硫酸盐还原颗粒污泥对Cr的吸附机理解析

以硫酸盐还原颗粒污泥作为研究对象,进行Cr的吸附容量研究及吸附等温线拟合,测定颗粒污泥中的硫化物含量、对比实验前后颗粒污泥的表面形态和微生物组成并采用傅里叶红外变换光谱(FTIR)分析颗粒污泥的表面基团。结果表明,颗粒污泥对Cr的吸附容量为6.84 mg/g,吸附过程可用Langmuir吸附等温式描述。颗粒污泥中硫化物含量达9.868 mg/g(湿重),对应每克颗粒污泥对Cr的最大吸附量可达10.69 mg;颗粒污泥表面生长大量的微生物,以杆菌为主,颗粒污泥表面丰富的微孔结构及微生物所分泌的胞外物均可有效吸附溶液中的Cr;FTIR分析结果显示,颗粒污泥中包含大量C=O、C-N及-S等基团,这些基团均可通过与C(rⅥ)或C(rⅢ)之间的静电吸附作用吸附溶液中的Cr。研究表明化学与生物吸附作用在硫酸盐还原颗粒污泥吸附溶液中的Cr过程中起到了重要的作用。     

离子色谱法测定大气中的甲磺酸

建立了以玻璃纤维膜-KB120气溶胶采样器采集大气中甲磺酸的采样方法;以0.1mmol·l-1H3BO3/0.1mmol·l-1 Na2B4O7为淋洗液的甲磺酸离子色谱分析方法.分析方法的精密度和准确度分别为5%和4%.并实测了青岛冬季大气气溶胶中MSA,SO2-4和NO-3的平均浓度分别为0.10μg·m-3,30.40μg·m -3和17.98μg·m-3.     

厌氧氨氧化电子受体的研究

在无机条件下,以该课题组已经培养出来的厌氧氨氧化污泥作为接种污泥,分别以硫酸盐、硝酸盐和亚硝酸盐为电子受体来研究氨的氧化反应。从去除速率的角度来看,以NO2--N、NO3--N和SO42--S为电子受体的反应器,分别在运行的第24.5天、40天和31天时达到0.030 0 kg/(m.3d)NH4+-N去除速率,则氧化氨的能力由大到小依次是:亚硝酸盐>硫酸盐>硝酸盐;从标准吉布斯自由能变化来看,3种反应都是可以发生的;以亚硝酸盐为电子受体的反应过程是一个消耗酸度的生物过程,而以硫酸盐为电子受体的反应过程是一个消耗碱度的生物过程。     

硫酸盐生物还原过程中涉硫组分代谢特性

通过硫酸盐生化代谢过程中涉硫组分（SO42-、SO32-、H2S、S2-、S2O32-、微生物含硫）等代谢特性模式研究,揭示了代谢过程中的主要限速步骤及过程代谢产物演替规律。SRB还原过程中限速步骤主要为亚硫酸根转化为硫化氢的过程,利用氮气吹脱硫化氢后,反应终点时各涉硫组分占总硫的51.38%,硫离子的量增加了2.09倍,硫酸根的去除率从83.5%提高到91.24%,亚硫酸根浓度呈现出降低的趋势;pH明显上升,并最终达到8.31,而无吹脱硫化氢的反应器最终pH为6.87。反应器中脱硫弧菌为优势菌,硫化氢被吹脱后,微生物在目、科、属水平上优势菌得到提高,硫化氢的存在抑制了优势菌的增殖。     

氯化铁和硫酸铁对酸性土壤中有效态镉和铅污染的修复作用

采用浸泡实验法研究了氯化铁和硫酸铁对酸性土壤中有效态镉和铅污染的修复效果,结果表明,氯化铁和硫酸铁均能有效去除土壤有效态镉和铅污染,Fe(Ⅲ)用量为50~100 mmol/kg时,有效态Cd和Pb的去除效果可达70%~96%。氯化铁和硫酸铁能去除土壤中的水溶态、碳酸盐结合态、腐殖酸结合态、铁锰氧化物结合态和强有机结合态Cd和Pb及交换态Cd。氯化铁和硫酸铁对Cd均既有洗脱修复作用又有固定修复作用,且洗脱修复作用的贡献稍大;氯化铁用量较小时(50 mmol/kg)对Pb既有固定修复又有洗脱修复作用,固定修复作用稍大;用量较大时(100 mmol /kg),对Pb只有洗脱修复作用。硫酸铁对Pb的修复作用则以固定修复作用为主,洗脱修复作用很小。     

石灰-聚铁法处理硫酸厂废水的研究

对各种处理硫酸厂废水的方法者了探讨,选择了以百石灰和聚合硫酸铁为药剂去除废水中砷,硫等污染物的方法。该法工艺简单,混凝剂投加量少,运行费用低,处理后的废水可达到排放标准。     

测定单个粒子的薄膜法及其应用

本文介绍改进后的薄膜法,主要是形态分析法和复合薄膜法。它们都是基于粒子和薄膜反应生成物的形态特征通过电镜来确定粒子成分的。前者可以检测单个酸性粒子,检出下限为７ ×１０－ １９ｇ;后者能同时检出一个粒子中所含的ＮＯ－３ 和ＳＯ２ －４ ,检出下限分别为３ ×１０－ １５ｇ 和７ ×１０－ １８ｇ。利用该方法对广州大气粒子进行了观察,结果表明改进后的薄膜法完全适用于对单个粒子的观察和测定。     

Experimental study on the effect of fly ash content in cemented paste backfill on its anti-sulfate erosion

ABSTRACT

In order to study the effect of fly ash content in cemented paste backfill (CPB) on its anti-sulfate erosion, the apparent phenomenon, strength development, and hydration products change the law of CPB with different fly ash content under long-term soaking of 5% sodium sulfate solution were studied by the macrotest and microanalysis, in addition, the mechanism of CPB anti-sulfate attack was analyzed by combining with a scanning electron microscope (SEM). The results indicated that the effect of sulfate environment on the strength of fly ash cemented paste backfill (FCPB) was mainly determined by the hydration products in the FCPB at different soaking times. In the early soaking stage, the formation of ettringite (AFt) in FCPB could improve its compactness, which was conducive to improving the strength of FCPB. In the late soaking stage, there were ettringite-type erosion damage and gypsum erosion-type damage internal of the FCPB with low content fly ash, resulting in microfracture, cracking of the FCPB, and reducing the strength. CPB with an appropriate content of fly ash could improve the internal structure of the FCPB to achieve the purpose of anti-sulfate erosion.     

Analysis of the recycling system for aluminum cans,focusing on collection,transportation, and the intermediate processing methods

In this article, the systems for the collection and intermediate processing of used beverage cans (UBCs) are compared and analyzed, focusing on the time taken and the cost of processing, the energy consumption, and the emissions of CO₂, SO _x , and NO _x , during the process. We found that cases where the UBCs were crushed in the discharging process gave better results, and how the UBCs were collected was the most important factor. It was more desirable to treat UBCs in one place than in two places. When the transportation distance was longer, the pressed form of UBCs was more convenient. When the transportation distance was short, the original form, the crushed form, and the shredded form of UBCs were all suitable. That is, the contribution of the transportation process to the evaluation was large when the transport distance was long, and the contribution of the treatment process was large when the transport distance was short.     

Experimental investigation of the lower flammability limit of volatile liquid fuel-aluminum powder mixtures in air

Aluminum powder was always chosen as an additive to improve the explosive performance. In this work, experiments were performed to investigate the lower flammability limit (LFL) of volatile liquid fuel-aluminum powder mixtures using a 20 L closed spherical stainless steel vessel at a temperature of 20 °C (293 K) and 40 °C (313 K). The volatile liquid fuels tested in the work were diethyl ether (DEE), epoxypropane (PO), n-pentane and n-hexane. DEE, PO and n-pentane are in the liquid phase at room temperature and can easily transition to the gas phase at 40 °C (313 K). Through a series of experiments carried out, it was found that the change in phase would affect the interaction between the components. Aluminum powder always has an inhibitory effect on the flammability of the mixtures when it is mixed with gas-phase fuels. The inhibition effect was most obvious when the aluminum powder concentration reached 200 g/m³. While the interaction between aluminum powder and liquid-phase volatile fuels was promotion and was influenced by the component proportion and the type of the volatile fuels.