内循环(IC)反应器运行规律研究

研究采用自制内循环(IC)反应器,以实验室模拟废水为进水,接种城市污水处理厂的剩余污泥,对反应器的启动及运行过程进行研究,在经过污泥驯化、颗粒培养、调整及稳定的不同阶段连续运行.结果表明:启动初期反应器pH过低,产甲烷菌生长受抑制,导致VFA累积,容易酸化.通过改变模拟废水中微量元素的浓度及添加缓冲溶液,酸化的反应器可...     

Aerobic granules cultivated and operated in continuous-flow bioreactor under particle-size selective pressure

A novel method based on the selective pressure of particle size （particle-size cultivation method, PSCM） was developed for the cultivation and operation of aerobic granular sludge in a continuous-flow reactor, and compared with the conventional method based on the selective pressure of settling velocity （settling-velocity cultivation method, SVCM）. Results indicated that aerobic granules could be cultivated in continuous operation mode by this developed method within 14 days. Although in the granulation process, under particle-size selective pressure, mixed liquor suspended solids （MLSS） in the reactor fluctuated greatly and filamentous bacteria dominated the sludge system during the initial operation days, no obvious difference in profile was found between the aerobic granules cultivated by PSCM and SVCM. Moreover, aerobic granules cultivated by PSCM presented larger diameter, lower water content and higher specific rates of nitrification, denitrifieation and phosphorus removal, but lower settling velocity. Under long term operation of more than 30 days, aerobic granules in the continuous-flow reactor could remain stable and obtain good chemical oxygen demand （COD）, NH4^＋-N, total nitrogen （TN） and total phosphorus （TP） removal. The results indicate that PSCM was dependent on the cultivation and maintenance of the stability of aerobic granules in continuous-flow bioreactors.     

SFBR中好氧颗粒污泥的培养及特性研究

接种自行培养的活性污泥,以模拟废水为基质,采用连续进水、间歇出水及厌氧/好氧交替的运行模式,尝试了在SFBR中进行好氧颗粒污泥的培养,并研究了好氧颗粒污泥的特性及反应器对污染物的去除效果.结果表明,通过逐步缩短沉降时间,28 d时成功培养出好氧颗粒污泥,所形成的好氧颗粒污泥呈黄色、形状不规则,且粒径较小(平均粒径0.56 mm),正常情况下的SVI保持在70 mL·g-1以下,EPS在59 d时达到最大值(以MLVSS计)373.24 mg·g-1,较培养初期增加了约2.5倍,运行后期由于颗粒出现解体,导致EPS急剧下降;反应器在运行过程中未能保持较高的污泥量,中后期MLSS始终在3 000mg·L-1以下;在63 d的运行时间里,除异常波动外,反应器对COD的去除率基本维持在90%左右,正常情况下出水COD小于100 mg·L-1,反应器对NH+4-N、TIN的去除效果波动较大,去除率分别为44.45%~94.72%及43.87%~93.13%,反应器对TP的去除率在44.50%~97.40%之间,正常情况下TP去除率可维持在60%以上;限于自动控制水平,夜间长时间的好氧饥饿期容易造成丝状菌过度生长,使得AGS在生长竞争中处于劣势,最终导致了AGS的解体.     

连续流反应器短程硝化的快速启动与维持机制

如何快速稳定地启动短程硝化工艺对低C/N比废水的处理具有十分重要的实际应用价值.针对城市污水厂以连续流工艺为主的现状,故对连续流反应器短程硝化的快速启动与维持进行研究.结果表明,利用间歇曝气,依次控制3个阶段的停/曝时间(15 min/45 min、45 min/45 min和30 min/30 min),连续流反应器经过60 d左右的运行,可以成功实现短程硝化的快速启动.控制停/曝时间为30 min/30 min,进水氨氮浓度为50或100 mg·L~(-1)时,亚硝化率分别可达90%或95%.另外,间歇曝气有利于抑制硝化菌(NOB)的活性,而缩短水力停留时间(HRT)可淘洗出NOB,两者结合可以更好地维持短程硝化.     

SCAR处理城市生活污水的效能及其微生物群落动态分析

利用强化循环厌氧反应器(SCAR)处理模拟城市生活污水,研究不同负荷条件下的反应器运行特征、污泥特性及微生物种群结构.结果表明,水力停留时间(HRT)为6 h可以作为反应器高效运行的关键控制参数,该条件下污水化学需氧量(COD)去除率达到75%以上.随着反应器容积负荷的逐渐提高,颗粒污泥中辅酶F420和产甲烷活性(SMA)逐渐增加,胞外聚合物(EPS)含量也不断提高,其中紧密黏附EPS(TB-EPS)含量的增加尤其明显.厌氧颗粒污泥性状和反应器对污染物的去除效率同时受到污泥负荷和HRT的影响,微生物的群落结构及其在反应器中的空间分布也受到污泥负荷的影响,不同代谢特征微生物在反应器不同空间位置的相对丰度随着污泥负荷的调整而改变.     

低温条件IASBR处理养猪沼液脱氮性能研究

以实际养猪沼液为研究对象,考察分步进水间歇曝气序批式生物反应器(IASBR)在低温条件下的脱氮性能.结果表明:IASBR反应器的硝化性能临界水温为10℃,水温低于10℃时硝化性能急剧下降,水温10℃以上时氨氮去除率达到90%以上,且水温15℃以上氨氮负荷极限可达到0.30 kg·m~(-3)·d~(-1);低碳氮比(COD/TN)1.7±0.3条件下,反硝化性能临界水温为20℃,20℃以上时TN去除率可保持在80%以上,最高达90%,20℃以下时脱氮效率明显降低,出现亚硝态氮积累现象.此外,IASBR反应器脱氮除磷效率高,温度对TOC和TP去除率的影响不敏感.不排泥条件下,进水COD/TN为3.1±0.4时,TN去除率高达90%以上,TOC和TP去除率分别高达83.6%±3.9%和58.5%±17.8%;随后COD/TN降低至1.7±0.3后,TN去除率仍高达80%以上,TOC和TP去除率仅略有降低分别为77.3%±4.6%、53.1%±10.1%.     

Emergency shutdown of fluidized bed reaction systems

With several industrial applications of fluidized bed technology recently commercialized worldwide, it becomes essential to develop safe operation methods for fluidized bed reaction systems (FBRSs) to prevent any influence on their process values, which lead to accidents. To preventing any disaster or malfunction in an FBRS, an emergency shutdown system (ESD) is initiated, closing the reaction system in case of any abnormality by effectively isolating the flammable gas. However, an ESD is also prone to the “inactivation problem,” in which in the case of failure it initiates the emergency shutdown, even when the operating conditions of the reaction system are abnormal. It is also vulnerable to a “malfunction problem,” where the emergency shutdown is performed even when the operating conditions of the reaction system are normal. In this study, these problems were solved by investigating a reaction system through the monitoring of appropriate parameters and setting up of trigger levels, which reflect the uniqueness of an FBRS using an ESD. The parameters were identified by analyzing the scenario leading to an accident. The trigger levels were determined as the points at which the loss is smaller in the presence of an ESD, as compared to the value of the loss function in the presence or absence of an ESD. Furthermore, the ESD design model was applied as a case study in the ammoxidation process of propylene. The results showed that an ESD can prevent an approximately 8 billion yen of loss due to accidents in plant operations, against an investment of 200 million yen.     

ABR反应器的碱度变化及调控研究

研究了折流厌氧反应器(ABR)运行中碱度的变化情况及其与ABR各格室中VFA、pH和COD变化之间的关系.结果表明,碱度沿程变化与反应器的VFA浓度变化密切相关,碱度和pH值的最低点出现在VFA浓度最高点.碱度条件是通过pH值影响系统的运行.ABR沿程碱度和pH值变化都存在一个先降低后上升的过程.碱度控制一般以保证ABR沿程最低pH值不低于6.0为准,6.5以上为佳.进水碱度的下限与反应器的进水浓度密切相关.在低负荷COD条件下[3.7 kg/(m³·d)],保持ABR运行良好的最低碱度为800 mg/L.     

喷淋环栅式除尘脱硫反应器的数学模拟

研制了一种由内外圈构成的喷淋环栅式除尘脱硫反应装置,气、液两相在内外圈之间通向运动,紊流冲激环栅时接触传质。基于溶质渗透理论,提出了以内塔穿孔速率V,液气比L/G,吸收浆液pH值为参数的脱硫效率模型。对比某电厂工况条件下测得的一系列实验数据,显示出该模型与实际情况具有良好的一致性,表明该模型可以用来作为工程设计、最优化技术和推测工业数据的理论参考工具。     

The effects of leachate recirculation with supplemental water addition on methane production and waste decomposition in a simulated tropical landfill

In order to increase methane production efficiency, leachate recirculation is applied in landfills to increase moisture content and circulate organic matter back into the landfill cell. In the case of tropical landfills, where high temperature and evaporation occurs, leachate recirculation may not be enough to maintain the moisture content, therefore supplemental water addition into the cell is an option that could help stabilize moisture levels as well as stimulate biological activity. The objectives of this study were to determine the effects of leachate recirculation and supplemental water addition on municipal solid waste decomposition and methane production in three anaerobic digestion reactors. Anaerobic digestion with leachate recirculation and supplemental water addition showed the highest performance in terms of cumulative methane production and the stabilization period time required. It produced an accumulated methane production of 54.87 l/kg dry weight of MSW at an average rate of 0.58 l/kg dry weight/d and reached the stabilization phase on day 180. The leachate recirculation reactor provided 17.04 l/kg dry weight at a rate of 0.14l/kg dry weight/d and reached the stabilization phase on day 290. The control reactor provided 9.02 l/kg dry weight at a rate of 0.10 l/kg dry weight/d, and reached the stabilization phase on day 270. Increasing the organic loading rate (OLR) after the waste had reached the stabilization phase made it possible to increase the methane content of the gas, the methane production rate, and the COD removal. Comparison of the reactors' efficiencies at maximum OLR (5 kgCOD/m(3)/d) in terms of the methane production rate showed that the reactor using leachate recirculation with supplemental water addition still gave the highest performance (1.56 l/kg dry weight/d), whereas the leachate recirculation reactor and the control reactor provided 0.69 l/kg dry weight/d and 0.43 l/kg dry weight/d, respectively. However, when considering methane composition (average 63.09%) and COD removal (average 90.60%), slight differences were found among these three reactors.