介质阻挡放电反应器中的二硫化碳降解特性

为了解CS₂(二硫化碳)在介质阻挡放电反应器中的降解特性,提高其去除率,设计并制作了同轴圆柱介质阻挡放电反应器,研究了介质层数、外施电压、中心电极材料及直径、背景气氛种类和RH(相对湿度)对CS₂去除率的影响. 结果表明:在外施电压(4.0～6.5kV)较低时,单介质反应器的CS₂去除率高于双介质反应器;而在外施电压(6.5～9.0kV)较高时,双介质反应器对CS₂的去除效果更好,增大外施电压有利于CS₂的降解. 铜丝比不锈钢丝更适合用作反应器的中心电极,此外,增加中心电极的直径也可提高CS₂去除率. 当中心电极直径从 3.2mm增至4.8mm时,CS₂平均去除率由63%增至75%,但平均质量能耗由510kJ/mg增至611kJ/mg. 同等条件下,CS₂在氧气中的平均去除率(74%)最大,空气(59%)中次之,氮气(48%)中最小;背景气氛中适量的RH(26%)有助于提高CS₂去除率,但RH太大(大于50%)反而会降低CS₂去除率.      

雾化介质阻挡放电联合电晕放电对染料溶液脱色研究

实验将介质阻挡放电与电晕放电组合在一个反应器内,以靛蓝二磺酸钠溶液为实验废水,将高压电极上通入50Hz交流高压电,在常压空气中形成介质阻挡放电-电晕放电系统,放电产生的低温等离子体及其活性基团作用于染料分子。考察了电源电压、电极间距、处理时间对染料溶液脱色率和能量效率水平的影响,确定反应器工作状态为介质阻挡放电系统电极间距30mm、电晕放电系统电极间距25mm、电源电压20kV。     

气井完整性概念初探及评价指标研究

针对目前国内外尚无明确的气井完整性概念和生产气井完整性评价指标体系的现状,分析了现有的关于气井完整性解释的不足,初步提出了气井完整性的概念,强调了气井完整性是气井处于地层流体发生无控制流动的风险在可接受范围之内的状态。并根据此概念,从完整性管理、屏障设备、监测状态三个方面,建立了气井完整性评价指标体系,分析了各个评价指标与气井完整性的关系。屏障设备完整性是气井完整性的核心,完整性管理是提高气井完整性的关键,监测状态是气井完整性最直接的判断依据。     

Enhanced retention of linuron, alachlor and metalaxyl in sandy soil columns intercalated with wood barriers

A study has been made of the effect a reactive barrier made of pine (softwood) or oak (hardwood) wood intercalated in a sandy soil column has on the retention of linuron, alachlor and metalaxyl (pesticides with contrasting physicochemical characteristics). The leaching of pesticides has been carried out under a saturated flow regime and breakthrough curves (BTCs) have been obtained at flow rates of 1 mL min⁻¹ (all pesticides) and 3 mL min⁻¹ (linuron). The cumulative curves in the unmodified soil indicate a leaching of pesticides >80% of the total amount of compound added. After barrier intercalation, linuron leaching decreases significantly and a modification of the leaching kinetics of alachlor and metalaxyl has been observed. The theoretical R factors increased ∼2.6-3.3, 1.2-1.6-fold, and 1.4-1.7-fold and the concentration of the maximum peak decreased ∼6-12-fold, 2-4-fold and 1.2-2-fold for linuron, alachlor and metalaxyl, respectively. When considering the three pesticides, significant correlations have been found between the theoretical retardation factor (R) and the pore volume corresponding to the maximum peaks of the BTCs (r = 0.77; p < 0.05) or the total volume leached (r = −0.78; p < 0.05). The results reveal the efficacy of reactive wood barriers to decrease the leaching of pesticides from point sources of pollution depends on the type of wood, the hydrophobicity of the pesticide and the adopted water flow rate. Pine was more effective than oak in decreasing the leaching of hydrophobic pesticide linuron or in decreasing the maximum peak concentration of the less hydrophobic pesticides in soils. Efficacy of these wood barriers was limited for the least hydrophobic pesticide metalaxyl.     

阴极氧还原产电生物可渗透反应栅的研究Ⅰ. 不锈钢毛电极模拟反应器

提出利用阴极氧还原和阳极微生物产电作用的产电生物可渗透反应栅（CORE-PRB）方法用于被有机物污染的地下水的修复,并以不锈钢毛为电极建立模拟反应装置验证了CORE-PRB的技术概念。实验中考察了分别以蔗糖＋醋酸盐和不同浓度的污泥消化液为进水时的反应电流,并研究电极距离对反应电流的影响。由于氧还原阴极阳极反应能力的限制,随着与阴极室距离加大,模拟反应装置各阳极室的电流迅速减小。有机基质的可生化性对模拟反应器的总电流也有显著影响。     

温度对等离子体与催化剂结合脱除Nox的影响

考察了温度对介质阻挡放电和CuZSM-5催化剂"一段法"结合脱除氮氧化物(NOx)的影响.实验表明,在250℃和300℃时,对于NO/N2,NO/O2/N2和 NO/C2H4/N2三个体系,"一段法"脱除NOx的活性都相对较低.在NO/O2/C2H4/N2体系中,250℃介质阻挡放电和CuZSM-5结合脱除NOx产生了明显的协同效应.在300℃,等离子体对脱除NOx起负作用.相对低温(150℃)时,等离子体的促进作用很小.电学实验表明,当反应温度由25℃升至450℃,"一段法"体系的李萨如(Lissajous)图形由平行四边形(25℃)逐渐变为椭圆形(450℃),表明较高温度时催化剂的介电性质发生了变化.原位发射光谱证明在不同温度下,"一段法"体系中等离子体气相产生的活性物种数量明显不同.     

DBD反应器关键操作参数对2,4-二氯酚去除的影响

采用同轴喷雾式介质阻挡放电(DBD)反应器处理2,4-二氯酚(2,4-DCP)模拟废水,考察了水质、废水流量、载气流量、放电频率等关键操作参数对2,4-DCP去除的影响。自来水中的CO₃^2-/HCO₃^-能够中和生成的硝酸/亚硝酸(载气含N₂),同时也能清除放电过程中产生的自由基,因而不利于2,4-DCP的去除。在DBD反应器的操作参数中,载气流量对于活性组分的产生及气相到液相的传质有显著影响,是最为关键的操作参数。反应器操作参数的变化会影响放电过程。同轴式反应器和废水雾化对污染物的矿化有利。在废水流量50 mL/min、载气流量15 L/min、放电频率17 kHz的最佳条件下处理60 min,2,4-DCP和TOC的去除率分别为69.77%和31.85%。     

控制轨道交通噪声道间声屏障研究

应用环境噪声预测与分析软件SOUNDPLAN对将设置在上海轨道交通6#线上下行线之间的道间声屏障插入损失进行了模拟计算。计算结果表明,安装道间声屏障可使得距离线路20～30m远的较高层建筑获得2～4.7dB的降噪效果;随着两侧声屏障高度的增加,安装道间声屏障对待测表面的影响范围在缩小;离轨道线路越近,道间声屏障的插入损失越大。     

等离子体脱硫运行参数分析

利用介质阻挡强电离放电产生非平衡等离子体,进行模拟烟气脱硫。通过一次回归正交设计,对影响非平衡等离子体脱硫效率的因素进行了分析,建立了多元线性回归模型,分析了因子的主次,并得到了实验指标和各因子之间的定量规律。通过对模型的优化,获得了使脱硫率较高的各因素的最优组合。     

Toluene removal characteristics by a superimposed wire-plate dielectric barrier discharge plasma reactor

A superimposed wire-plate dielectric barrier discharge reactor was used to remove toluene in this study. The effects of oxygen content, gas flow rate, gas initial concentration and with/without catalyst on toluene decomposition were investigated. It was found that an optimal toluene removal was achieved when the oxygen content was about 5%. Under this condition, the highest toluene removal efficiency of 80.8% was achieved when the gas concentration was 80 mg/m^3. The toluene removal efficiency decreased with the increase of the gas flow rate and the initial concentration of toluene. In addition, the ozone concentration decreased with the increase of the initial concentration of toluene. It suggested that combining DBD （dielectric barrier discharge） with Co3O4/Al2O3/foam nickel catalyst in-situ could improve the toluene removal efficiency and suppress ozone formation. Products analysis showed that the main products were CO and CO2 when oxygen was more than 5%.