超声辐射浸渍法制备Fe-Ni-Mn/Al2O3催化剂及性能研究

以Al2O3为载体,分别采用超声辐射浸渍法和普通浸渍方法制备Fe-Ni-Mn/Al2O3催化剂。采用BET、XRD和SEM对催化剂的理化性质和孔结构进行了分析,以模拟酸性绿B废水为研究对象考察催化剂的催化性能。实验结果表明,浸渍溶液pH值和焙烧温度显著影响催化剂的性能。与普通浸渍法相比,超声浸渍法制备的Fe-Ni-Mn/Al2O3催化剂对酸性绿B脱色反应表现出较高的催化活性。     

Role of dissolved humic acids in the biodegradation of a single isomer of nonylphenol by Sphingomonas sp

This study shows the important role of humic acids in the degradation of ¹⁴C and ¹³C labeled isomer of NP by Sphingomonas sp. strain TTNP3 and the detoxification of the resulting metabolites. Due to the association of NP with humic acids, its solubility in the medium was enhanced and the extent of mineralization of nonylphenol increased from 20% to above 35%. This was accompanied by the formation of significant amounts of NP residues bound to the humic acids, which also occurred via abiotic reactions of the major NP metabolite hydroquinone with the humic acids. Gel permeation chromatography showed a non-homogenous distribution of NP residues with humic acids molecules, with preference towards molecules with high-molecular-weight. Solid state ¹³C nuclear magnetic resonance spectroscopy indicated that the nonextractable residues resulted exclusively from the metabolites. The chemical shifts of the labeled carbon indicated the possible covalent binding of hydroquinone to the humic acids via ester and possibly ether bonds, and the incorporation of degradation products of hydroquinone into the humic acids. This study provided evidences for the mediatory role of humic acids in the fate of NP as a sink for bacterial degradation intermediates of this compound.     

H-ZSM-5分子筛吸附-氧化NOx的研究

针对湿法脱硫后船舶尾气特点,考察了3种不同硅铝比的H-ZSM-5分子筛对船舶脱硫后尾气中NO_x的吸附-氧化过程及其影响因素,并采用TPD研究了干气下不同硅铝比的分子筛吸附饱和后的脱附情况.结果表明:干气条件下,硅铝比低的分子筛具有较好的吸附效果;硅铝比高的分子筛具有较好的抗水性,但从干气到饱和湿度下,硅铝比为300的分子筛的NO氧化率从36%降至18%;干气下,低温有利于分子筛的吸附-氧化;分子筛用量增加能够增加其对NO_x的吸附效果和氧化效果.TPD结果表明:NO和NO2共吸附在分子筛上,3种分子筛中脱附出的NO_x中NO2均占脱附总量的80%以上,但在600℃时,NO_x在分子筛上脱附仍不完全.     

不同制备方法对Cu-SSZ-13催化性能的影响

为了考察制备方法对Cu-SSZ-13催化剂在氨选择性催化还原NO_x(NH_3-SCR)中催化性能的影响,使用不同的方法和载体,制备出理化性质有明显差异的3种催化剂(Cu_(3.9)-Na_(0.8)-SSZ-13、Cu_(5.1)-H-SSZ-13和Cu_(4.0)-Na_(4.0)-SSZ-13),并考察3种催化剂的水热稳定性和抗硫中毒性能.结果表明,由于具有适宜的Cu负载量,并且Cu物种的稳定性极高,一步合成法制备的Cu_(3.9)-Na_(0.8)-SSZ-13催化剂的水热稳定性优于液相离子交换法制备的两种催化剂.而以H-SSZ-13为载体,液相离子交换法负载Cu物种制备的Cu_(5.1)-H-SSZ-13催化剂具有最优的抗硫中毒能力,这与其较多的酸性位有关.因此,含有较多酸性位并且活性物种稳定性高是制备水热稳定性和抗硫中毒能力较优的Cu-SSZ-13催化剂的关键.     

济南市“十三五”环境保护所面临的形势研究

随着我国经济发展进入新常态,"十三五"期间的环境保护工作也进入新阶段,为准确制定济南市"十三五"环境保护规划,文章对济南市经济总体发展情况,农业、工业和服务业发展情况,以及能源消费情况等方面进行了全面分析和预测,对"十三五"期间济南市环境保护工作面临的问题进行了识别,以期对济南市"十三五"环境保护所面临的形式做出全面准确的研判。     

"十三五"环境保护的网络舆情研究

以百度为数据获取渠道,综合分析了以下几类环境保护网络舆情:(1) 环境保护"十三五"规划的网络舆情分析,包括网民关注热点和网民特征;(2)"十二五"期间,网民对"空气"、"水资源"、"生活垃圾"、"噪声"、"土壤"等问题的总体关注度;(3)"十二五"期间,网民对"空气"、"水资源"、"噪声"、"土壤"四类问题的关注焦点.把握网络舆情发展的规律和趋势,加强引导和管理,将有助于环境保护"十三五"规划的有效实施.     

1420铝锂合金模锻件锻造工艺的研究

利用高温变形实验 ,研究了 14 2 0铝锂合金在不同变形条件下的变形行为 ,获得合金的塑性图、变形抗力图、晶粒尺寸 变形程度关系图 ,确定出合金的锻造工艺参数 :锻造温度为 35 0～4 2 0℃ ,临界变形程度为 8%～ 10 % ,变形速率以低速为宜。结合实际情况 ,制定出合理的、经济的14 2 0铝锂合金模锻件成形工艺 ,即 6 0 0 0t水压机上多方锻开坯→车成锥体→ 80 0 0t卧式挤压机上终压模成形。生产出的 14 2 0合金模锻件尺寸精度高 ,综合性能优良。     

铝盐混凝除砷影响因素及机制研究

铝盐混凝法被广泛应用于饮用水除砷工程.本研究选取三氯化铝(AlCl3)和富含Al13的聚合氯化铝(PACl)为絮凝剂,考察铝形态、pH值、腐殖酸(HA)以及共存阴离子对砷去除的影响与机制.结果表明,2种絮凝剂对As(Ⅲ)去除效能较低,对As(Ⅴ)去除率可达到近100%.pH影响混凝过程中铝形态分布,从而对铝盐混凝除砷效能产生重要影响.铝盐除砷效能与混凝过程中的Al13形态含量呈正相关关系.由于竞争吸附作用,HA和部分共存阴离子对砷的混凝去除产生负面影响.HA对混凝效能影响与絮凝剂投药量相关,投药量越低,则影响越大.PO34-和F-对混凝除砷效能影响显著,SiO23-、CO23-和SO24-对混凝除砷效能影响较小.本研究将对饮用水强化混凝去除原水中砷具有指导意义.     

Preparation of high concentration polyaluminum chloride with high content of Alb or Alc

A novel membrane distillation concentration method was used to prepare high concentration polyaluminum chloride (PACl) with high content of Al_b or Al_c. 2.52 mol/L PACl₁ with 88% Al_b and 2.38 mol/L PACl₂ with 61% Al_c were successfully prepared. Three coagulants, AlCl₃, PACl₁ and PACl₂ were investigated on their hydrolysis behavior and speciation under different conditions. The effects of pH and dilution ratio on Al species distribution were investigated by ferron assay. Experimental result showed that pH had a significant effect on Al species distribution for the three coagulants. Dilution ratio had little effects on Al_b and Al_c distribution in whole dilution process except the beginning for PACl₁ and PACl₂. The results indicated that transformation of Al depends largely on their original composition. AlCl₃ was the most unstable coagulant among these three coagulants during hydrolysis process. PACl₁ and PACl₂ with significant amounts of highly charged and stable polynuclear aluminum hydrolysis products were less affected by the hydrolysis conditions and could maintain high speciation stability under various conditions.