混凝-生物接触氧化处理合成橡胶碱洗废水

对化学合成橡胶碱洗废水进行了有机组分和可生化性分析,废水主要含有氯甲烷、六甲苯、异丁醇、甲醇等污染物质,生化降解实验中废水TOC可在6d内从60．9mg／L下降至0．0mg／L,可生化降解性好,适于生化处理。选择混凝．生物接触氧化组合工艺对废水进行处理,采用优化条件（pH=8、PAC=40mg／L、PAM=8mg／L）进行混凝,碱洗废水COD去除率为9．95％～72．94％（平均31．51％）;混凝后的碱洗废水与冲洗废水1：5混合进行接触氧化处理,在HRT为36h的情况下,COD去除率为65．6％-72．6％（平均70．4％）,出水COD为134～331mg／L,满足企业废水排放市政管网的要求;同时,实验发现COD去除率与COD容积负荷存在指数函数变化关系。     

铁炭内电解-厌氧-好氧工艺处理阿维菌素废水的试验研究

血清瓶毒性试验表明 ,AVM对厌氧消化产生强烈的抑制作用。AVM废水经铁炭内电解预处理后 ,COD和AVM的去除率分别达到 19.5 %和 6 8.5 % ,可大大降低废水的毒性。预处理出水再经UASB +生物接触氧化反应器进一步处理 ,当生化系统进水COD为 6 0 0 0— 6 5 0 0mg/L时 ,出水COD为 2 5 0— 2 80mg/L ,总COD去除率达到 95 .6 % ,出水达到生物制药行业排放标准     

混凝-水解-接触氧化-气浮工艺处理印染废水

采用混凝-水解酸化-接触氧化-气浮工艺,处理印染废水,运行结果表明：对CODcr SS、色度的去除率分别为91．5％、92％、90％,出水达到《纺织染整工业水污染排放标准》（GB4287—92）的一级标准。     

膜生物反应器生物降解与膜分离共作用特性研究

膜生物反应器实质是生物降解与膜分离相互影响,共同作用的过程,污泥浓度与通量之间存在一定的相关关系,膜分离对生和性能尤其是细菌活性有着重要的影响,而生物反应器内细菌胞外聚合物,溶解性有机物及微细胶体可能成为形成凝胶层导致通量下降的主要因素。     

四种净水工艺对水源水微量有机物去除的研究

以UV254和CODMn代表饮用水源水中有机物替代指标.对常规处理、生物陶粒预处理、生物滤池、生物活性炭(BAC)、颗粒活性炭(GAC)、纳滤和光催化氧化进行组合,形成不同的处理流程,研究各流程对UV254和CODMn的去除效果.结果表明,各工艺流程都有一定的处理效率,其中以生物滤池和纳滤为主的组合流程处理效果最佳.此流程对UV254的去除率接近100%,CODMn的去除率达到78.6%,大大提高了饮用水的安全性.     

造纸中段废水与生活污水合并深度处理工艺

采用水解酸化 CAST 混凝 复合滤池与水解酸化 接触氧化 混凝 复合滤池2种组合工艺对造纸中段废水与生活污水进行合并处理对照试验.结果表明,两种工艺都是切实可行的,二级出水均可达到<污水综合排放标准>(GB8978-1996)二级标准,深度处理出水可达中水水质要求.其中以水解酸化 CAST 混凝 复合滤池组合工艺效果最好.     

Chemical industry wastewater treatment

Treatment of chemical industrial wastewater from building and construction chemicals factory and plastic shoes manufacturing factory was investigated. The two factories discharge their wastewater into the public sewerage network. The results showed the wastewater discharged from the building and construction chemicals factory was highly contaminated with organic compounds. The average values of chemical oxygen demand (COD) and biochemical oxygen demand (BOD) were 2912 and 150 mgO₂/l. Phenol concentration up to 0.3 mg/l was detected. Chemical treatment using lime aided with ferric chloride proved to be effective and produced an effluent characteristics in compliance with Egyptian permissible limits. With respect to the other factory, industrial wastewater was mixed with domestic wastewater in order to lower the organic load. The COD, BOD values after mixing reached 5239 and 2615 mgO₂/l. The average concentration of phenol was 0.5 mg/l. Biological treatment using activated sludge or rotating biological contactor (RBC) proved to be an effective treatment system in terms of producing an effluent characteristic within the permissible limits set by the law. Therefore, the characteristics of chemical industrial wastewater determine which treatment system to utilize. Based on laboratory results engineering design of each treatment system was developed and cost estimate prepared.     

生物-物化工艺处理造纸工业废水实例分析

以任丘市星火集团公司造纸厂废水处理工程为例，介绍了采用生物处理、物化处理相结合的工艺处理造纸工业废水的工艺流程以及主要设计参数。该工艺运行稳定，处理效果好，ＣＯＤ的去除率达到８０％以上，处理后的废水水质达到了《造纸工业水污染物排放标准》（ＧＢ３５４４－９２）中的二级标准。     

生物型煤固硫技术

研究出生物型煤的生产工艺流程，对型煤和生物型煤的固流效果进行了对比。成功地试验生产出固硫性能优良的生物型煤，为消除煤能源利用中的硫污染开辟了新途径。     

Protecting the piping plover under section 7 of the endangered species act

Section 7(a)(2) of the Endangered Species Act directs federal agencies to ensure that their actions do not jeopardize the continued existence of endangered and threatened species. The US Fish and Wildlife Service (USFWS) issues jeopardy or nonjeopardy biological opinions on proposed federal actions that affect endangered and threatened species. We summarize several biological opinions issued by the USFWS to protect the threatened piping plover (Charadrius melodus). These opinions address federal actions involving hundreds of piping plovers on the Missouri River system and a few piping plover pairs on short stretches of Atlantic coast beach. Some of these opinions are decisive, but most allow the proposed action to proceed conditional upon a lengthy set of reasonable and prudent alternatives to protect the piping plover. These conditions may prove difficult to track and will add to the workload of the USFWS.