典型装备温度响应测量及平衡时间研究

目的 研究武器装备在温度环境试验过程中温度的测量方法和温度平衡稳定的时间。方法 利用直接测量方法对3种典型装备进行温度响应时间测量和分析,找出不同类型装备的传热规律,明确其温度环境试验的作用机理,确定装备的温度平衡时间。结果 通过多项试验测试的数据分析了武器装备温度试验应力的选取,在低温和高温工作试验时,整体温度平衡所需时间应适当延长8～10h,高温贮存时间偏短,应适当延长4～6h。结论 在武器装备温度环境试验中,应根据自身性能特点获得装备的真实温度相应特性,在条件允许的情况下,尽可能地敞开武器装备的密闭空间,加快热交换,以缩短达到温度平衡的时间。对于关键及敏感部件,应实时进行温度响应测量,保证试验量级选取的科学合理,为装备环境分析及试验方案的制定提供参考依据。     

基于指数标度法的大气污染物标准浓度限值

从韦伯—费希纳定律S＝KlogR出发,指出在大气污染物背景浓度限值C_ioo至明显危害浓度限值C_I∞范围内,当污染物浓度成等比变化时,人对污染物浓度刺激量的主观差别感觉成等差变化。应用＂等差分级、等比赋值＂的指数标度法计算出６种大气污染物的三级标准浓度限值与我国制定的《大气环境质量标准》,GB3095－82规定的污染物日平均浓度限值基本接近,为我国《大气环境质量标准》提供了合理依据。     

用活性填料催化氧化-硝酸吸收法脱除氮氧化物的研究

为了提高硝酸吸收氮氧化物的效率,对活性填料催化氧化-硝酸吸收NOx进行了研究.结果表明:活性填料能明显提高NOx的吸收效率;当NOx中NO2体积百分含量增加,其吸收效率增加;随进气浓度和液气比的增大,NOx吸收效率增加;随NO2浓度的增加,NO的吸收效率先增加后减少,在NO/NO2为3时,NO吸收效率最高;随NO的增加NO2的吸收效率先增加后减少,在NO/NO2为0.6～1之间,NO2的吸收效果较好.     

建筑材料放射性测量中存在的技术问题

阐述了GB 50325-2001《民用建筑工程室内环境污染控制规范》中存在的问题,指出该规范仅对建筑材料放射性的测量不确定度D(当K=1时,D≤20%)提出了要求,未对测量时间、仪器测量下限和放射性物质特征峰漂移提出要求.实验证明,这些存在的问题对建筑材料放射性测量数据的准确性有影响.     

Estimating the Unknown Components of Nutrient Mass Balances for Forestry Plantations in Mine Rehabilitation, Upper Hunter Valley, New South Wales, Australia

Commercial forestry plantations as a postmining land use in the Upper Hunter Valley of New South Wales, Australia are restricted by both the poor nutrient availability of mining substrates and low regional rainfall. An experiment was conducted to investigate whether municipal waste products and saline groundwater from coal mining operations could improve early tree growth without impacting on the environment through salt accumulation and/or nutrient enrichment and changes in groundwater quality. Potential impacts were investigated by quantifying the nutrient cycling dynamics within the plantation using an input–output mass balance approach for exchangeable calcium (Ca²⁺), exchangeable magnesium (Mg²⁺), exchangeable potassium (K⁺), exchangeable sodium (Na⁺), nitrogen (N), and phosphorus (P). Measured inputs to and outputs from the available nutrient pool in the 0–30 cm of the overburden subsystem were used to estimate the net effect of unmeasured inputs and outputs (termed “residuals”). Residual values in the mass balance of the irrigated treatments demonstrated large leaching losses of exchangeable Ca, Mg, K, and Na. Between 96% and 103% of Na applied in saline mine-water irrigation was leached below the 0–30-cm soil profile zone. The fate of these salts beyond 30 cm is unknown, but results suggest that irrigation with saline mine water had minimal impact on the substrate to 30 cm over the first 2 years since plantation establishment. Accumulations of N and P were detected for the substrate amendments, suggesting that organic amendments (particularly compost) retained the applied nutrients with very little associated losses, particularly through leaching.     

衡山冻雨金属元素污染特征和来源解析

冻雨是冬春季节常见的灾害性天气,在我国主要分布在南方山区。冻雨在到达地表前以过冷水形式存在,是一种特殊的降水类型,其化学特性鲜见报道。2015年12月—2016年3月在南岳衡山气象站(海拔1265.9 m)收集了38个冻雨样品,使用电感耦合等离子体质谱分析了其中25种金属元素的浓度,并运用正定矩阵因子法受体模型解析了其来源。结果表明：冻雨中25种金属元素的浓度变化范围达7个数量级(2×10^-4—4×10³μg·L^-1),且大部分元素的浓度随着冻雨温度和pH的降低而增加。26%的冻雨样本受东北气团的影响,地壳元素浓度较高;而来自西南气团的冻雨样本占38%,重金属污染较重;南部气团(36%)携带的元素浓度相对较低。与国内外其他高山站点观测结果相比,衡山冻雨中金属元素的浓度水平整体上高于雨水但低于云水。通过富集因子分析发现,冻雨中Sb、Se、Cd、As、Zn和Pb等重金属明显受到人为源的影响,呈严重富集特征。源解析结果表明燃煤对冻雨化学成分的贡献最大(占31%),二次源、扬尘、工业排放和生物质燃烧的贡献分别为30%、18%、1...     

酸沉降对缙云山湖水化学的影响

为了解我国典型酸雨区酸沉降时间变化特征以及对水化学特征的影响,利用2001—2020年东亚酸沉降监测网(EANET)的湿沉降与湖泊监测数据,使用MK检验分析缙云山酸沉降和湖水化学长期变化特征,使用Spearman相关系数明确酸沉降对湖水化学特征的影响。结果表明：2001—2020年,缙云山酸雨问题已得到改善,但降水p H值在3.94—5.15,平均值为4.41,酸雨问题依然严峻。硫和溶解无机氮(dissolved inorganic nitrogen,DIN)沉降通量分别为32.85 kg·hm^-2·a^-1和22.55 kg·hm^-2·a^-1,酸雨类型已由“硫酸型”转变为“硫酸-硝酸混合型”。湖水pH值的范围在5.25—7.50,平均值为5.86,酸化频率为30%。湖水pH值与降水pH值之间的相关性(r=0.56,P<0.01)表明酸沉降对湖水酸化有一定作用。因此,对于酸化水体的治理须考虑大气沉降因素,只有协同治理大气污染才能根治水生生态系统的退化现象。     

重庆地下热水径流特征研究

重庆地下热水资源丰富,但对其径流特征缺乏研究,盲目开采致使许多温泉泉流量减小、水温降低,甚至断流、枯竭。为指导地下热水的科学开采,文章对重庆地下热水的常规化学组分及同位素组分特征进行了研究,分析了地下热水补给、径流条件,指出大气降水为其补给源,补给区在重庆以北大巴山及华莹山背斜华莹山和铜锣峡背斜北端的岩溶露头区,嘉陵江组(T1j)为其储水层,地下热水主要沿背斜T1j地层由北往南流,同一背斜地下热水由北到南为一个统一的热水系统。     

强风环境非平稳风速模型及应用

提出了强风环境非平稳风速分析模型。该模型将风速记录分解为时变平均风和零均值平稳脉动风分量两部分,给出了经验模型法确定时变平均风的步骤并重新定义了风特性参数的计算公式。分别采用非平稳和平稳风速模型进行了1 851小时实测强风资料的风特性参数计算并做了对比分析。结果显示非平稳模型计算得到的紊流强度和积分尺度较平稳模型小,而平均风速及相干函数的衰减系数则相当接近,非平稳模型较平稳模型更适合描述强风特性。     

Precision Measurements from Very-Large Scale Aerial Digital Imagery

Managers need measurements and resource managers need the length/width of a variety of items including that of animals, logs, streams, plant canopies, man-made objects, riparian habitat, vegetation patches and other things important in resource monitoring and land inspection. These types of measurements can now be easily and accurately obtained from very large scale aerial (VLSA) imagery having spatial resolutions as fine as 1 millimeter per pixel by using the three new software programs described here. VLSA images have small fields of view and are used for intermittent sampling across extensive landscapes. Pixel-coverage among images is influenced by small changes in airplane altitude above ground level (AGL) and orientation relative to the ground, as well as by changes in topography. These factors affect the object-to-camera distance used for image-resolution calculations. ‘ImageMeasurement’ offers a user-friendly interface for accounting for pixel-coverage variation among images by utilizing a database. ‘LaserLOG’ records and displays airplane altitude AGL measured from a high frequency laser rangefinder, and displays the vertical velocity. ‘Merge’ sorts through large amounts of data generated by LaserLOG and matches precise airplane altitudes with camera trigger times for input to the ImageMeasurement database. We discuss application of these tools, including error estimates. We found measurements from aerial images (collection resolution: 5–26 mm/pixel as projected on the ground) using ImageMeasurement, LaserLOG, and Merge, were accurate to centimeters with an error less than 10%. We recommend these software packages as a means for expanding the utility of aerial image data.