二段混凝沉淀-曝气氧化-砂滤处理印刷电路板废水

探讨印刷电路板废水处理工艺。针对某印刷电路板厂废水水质特点,采用“二段混凝沉淀一曝气氧化一砂滤”工艺对其进行处理。运行结果表明,废水准确分类及预处理、曝气氧化和投加重金属捕捉荆是保证出水达标的重要措施。该工艺处理效果稳定,出水水质低于《污水综合排放标准》（GB8978-1996）中一级标准。本研究为印刷电路板废水的处理提供了一条可行途径。     

基于声发射技术的T700碳纤维/树脂基体界面性能评估

目的 采用声发射技术,对东丽T700碳纤维和2款树脂基体的界面性能进行评估。方法 通过多组单丝拉伸试验,获取T700碳纤维Weibull形状参数m和尺度参数σ₀。使用单纤维断裂方法,利用声发射技术进行监测,选择声发射信号的幅值和能量作为特征,对T700碳纤维和透明的E51环氧树脂及不透明的聚苯硫醚树脂的单纤维断点数量分别进行评估,并与显微镜观察的数量进行对比。结果 获取了T700碳纤维与2种树脂的单纤维断裂声发射信号特征数值。通过声发射监测和显微镜观察法,测量得T700碳纤维与E51环氧树脂的界面剪切强度分别为44.03、46.47 MPa,偏差在5.5%左右。通过声发射技术,测量得T700碳纤维与聚苯硫醚树脂的界面剪切强度达33.43 MPa。结论 使用声发射技术能够准确监测碳纤维/树脂界面中单纤维的断裂信号,为评价纤维和不透明树脂的界面性能提供了有效方法。     

手喷漆清洗剂的研制

为了有效地清除城市小广告以及街头涂鸦,研制了一种针对热塑性丙烯酸树脂类手喷漆的乳液型脱漆剂。采用单因素实验法研究了有机溶剂的种类、用量,主、助溶剂的质量比,表面活性剂的种类、用量,甲酸的用量,对脱漆效率的影响。实验结果表明:脱漆剂的最佳组成为以乙酸丁酯为主溶剂,苯甲醇为助溶剂,十二烷基苯磺酸钠和OP-10复配为表面活性剂,甲酸为促进剂,石蜡为挥发抑制剂。当乙酸丁酯为27 g,苯甲醇为9 g,十二烷基苯磺酸钠为1 g,OP-10为1 g,甲酸为2 g,石蜡为6 g时脱漆效率最高。在最佳实验配方及其用量的条件下,1 mL脱漆剂所能擦除漆膜的面积为70.65 cm2。并且脱漆剂中水含量超过50%,其余组成部分均为低毒、挥发性不大的物质,易于生物降解,市售常见,成本低廉,符合绿色化学"高效、洁净、经济、环保"的要求。     

环保型脲醛树脂胶粘剂的合成研究

介绍了聚乙烯醇(PVA)、三聚氰胺在脲醛树脂胶粘剂合成过程中所起的改性作用,研究了反应温度、反应体系pH、甲醛与尿素摩尔比、PVA和三聚氰胺用量对脲醛树脂胶粘剂性能的影响。试验结果表明,在反应温度为80℃、反应体系pH为5．0、甲醛与尿素摩尔比为1．5、PVA和三聚氰胺用量分别为尿素与甲醛溶液总质量的1．0％和5％的条件下,合成的脲醛树脂胶粘剂的剪切强度为2．99MPa,游离甲醛的质量分数由传统工艺生产产品的0．6％～0．8％降低至0．063％,耐沸水时间为108min,且贮存稳定性好,达到了HJBZ-1998国家环境标志产品技术要求。     

An efficient resin for solid-phase extraction and determination by UPLCMS/MS of 44 pharmaceutical personal care products in environmental waters

• A hydrophilic resin (GCHM) was facile synthesis and characterized. • Average absolute recovery of GCHM (75.6%) performs better than Oasis^® HLB. • Detection limits of method (SPE-UPLC-MS/MS) ranged between 0.03 and 0.6 ng/L. • 22 PPCPs were determined in environmental waters ranging from 0.5 to 1590 ng/L. In this study, a hydrophilic resin named GCHM was fabricated based on poly(N-vinyl pyrrolidone-co-divinylbenzene), characterized, and applied as a solid-phase extraction (SPE) material. Up to 44 pharmaceuticals and personal care products (PPCPs) belonging to 10 classes were recovered in environmental water samples. Different variables affecting extraction, such as adsorbent amount, sample pH, and loading speed, were optimized. Under optimal conditions, the average absolute recovery of 44 PPCPs was 75.6% using GCHM, indicating a better performance than the commercial Oasis^® HLB. SPE with home-made hydrophilic polymeric sorbent followed by ultra-performance liquid chromatography and tandem mass spectrometry was validated, and the method achieved good linearity (r²>0.991, for all analytes). In addition, the method detection limits of target compounds ranged from 0.03 to 0.6 ng/L. The developed method was applied to determine PPCPs in 10 environmental water samples taken from the Yangtze River, Huaihe River, and Taihu Lake, 1 groundwater sample from Changzhou in Jiangsu Province, 1 wastewater sample from Xiamen and 2 seawater samples from the Jiulong River in Fujian Province, China. In these samples, 22 compounds were determined at levels ranging from 0.5 to 1590 ng/L.     

树脂吸附法处理硝基苯和硝基氯苯生产废水的研究

研究了用ＣＨＡ－１１１树脂吸附处理硝基本和硝基氯苯生产废水的最佳工艺条件，当废水中硝基苯类化合物含量为６３９ｍｇ／Ｌ时，ＣＨＡ－１１１树脂的工作吸附容量为１２６ｍｇ／ｍＬ，处理水量为１９０ＢＶ，处理后硝苯类化合物的浓度〈５ｍｇ／Ｌ，去除率〉９９％；采用异丙醇作脱附剂；表明该树脂的吸附与脱附性能良好。     

OPA柱前衍生-反向高效液相色谱法测定水中游离氨基酸

采用邻苯二甲醛柱前衍生5种氨基酸,用反向高效液相色谱法测定衍生化产物,通过优化衍生化条件和色谱条件,使该方法在0.25μmol/L~25μmol/L范围内线性良好。方法检出限为0.08μmol/L~0.12μmol/L,标准溶液测定6次的RSD为0.1%~1.2%,空白加标样的回收率为80.3%~115%。用该方法测定实际水样,5种氨基酸测定值均低于0.514μmol/L,加标回收率在75.5%~120%之间。     

提高植物修复效率的技术途径与强化措施

通过物理、化学或生物学手段,从土壤、植物及其生境3个方面着手来提高植物去除土壤重金属能力是植物修复技术应用研究的重要方向.对国内外植物修复过程中所应用的强化手段与辅助措施进行了一定的研究,分别阐述了施肥、水分管理、耕作栽培、修复剂、生物技术等方法的作用机制及应用效果.今后,植物修复技术需针对有应用前景的超富集植物进行生境特征的系统研究,并着重开发高效、低风险的土壤修复剂,注重植物修复成套技术的工程应用研究.     

水中微量甲基膦酸类化合物的树脂富集与GC／MS分析

本文使用三种阴离子交换树脂（即大孔弱碱型Ｄ－３０１－Ｒ,强碱型Ｄ－２９６,２０１Ｘ７）柱对水中微量甲基膦酸类化合物的富集方法进行了研究。含磷毒剂降解产物的水样用气相色谱／质谱法进行定性定量分析。结果表明,Ｄ－３０１－Ｒ阴离子交换树脂柱对甲基膦酸的富集回收率高于６０％。     

In situ measurements of concentrations of Cd, Co, Fe and Mn in estuarine porewater using DGT

Vertical profiles of metals were measured by the in situ application of DGT (diffusive gradients in thin films). Well-defined laboratory systems ensured the good reproducibility and precision DGT accumulated metals on a chelex resin after diffusional transport through a layer of hydrogel. Three kinds of DGT probes (with three thicknesses of diffusive gel: 0.40 mm, 0.80 mm and 1.92 mm) measured interfacial concentration and induced flux from solid to solution phase which had intricate variations with depth. The DGT induced flux and interfacial concentration of four metals belonged to “partially sustained” state, indicating a labile equilibrium of metals between solid phase and porewater. The concentration profiles showed the good correlation between Mn and Co and peak concentrations of Mn and Fe between −2.00 cm and −5.25 cm with depth.