Spatial variations in selected metal contents and particle size distribution in an urban and rural atmosphere of Islamabad, Pakistan

Spatial variations in total suspended particulate matter (TSP) were investigated for distribution of metals and particle size fractions in the urban and rural atmosphere of Islamabad, Pakistan. The metals Na, K, Fe, Mn, Pb, Cd, Cr, Zn, Ni and Co, and the particle fractions <2.5, 2.5-10, 10-100 and >100 microm were included in the study. TSP samples were trapped on glass fibre filters using high volume samplers and quantification of metals was done using Atomic Absorption Spectrometry employing HNO(3) based wet digestion. At the urban site, Na was dominant at 2.384 microg/m(3) followed by K, Fe and Zn with 0.778, 0.667 and 0.567 microg/m(3) as mean concentrations, respectively. The metal levels for the rural site ranged from 0.002 microg/m(3) for Cd to 1.077 microg/m(3) for Na. However, compared with the urban site, mean Pb concentration showed an almost two-fold enhancement, i.e., 0.163 Vs. 0.327 microg/m(3). Metals and particle size source identification was done using Principal Component Analysis and Cluster Analysis. Five sources were traced out for the urban site: industrial, soil, automobile emissions, metallurgical industries and excavation activities. For the rural site, four sources were recorded: agricultural, automotive emissions, excavation activities and metallurgical units. Collectively, for both the sites, PM(10-100) emerged as a major contributor to TSP, followed by PM(2.5-10), PM(<2.5) and PM(>100) in that order. The metals showed in general positive relationship with fine particulate fractions (PM(2.5-10), PM(<2.5)), and negative correlation with coarse fractions (PM(10-100), PM(>100)). Comparison with the corresponding data from various Asian sites revealed that the levels of Na, K, Fe, Mn, Co and Ni for the present study were lower than those reported for grossly polluted cities of the world.     

Particle size distributions and health-related exposures of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) of sinter plant workers

This study measured particle size distributions of polychlorinated dibenzo-p-dioxins and dibenzofurans (PCDD/Fs) in two workplace atmospheres of the sintering grate and rough roll shredder in a sintering plant, and to assess their workers’ health-related exposures. We found that the PCDD/F concentration of the sintering grate (site A = 14.47 pg m⁻³) was lower than that of the rough roll shredder (site B = 17.20 pg m⁻³). Particle size distributions of PCDD/Fs were in the form of the unimodal with the mass median aerodynamic diameter (MMAD) of 4.74 μm and 5.23 μm, and geometric standard deviation (σ_g) of 3.15 and 2.15 for the site A and B, respectively. The above results suggest that the workplace of the site A had a less fraction of coarse particles than that of the site B. The estimated PCDD/F concentrations of the inhalable fraction (11.0 pg m⁻³) and thoracic fraction (8.89 pg m⁻³) of the site A were lower than those of the site B (12.4 and 9.39 pg m⁻³, respectively). But to the contrary the estimated respirable fraction of the site A (5.05 pg m⁻³) was slightly higher than that of the site B (4.93 pg m⁻³). Our results clearly indicate the importance to conduct particle size segregating samplings for assessing human PCDD/F exposures.     

Evaluation of methods for the physical characterization of the fine particle emissions from two residential wood combustion appliances

The fine particle emissions from a U. S. certified non-catalytic wood stove and a zero-clearance fireplace burning Quercus rubra L. (northern red oak) and Pseudotsuga menziesii (Douglas fir) cordwood each at two different moisture levels were determined. Emission testing was performed using both time-integrated and continuous instrumentation for total particle mass, particle number, particle size distribution, and fixed combustion gases using an atmospheric wind tunnel, full-flow laboratory dilution tunnel, and dilution stack sampler with a comparison made between the three dilution systems and two sampling filter types. The total mass emission factors (EFs) for all dilution systems and filter media are extremely variable ranging from <1 to 55 g kg⁻¹ of dry wood depending on the combination of appliance type, wood species and moisture content, filter medium, and dilution system. For Teflon filter sampling of stove emissions in the wind tunnel, the total mass EFs varied from 2 to 8 g kg⁻¹ of dry fuel depending on wood type whereas the equivalent fireplace emissions burning wet oak averaged 11 g kg⁻¹. A substantial number of ultrafine particles in the accumulation size range were also observed during all tests as determined by an Electrical Low Pressure Impactor (ELPI) and Scanning Mobility Particle Sizer. The PM-2.5 (particles ≤2.5 μm in aerodynamic diameter) fractions determined from the ELPI electrometer data ranged from 93 to 98% (mass) depending on appliance type as reported previously by Hays et al. (Aerosol Science, 34, 1061, 2003).     

Volcanic sulphate and arctic dust plumes over the North Atlantic Ocean

High time resolution aerosol mass spectrometry measurements were conducted during a field campaign at Mace Head Research Station, Ireland, in June 2007. Observations on one particular day of the campaign clearly indicated advection of aerosol from volcanoes and desert plains in Iceland which could be traced with NOAA Hysplit air mass back trajectories and satellite images. In conjunction with this event, elevated levels of sulphate and light absorbing particles were encountered at Mace Head. While sulphate concentration was continuously increasing, nitrate levels remained low indicating no significant contribution from anthropogenic pollutants. Sulphate concentration increased about 3.8 μg m⁻³ in comparison with the background conditions. Corresponding sulphur flux from volcanic emissions was estimated to about 0.3 TgS yr⁻¹, suggesting that a large amount of sulphur released from Icelandic volcanoes may be distributed over distances larger than 1000 km. Overall, our results corroborate that transport of volcanogenic sulphate and dust particles can significantly change the chemical composition, size distribution, and optical properties of aerosol over the North Atlantic Ocean and should be considered accordingly by regional climate models.     

Roles of SO2 oxidation in new particle formation events

The oxidation of SO₂ is commonly regarded as a major driver for new particle formation (NPF) in the atmosphere. In this study, we explored the connection between measured mixing ratio of SO₂ and observed long-term (duration > 3 hr) and short-term (duration < 1.5 hr) NPF events at a semi-urban site in Toronto. Apparent NPF rates (J₃₀) showed a moderate correlation with the concentration of sulfuric acid ([H₂SO₄]) calculated from the measured mixing ratio of SO₂ in long-term NPF events and some short-term NPF events (Category I) (R² = 0.66). The exponent in the fitting line of J₃₀ ~ [H₂SO₄]ⁿ in these events was 1.6. It was also found that SO₂ mixing ratios varied a lot during long-term NPF events, leading to a significant variation of new particle counts. In the SO₂-unexplained short-term NPF events (Category II), analysis showed that new particles were formed aloft and then mixed down to the ground level. Further calculation results showed that sulfuric acid oxidized from SO₂ probably made a negligible contribution to the growth of > 10 nm new particles.     

长江口潮滩含氯有机物的分布及与TOC、粒度的相关性

对长江口潮滩表层沉积物中的含氯有机物进行GC—ECD测试。结果表明,含氯有机物总量在1.159～54.957ng/g之间,平均值为11.204ng/g,其中多氯联苯(PCBs)含量<有机氯农药(OCPs)含量。含量高低分布随采样点位置变化显著,排污口附近出现最大值,离排污口越远,含量越低,总体显示出在近河口区含量远高于沿岸区。同时,PCBs和OCPs相关性分析结果表明,它们很可能具有相似的分布机制和输入来源。另外,长江口潮滩表层沉积物中含氯有机物的含量与TOC、粒度的相关性很低(r2<0.05),显示了研究区的特殊性和复杂性。     

Characterisation and seasonal variations of particles in the atmosphere of rural, urban and industrial areas: Organic compounds

Atmospheric aerosol samples(PM_(2.5–0.3), i.e., atmospheric particles ranging from 0.3 to2.5 μm) were collected during two periods: spring–summer 2008 and autumn–winter 2008–2009, using high volume samplers equipped with cascade impactors. Two sites located in the Northern France were compared in this study: a highly industrialised city(Dunkirk) and a rural site(Rubrouck). Physicochemical analysis of particulate matter(PM) was undertaken to propose parameters that could be used to distinguish the various sources and to exhibit seasonal variations but also to provide knowledge of chemical element composition for the interpretation of future toxicological studies. The study showed that PM2.5–0.3concentration in the atmosphere of the rural area remains stable along the year and was significantly lower than in the urban or industrial ones, for which concentrations increase during winter.High concentrations of polycyclic aromatic hydrocarbons(PAHs), dioxins, furans and dioxin like polychlorinated biphenyls(DL-PCBs), generated by industrial activities, traffic and municipal wastes incineration were detected in the samples. Specific criteria like Carbon Preference Index(CPI) and Combustion PAHs/Total PAHs ratio(CPAHs/TPAHs) were used to identify the possible sources of atmospheric pollution. They revealed that paraffins are mainly emitted by biogenic sources in spring–summer whereas as in the case of PAHs, they have numerous anthropogenic emission sources in autumn-winter(mainly from traffic and domestic heating).     

Chemical characterisation of particulate matter in urban transport modes

Traffic is a main source of air pollutants in urban areas and consequently daily peak exposures tend to occur during commuting. Personal exposure to particulate matter (PM) was monitored while cycling and travelling by bus, car and metro along an assigned route in Lisbon (Portugal), focusing on PM2.5 and PM10 (PM with aerodynamic diameter <2.5 and 10 µm, respectively) mass concentrations and their chemical composition. In vehicles, the indoor-outdoor interplay was also evaluated. The PM2.5 mean concentrations were 28?±?5, 31?±?9, 34?±?9 and 38?±?21?µg/m³ for bus, bicycle, car and metro modes, respectively. Black carbon concentrations when travelling by car were 1.4 to 2.0 times higher than in the other transport modes due to the closer proximity to exhaust emissions. There are marked differences in PM chemical composition depending on transport mode. In particular, Fe was the most abundant component of metro PM, derived from abrasion of rail-wheel-brake interfaces. Enhanced concentrations of Zn and Cu in cars and buses were related with brake and tyre wear particles, which can penetrate into the vehicles. In the motorised transport modes, Fe, Zn, Cu, Ni and K were correlated, evidencing their common traffic-related source. On average, the highest inhaled dose of PM2.5 was observed while cycling (55 µg), and the lowest in car travels (17 µg). Cyclists inhaled higher doses of PM2.5 due to both higher inhalation rates and longer journey times, with a clear enrichment in mineral elements. The presented results evidence the importance of considering the transport mode in exposure assessment studies.     

沈阳市大气细菌与真菌粒子的关系

用ＡＮＤＥＲＳＥＮ生物粒子采样器对沈阳市大气细菌和真菌粒子的密度、密度分布、粒度分布及两者关系进行了观察和。结果表明，沈阳市大气年平均密度细菌粒子为７２２８个／ｍ＾３，真菌粒子为１７９７个／ｍ＾３，细菌为真菌的４．１倍。细菌粒子密度和粒度均呈正偏态分布，真菌粒子密度和粒度均呈对数正态分布。〈８．２μｍ的可吸入粒子，细菌为４３２６个／ｍ＾３，占其总数的６１．４％；真菌为１５８３个／ｍ＾３，占其总数的     

空气微生物不同高度分布情况研究

空气微生物是城市生态系统重要的生物组成部分,空气中广泛分布的细菌、真菌孢子、放线菌和病毒等生物粒子不仅具有极其重要的生态功能,还与城市空气污染,城市环境质量和人体健康密切相关。从生态系统角度出发,着重论述了城市微生物气溶胶的粒谱范围、空气微生物浓度和组成在不同高度变化的相关规律。