Comparison of CNT-PVA membrane and commercial polymeric membranes in treatment of emulsified oily wastewater

CNT-PVA membrane was fabricated and compared with polymeric membranes. The separation performance was evaluated by homemade and cutting fluid emulsions. The three membranes show similar oil retention rates. CNT-PVA membranes have higher permeation fluxes compared with polymeric membranes. CNT-PVA membrane shows higher fouling resistance. Membrane separation is an attractive technique for removal of emulsified oily wastewater. However, polymeric membranes which dominate the current market usually suffer from severe membrane fouling. Therefore, membranes with high fouling resistance are imperative to treat emulsified oily wastewater. In this study, carbon nanotube-polyvinyl alcohol (CNT-PVA) membrane was fabricated. And its separation performance for emulsified oily wastewater was compared with two commercial polymeric membranes (PVDF membrane and PES membrane) by filtration of two homemade emulsions and one cutting fluid emulsion. The results show that these membranes have similar oil retention efficiencies for the three emulsions. Whereas, the permeation flux of CNT-PVA membrane is 1.60 to 3.09 times of PVDF membrane and 1.41 to 11.4 times of PES membrane, respectively. Moreover, after five consecutive operation circles of filtration process and back flush, CNT-PVA membrane can recover 62.3% to 72.9% of its initial pure water flux. However, the pure water flux recovery rates are only 24.1% to 35.3% for PVDF membrane and 6.0% to 26.3% for PES membrane, respectively. Therefore, CNT-PVA membrane are more resistant to oil fouling compared with the two polymeric membranes, showing superior potential in treatment of emulsified oily wastewater.     

Mineral, chemical and radiological investigation of a black sand at Touzla Cape, near Thessaloniki, Greece

A black-sand formation located at Touzla Cape, near Thessaloniki city, Greece, was investigated using optical microscopy, powder-XRD, SEM-EDS, INAA and in-situ -ray spectrometry. This black sand is mainly composed of ilmenite, magnetite, garnet, zircon and rutile. Also present, in minor or trace amounts, are quartz, sphene, pyroxenes, sillimanite, feldspars, biotite, haematite, tourmaline, chromite, niobian-rutile and pyrrhotite. Niobian-rutile and pyrrhotite were found as inclusions in ilmenite and magnetite respectively. The radioactivity measurements indicated contributions of the uranium and thorium radioactive series and of 40K and 137Cs, and the maximum value of the total absorbed dose rate in air was found to be 62, 172, 8 and 2 nGy h-1 respectively. The main radioactivity of the uranium and thorium series is attributed to the fractions of zircon (304 µg Th g-1 and 157 µg U g-1), of ilmenite (89 µg Th g-1) and to a lesser extent to the fraction of garnet (5 µg Th g-1). The zircon fraction also contained 5076 µg Hf g-1. Some minerals and elements (Ti, Zr, Hf, Th, U) contained in the black sand could be of potential economic value. The high proportions of monomineralic grains along with the variations observed in mineral phases, in colour, in sphericity, in roundness, in grain size, in composition and in mineral inclusions, imply that the minerals and grains were subjected to several cycles of weathering and sedimentation, as well as being derived from multiple source rocks and areas.     

Ancillary benefits of reduced air pollution in the US from moderate greenhouse gas mitigation policies in the electricity sector

Actions to slow atmospheric accumulation of greenhouse gases also would reduce conventional air pollutants yielding “ancillary” benefits that tend to accrue locally and in the near-term. Using a detailed electricity model linked to an integrated assessment framework to value changes in human health, we find a tax of $25 per metric ton of carbon emissions would yield NO_x-related health benefits of about $8 per metric ton of carbon reduced in the year 2010 (1997 dollars). Additional savings of $4–$7 accrue from reduced investment in NO_x and SO₂ abatement in order to comply with emission caps. Total ancillary benefits of a $25 carbon tax are $12–$14, which appear to justify the costs of a $25 tax, although marginal benefits are less than marginal costs. At a tax of $75, greater total benefits are achieved but the value per ton of carbon reductions remains roughly constant at about $12.     

Carbon monoxide levels at a toll plaza near Durban, South Africa

Reliable measurements of pollutant levels in the vicinity of a toll plaza appear to be rare. In order to assess the exposure of toll booth operators to carbon monoxide, a continuous carbon monoxide monitor was installed at head height in the booth of a medium density traffic lane at the Mariannhill toll plaza, situated on a busy highway near Durban, South Africa. Measurements in excess of 500 ppmv were recorded and the high daily mean carbon monoxide concentrations may account for some of the symptoms such as headaches and general malaise that have been reported by workers in the booths. Generally, carbon monoxide levels recorded far exceed the recommended limit set by the South African authorities. These results have led to recommendations regarding the structure of new and existing toll booths to minimize the exposure of toll booth workers to adverse effects of vehicle-emitted pollutants.     

环境中一氧化碳监测技术现状

通过对一氧化碳危害性的论述,说明了环境中对一氧化碳浓度进行监测的必要性。对基于一氧化碳的理化性质进行的几种检测技术及在此基础上开发的监测仪器,设备进行了分析、比较,阐述了一氧化碳监测技术的现状。     

Restoration of Some Parameters in the Development of Benthos After Reduction of Anthropogenous Loading in the Ecosystem of the Sevastopol Bay in the Black Sea

Research on benthic communities have been carried out in the Sevastopol Bay of the Black Sea for a hundred years. The anthropogenous influence began to have an effect already in the 20–30^th. In this period, all oyster-banks were lost and the mussel-silt and mellina-silt communities have begun to degrade and were not found during almost seventy years in the Bay. The worst state of benthic communities was observed in the 60–90^th, when species of bottom animals were not found over some parts of the sea. In this period, only 10 macrozoobenthic species were registered in the Bay. Mollusks: Nassarius reticulatus, Bittium reticulatum, Cerastoderma glaucum and polychaetes: Nephtys hombergii, Neanthes succinea have proved the most enduring at high anthropogenous loadings The faunistic complex of benthic species registered in 1913 had the greatest similarity to the benthic species complex of 2002. Return of mussel, Melinna palmata polychaete and Ascidiella aspersa sea squirt in benthic communities of the Sevastopol Bay are responsible for the similarity between these faunistic complexes. The restoration of local populations of these benthic species has followed the significant decrease of the anthropogenous loading on the sea ecosystems as a result of the significant reduction of the military naval base in the Bay during the last five to ten years.     

Baselines for land-use change in the tropics: application to avoided deforestation projects

Although forest conservation activities, particularly in the tropics, offer significant potential for mitigating carbon (C) emissions, these types of activities have faced obstacles in the policy arena caused by the difficulty in determining key elements of the project cycle, particularly the baseline. A baseline for forest conservation has two main components: the projected land-use change and the corresponding carbon stocks in applicable pools in vegetation and soil, with land-use change being the most difficult to address analytically. In this paper we focus on developing and comparing three models, ranging from relatively simple extrapolations of past trends in land use based on simple drivers such as population growth to more complex extrapolations of past trends using spatially explicit models of land-use change driven by biophysical and socioeconomic factors. The three models used for making baseline projections of tropical deforestation at the regional scale are: the Forest Area Change (FAC) model, the Land Use and Carbon Sequestration (LUCS) model, and the Geographical Modeling (GEOMOD) model. The models were used to project deforestation in six tropical regions that featured different ecological and socioeconomic conditions, population dynamics, and uses of the land: (1) northern Belize; (2) Santa Cruz State, Bolivia; (3) Paraná State, Brazil; (4) Campeche, Mexico; (5) Chiapas, Mexico; and (6) Michoacán, Mexico. A comparison of all model outputs across all six regions shows that each model produced quite different deforestation baselines. In general, the simplest FAC model, applied at the national administrative-unit scale, projected the highest amount of forest loss (four out of six regions) and the LUCS model the least amount of loss (four out of five regions). Based on simulations of GEOMOD, we found that readily observable physical and biological factors as well as distance to areas of past disturbance were each about twice as important as either sociological/demographic or economic/infrastructure factors (less observable) in explaining empirical land-use patterns. We propose from the lessons learned, a methodology comprised of three main steps and six tasks can be used to begin developing credible baselines. We also propose that the baselines be projected over a 10-year period because, although projections beyond 10 years are feasible, they are likely to be unrealistic for policy purposes. In the first step, an historic land-use change and deforestation estimate is made by determining the analytic domain (size of the region relative to the size of proposed project), obtaining historic data, analyzing candidate baseline drivers, and identifying three to four major drivers. In the second step, a baseline of where deforestation is likely to occur–a potential land-use change (PLUC) map—is produced using a spatial model such as GEOMOD that uses the key drivers from step one. Then rates of deforestation are projected over a 10-year baseline period based on one of the three models. Using the PLUC maps, projected rates of deforestation, and carbon stock estimates, baseline projections are developed that can be used for project GHG accounting and crediting purposes: The final step proposes that, at agreed interval (e.g., about 10 years), the baseline assumptions about baseline drivers be re-assessed. This step reviews the viability of the 10-year baseline in light of changes in one or more key baseline drivers (e.g., new roads, new communities, new protected area, etc.). The potential land-use change map and estimates of rates of deforestation could be re-done at the agreed interval, allowing the deforestation rates and changes in spatial drivers to be incorporated into a defense of the existing baseline, or the derivation of a new baseline projection.     

活性炭纤维电极法处理草浆造纸黑液的应用研究

用活性炭纤维（ＡＣＦ）电极法和酸析、凝聚处理加电极组合方法，对造纸黑液进行处理。结果表明，电极法处理黑液，ＣＯＤｃｒ、色度去除率分别达６４．２５％和９４％；“酸化＋电解（４５ｍｉｎ）＋Ｆｅｎｔｏｎ试剂”的综合治理方法效果较好，ＣＯＤｃｒ、色度去除率分别达９４．２％和９９．６％，出水近乎清澈透明。     

Comparison of Black Carbon,Total Organic Carbon,and PAH Concentrations in Surface Sediments from Two Main Rivers in Henan Province,China

Black carbon (BC) in surface sediments from Henan section of Yellow River and Huaihe River, China, was determined. Average content of BC in Huaihe River was 0.33%, higher than that in Yellow River (n?=?23) with mean value of 0.15%. Distribution patterns of BC in Yellow River and Huaihe River were similar, namely that tributaries had higher BC content than main stream. In addition, BC content in the mainstream of Yellow River and Huaihe River decreased with altitude. The BC content presented a significant positive correlation with clay (r?=?0.672; p?<?0.01) content in Yellow River, while neither did in Huaihe River. The ratio of BC/TOC ranged from 1.8–57.4% (median 29.6%), evidencing pyrogenic fossil fuel source of BC in Yellow River. Relatively low values of BC/TOC in Huaihe River (5.3%–28.8%, median 7.5%,) reflected that the origin of BC is from burning of biomass. In addition, Pearson rank correlation analysis showed that BC was in strong correlation with lighter PAH in Yellow River, while BC was in significant correlation with heavier PAH in Huaihe River. The ratio of BC/TOC indicated that BC in Yellow River mainly came from fossil fuel combustion, while BC in Huaihe River was primarily from biomass burning.     

Stable hydrogen,carbon and chlorine isotope measurements of selected chlorinated organic solvents

Stable hydrogen isotopes of two chlorinated solvents, trichloroethylene (TCE) and 1,1,1-trichloroethane (TCA), provided by five different manufacturers, were determined and compared to their carbon and chlorine isotopic signatures. The isotope ratio for delta2H of different TCEs ranged between +466.9 per thousand and +681.9 per thousand, for delta13C between -31.57 per thousand and -27.37 per thousand, and for delta37Cl between -3.19 per thousand and +3.90 per thousand. In the case of the TCAs, the isotope ratio for delta2H ranged between -23.1 per thousand and +15.1 per thousand, for delta13C between -27.39 per thousand and -25.84 per thousand, and for delta37Cl between -3.54 per thousand and +1.39 per thousand. As well, a column experiment was carried out to dechlorinate tetrachloroethylene (PCE) to TCE using iron. The dechlorination products have completely different hydrogen isotope ratios than the manufactured TCEs. Compared to the positive values of delta2H in manufactured TCEs (between +466.9 per thousand and +681.9 per thousand), the dechlorinated products had a very depleted delta2H (less than -300 per thousand). This finding has strong implications for distinguishing dechlorination products (PCE to TCE) from manufactured TCE. In addition, the results of this study show the potential of combining 2H/1H analyses with 13C/12C and 37Cl/35Cl for isotopic fingerprinting applications in organic contaminant hydrogeology.