钱塘江引水降氮示范工程的构建和运行研究

针对杭州西湖钱塘江引水低碳高氮的特点,提出以改性水草塘—复合垂直流人工湿地(IVCW)相耦合的生物—生态工艺进行引水处理,对该引水降氮示范工程的构建和运行效果进行了跟踪研究。结果表明,整个稳定运行期间(2012年7月19日至11月19日),耦合工艺对COD、TN、硝酸盐氮、TP的平均去除率分别为52.27%、52.49%、53.69%、52.79%,系统出水满足《地表水环境质量标准》(GB 3838—2002)Ⅳ标准;改性水草塘和IVCW单元作为耦合工艺的两个重要组成部分,在脱氮、除磷方面优势互补,从而共同保证出水水质的稳定;在改性水草塘单元,温度与COD的去除效果呈负相关关系,进水C/N与TN去除效果呈正相关关系;而在IVCW单元,温度与COD、TN的去除效果均呈线性正相关关系,进水C/N与两者的去除效果也呈正相关关系,且对COD的影响要大于对TN的影响。     

A2O-MBR工艺处理城市污Z作农业灌溉用水中试研究

为开发一种污水再生利用于农田灌溉领域的新型技术,本实验以城市污水为研究对象,采用A2O—MBR工艺进行中试研究,并将系统出水水质与《农田灌溉水质标准（GB5084—2005）》的主要水质指标进行对比分析。结果表明,系统COD和BOD,出水浓度范围分别为3．2～59．6mg／L、1．0～7．6mg／L,系统出水pH为7．16～7．54,悬浮物浓度几乎为0,上述指标均符合标准;TP、TN和氨氮的出水范围分别为0．03～0．79mg／L、1．6～17．7mg／L和0．8～10．3mg／L。《农田灌溉水质标准》没有对上述3个指标提出具体要求,且少量的氮磷是植物生长的营养元素。该系统出水的主要水质指标符合标准兽求．     

活性污泥缺氧转化1-2-7-三氨基-8-羟基-3-6-萘二磺酸

1—2-7-三氨基-8-羟基-3—6-萘二磺酸（TAHNDS）作为偶氮染料的脱色产物很难被常规的厌氧-好氧染料废水处理工艺所去除。研究了未经驯化的活性污泥对TAHNDS的缺氧转化效果。结果表明,只有在特定的缺氧条件下（ORP在-50～-150mV之间）,TAHNDS才能被活性污泥所降解转化。当浓度在10—80mg／L范围内,TAHNDS可在72h内转化93％以上。加入100mg／L的硝酸盐和0．64mmol／L的氧化还原介体蒽醌-2-磺酸钠（AQS）可将40mg／L的TAHNDS的转化时间从84h缩短到36h。光谱及HPLC—MS分析表明,TAHNDS在缺氧条件下主要是通过脱氨基和脱磺酸作用生成已知可好氧生物降解的3,5-二氨基4-羟基萘-2-磺酸。因此,缺氧处理有望作为预处理工艺促进废水中TAHNDS的完全降解。     

铁氧化物复合氧化铝催化臭氧化过程中溴酸盐的生成控制

以市售活性炭、硅藻土和氧化铝小球为载体,考察了负载铁基活性组分对催化臭氧化过程中溴酸盐的控制情况,其中,铁基复合氧化铝小球体现出更好的溴酸盐还原特性和催化剂稳定性,证实催化剂中铁氧化物是溴酸盐得到有效控制的主要活性组分。进一步考察了铁基复合氧化铝小球催化臭氧化处理实际原水过程中对溴酸盐的生成控制,以及反应过程中溶解性有机碳（DOC）的去除情况。结果表明,与单独臭氧化相比,该催化剂既能有效去除水中的溶解性有机物,又能明显抑制溴酸盐的生成,反应50h,其活性并没有明显下降。催化剂失活主要归因于吸附位点数量的下降,可以通过负载铁氧化物来实现催化剂的再生。     

磷酸活化-微波热解改性污泥对镉的吸附性能

以城市污水处理厂剩余污泥为原料,利用磷酸活化-微波热解制取改性污泥。以此污泥作为吸附剂,对含Cd2+废水进行了吸附实验研究。考察了溶液反应时间、Cd2+浓度、pH值和吸附剂用量对镉吸附去除效果的影响;利用等温吸附实验作出吸附等温线,并考察了改性污泥吸附剂吸附Cd2+的动力学方程。实验结果表明,改性污泥对Cd2+有良好的吸附性能,吸附最佳pH值为6.0,吸附较好地符合一级动力学吸附模型和Langmuir-Freundlich等温吸附方程,吸附为物理吸附,吸附反应发生12 h后达到吸附平衡。     

中国陆上油藏CO2封存潜力评估

CO2捕集与封存是减缓气候变化的一种关键的碳减排选择方案。将CO2注入油藏作为一种碳埋存方式引起广泛关注。作为判断某一国家、某一区域或某一具体储层是否适合CO2地质封存开展的重要依据之一,有必要在规划碳捕集与封存(CCS)项目前,对潜在的封存库进行封存潜力评估。本文在已有可公开的地质资料的基础上,评估了中国陆上216个油田实施CO2地质封存的潜力,并与相关研究结果进行了比较。结果表明:在满足埋存深度大于800 m的筛选条件下,当假设我国陆上油田全部用于CO2-EOR时,CO2封存潜力约3.6 Gt;当陆上油田全部视为废弃油藏处理时,CO2理论封存潜力约4.6 Gt。其中,东北和华北地区油藏封存CO2潜力巨大,占陆上油田CO2封存总量的60%以上;同时这里CO2集中排放源分布密集,排放源和封存地间的匹配性良好,可以减少CO2运输和封存成本。在这两个地区可以优先考虑实施油藏封存CO2项目。     

Plutonium isotopes concentration in seawater and bottom sediment off the Pacific coast of Aomori sea area during 1991-2005

A radioactivity survey was launched in 1991 to determine the background levels of ^239+240Pu in the marine environment off a commercial spent nuclear fuel reprocessing plant before full operation of the facility. Particular attention was focused on the ²⁴⁰Pu/²³⁹Pu atom ratio in seawater and bottom sediment to identify the origins of Pu isotopes. The concentration of ^239+240Pu was almost uniform in surface water, decreasing slowly over time. Conversely, the ^239+240Pu concentration varied markedly in the bottom water and was dependent upon the sampling point, with higher concentrations of ^239+240Pu observed in the bottom water sample at sampling points having greater depth. The ²⁴⁰Pu/²³⁹Pu atom ratio in the seawater and sediment samples was higher than that of global fallout Pu, and comparable with the data in the other sea area around Japan which has likely been affected by close-in fallout Pu originating from the Pacific Proving Grounds. The ²⁴⁰Pu/²³⁹Pu atom ratio in bottom sediment samples decreased with sea depth. The land-originated Pu is not considered as the reason of the increasing ^239+240Pu concentration and also decreasing the ²⁴⁰Pu/²³⁹Pu atom ratio with sea depth, and further study is required to clarify it.     

Cs, Pu concentrations and the Pu/Pu atom ratio in a sediment core from the sub-aqueous delta of Yangtze River estuary

A sediment core collected from the sub-aqueous delta of the Yangtze River estuary was subjected to analyses of ¹³⁷Cs and plutonium (Pu) isotopes. The ¹³⁷Cs was measured using γ-spectrometry at the laboratories at the Nanjing University and Pu isotopes were determined with Accelerator Mass Spectrometry (AMS), measurements made at the Australian National University. The results show considerable structure in the depth concentration profiles of the ¹³⁷Cs and ^239+240Pu. The shape of the vertical ¹³⁷Cs distribution in the sediment core was similar to that of the Pu. The maximum ¹³⁷Cs and ^239+240Pu concentrations were 16.21 ± 0.95 mBq/g and 0.716 ± 0.030 mBq/g, respectively, and appear at same depth. The average ²⁴⁰Pu/²³⁹Pu atom ratio was 0.238 ± 0.007 in the sediment core, slightly higher than the average global fallout value. The changes in the ²⁴⁰Pu/²³⁹Pu atom ratios in the sediment core indicate the presence of at least two different Pu sources, i.e., global fallout and another source, most likely close-in fallout from the Pacific Proving Grounds (PPG) in the Marshall Islands, and suggest the possibility that Pu isotopes are useful as a geochronological tool for coastal sediment studies. The ¹³⁷Cs and ^239+240Pu inventories were estimated to be 7100 ± 1200 Bq/m² and 407 ± 27 Bq/m², respectively. Approximately 40% of the ^239+240Pu inventory originated from the PPG close-in fallout and about 50% has derived from land-origin global fallout transported to the estuary by the river. This study confirms that AMS is a useful tool to measure ²⁴⁰Pu/²³⁹Pu atom ratio and can provide valuable information on sedimentary processes in the coastal environment.     

Detection of tritium sorption on four soil materials

In order to measure groundwater age and design nuclear waste disposal sites, it is important to understand the sorption behavior of tritium on soils. In this study, batch tests were carried out using four soils from China: silty clays from An County and Jiangyou County in Sichuan Province, both of which could be considered candidate sites for Very Low Level Waste disposal; silty sand from Beijing; and loess from Yuci County in Shanxi Province, a typical Chinese loess region. The experimental results indicated that in these soil media, the distribution coefficient of tritium is slightly influenced by adsorption time, water/solid ratio, initial tritium specific activity, pH, and the content of humic and fulvic acids. The average distribution coefficient from all of these influencing factors was about 0.1-0.2 mL/g for the four types of soil samples. This relatively modest sorption of tritium in soils needs to be considered in fate and transport studies of tritium in the environment.     

Depth profile of ²³⁶U/²³⁸U in soil samples in La Palma, Canary Islands

The vertical distribution of the ²³⁶U/²³⁸U isotopic ratio was investigated in soil samples from three different locations on La Palma (one of the seven Canary Islands, Spain). Additionally the ²⁴⁰Pu/²³⁹Pu atomic ratio, as it is a well establish tool for the source identification, was determined. The radiochemical procedure consisted of a U separation step by extraction chromatography using UTEVA^® Resin (Eichrom Technologies, Inc.). Afterwards Pu was separated from Th and Np by anion exchange using Dowex 1x2 (Dow Chemical Co.). Furthermore a new chemical procedure with tandem columns to separate Pu and U from the matrix was tested. For the determination of the uranium and plutonium isotopes by alpha spectrometry thin sources were prepared by microprecipitation techniques. Additionally these fractions separated from the soil samples were measured by Accelerator Mass Spectrometry (AMS) to get information on the isotopic ratios ²³⁶U/²³⁸U, ²⁴⁰Pu/²³⁹Pu and ²³⁶U/²³⁹Pu, respectively. The ²³⁶U concentrations [atoms/g] in each surface layer (∼2 cm) were surprisingly high compared to deeper layers where values around two orders of magnitude smaller were found. Since the isotopic ratio ²⁴⁰Pu/²³⁹Pu indicated a global fallout signature we assume the same origin as the probable source for ²³⁶U. Our measured ²³⁶U/²³⁹Pu value of around 0.2 is within the expected range for this contamination source.