污泥增活剂影响MBR处理效果试验研究

向一体式膜生物反应器(Membrane Bioreactor,MBR)中投加污泥增活剂,与普通MBR进行试验对比,考察了污泥增活剂-MBR复合工艺对污染物去除的强化作用及对混合液污泥特性的影响。结果表明,污泥增活剂不仅提高了COD和氨氮的去除效果,而且由于增活剂与污泥形成的生物团粒的有效作用使系统总氮去除率提高10%以上。污泥增活剂-MBR中污泥混合液胞外聚合物(extra-cellular polymeric substances,EPS)含量高于MBR,上清液溶解性微生物产物(soluble microbial products,SMP)和Zeta电位相对较低,及EPS与SMP和Zeta电位的变化对应规律,说明污泥增活剂使EPS含量升高,促进了污泥活性的提高。较低的SMP浓度将降低膜自身污染的程度,活性炭的作用可使泥饼层结构疏松,能够减缓泥饼层带来的膜通量下降。     

电石渣理化性质的分析与表征

电石渣是电石水解获取乙炔气后产生的一种工业废渣。文章采用SEM、XRD和DSC/TG等现代测试手段,对其理化性质进行分析和表征,结果表明:电石渣是由一些十分细微颗粒组成,其化学成分主要是CaO,其次是Al2O3、SiO2等。电石渣中微量元素未超过排放标准、放射性符合建筑主体材料技术要求。电石渣是以Ca(OH)2为主晶相,并含有少量CaCO3。     

垂直潜流人工湿地堵塞微观概念模型的提出

根据垂直潜流人工湿地发生堵塞的成因主要是基质层中不可滤物质积累的结论,在分析垂直潜流人工湿地堵塞物形态及成分粒径的基础上,首次提出了基质间不可滤物质积累微观概念模型的假设;并根据微观概念模型,在考虑生物膜、无机物积累等动态变化因素条件下提出基质间完全堵塞所需时间、基质表面发生雍水所需时间及基质渗透系数随时间变化的关系.     

河水-地下水交互带沉积物中抗生素和代谢产物提取方法优化及其分布特征

河水-地下水交互带是污染物发生富集、降解和转化等生物地球化学过程的重要场所.抗生素作为一类广泛关注的有机污染物,探索其在交互带中的分布特征对认识特殊生境下污染物迁移转化过程具有重要意义.由于交互带氧化还原条件变化敏感,沉积物组成特殊,建立了一种有效提取交互带中22种抗生素及4种磺胺类代谢产物的前处理方法,并对样品初始状态、提取温度、提取液p H值以及有机提取溶剂进行了优化.同时对汉江下游河水-地下水交互带沉积物中的抗生素含量进行分析,结果表明,采用p H=3的乙腈/乙二胺四乙酸二钠(Na₂EDTA)-Mcllvaine缓冲液(1∶1,体积比)对未经氧化的沉积物原样在40℃条件下进行3次微波提取,目标抗生素的回收效果最好.汉江下游交互带沉积物中共检出11种抗生素,其中以土霉素(OTC)和氧氟沙星(OFL)为主,最高检出含量分别为6.77 ng·g^-1和5.81 ng·g^-1.不同交互剖面中抗生素含量的垂向分布差异较大,主要与沉积物岩性、抗生素理化性质和地表水-地下水交互作用等影响因素有关.     

镉污染大田条件下不同品种水稻镉积累的特征及影响因素

选取适合当地种植的8个水稻品种为试验对象,开展大田试验,比较不同品种水稻对重金属Cd的积累、吸收和转运特征,筛选出适合当地种植的Cd低累积水稻品种,并分析水稻低累积程度及稳定性影响因素.结果表明:(1)根据综合积累指数(P_N)评价方法筛选出对Cd综合积累能力低的水稻品种有:川优3203、川优6203、德粳6号和沈优17.(2)综合考虑稻米Cd含量和产量,适合在该地区种植的水稻品种为川优3203和川优6203,既能安全保障稻米Cd含量,又能保证水稻高产.(3)川优3203和川优6203在不同p H和不同总镉范围内稻米中Cd含量均显著低于其他品种,且在不同土壤条件下表现得很稳定.(4)水稻品种的差异对水稻的稻米富集能力有较大的影响,而对水稻茎叶向水稻稻米的转运能力的影响较小;川优3203和川优6203的低富集系数,加之其较低的转运,最终呈现出稻米较低的镉富集能力.(5)相关性分析发现,稻米Cd含量受水稻富集系数影响最大,受根际土壤总Cd含量影响最小.     

Performance of a large-scale greenhouse solar dryer integrated with phase change material thermal storage system for drying of chili

ABSTRACT

Large-scale greenhouse solar dryers have been used for drying various products and this type of dryer is usually equipped with LPG burner as auxiliary heater, which creates more operating cost. To overcome this problem, phase change material (PCM) thermal storage was proposed to substitute for the LPG burner. In this work, the performance of a large-scale greenhouse solar dryer integrated with a PCM as a latent heat storage for drying of chili was investigated. Experimental studies were conducted to compare the performance of this dryer with that of another large-scale greenhouse solar dryer without the PCM thermal storage and open sun drying. Chili with an initial moisture content of 74.7% (w.b.) was dried to a final moisture content of 10.0% (w.b.) in 2.5 days, 3.5 days, and 11 days using the solar dryer integrated with the PCM thermal storage, the solar dryer without the PCM thermal storage and the open sun drying, respectively. The performance of the solar dryer integrated with the PCM thermal storage was also evaluated using exergy analysis. The exergy efficiency of the drying room of the solar dryer integrated with the PCM thermal storage and the solar dryer without the PCM thermal storage for drying of chili was found to be 13.1% and 11.4%, respectively and the thermal storage helps to dry chili during adverse weather conditions. The results of exergy analysis implied that the exergy losses from the dryer with the PCM should be reduced.     

碳纤维复合材料粉尘爆炸强度特性研究

碳纤维复合材料是应用于航天、航空领域的高性能材料之一,对于该材料的粉尘爆炸特性还未有相关研究报告。为了研究碳纤维复合材料粉尘的爆炸强度特性,本文采用20L球形粉尘爆炸测试实验系统开展了相关实验研究。实验测得碳纤维复合材料粉尘爆炸下限浓度为50g/m 3,最大爆炸压力为0.48MPa。在测试浓度范围内,最大压力上升速率和爆炸指数均随浓度的增大而变大。另外,在其爆炸强度特性研究的基础上,对产尘车间的环境风险进行了初步辨识,提出了相应的防护措施。本文的研究成果对此类碳纤维复合材料粉尘的工业防护具有实际的指导作用,对于该粉尘的爆炸机理的深入研究也具有一定的参考价值。     

Evaluation of thermal hazard characteristics of four low temperature reactive azo compounds under isothermal conditions

The polymerization reaction can lower the threshold of the required energy by the initiator to improve the efficiency of the overall process reaction. Emerging polymerization initiators are also a major focus of process improvement and technological progress. Azo compounds (azos), which used in dyeing applications, are subsequently used in polymerization reactions due to their highly exothermic reaction characteristics. Although higher heat release can promote polymerization and modify the product, heat generation may also cause process hazards.These thermal hazard parameters were studied by selecting dimethyl 2,2′-azobis(2,4-dimethylvaleronitrile) (ABVN), 2,2′-azobis(2-methyl propionate) (AIBME), 2,2′-azobis(2-methylpropionamide) dihydrochloride (AIBA), and 2,2′-azobis(isobutyronitrile) (AIBN), which are common azo initiators at present. Thermal hazards are closely related to the reaction kinetics of the substance itself. The form of the reaction, the apparent activation energy and the thermodynamic parameters of the exothermic mode were also obtained.Kinetic analysis of the actual process using the experimental data of the isothermal calorimetry model is rarely used in the evaluation of related thermal hazard characteristics. The simulation results revealed the kinetic azo models and were further applied to calculate the runaway situations of azo under specific boundary conditions.     

不同冲击速度下硬煤的力学特性试验研究

为了研究硬煤破坏过程中的动态力学特性，采用Φ50 mm变截面分离式霍普金森压杆（SHPB）试验系统，对45#钢制薄壁套筒施加环向约束的硬煤试件进行不同加载速率的冲击压缩试验，得到被动围压下轴向应力-应变曲线、径向应力-应变曲线及最大被动围压和冲击速度的关系。研究结果表明:峰值应力、峰值应变随着冲击速度的增大而增大，最大被动围压值与冲击速度呈幂次增长的关系；被动围压下的硬煤试件变形受到限制，试件延性、抗压能力显著提高；随着冲击速度的增大，薄壁套筒对试件的约束也逐渐增大，达到峰值后，冲击速度对被动围压的影响减小，筒壁厚度影响着被动围压效果。     

湖北省湖泊资源特点及开发利用

通过对湖北省境内主要湖泊（面积大于１０ｋｍ＾２）的调查与分析，阐述了湖泊资源的几个特点，探讨了湖泊资源利用中存在的问题，并就湖泊资源的合理开发利用途径提出了建议。