gas was further used to aerate the culture of Chlorella vulgaris. The microalgal growth rates in Bristol medium and the wastewater with the off-gas increased from 0.08 to 0.22 g/L/d and from 0.15 to 0.24 g/L/d, respectively. Meanwhile, the aerobically treated swine manure showed a higher methane yield during anaerobic digestion. The experimental results were used to establish a demonstration unit consisting of a 100 L composter, a 200 L anaerobic digester, a 60 L tubular photobioreactor, and a 300 L micro-open raceway pond.