Effect of humic substances on the precipitation of calcium phosphate

For phosphorus （P） recovery from wastewater, the effect of humic substances （HS） on the precipitation of calcium phosphate was studied. Batch experiments of calcium phosphate precipitation were undertaken with synthetic water that contained 20 mg/L phosphate （as P） and 20 mg/L HS （as dissolved organic carbon, DOC） at a constant pH value in the range of 8.0-10.0. The concentration variations of phosphate, calcium （Ca） and HS were measured in the precipitation process; the crystalline state and compositions of the precipitates were analysed by powder X-ray diffraction （XRD） and chemical methods, respectively. It showed that at solution pH 8.0, the precipitation rate and removal efficiency of phosphate were greatly reduced by HS, but at solution pH ≥9.0, the effect of HS was very small. The Ca consumption for the precipitation of phosphate increased when HS was added; HS was also removed from solution with the precipitation of calcium phosphate. At solution pH 8.0 and HS concentrations ≤3.5 mg/L, and at pH ≥ 9.0 and HS concentrations ≤ 10 mg/L, the final precipitates were proved to be hydroxyapatite （HAP） by XRD. The increases of solution pH value and initial Ca/P ratio helped reduce the influence of HS on the precipitation of phosphate.     

A new approach to Assess Atmospheric Nitrogen Deposition by Way of Standardized Exposition of mosses

A standardized method of moss exposition for assessing variations in nitrogen deposition was tested in the western part of Germany. Six pleurocarpous moss species were transplanted to two sites differing in their deposition rates but being comparable as to their climatic conditions. The mosses were exposed in standardized containers over a period of 12 months; the focus of interest was the effect of N deposition on nitrogen content and on ¹⁵N natural abundance (δ¹⁵N-values). Within the first nine months only trends could be observed. However, after one year all species tested showed significantly higher N concentrations at the highly polluted site. Besides, more negative δ¹⁵N-values possibly reflecting the higher ammonium input were detected at this site. Surprisingly, most of the plants though being kept in plastic containers without a favourable substratum did not show any conspicuous deficiency symptoms. The potential advantages of a standardized moss exposition for N monitoring purposes are discussed. It is concluded that the method presented here can yield significant results in particular if the number of testing sites is increased.     

反渗透技术在小便池废水回用中的试验研究

首先将自配模拟尿液稀释不同的倍数后进行反渗透处理,确定了适宜的操作压力和合理的稀释倍数,然后用实际的人体尿液进行验证试验,经反渗透处理后,BOD5去除率达到98.3%、氨氮去除率达到97.7%、电导率降低了96.1%,产水投碱和二氧化氯后可达到城市杂用水水质标准(GB/T18920-2002)的要求,回用作冲厕用水。最后指出了值得关注的研究方向,以期能为小便池废水的循环利用提供一定的参考。     

峨眉山景区旅游商品的开发与营销模式

通过对旅游商品定义的综述,界定了旅游商品的定义、范围和功能,同时对峨眉山景区旅游商品的开发、需求、购买力等抽取420份问卷作为样本,分析了峨眉山旅游商品的需求现状,并以旅游者需求现状为依据,对峨眉山旅游商品的开发和营销提出了“4P＋4C＋4R”营销策略,以期对其它景区的旅游商品开发和营销具有一定的借鉴意义。     

硫化物生物氧化脱硫技术研究现状

介绍了近年来国内外硫化物生物氧化为单质硫的各种脱硫技术.分析总结了硫化物生物氧化为单质硫工艺的各种影响因素,包括氧硫比、溶解氧浓度、硫化物浓度、化学氧化、微生物菌种、pH值、温度等因素.提出了生物氧化脱硫技术的发展前景.该技术将脱硫和单质硫的回收和为一体,是一种安全、低成本将含硫废液变废为宝的工艺技术.     

悬浮填料活性污泥法优化填料投配比试验

悬浮填料活性污泥法中试试验系统,利用某城市污水厂生产工艺回流污泥为系统悬浮污泥,探讨了悬浮填料投配比、投配方式和中试硝化效果之间的关系。试验结果表明,悬浮填料最小投配比为15%即可满足系统硝化功能的要求;悬浮填料的投配方式宜采用集中投配并布置于曝气池的末端,这样既可提高系统的生物膜量,又有利于硝化反应的实现。而且,控制适当的溶解氧浓度,悬浮填料的投加有助于同步硝化反硝化更充分的进行。     

动态稀释校准仪对VOCs自动监测系统的影响

基于环境空气VOCs自动监测系统中动态稀释校准仪在相同稀释比和不同稀释流量条件下,对仪器测试结果误差的影响进行研究,指出了当前环境空气VOCs自动监测普遍使用的校准仪的不足之处。选取臭氧前体物(PAMS) 57种有机化合物,以不同稀释总流量,分别测试0. 5和1. 0 nmol/mol的平均检出限以及平均回测偏差,结果显示,在输出流量1 000 m L/min时,平均检出限分别在0. 02～0. 17和0. 01～0. 10 nmol/mol;平均回测偏差在-12%～26%和-28%～10%。当总输出流量 1 000 m L/min时,多点曲线各浓度点重复性5%。     

Ti3C2纳米层状材料对废水中Cr（Ⅵ）的光催化去除性能

以Ti₃AlC₂为原料,采用HF刻蚀工艺制备出12种Ti₃C₂纳米层状材料,对其形貌进行了表征,并考察了以其作为光催化剂对废水中Cr（Ⅵ）的处理效果。实验结果表明：HF体积分数为80%、刻蚀时间为48 h时得到的MX-80-48的形貌较好;MX-80-48具有类似石墨烯的二维层状结构,纳米层厚度约20~50 nm,孔径2~10 nm,比表面积14.8 m²/g,在400~700 nm可见光范围内表现出强烈的吸光性;当Cr（Ⅵ）的初始质量浓度为40.00 mg/L、MX-80-48投加量为200 mg/L、pH=2、反应时间4 h（暗反应1 h+光照3 h）时,Cr（Ⅵ）去除率可达100%。     

预氧化聚丙烯腈/g-C3N4光催化降解罗丹明B

以聚丙烯腈(PAN)和g-C_3N_4为原料,采用超声波辅助分散的溶液浸渍法及煅烧法制备了具有共轭结构的预氧化聚丙烯腈/g-C_3N_4复合光催化剂(CPAN/g-C_3N_4),采用XRD、SEM、FTIR、UV-Vis DRS、EIS等技术对光催化剂进行了表征,考察了CPAN/g-C_3N_4对罗丹明B(Rh B)的可见光催化降解性能。结果表明:CPAN与g-C_3N_4具有良好的协同作用,使g-C_3N_4片状结构堆叠体颗粒显著减小,明显增强了光催化剂在全部光谱范围内的光吸收,有效提高了光生电子-空穴分离效率;在PAN与g-C_3N_4质量比为1∶200、煅烧温度250 ℃、煅烧时间1 h条件下所制备的CPAN/g-C_3N_4光催化活性最高,且具有良好的光催化活性稳定性。超氧自由基和光生空穴为CPAN/g-C_3N_4复合光催化剂光降解罗丹明B的主要活性物种。     

FCR多级接触氧化系统处理乳品工业废水的研究

为提高乳品工业废水生物处理的去污脱氮能力,以新型螺旋状纤维填料作为载体,采用多级氧化槽内不同种类微生物形成的食物链系统（food chain reactor）,详细考察了不同水力停留时间COD、TN、NH^＋₄-N、TP等的去除率及其去除机理,并对污泥减量化效果进行了初步探讨.结果表明,当进水COD为842～1 843 　mg/L、TN为36.3～92.2 　mg/L、NH^＋₄-N为30.1～52.1 　mg/L,HRT=6　h时,系统COD的平均去除率达到93.3%;TN和NH⁺₄-N的去除效果显著,其平均去除率分别达到73.3%和80.7%,出水COD、TN、NH⁺₄-N平均值分别为79.4　mg/L、9.6 　mg/L、6.1　mg/L,均低于《污水综合排放标准》（GB 8978-2002）的一级标准.该系统不仅具有较高的去污脱氮效果,而且产生的剩余污泥量极少,其污泥产率的平均值为7.7%.该系统运行费用低,操作管理方便,长期运行稳定,可应用于城市污水、中高浓度有机废水（如餐厅污水、食品工业废水）等的处理.