MFC-MBR耦合系统运行效果

膜生物反应器(MBR)是一种高效的污水处理工艺,而微生物燃料电池(MFC)能有效降解污泥中的胞外生物有机质(EBOM)并回收电能.将MFC与MBR联用,建立了一套能够有效抑制膜污染同时回收电能的新系统——MFC-MBR耦合系统,MBR的剩余污泥经MFC处理后回流.以传统MBR为对照,对耦合系统中污水处理效果、膜污染情况和污泥混合液的性质进行研究.研究表明,耦合系统的污水处理效果没有明显恶化,COD去除率为94％,NH4+-N的去除率为92％.耦合系统能够有效减缓膜污染的发生,清洗周期延长了28％.污泥混合液的MLVSS/MLSS稳定在80％ ～ 88％,系统内几乎没有无机颗粒积累.松散结合态胞外聚合物(LB-EPS)降低了48％,使污泥混合液性质得到改善.较低的污泥比阻(2.69×1012m/kg)和标准化毛细吸水时间(1.67 s·L/g MLSS),证明耦合系统污泥混合液脱水性能提高了.     

臭氧催化氧化工艺深度处理印染废水

采用正交实验对催化剂NiO/γ-A12O3的制备条件进行优化,并探讨臭氧催化氧化法对于印染废水的深度处理效能.结果表明,最优的催化剂制备条件为:浸渍液浓度为3％、浸渍时间为4h、灼烧温度为450℃、灼烧时间为3h.臭氧催化氧化反应15 min时,COD浓度由84.22 mg/L降低至50.00 mg/L以下;氨氮浓度由10.88 mg/L降低至5.01 mg/L;色度去除率达到69％,明显高于单纯臭氧氧化的反应效率.     

污水处理厂AB法工艺改造方案的探讨

针对漳州市东区污水处理厂AB法工艺改造的目标,分析了AB法工艺的局限性,结合该污水处理厂AB法工程的现有设施,从技术上探讨了5种具有脱氮除磷功能的工艺改造方案的可行性,并得到了适合于该污水处理厂AB法工艺改造的方案。     

微生物法处理海上钻井废钻井液

微生物法适用于海上钻井含油废弃物的处理。通过多次对菌株采集、分离、纯化和培养驯化,选育得到了3株对石油烃类有很好降解效果的石油类降解菌;确定了石油类降解菌适宜的生化处理条件:最佳生长及原油降解温度为50℃、最佳生长及原油降解酸碱性环境为pH=6.0、最佳菌株接种量2%、最佳原油初始浓度为500mg/L。处理后的含油废弃钻井液含油量基本稳定在2mg/L以下,降解率达98%以上。     

油田压裂返排液处理技术实验研究

油气井压裂作业过程中产生的压裂返排液已成为当前油田水体的主要污染源之一。文章对吉林油田公司压裂返排液处理工艺进行了实验研究。结果表明:在采用絮凝、微波强氧化、活性炭毡处理、纳滤/反渗透集成处理工艺后,压裂返排液CODCr可以达到GB 8978-1996《污水综合排放标准》一级标准要求。该研究为压裂返排液处理装置的设计和现场实施提供了实验基础。     

新农村建设污水处理工程实例

山海关区新民居污水治理工程采用水解酸化+接触氧化+曝气生物滤池为主的工艺进行污水治理,实际运行结果表明:系统运行稳定,处理出水COD≤48 mg.L-1,BOD5≤9 mg.L-1,SS≤10 mg.L-1,NH3-N≤4.5 mg.L-1,TP≤0.47 mg.L-1,处理出水达到《城镇污水处理厂污染物排放标准》(GB 18918-2002)一级A标准,出水用于农村绿化和农灌,经济效益和环境效益明显。     

Chlorinated solvents in a petrochemical wastewater treatment plant: an assessment of their removal using self-organising maps

The self-organising map approach was used to assess the efficiency of chlorinated solvent removal from petrochemical wastewater in a refinery wastewater treatment plant. Chlorinated solvents and inorganic anions (11 variables) were determined in 72 wastewater samples, collected from three different purification streams. The classification of variables identified technical solvents, brine from oil desalting and runoff sulphates as pollution sources in the refinery, affecting the quality of wastewater treatment plant influent. The classification of samples revealed the formation of five clusters: the first three clusters contained samples collected from the drainage water, process water and oiled rainwater treatment streams. The fourth cluster consisted mainly of samples collected after biological treatment, and the fifth one of samples collected after an unusual event. SOM analysis showed that the biological treatment step significantly reduced concentrations of chlorinated solvents in wastewater.     

Removal of tetrabromobisphenol A by conventional activated sludge, submerged membrane and membrane aerated biofilm reactors

The goal of this study was to compare removal efficiencies of tetrabromobisphenol A (TBBPA) using typical wastewater treatment technologies, and to identify the most significant mechanisms of removal. Two types of municipal wastewater reactors were studied: a full-scale conventional activated sludge (CAS) reactor with tertiary treatment; and three pilot-scale membrane bioreactors (MBRs) having different sludge retention times (SRTs). All four reactors were fed the same influent. A third reactor type, a membrane aerated biofilm reactor (MABR) was fed tap water, ammonia, and TBBPA. TBBPA in municipal influent ranged from 1 to 41 ng L⁻¹ (n = 10). The CAS effluent had an average TBBPA concentration of 0.7 ± 1.3 ng L⁻¹ (n = 3). Effluent concentrations from the MBRs were an average of 6 ± 6 ng L⁻¹ TBBPA (n = 26). Significant TBBPA removal was observed in the MABR throughout the 5 week of study (p ? 0.05). Removal of TBBPA from wastewater treatment was found to be due to a combination of adsorption and biological degradation. Based on experimental results, nitrification is likely a key process therein. No significant relationship between removal of TBBPA and SRT was identified (p ? 0.05).     

原位热处理技术修复重质非水相液体污染场地研究进展

重质非水相液体(DNAPLs)是土壤及地下水中广泛存在的有机污染物,原位热处理技术是目前修复受DNAPLs污染土壤及地下水的最具潜力的技术之一。综述了国内外常用原位热处理技术的基本原理及其影响因素,介绍了相关现场应用实例,并展望了该技术未来的应用前景和发展趋势,以期为中国污染土壤及地下水的原位修复提供有益借鉴。     

改性多壁碳纳米管对水中Cd~（2＋）的去除

为了增加多壁碳纳米管（multiwall carbon nanotubers,MWNTs）对水中Cd2＋的吸附量,使用混酸对多壁碳纳米管进行氧化处理,采用红外光谱进行结果表征,并探讨了吸附时间、pH值和MWNTs的使用量、Cd2＋的浓度及干扰离子对镉离子吸附的影响。结果表明,吸附时间为1.5 h、pH为5.3、吸附效果最佳,随MWNTs量的增加Cd2＋去除量增加,共存的阳离子会降低对Cd2＋的吸附效果,对Cd2＋的吸附符合Longmuir吸附定律。研究同时表明,pH小于2时Cd2＋能容易从碳纳米管上解吸。初步探讨了Cd2＋吸附机制。